WaveReady Eight-Port Any Service OTN Muxponder WRM-8008T000B

Transcription

1 WaveReady Eight-Port Any Service OTN Muxponder WRM-8008T000B Data Sheet

2 A flexible WDM transport solution The WRM-8008 is a next-generation OTN muxponder that can transparently aggregate up to eight client signals in an OTU2 signal. Using the latest OTN multiplexing capabilities, the WRM-8008 enables a flexible and efficient aggregation of multiple services over one wavelength. It simplifies the network deployment of new services by minimizing the need for provisioning and also by providing an embedded management channel using the OTN layer to manage remote nodes. Its flexible pluggable interfaces support a variety of transceivers on both client and line interfaces (850 nm, 1310 nm, 1550 nm, and WDM). Due to its high flexibility and density, the WRM-8008 is the optimal OTN aggregation and transport solution for access and metro networks. Simple and easy to manage The WRM-8008 can be managed using TL-1 or SNMP or by using the WaveReady Node and Multinode Manager graphical user interface. The muxponder also supports manual provisioning, diagnostic loopback for testing, optical power monitoring, and other features. These functions facilitate fault location and correction and simplify operations required to manage services and service-level agreements. WaveReady WRM muxponders provide a transparent and efficient Layer 1 aggregation solution with the key protocol mapping and multiplexing capabilities required by both access and core networks. They also provide many other benefits. First, they optimize for transport of multiple services over one wavelength by leveraging the latest OTN mapping and multiplexing standards. Second, they simplify the operation and provisioning of multi-service transport solutions when compared to traditional MSPP based on a SONET/SDH VCAT architecture. Finally, the platform differentiates itself by its ease of use and its plug-and-play approach which reduces provisioning requirements. Key Benefits Simplify network deployment via embedded Ethernet-based management channel Self-configuring for accelerated service turn-up and time to revenue Standards-based OTN for efficient protocol mapping and interoperability Simplify sparing and inventory management Fully utilize network capacity through 10 G sub-wavelength aggregation, deferring costly network upgrades Improve network and equipment utilization Key Features Aggregates up to eight client signals in OTN standards-based OTU2 containers Client signal mapping using ODU0 and ODU1; data rates from 125 Mbps up to 4.25 G Supports standard and enhanced FEC for improved performance and reach Built-in remote Ethernet-based management channel Performance monitoring statistics on both client and line interfaces Supports tunable XFP transceivers on line interfaces Supports flexible SFP interfaces and client interfaces (SR, IR, LR, and WDM) Supports synchronous and asynchronous mapping Diagnostic loopback on all ports for rapid, remote troubleshooting Application Next-generation metro and aggregation DWDM networks, conserving fiber and wavelengths Cost-effective aggregation mobile base stations for efficient transport to mobile switching centers Delivery of high-value data services over DWDM supporting guaranteed data rates through OTN multiplexing Efficient enterprise and data center interconnect solutions using a single module 2

3 As illustrated below, the WaveReady platform aggregates and transparently transports any service over OTN while providing a full end-to-end management solution. The WRM-8008 supports the multi-service performance monitoring capabilities required to guarantee service level agreements (SLAs). When combined with other WaveReady products, the WRM-8008 provides a full WDM transport solution that is reliable, scalable, and easy to manage. Central Office OC3/12/48, SDH1/4/16, ODU0 Central Office OC3/12/48, SDH1/4/16, ODU0 WRM8008 Muxponder nx10 G DWDM WRM8008 Muxponder OTN In-Band OAM Specifications 1 Parameter Minimum Typical Maximum Electrical DC supply voltage Power dissipation Alarm relay signals Physical Size (H x W x L) Weight (approximate) Environmental 48 V 80 W Dry contact major and minor alarms. Relay open under normal operation. Relay closed when power is off. 6.8 x 2.2 x 8.8 in (17.3 x 5.6 x 22.4 cm) 3.1 lbs (1.4 kg) Normal operating temperature 0 C 40 C Extended operating temperature 5 C 55 C Storage temperature 40 C 85 C Relative humidity (non-condensing) 5% 90% Compliance Telcordia NEBS Level 3; FDA Class 1M laser device; FCC Class A device; UL First Edition; CAN/CSA C22.2 No ; CE; RoHS (Exemptions 7b, 8a); IEC Section 5.7 and IEEE 1613 Section 7 and 8 (EMI Immunity) Interface Optical Craft TL1/SNMP Front panel Description LC/PC on all ports Requires WaveReady 3500F-HP-series shelf and a WaveReady COM300 module. Craft access through RS232/DB-9 connector on front panel of COM300 module. Requires WaveReady 3500F-HP-series shelf and a WaveReady COM300 communications module. TL1/SNMP interfaces via the 10/100BaseT Ethernet/RJ45 connector on the front panel of a COM300. Three LEDs: Module (power), MAJ/CRIT (major/critical alarm), MIN (minor alarm) Notes: 1. Specifications are worst case, end-of-life over specified temperature and wavelength range.the maximum loss should be 0.2 db lower. 3

