Courtesy of:discountcarstereo.com BLU-C5. Quick Start Audio Streaming Installation Guide for select Corvette

Transcription

1 Courtesy of:discountcarstereo.com BLU-C5 Quick Start Audio Streaming Installation Guide for select Corvette Created January 16, 2013 Revised October 24, 2018

2 Introduction: Just because you drive an older car does not mean you have to settle for old technology. Many C5 owners will be pleased to know that they can upgrade the audio system to support Bluetooth Audio Streaming without replacing the Radio. The BLU-C5 connects directly to Radio OR if car is wired for CD Changer (10-pin); connection can be made there. CD Changer (if present) must be disconnected). A Bluetooth wireless connection means no wires, clutter or complicated setup. Pair Smartphone or Tablet and enjoy GPS prompts, Music Apps etc. on the car system. See Frequently Asked question at the end of this guide. Installation 1: (To Radio) Remove Radio from dashboard to gain access to the connectors. (Click link below for radio removal instruction video) 3. Connect vehicles 20-pin plug from step 2 to 20-pin connector (white) on installation harness (See Fig. 2). Fig. 2 installation harness (PXHGM4) 4. Connect 20-pin plug (black/gray) from installation harness (See Fig. 2) to 20-pin connector on Radio vacated in step 2 5. Check that dip position (See Fig. 3) otherwise perform that step at this time. 1. Disconnect 10-pin plug at CD Changer (if present) 2. Disconnect factory 20-pin plug from Radio (See Fig. 1) Fig. 3 Note: Turn switch #6 to ON to boost audio playback. 6. Connect 22-pin Molex plug on installation harness (See Fig. 2) to Module (See Fig. 4) Fig. 1 C5 Radio connectors

3 Fig way connector on module Fig Connect (Tap) red wire to ACC (Accessory) supply power in your vehicle : locate 3-pin plug under passenger toe board near BCM (covered with black duct tape) --- locate and tap the yellow Accessory wire ( See Fig. 5) Fig Models appears not to have this 3-pin plug. Alternately we suggest fuse: #22, #11 of interior fuse box. (See Fig. 7). Please test for engine noise prior to final install. To aid the install we suggest a mini-tap as seen in Fig. 6 Fig. 7 C5 interior fuse box Tuck and secure any extra wires away from moving parts and test operation.

4 Installation 2: (Pre-wired trunk/hatch) Alert! This option is for vehicles pre-wired with 10-pin CD Changer plug (see Fig. 9). If vehicle has a CD Changer it must be disconnected. 1. Locate factory pre-wired 10-pin CD Changer plug at the rear of vehicle (hatch/trunk) 2. Connect factory 10-pin plug (See Fig. 9) to 10-pin slot on installation harness (See Fig. 10) Fig way connector on module 4. Proceed to step5 on page 2 above to complete the rest of the installation. Pairing: Pairing process varies between devices but basic steps are the same. This process is done upon initial install and will not have to be repeated. Pairing will initiate as soon as ignition is Fig. 9 factory 10-pin CD Changer plug On A2DP device: go to Settings, Wireless & Networks, Bluetooth Settings 3. Select Bluetooth and turn on. 4. Then select Bluetooth settings 5. Tap Scan for devices. 6. Wait for Bluetooth device name to appear and select it. (See below) Blue LED inside module glows steady (paired) Fig pin connector (PXHGM2) 3. Connect 22-pin Molex plug from installation harness to Module (See Fig. 11)

5 Frequent asked questions Test Operation: Press CD/AUX button on radio 3. Launch Smartphone or tablet audio streaming application. 4. Turn volume up on phone and use radio volume control button to set playback level. Warning! Playlist and Track selection is *NOT* possible from the Radio. Use audio device built-in controls to access and control the audio files. 5. If correct operation is confirmed go ahead and reinstall the Radio. 1. Does the BLU-C5 work if my car has a CD Changer? YES; but Changer must be permanently disconnected. 2. Can I install the BLU-C5 without removing radio? NO; The BLU-C5 connects to the back of the radio. 3. Does this adapter support phone calls? NO; The BLU-C5 does not support hands-free calls. Purchase our C5CD-HF (requires and retains CD Changer) 4. Does this work on all Corvette Radios? NO; this adapter works on Corvette (C5) Radios with Tape / CD/ 5. How do I remove the radio from dashboard? Please click video link for help removing radio: 6. Bluetooth connection is temporarily lost when turn signal or wipers are turned on. What can I do to fix this? This is likely due to a power supply issue in your car and unlikely a bad module. If module plays continuously when wipers or turn signal is off, the module is fine. If Bluetooth playback is interrupted due to use of an accessory (e.g. wiper motors etc.) because these are loading down the circuit to which the module accessory wire is connected. If this occurs, consider relocating the accessory wire (RED) to an alternate ACC power supply location or have vehicles electrical system checked by qualified technician. Disclaimer GM or Apple hen possible professional installation is recommended Call or support@discountcarstereo.com 1995-Oct-18 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.