user s manual LoudSpeak r model #: BTS01 Portable Bluetooth Speaker

Transcription

1 user s manual LoudSpeak r model #: BTS01 Portable Bluetooth Speaker

2 hello. What s Included Unpack LoudSpeak r and make sure all accessories are put aside so they will not be lost. Thank you for purchasing LoudSpeak r [ BTS01]. Portable Bluetooth Speaker Features Bluetooth EDR Hands free speakerphone Wireless range of approximately 30 feet ProTune Speaker System with RealBass Technology Answer calls & control your music from the speaker Easy USB charging Noise cancelling microphone Rechargeable Li-ion battery with over 5 hours of calls/playback Auxiliary input to play music from any device with a headphone jack Voice notifications Battery indicator on smart phones The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. Mini USB Cable Portable Speaker Page 2 Page 3

3 Contents Safety Information Introduction What s Included Safety Information Getting Started Controls Operational Instructions Charging Power Up Using the Audio Line in Connection Pairing Your Bluetooth Device Connecting to a Paired Bluetooth Music Playback Functions Hands Free Speakerphone LED Light Indicator Troubleshooting Compliance with FCC Regulations Specifications Warranty Information Important Safety Instructions Please read all safety and operating instructions carefully before installation and use. Keep these instructions handy for future reference. Take special note of all warnings listed in this user s manual and on LoudSpeak r. 1. Water and Moisture - LoudSpeak r should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Objects and Liquid Entry - Care should be taken so that external objects do not fall into and liquids are not spilled onto any openings or vents located on the product. 3. Heat - LoudSpeak r should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. 4. Damage Requiring Service - LoudSpeak r should be serviced by qualified service personnel when: A. objects have fallen into or liquid has been spilled onto the enclosure. B. LoudSpeak r has been exposed to rain. C. LoudSpeak r has been dropped or the enclosure damaged. D. LoudSpeak r exhibits a marked change in performance or does not operate normally. 5. Servicing - The user should not attempt to service LoudSpeak r beyond those methods described in the user s manual. Opening or removing covers will expose you to dangerous voltage and other hazards. Service methods not covered in the user s manual should be referred to qualified service personnel. 6. Safety Check - Upon completion of any service or repair to LoudSpeak r, ask the service technician to perform safety checks to determine that the product is in proper working condition. 7. Battery - This device contains a rechargeable Lithium-ion battery. Please do not attempt to replace the battery yourself. The battery may only be replaced by our authorized service centers. Page 4 Page 5

4 Getting Started Operational Instructions Controls Charging - Charge your LoudSpeak r through any USB jack or wall charger. - The LED indicator will begin to blink blue. - Full charge time is two hours and the LED indicator will stop blinking. Power Up - Slide the switch on the back of the speaker to the ON position. - Press and hold the until the front LED indicator turns on blue. - To power down your speaker, hold down the button until the speaker says Goodbye During Bluetooth Music Playback General - On the back of the speaker, slide the main power switch to the OFF position to prevent accidental button presses. 1. Previous track 4. Microphone 2. Play/Pause 5. Volume down 3. Next track 6. LED indicator Using the Audio Line in Connection (aux-input) 7. Power ON/OFF; - To playback your music via the AUX-IN port, plug a standard stereo headphone During Phone Calls Enter Bluetooth paring mode cable (3.5 mm) from your audio device to LoudSpeak r and begin playback on your (Long hold while device is off) 1. and 3. Mute/Unmute the microphone audio device. 8. Volume up 2. During ringing: Answer incoming call/ 9. Stereo speaker Reject incoming call (long press) 10. Passive radiator subwoofer During the call: End current call/ 11. OFF /ON switch Toggle audio between the phone and 12. USB charging jack speaker (long press) 13. Aux-in jack Page 6 Page 7

5 Operational Instructions Operational Instructions Pairing Your Bluetooth Device Note: Please see page 13 of this manual for Bluetooth compatibility information. Step 1: On your Loudspeak r: - Make sure the speaker is powered off, and the master switch on the rear is in the ON position. - Press and hold the button until the front LED indicator flashes RED/BLUE. - The speaker will say Discovering. - Your speaker is now in pairing mode and is ready to connect to your Bluetooth device. Note: The speaker will stay in pairing mode for up to 3 minutes. Step 2: On your compatible Bluetooth device: - Navigate to the Bluetooth menu on your device. - Turn on Bluetooth and begin searching for available devices to pair. - Select LoudSpeak r from the list of results, and your device will begin to pair. - If your device asks for a pairing pass code, enter Once paired, you will hear a voice prompt and the LED indicator on the speaker will only flash blue. - The LoudSpeak r has a wireless range of approximately 30 feet, and your media device will stay connected to the speaker within that range. Connecting to a Paired Bluetooth Device - You will only need to pair your Bluetooth device with the speaker one time. - The next time your Bluetooth device and the speaker are in range of each other, and the Bluetooth feature is turned on, they will automatically connect. - The speaker will only automatically connect to the last Bluetooth device it was connected to. - If your paired device does not automatically connect, navigate to the Bluetooth menu on your device and select LoudSpeak r from the list. Note: Your LoudSpeak r can pair with and remember multiple devices, however it can only connect with one device at a time. Music Playback Functions - Once your media device is connected to the speaker, simply start playing your music, movie or game. All the audio will automatically be played through LoudSpeak r. - Press to Play/Pause the audio. - Press to skip to the next track. - Press to skip to the previous track. - Press + or - to adjust the volume level of the speaker. - When maximum or minimum volume level is reached, you will hear an alert tone. - During an incoming call, the music will automatically pause playback and you can answer/reject the call using the button controls. Note: Many Bluetooth devices, including iphone & ipad, will not require you to Note: The volume controls on your media device work separately from the volume enter a pairing pass code. controls on the LoudSpeak r. Page 8 Page 9