4 Specifications Supported SFPs Client SFPs Description Part number Bit rate (Mbps) Launch power (dbm) Reach Receiver sensitivity SFP transceiver, dual speed (100/1000BT) Copper, 100 m SFP transceiver, multirate ( Mbps) with DDM, 1310 nm, 5 10 km SFP transceiver, multirate ( Mbps) with DDM, 1310 nm, km SFP transceiver, dual rate (1062, 1250 Mbps) with DDM, 1310 nm, 10 km SFP transceiver, tri rate (1062, 1250, 2125 Mbps) with DDM, 850 nm CWDM SFPs SFP transceiver, multirate ( Mbps) with DDM, CWDM, 80 km (See CWDM table for wavelength) SFP transceiver, tri rate (1062, 2125, 4250 Mbps) with DDM, CWDM, km (See CWDM table for wavelength) DWDM SFPs SFP transceiver, multirate ( Mbps) with DDM, DWDM, 120 km (See DWDM table for wavelength) SFP transceiver, tri rate (1062, 2125, 4250 Mbps) with DDM, DWDM, km (See DWDM table for wavelength) WRT-SFPBT1000SC 125, 1250 N/A 100 m N/A WRT-SFPS24SC km 5 km WRT-SFPS24SCIR km 20 km 22 dbm (GigE) 18 dbm (OC-48) 22 dbm (GigE) 18 dbm (OC-48) WRT-SFPS10SC km 19 dbm WRT-SFPM20SC m WRT-SFPL3C24SC-0YY km 28 dbm WRT-SFPI3C42SC-0YY km 30 km WRT-SFPL3T24SC-0XX dbm WRT-SFPL3T42SC-0XX dbm (1 Gbps) 15.0 dbm (2 Gbps) 22 dbm (1 Gbps) 16.5 dbm (4.25 Gbps) 28 dbm (OC-48) 23 dbm (4G FC) Supported Line-side XFPs 850 nm multimode line XFP (short reach) WRT-XFPMMR8 Protocol Bit rate (Gbps) Wavelength (nm) Launch power (dbm) Reach (m) Stressed receiver sensitivity 10 G Ethernet WAN PHY to to G Ethernet LAN PHY to to G Fibre Channel to to nm single-mode line XFP (short reach) WRT-XFPSMR3A Protocol Bit rate (Gbps) Wavelength (nm) Launch power (dbm) Reach (km) Receiver sensitivity (dbm) OC-192/STM G Fibre Channel OC-192 with G.709 FEC nm single-mode line XFP (intermediate reach) WRT-XFPSMRIR2 OC-192/STM G Ethernet WAN PHY G Ethernet LAN PHY G Fibre Channel OC-192 with G.709 FEC Tunable single-mode line XFP (long reach) WRT-XFPSMTLR2-001 OTU2 G.709 FEC Tunable single-mode line XFP (long reach) WRT-XFPSMRIR2 OTU2 G.709 FEC Maximum input power (dbm) 4

5 Specifications CWDM SFP channel plan CWDM SFPs support the following wavelengths (λ). The channel number is used in the part number suffix YY. For example, a 2.5 G CWDM SFP using wavelength 1590 nm would be WRT- SFPL3C24SC-059. Channel number Wavelength λ (nm) DWDM SFP and XFP channel plans DWDM XFPs and SFPs support the following ITU frequencies and wavelengths (λ). The ITU channel number is used in the part number suffix XX. For example, a 2.5 G DWDM SFP using wavelength nm would be WRT-SFPL3T24SC-061. ITU Channel Frequency [THz] Wavelength [nm] ITU Channel Frequency [THz] Wavelength [nm]

6 Ordering Information Product code WRM-8008T000B Description 8-port any service OTN muxponder North America Toll Free: LITE (5483) Outside North America Toll Free: LITE (5483) China Toll Free: LITE (5483) 2015 Lumentum Operations LLC Product specifications and descriptions in this document are subject to change without notice. wrm8008-ds-cms-tm-ae