System Configuration and Order-information Guide TX120. February 2009

Transcription

1 System Configuration and Orderinformation Guide TX20 February 2009

2 PRIMERGY TX20 Front View Option Bay DVDROM Drive Hard Disk Bay Back View Inside View Hard Disk Bay Option Bay Power Supply Mouse Keyboard Serial Port Display 0/00BASETX Connector (for Remote Management Controller) 0/00/000BASET Connector PCI Slot CPU DIMM Slot PCI Slot front side

3 PRIMERGY TX20 Instruction This document contains basic product and configuration information that will enable you to configure your system. Only these tools will ensure a fast and proper configuration of your PRIMERGY server. You can configure your individual PRIMERGY servers in order to meet your specific requirements. Please follow the lines. If there is a junction, you can choose which way or component you would like to take. Go through the configurator by following the lines from the top to the bottom. The color of the junction means as follows. Key to Or And

4 PRIMERGY TX20 Data Sheet Type Model Compact Size Server 2.5inch SAS model Base Unit Celeron 430 (.80GHz) PGUT23A CPU Frequencies SecondLevelCache Intel Xeon 3070 (2.66GHz) *5 / 3040 (.86GHz) *6 / Intel Celeron 430 (.80GHz) 4MB ( Intel Xeon 3070 (2.66GHz) ) / 2MB ( Intel Xeon 3040 (.86GHz) ) / 52KB ( Intel Celeron 430 (.80GHz) ) FrontSideBus Number of processors (max. ) Number of cores 2 per processor ( Intel Xeon 3070 (2.66GHz) / 3040 (.86GHz) ) / per processor ( Intel Celeron 430 (.80GHz) ) 066MHz ( Intel Xeon 3070 (2.66GHz) / 3040 (.86GHz) ) / 800MHz ( Intel Celeron 430 (.80GHz) ) Chipset Intel 3000 TPM (Trusted Platform Module) Memory Standard 52MB (52MB ECC DDR2 SDRAM DIMM x ) Maximum * 8GB (2GB ECC DDR2 SDRAM DIMM x 4) Graphics Controller Resolution *2 incl. Remote Management Controller, VRAM :.7MB 640x480/800x600/024x768/280x024 dot Internal Bays Number of bays 2 (hot plug) 2.5 inch Available HDD *3 2.5inch, SAS, 0krpm, 73.4GB (PGHDD7B) HDD (SAS) 2.5inch, SAS, 0krpm, 46.8GB (PGHDD4B) 2.5inch, SAS, 5krpm, 73.4GB (PGHDD75B) Maximum * GB (46.8GB x 2) Option Bays DVDROM 2 ( free bays) Max 8 DVDROM / Max 24 CDROM (IDE) PCI Slots (x4) [x8] : LowProfile Card (x) [x] PCI (32bit/33MHz) [5.0V] : LowProfile Card : LowProfile PCI Card RAID standard (onboard, with RAID function) SAS Interface (onboard) SAS x 2ports FDD *7 Network Interface (onboard) port (000BASET/00BASETX/0BASET) Interfaces Display (Analog RGB), Serial Port (DSUB 9pins), Keyboard (PS/2type Mini DIN 6pins) Mouse (PS/2type Mini DIN 6pins), USB x 5 (ver. 2.0) (Internal : x,external : x 4) Server Management Software Remote Service function connector ServerView (standard) standard (onboard, Remote Management Controller) port (00BASETX/0BASET) Power supply Voltage AC 0027V (50/60Hz) / AC V (50/60Hz) x (max. ) Power consumption 75W / 630kJ/h (max.) Redundant power supply Redundant Fan Dimensions (mm) Weight 99 (W) x 399 (D) x 340 (H) 0kg (max.) Environmental Conditions Temperature035 C / Humidity 2080% (non condensing ) OS Support *4 Windows Server 2008 Standard (32bit) *8 / Windows Server 2008 Standard (64bit) *8 Windows Server 2003 R2, Standard Edition / Windows Server 2003 R2, Standard Edition (SP2) Windows Server 2003, Standard Edition (SP/SP2) Windows Server 2003 R2, Standard x64 Edition / Windows Server 2003 R2, Standard x64 Edition (SP2) Windows Server 2003, Standard x64 Edition / Windows Server 2003, Standard x64 Edition (SP2) Red Hat Enterprise Linux ES (v.4 for x86) *9 / Red Hat Enterprise Linux 5 (for x86) *9 *0 Red Hat Enterprise Linux ES (v.4 for EM64T) *9 / Red Hat Enterprise Linux 5 (for Intel64) *9 *0 Attached tool (Standard) ServerStart (Setup Support tool) * *. Available memory capacity will be changed by the type of OS. Please find more details in Notes [Memory OS Compatibility List]. *2. Resolution is determined by functions of the display monitor and OS. *3. HDD capacity is calculated according to the formula GB=000 3 byte. *4. Drivers for Linux are not attached. Please download and use drivers of the following URL. *5. CPU Conversion kit: Celeron 430(.80GHz) > Xeon 3070(2.66GHz) (PGBFU32W2) is available for upgrading to Intel Xeon 3070 (2.66GHz). *6. CPU Conversion kit: Celeron 430(.80GHz) > Xeon 3040(.86GHz) (PGBFU32Y) is available for upgrading to Intel Xeon 3040 (.86GHz). *7: One USBFDD is required as a minimum in multiple servers. It is necessary to procure USBFDD separately. *8. Regarding Windows Server 2008, please refer to the following URL. *9. Regarding supported kernel versions of Linux, please refer to the following list. *0. VM (Virtual Machine) function is not supported. *. ServerStart doesn't support Linux and Windows Server *. Noise level is 32dB.

