High Performance Sound Pick-up Microphone Kits

Transcription

1 OEM Version High Performance Sound Pick-up Microphone Kits Installation and Operating Manual Audio Monitoring System Kit A ASM-AK For Indoor & Outdoor Audio Monitoring System Kit B ASM-BK For Indoor Only WARNING: Please consult with your legal advice regarding Audio Recording. See Important Notice on page 6. Copyright All Rights Reserved. 1 REV V31

2 SAFETY WARNINGS 1. Read this manual carefully before installing the unit Please read this manual first for correct installation and operation. 2. Never install the camera near electric or magnetic fields Install the product away from TV, radio transmitter, magnet, electric motor, transformer, audio speakers since the magnetic fields generate from above devices would distort the video image. 3. Never install or use the product in areas exposed to water, oil or gas The water, oil or gas may result in operation failure, electric shock or fire. Do not use this unit near water-for example, near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, near a swimming pool, in an unprotected outdoor installation, or any area which is classified as a wet location. 4. Power Cord Protection Touching the wet power cord with hands or touching the power cord with wet hands may result in electric shock. Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, playing particular attention to cords and plugs, convenience receptacles, and the point where they exit from the appliance. 5. Do not operate the product in environments where the temperature, humidity or power source is beyond the specified ones Use the camera in suitable environments where the temperature is within -10 C~50 C and humidity below 90%. Use the input power source as the specifications listed. 6. Never disassemble the product nor put impurities in it Disassembly or impurities may result in trouble or fire. 7. Stop using when the product emits smoke or abnormal heat 8. Servicing Do not attempt to repair this unit yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. 9. Retain Instructions THE SAFETY AND OPERATING INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE. WARRANTY Sentry US warrants that at the time of shipment products manufactured by Sentry US to be free of defects in material and workmanship. Should a defect appear with one year (12 months) from date of shipment, Sentry US will, at its sole discretion, repair or replace the defective equipment. This equipment shall not be accepted for repair or return without prior notification by Sentry US. This warranty does not extend to any Sentry US product that has been subject to improper or incorrect installation, misuse, accident, or in violation of installation instructions provided by Sentry US. Returned shipments to Sentry US shall be at customer s expense. Sentry US will return the equipment prepaid via Best Way. Copyright All Rights Reserved. 2 REV V31

3 FEATURES ASM-AK Advanced Denoise & Echo Cancelling Circuit Omni-Directional Monitoring Range 100ft 2 / 9m 2 12V DC Current: 30mA Output Level: 0~6V Sensitivity: -47dB Frequency Response: 20Hz~20KHz Impedance: 600Ω (Imbalance) ASM-BK Advanced Denoise & Echo Cancelling Circuit Omni-Directional Monitoring Range 380ft 2 / 35m 2 12V DC Current: 30mA Output Level: 0~6V Sensitivity: -47dB Frequency Response: 20Hz~20KHz Impedance: 600Ω (Imbalance) LIST OF COMPONENTS One (1) ASM-A or ASM-B: Omni-Directional Sound Pick-up Microphone One (1) ASP-001: Audio Interface Adapter also provide power to ASM-A or ASM-B One (1) P12DCL500: 12V DC 500mA Power Adapter Sold Separately, available for UL/cUL, CE, PSE-JET o Linear Adapter with Regulator Avoid Interference One (1) 3.5mm STEREO Connector Cable for connection to DVR w/ 3.5mm Stereo Audio Input One (1) 3.5mm MONO / RCA Connector Cable for connection to ASP-001 via 3.5mm plug and to DVR via RCA plug One (1) Installation and Operating Manual * For any returns, please include all components listed above with original packaging in Resalable Condition. Absolutely No Returns will be accepted if any component is missing/damaged. INSTALLATION Installing the Microphone The ASM-A microphone is designed for surface mounting on the wall. This microphone has an omni-directional monitoring range of 100ft 2 / 9m 2. The ASM-B microphone is designed for surface mounting to a ceiling or wall. This microphone has an omni-directional monitoring range of 380ft 2 / 35m 2. For best results, install the microphone as close to the desired area of coverage as possible. Avoid mounting microphone to ceiling heights in excess of 10ft, or near air vents, refrigeration units, or other audio interferences. Located on back side of ASM-A / ASM-B is a wire with 3 bare leads. BLACK: Ground (common) YELLOW: Audio RED: 12V DC Using recommended wiring, connect as follows: BLACK: to terminal G (Ground) YELLOW: to terminal A (Audio) RED: to terminal V (12V DC) ASM-A can be mounted on a wall plate for indoor purposes and it can also be mounted on a junction box cover plate for outdoor purposes. Plate is not included in kit. NOTE: Make wiring connection on back side of microphone before installing microphone to ceiling or flat surface. If using wiring from other manufacturers, color code may vary. Copyright All Rights Reserved. 3 REV V31