6 Operational Instructions Troubleshooting Hands Free Speakerphone - Outgoing calls To place a call, simply initiate the call from your compatible Bluetooth phone and the call will automatically be routed through your paired LoudSpeak r. - Incoming calls Press to answer the call on your speaker. Press and hold to reject the call. - During a call Press to hang up. Press and hold to route the call back and forth between your phone and the speaker. Double press to answer call waiting. Double press to toggle between the original call and the new call. Press or at anytime during the call to mute your microphone. The light indicator will blink blue. LED Light Indicator (on front of speaker) - No light: Power OFF - Flashing blue & red: Paring Mode - Solid blue: Power ON (Battery level>30%) Remarks: - Solid red: Power ON (Battery level<30%) If troubleshooting does not eliminate the problem, shut down the speaker by sliding the switch on - Blinking red/auto power OFF in 5 mins: Power ON (Battery level<10%) the back to OFF. In case the problem still exists, see warranty information on page 15 to obtain - Flashing blue: Charging service. - No light: Power OFF + fully charged Page 10 Page 11 Symptom Music is not streaming over Bluetooth No power LoudSpeak r doesn t answer phone calls Music doesn t resume after hanging up a call No music control by LoudSpeak r Solution Make sure your Bluetooth device has A2DP profile. Check if both devices are paired and connected over Bluetooth. Restart the LoudSpeak r to auto-connect with your Bluetooth device. Make sure LoudSpeak r is fully charged. Make sure your mobile device has HSP/HFP profile. Check if both devices are paired and connected over Bluetooth. Restart the LoudSpeak r to auto-connect with your Bluetooth device. Press play to resume music. Make sure your Bluetooth device has AVRCP profile.

7 Compliance with FCC Regulations Specifications The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate Radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to Radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to Radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced Radio/television technician for assistance. - Full-range dual 35mm driver + passive radiator - Distortion <= 10% - Frequency response: 200 Hz - 15k Hz - Li-ion battery: 700mAh - Playtime: up to 5 hours - Charging time: 2 hours - Bluetooth EDR - Bluetooth compatibility: Bluetooth 2.0 or above device with A2DP/AVRCP/HFP/HSP THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE speaker ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. If at any time in the future you should need to dispose of this product, please note that: waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. Page 12 Page 13

8 Warranty Information Warranty Information Limited Warranty The AT&T brands are used under license. Any repair, replacement, or warranty service, and all questions about this product should be directed to Concept 101 LLC at or call 1 (888) from the USA or Canada. Concept 101 LLC warrants to the original purchaser that the product will be free from defects in material, parts and workmanship for the period designated for this product. The warranty commences the day the product is purchased and covers up to a period of one (1) year. Concept 101 LLC agrees that it will, at its option, replace the defective product with either a new or remanufactured speaker equivalent to your original purchase during the warranty period. Should the Parts warranty period exceed the Labor warranty period, Concept 101 LLC will supply at no charge for the remainder of the Parts warranty, any new or remanufactured replacement parts as required by the product. During this period all labor and service charges will become the responsibility of the customer. Exclusions: This warranty does not apply to the appearance or exterior of the product which may have been damaged or defaced, altered or modified in design or construction. This warranty does not apply if the serial number is altered or removed, or if there is any damage due to power line surge, user damage to the AC power cord, connection to improper voltage source, general misuse, accidents, or repair attempts by unauthorized service agents. Other exclusions include ear pads, rechargeable and non-rechargeable batteries. Some states do not allow the exclusion or limitations of incidental or consequential damages, or limitations on how long the warranty lasts. In these cases the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Obtaining Service: To obtain service, product literature, supplies or accessories please call , or visit our website, to create a ticket for exchange/repair. Please make sure to provide the date of purchase, model number and a brief description of the problem. Our customer service representative will contact you or send detailed return instructions. Concept 101 LLC does not warrant that the speaker will work properly in all environmental conditions, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose other than the purpose identified within this user s manual. Concept 101 LLC has made every effort to ensure that this user s manual is accurate and disclaims liability for any inaccuracies or omissions that may have occurred. Information in this user s manual is subject to change without notice and does not represent a commitment on the part of Concept 101 LLC. Concept 101 LLC reserves the right to make improvements to this user s manual and/or to the products described in this user s manual at any time without notice. If you find information in this manual that is incorrect, misleading, or incomplete, please contact us through our website. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CUSTOMER; Concept 101 LLC SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE DURATION OF THE WARRANTY. Page 14 Page 15

9 Memo Memo Page 16 Page 17

10 Memo purchase date: place of purchase: Page 18 Page 19

11 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property licensed to Concept 101 LLC, New York, New York Printed in China. Issue 7 AT&T 02/2012.