5 PRIMERGY TX20 Configuration Diagram 2.5 inch HDD Bay (hot plug) DVDROM Drive Option Bay Power Supply Unit Hard Disk 2.5inch Bay (hot plug) Standard Drive Cage( HDD x 2ports ) Bay SAS 2.5 inch HDD Bay 2 (hot plug) Memory DIMM Slot 2B DIMM Slot B DIMM Slot 2A DIMM Slot A Bay 2 SAS CPU Xeon 3070 / 3040 Celeron 430 PCI Slots PCI3 (x) PCI2 (x4) PCI PCI 32bit/33MHz *Components installed as standard configuration marked in grey. Mountable I/O Options PCI Slot 2 3 PCI Mount Priority Mountable Cards Bus 32bit/ 33MHz x4 lane x lane Max No. of Mount Remarks Low Profile 5.0V x8 socket x socket High SCSI Ctrl U60 lp Eth. Ctrl 000BASET Cu lp PG30L PG892L PCI/64bit PCIX/64bit [] [] LowProfile PCI Card, External SCSI Controller LowProfile PCI Card Eth. Ctrl 000BASESX Fibre LC lp PG882L PCIX/64bit [] LowProfile PCI Card Eth. Ctrl xgbit PCI 000BASET lp PG853L Eth. Ctrl xgbit PCIE 000BASESX lp PG288L PCI/32bit (x4) [] [] 3 LowProfile PCI Card No AFT/ALB Support LowProfile Card Low Eth. Ctrl 2xGbit PCIE 000BASET lp Eth. Ctrl xgbit PCIE 000BASET lp PG286L PG289L (x4) (x) [] [] LowProfile Card LowProfile Card * [n] : Installation Priority * : cannot be installed Connection Table *CPU Conversion Kit (available only for a Configure to Order (CTO) option; no separate shipment is possible) Type Product ID CPU Conversion Kit: Intel Celeron 430(.80GHz/52KB) > Intel Xeon 3070 (2.66GHz/4MB) Celeron 430(.80GHz) Convert the CPU installed as standard in the base unit to the other. > Xeon 3070(2.66GHz) PGBFU32W2 (Note: This option can be ordered only as coupled with the base unit. (for CTO) A separate shipment is not possible.) CPU Conversion Kit: Intel Celeron 430(.80GHz/52KB) > Intel Xeon 3040 (.86GHz/2MB) Celeron 430(.80GHz) Convert the CPU installed as standard in the base unit to the other. > Xeon 3040(.86GHz) PGBFU32Y (Note: This option can be ordered only as coupled with the base unit. (for CTO) A separate shipment is not possible.)