4 Installing the Audio Interface Adapter The ASP-001 Audio Interface Adapter serves as an interface device between the microphone and the audio receiver (DVR/VCR, PC sound card, etc.). The ASP-001 can be installed several ways: 1. Wall mounted close to DVR/VCR or IP Network Camera, etc. 2. Attached to side of the receiving device using two-way ¼ adhesive tape (not provided). WIRING CONNECTION FROM MICROPHONE TO AUDIO INTERFACE ADAPTER Bring in other end of wiring from microphone and connect to MIC INPUT terminal block on ASP-001 marked, G, A and V. Connect as follows: BLACK wire of microphone to terminal G of ASP-001 Ground (common) YELLOW wire of microphone to terminal A of ASP-001 Audio Output RED wire of microphone to terminal V of ASP V DC APPLICATION DIAGRAM & CONNCECTION DESCRIPTION Copyright All Rights Reserved. 4 REV V31

5 To apply power to the system, P12DCL500 12V DC linear power supply is recommended. First connect small end (female 90 plug) into 12V DC jack on the ASP-001 audio interface, then connect 2-prong power block to a standard 110V A outlet or power strip. CONNECTION BETWEEN THE ASP-001 AND A DVR, IP NETWORK CAMERA WITH 3.5mm MONO/RCA TYPE AUDIO CONNECTIONS To make connection to DVR, plug the 3.5mm cable (supplied) into the audio out jack located on the front of ASP-001, connect the RCA end of the cable to the DVR s audio in jack. CONNECTION BETWEEN ASP-001 AND A DVR, IP NETWORK CAMERA OR PC SOUNDCARD WITH 3.5mm STEREO TYPE CONNECTION. To make connection, plug the 3.5mm stereo cable (supplied) into the audio out jack located on the front of the ASP-001. Connect the other end of the cable to audio in of DVR, IP Network Camera or line in of PC soundcard 3.5mm Stereo Connector Cable 3.5mm Mono / RCA Connector Cable PARTS ASP-001 Audio Interface Adapter ASM-A Microphone ASM-B Microphone Copyright All Rights Reserved. 5 REV V31

6 SPECIFICATIONS Audio Monitoring System Kit P.I.C. D-51 D-52 Model ASM-A ASM-B Indoor/Outdoor Indoor & Outdoor Indoor Microphone Mount Type Wall Ceiling Monitoring Range Denoise Technology Echo Canceling 100ft 2 / 9m 2 Omni-directional Yes Yes Output Level 0~6V Sensitivity Frequency Response Impedance Power Supply Dimension (without wires) 1.42 (Ø) x 1.73 (H) / 36mm(Ø) x 44mm(H) -47dB 20Hz~20KHz 600Ω (Imbalance) 12V DC 380ft 2 / 35m 2 Omni-directional 4.25 (Ø) x 1.57 (H) / 108mm(Ø) x 40mm(H) Weight 0.18 lb / 85g 0.28 lb / 127.5g Interface Adapter Model Power Supply Output Current Wave Frequency Dimension Weight With Mic. Input Terminal Block Without Mic. Input Terminal Block ASP V DC < 280mA < 20mvrms 2.91 (W) x 1.14 (H) x 2.8 (D) / 74mm(W) x 29mm(H) x 71mm(D) 2.91 (W) x 1.14 (H) x 2.44 (D) / 74mm(W) x 29mm(H) x 62mm(D) 0.25 lb / 113g * Specifications are subject to change without notice IMPORTANT NOTICE Please follow your local privacy laws and regulations when using this product in a public setting. When this equipment is used as part of an audio monitoring system, the law requires that the public be given notice of audio monitoring on the premises. Seller is not responsible for any improper usage of this product. Copyright All Rights Reserved. 6 REV V31