8205-E6C ENERGY STAR Power and Performance Data Sheet

Transcription

1 8205-E6C ENERGY STAR Power and Performance Data Sheet

2 ii 8205-E6C ENERGY STAR Power and Performance Data Sheet

3 Contents 8205-E6C ENERGY STAR Power and Performance Data Sheet iii

4 iv 8205-E6C ENERGY STAR Power and Performance Data Sheet

5 8205-E6C ENERGY STAR Power and Performance Data Sheet IBM 8205-E6C Table 1. System Characteristics System Characteristics Form Factor 4U Available Processor Sockets 2 Available DIMM Slots / Max Memory Capacity 32 / 512 GB ECC and/or Fully Buffered DIMMs Yes Available Expansion Slots 9 PCIe Minimum and Maximum # of Hard Drives 1 to 6 Redundant Power Supply Capable? Yes Power Supply Make and Model Emerson Network Power J000 Power Supply Output Rating* (watts) 1725 Minimum and Maximum # of Power Supplies 1 and 2 Input Power Range (AC or DC) V ac Power Supply Efficiency at Specified Loadings* 85.3@10%, 90.7@20%, 92.3@50%, 89.2@100% Power Supply Power Factor at Specified Loadings* 0.861@10%, 0.941@20%, 0.986@50%, 0.997@100% Operating Systems Supported AIX, IBM i, i5/os, OS/400, Linux Installed Operating System for Testing AIX * Note: Power supply information is for a single power supply only Table 2. System Configurations System Configurations Minimum Typical Maximum Configuration ID FC EPCB (2x), FC EM16 (8x) FC EPCB (2x), FC EM16 (12x) FC EPCB (2x), FC EM32 (16x) Processor Information 2 x 8-core 3.55 GHz POWER7 processor card Memory Information 16 x 8GB DIMMs, 1067 MHz, 2Gb DDR3 DRAM 2 x 8-core 3.55 GHz POWER7 processor card 24 x 8GB DIMMs, 1067 MHz, 2Gb DDR3 DRAM 2 x 8-core 3.55 GHz POWER7 processor card 32 x 16GB DIMMs, 1067 MHz, 2Gb DDR3 DRAM Internal Storage 1 x 2.5 inch, 15 krpm SAS 3 x 2.5 inch, 15 krpm SAS 6 x 2.5 inch, 15 krpm SAS 1

6 Table 2. System Configurations (continued) System Configurations Minimum Typical Maximum I/O Devices 1 x 2-Port 10/100/1000 Base-TX Ethernet Power Supply Number and Redundancy Configuration Management Controller or Service Processor Installed? Other Hardware Features / Accessories 3 x 2-Port 10/100/1000 Base-TX Ethernet, 1 x 2-Port Gigabit Ethernet-SX Yes Yes Yes 4 x 2-Port 10/100/1000 Base-TX Ethernet, 1 x 2-Port Gigabit Ethernet-SX, 3 x 4-Port 10/100/1000 Base-TX, 2 x 2-port 4Gb Dual Port Fibre Channel DVD-RAM, LTO-5 tape DVD-RAM, LTO-5 tape DVD-RAM, LTO-5 tape Table 3. Power Data Power Data Minimum Typical Maximum Idle Category (1S and 2S Category D: Managed Dual Installed Processor (2P) Servers only) ENERGY STAR Idle Power Allowance (1S and 2S only) Measured Idle Power (watts) Power at Full Load* (watts) Benchmark / Method Used LINPACK for Full Load Test Test Voltage and Frequency 230 V 50Hz or 60Hz for Idle and Full Load Test Range of Total Estimated Energy Usage ** (kwh/year) 6,885 to 11,178 7,814 to 12,334 10,249 to 15,488 Link to Detailed Power Calculator (if available) * Note: Full load power represents the sustained, average power at 100% load of the given workload, and does not necessarily represent the absolute peak power or the highest average, sustained power possible for other workloads. ** Note: Estimated kwh/year gives the absolute range of energy use a user could expect from continuous operation (24x7x365) and ranges from 100% Idle usage to 100% full load operation. The calculation also includes typical data center overhead at a ratio of 1 watt of overhead to every 1 watt of IT load (corresponding to a PUE of 2.0). Closer approximations may be found by using established power calculators and specific information about the intended operating environment (e.g., average time at Idle, data center PUE, etc.). Table 4. Power and Performance for Benchmark #1 Power and Performance for Benchmark #1 Minimum Typical Maximum Benchmark Used and Type of Workload LINPACK E6C ENERGY STAR Power and Performance Data Sheet

7 Table 4. Power and Performance for Benchmark #1 (continued) Power and Performance for Benchmark #1 Minimum Typical Maximum Avg. Power Measured 638 Watts 704 Watts 884 Watts During Benchmark Run Benchmark Performance Gflops Gflops Gflops Score Power Performance Ratio (perf score/avg. power) Link to Full Benchmark Report (Where Available) Table 5. Power Saving Features Power Saving Features Enabled on Shipment End-User Enabling Required Processor Dynamic Voltage and No Yes Frequency Scaling Processor or Core Reduced Power Yes No States Power Capping No Yes Variable Speed Fan Control Based on Yes No Power or Thermal Readings Low Power Memory States Yes No Low Power I/O States No No Liquid Cooling Capability No No Other1: Other2: Other3: Other4: Table 6. Power and Temperature Measurement and Reporting Power and Temperature Measurement and Reporting Input Power Available & Accuracy? Yes, +/- 3% Input Air Temp Available & Accuracy? Yes, +/- 1 C typical, +/- 2 C maximum Processor Utilization Available? Yes Other Data Measurements Available & Accuracy? Compatible Protocols for Data Collection REST Averaging method and time period 30 second average, 1 second peak Table 7. Thermal Information* Thermal Information* Minimum Typical Maximum Total Power Dissipation (watts) Delta Temperature at Exhaust at Peak Temp. ( C) Airflow at Maximum Fan Speed (CFM) at Peak Temp E6C ENERGY STAR Power and Performance Data Sheet 3

8 Table 7. Thermal Information* (continued) Thermal Information* Minimum Typical Maximum Airflow at Nominal Fan Speed (CFM) at Nominal Temp * References: ASHRAE Extended Environmental Envelope Final August 1, 2008 Thermal Guidelines for Data Processing Environments, ASHRAE, 2004, ISBN Peak temperature is defined as 35 C, Nominal Temperature is defined as C Notes: 1. SPECpower_ssj2008 is a registered trademark of the Standard Performance Evaluation Corporation (SPEC). Benchmark results stated above reflect results published on XX/XX/XX. For the latest SPECpower_ssj2008 benchmark results, visit E6C ENERGY STAR Power and Performance Data Sheet