6 PRIMERGY TX20 Memory Memory Slot Max: 8GB (2GB DIMM x 4) Memory Module52MB (52MB DIMM x ) PGRM5BE Standard Memory Module: 52MB (52MB DIMM x ) PGBRM5BE (for CTO) Memory ModuleGB (GB DIMM x ) PGRMBE PGBRMBE (for CTO) Memory Module2GB (2GB DIMM x ) PGRM2BE PGBRM2BE (for CTO) Memory Slot Memory Module Conversion kit (for CTO) Memory Module Conversion kitgb PGBRUBE (for CTO) Memory Module Conversion kit2gb PGBRU2BE (for CTO) *. Notes on installing memory. Memory is installed by one or more DIMMs. 2. The memory capacities of the slots should be in ascending order in the following sequence: A > B > 2A > 2B 3. Available memory capacity depends on the type of OS and some memory area is used for PCI resource management. The following table shows installed memory capacity and available memory capacity. OS Installed Memory Capacity Available Memory Capacity Windows Server 2008 Standard (32bit) Windows Server 2003 R2, Standard Edition (SP2) Windows Server 2003, Standard Edition (SP2) ~3.5GB 3.5GB~4.0GB 3.5GB * Same as installed memory capacity Windows Server 2008 Standard (64bit) Windows Server 2003 R2, Standard x64 Edition (SP2) Windows Server 2003, Standard x64 Edition (SP2) Red Hat Enterprise Linux ES (v.4 for x86) Red Hat Enterprise Linux 5 (for x86) Red Hat Enterprise Linux ES (v.4 for EM64T) Red Hat Enterprise Linux 5 (for Intel64) ~8.0GB Same as installed memory capacity *. If installed memory capacity is more than 3.5GB, it is necessary to set "PAE (Physical Address Extension)" of OS. The following () and (2) are the ways to set "PAE" of OS, and Fujitsu recommends (). () Set "PAE" of OS. Regarding setting "PAE" of OS, please refer to website of Microsoft. (2) Set "DPE (Data Execution Prevention)" of CPU. If "DPE" of CPU is set as "available" by executing the following procedure, "PAE" of OS is set automatically. [] Execute "BIOS setup utility". [2] Select "Advanced" menu. [3] Select "Advanced Processor" submenu. [4] Set "NX Memory Protection" as "Enabled". Connecting Internal HDD and Internal Backup Devices Type of HDD connection Internal Backup Devices PRIMERGY TX20 Connection Interface USB ('') Connection SATA (''2) Connection SAS / RAID Onboard SAS Onboard USB (internal port) Onboard SATA ('') USB Backup Devices: PGDT5042 (''2) SATA Backup Devices: PGRD0 Internal HDD (2.5inch Bay) SAS / RAID Configuration Max: 2 HDDs on board SAS controller *. RAID configuration can be set. HDD SAS 0k 73GB hot plug 2.5inch PGHDD7B PGBHDD7B (for CTO) HDD SAS 0k 47GB hot plug 2.5inch PGHDD4B PGBHDD4B (for CTO) HDD SAS 5k 73GB hot plug 2.5inch PGHDD75B PGBHDD75B (for CTO)

7 PRIMERGY TX20 Internal backup device (USB) USB Interface (internal) Tape Drv DAT72 36GB internal PGDT5042 PGBDT5042 (for CTO) slot / Max: *. One internal backup device can be mounted. on board SATA controller Internal Data Cartridge Drive Unit PGRD0 PGBRD0 (for CTO) *. One internal backup device can be mounted. *. If you would like to purchase data cartridges, please refer to the following web site. External DVDRAM USB Interface DVDRAM USB Extension Cable PGCBLU002 LAN Card Onboard LAN Eth. Ctrl 2xGbit PCIE 000BASET lp PG286L Twist Pair Cable ( Category 5e) Bus PGB286L (for CTO) * Dual Port Eth. Ctrl xgbit PCIE 000BASESX lp PG288L Multi Mode Fibre Channel Cable Eth. Ctrl xgbit PCIE 000BASET lp PG289L Twist Pair Cable ( Category 5e) PGB289L (for CTO) PCI Bus Eth. Ctrl 000BASET Cu lp PG892L PGB892L (for CTO) Eth. Ctrl xgbit PCI 000BASET lp PG853L PGB853L (for CTO) * No AFT/ALB Support Eth. Ctrl 000BASESX Fibre LC lp PG882L Multi Mode Fibre Channel Cable Server Management (Remote Management Controller) LAN interface for Remote Management Controller Twist Pair Cable ( Category 5e) Remote Management Ctrl Upgrade kit PGRMCU Specifications are subject to change without notice. For the latest detailed information, contact your local representative. All brand names and product names are trademarks and registered trademarks of their respective holders Fujitsu Limited. All rights reserved. Printed in Japan.