SAM Listed LED Optimized Drivers. Environmental. Electrical Specifications at 25 O C E Output Current. Voltage Accuracy

Transcription

1 Model: LD40W480 UL SAM Series Drive Mode: Constant Voltage Technology: PFC Off-Line Switch Mode Power: 40W Max. Voltages: 1VDC or 4VDC Currents: 418mA mA Environmental 1. Operating temperature: Tc 90C Maximum. Reference -30 to +60 C ambient. Storage temperature range: -40 to +85 C 3. Humidity (non-condensing): 5% - 95%RH 4. Cooling: Convection 5. Vibration Frequency: 5-55Hz/g, 30 minutes 6. Impact resistance: 1g/s Safety and Compliance 1. UL879 SAM, UL8750, EN61347, CSA. safety certified. FCC, 47CFR Part 15 Class B & EN55015 certified 480Vac Versions are FCC, 47CFR Part 15 Class A 3. Water resistant and Dust Proof Design: IP66, NEMA4, for Dry, Damp, Wet Locations. 4. Meets EN & EN Class C 5. Protection: output over-voltage, output over-current, output short circuit, auto-recovery. 6. EN : kv L-N, 8/0 µsec surge protection. Electrical Specifications at 5 O C Input voltage range: Vac Frequency: 47-63HZ Power Factor: > 0.90 at Full Load THD%: < 0% at Full Load Inrush current: <0A at 5C, 30V, cold start, Full Load Efficiency: 8% typical at 30Vac Full Load Line regulation accuracy: + 3% Load regulation accuracy: + 4% Constant Voltage Versions Part Number () (3) US Class CN Class UL Types Voltage E3566 Current Voltage Accuracy Power Maximum IP66 Typical Efficiency (1) Vac In Range LD40W480-1 YES YES HL 1V ma + 5% 40W 81% Vac 0.15 A LD40W480-1-W YES YES HL 1V ma + 5% 40W 81% Vac 0.15 A LD40W480-4 YES YES HL 4V ma + 5% 40W 8% Vac 0.15 A LD40W480-4-W YES YES HL 4V ma + 5% 40W 8% Vac 0.15 A Iac In Max Notes 1. Typical efficiency measured at 30VAC input, full load. Plastic cases are available in White. Add -W to the end of the part number. Example LD40W480-1 is Black Plastic, LD40W480-1-W is white plastic case. 1 1 EPtronics, Inc. Inc. Los Los Angeles, Angeles, California California T: 800 T: E: Sales@EPtroncs.com E: Sales@EPtronics.com Rev. 0/6/016 08/01/010

2 Labeling Example DC + = RED - = BLUE LED Optimized Driver EPtronics, Inc / AC Input L = BLACK N = WHITE Mechanical Dimensions: Inches [mm] Material: Black PC ABS Plastic Case Fully Encapsulated Weight: 311 grams (11.0 oz) Typical Part Number: LD40W480-4 Input Voltage: VAC 50/60 Hz Input Current: 0.13 Amp Max Voltage: 4 VDC Current: mA Power: 40W Max UL & cul Class, UL Type HL SAM Recognized IP66 Made in China E3566 REV A1. HG HOT SPOT

3 Typical Strip Lighting Application Circuit: AC LINE AC NEUTRAL EARTH GND LD40W480-XX CV LED+ LED- Table below can be used to determine the combination of maximum current through a 1V electrical wire, size (AWG) and length of cable. Length (feet) American Wire Gauge (AWG) Current (amps) 5 A 10 A 15 A 0 A 5 A 30 A 40 A 50 A 60 A 70 A / /0 1/ /0 /0 / /0 /0 /0 3/ /0 /0 3/0 3/ /0 /0 3/0 3/0 4/0 3

4 Input Specifications Input Voltage Per Table Per Table 10, 30, 40, 77 Vac Nominal Values Input Frequency 47 Hz 63 Hz 50/60Hz Nominal Input AC Current Per Table Measured at 10Vac/60Hz Input, Full load. THD 0% Measured at 10, 30, 77Vac Input, Full Load Power Factor (PF) 0.90 Measured at 10, 30, 77Vac Input, Full Load Specifications DC Voltage -5% Per Table +5% Per Tables on Page 1 DC Current Per Table Per Table Per Tables on Page 1 Power Per Table Per Tables on Page 1 Ripple & Noise (Vpk-pk) 0% Vo Ripple (Ipk-pk) 50% Io 0 MHz BW, Full load output in parallel with 0.1 µf ceramic & 10 µf Electrolytic. 0 MHz BW, Full load output in parallel with 0.1 µf ceramic & 10 µf Electrolytic. 10 Hz component Start-up Time 700 ms 1000 ms Measured at 10Vac/60Hz Input, Full load. Hold-up Time 30 ms 77Vac Input, Full load. Environmental Specifications Case Temperature (Tc) -30 O C +90 O C Measured at location specified on case. Operating Temperature (Ta) -30 O C +60 O C This is a reference range. Tc controls temperature range. Storage Temperature (Ts) -40 O C +85 O C Non operating temperature range. Operating Humidity 95% RH Relative Humidity, non-condensing. Vibration 5 Hz 55 Hz G, 10 minutes/1 cycle, period 30 minutes, each along X, Y, Z axis. MTBF 34,000 Hours MIL-HDBK-17F Notice, Ta = 5C, Full Load. Protection Specifications Short Circuit (SCP) No Damage, Auto recovery after short is removed. Over Current (OCP) +8% Io Constant Current Limiting circuit. Over Voltage (OVP) 10% Vo No Damage, Auto recovery after fault is removed. 4

5 Safety Certification Safety UL/CUL CE Withstand Voltage Isolation Resistance Notes/Standards UL879 SAM, CAN/CSA-. No. 87-M89, UL8750 & CAN/CSA-. No , UL1310 & CAN/CSA-. No. 3-M91 for Class, UL101/CSA-C. No for Non Class, UL Type TL & HL as noted EN , EN Input to : 3750 Vac Input to : >100 MΩ, 5 O C, 70 % RH EMC Certification Standard FCC, 47CFR Part 15 EN EN EN EN Energy Star Class B, except 480Vac versions which are Class A Notes/Conditions Limits and methods of measurement of radio disturbance characteristics of electrical lighting and similar equipment. Part 3-: Limits for harmonic current emissions Class C, >80% Rated Power Part 3-3: Limitation of voltage changes, voltage fluctuations and flicker. Part 4-5: Surge Immunity test, kv L-N, 4 kv L-FG & N-FG Energy Star transient protection: Ballast or driver shall comply with ANSI/IEEE C and ANSI/IEEE C , Category A operation. The line transient shall consist of seven strikes of a 100 khz ring wave,.5 kv level, for both common mode and differential mode. 5