Targus Memory Stick Reader for Notebook Computers

Transcription

1 Targus Memory Stick Reader for Notebook Computers

2 Targus Memory Stick Reader Introduction Thank you for purchasing the Targus Memory Stick Reader (TMS Reader). Lightweight and ultra-portable, the TMS Reader runs off your notebook computer s power supply and enables you to transfer data between your computer and devices that use memory stick media, such as a digital camera, personal organizer, voice recorder, MP3 player, Personal Digital Assistant (PDA), or handheld computer. See Supported Media Formats on page 7 for a list of compatible media. After installing the software driver, you can use the TMS Reader at any time by plugging in its Universal Serial Bus (USB) connector to your computer s USB port. You can also use the TMS Reader with the supplied USB extension cable to increase the cable length. In addition to this user s guide, this package contains: Targus Memory Stick Reader Driver software CD USB extension cable 2

3 Targus Memory Stick Reader 3 System Requirements To use the Targus Memory Stick Reader, your computer must meet the following hardware and operating system requirements. PC Pentium or equivalent processor, with hard disk drive USB interface (compliant to USB 1.1) CD-ROM drive Windows 98/Me/2000 operating system Macintosh USB interface (compliant to USB 1.1) CD-ROM drive Macintosh 8.6 or higher operating system Installing the Targus Memory Stick Reader Driver Software NOTE: You must install the driver software before connecting the TMS Reader to your computer.

4 Targus Memory Stick Reader 4 Windows 98/Me/2000 Operating System 1 Turn on your computer (if it is not already on). 2 Insert the driver software CD into your computer s CD-ROM drive. 3 If Setup does not begin automatically, click Start, then Run, and enter D:\autorun.exe (where D: is the path of your CD-ROM drive) and then click OK. 4 Follow the on-screen instructions and restart your computer to complete installation. You are now ready to connect the TMS Reader to an available USB port on your computer. See Connecting the Targus Memory Stick Reader to Your Computer on page 5. Macintosh 1 Turn on your computer (if it is not already on). 2 Exit all active programs, including those in the Startup folder, and disable any virus-scanning software. 3 Insert the driver software CD into your computer s CD-ROM drive.

5 Targus Memory Stick Reader 5 4 From the driver software CD, double-click the USB Storage icon and then the Reader icon. 5 Click the Install button and follow the remaining on-screen instructions. 6 To complete installation, restart your computer. You are now ready to connect the TMS Reader to an available USB port on your computer. See Connecting the Targus Memory Stick Reader to Your Computer below. Connecting the Targus Memory Stick Reader to Your Computer NOTE: The TMS Reader supports hot swapping you can connect and disconnect the reader while your computer is running. After installing the driver software, connect the TMS Reader to your computer by plugging the standard USB end of the reader into an available USB port. If necessary, use the supplied USB extension cable to increase the cable length.

6 Targus Memory Stick Reader 6 Using the Targus Memory Stick Reader After installing the driver software and connecting the TMS Reader to your computer, you can begin using the reader. Insert media from your digital camera, PDA or other device into the reader s media slot and your computer automatically recognizes the media and data. General Operating Hints When using the TMS Reader: You can insert and remove media from the TMS Reader while your computer is running. A short delay is normal before the TMS Reader begins sending data to your computer. The TMS Reader s status light glows continuously when your computer s operating system recognizes that the TMS Reader is connected to your computer. Make sure that data transfer between the TMS Reader and your computer is complete before removing media from the reader. Your computer recognizes the TMS Reader as being a removable media device (like an external diskette drive) and the media s data appears as one or more files.

7 Targus Memory Stick Reader 7 If you are running the Windows 2000 operating system, you must stop the TMS Reader before removing it from your computer. To do this, double-click the unplug or eject hardware icon in the system tray. Additional Operating Hints for Macintosh Users Make sure that you move the removable drive icon (named Untitled ) to the trash can before removing media from the TMS Reader or disconnecting the reader from your computer s USB port. To avoid possible compatibility problems, avoid using the TMS Reader to format media. Specifications Supported Media Formats Memory Stick USB Serial Bus Data Rate Up to 12Mb/sec Read/Write Performance Up to 12Mb/sec Memory Stick Read/Write Capacity 2 MB, 4 MB, 8 MB, 16 MB, 32 MB, 64 MB, 128 MB and greater

8 Targus Memory Stick Reader 8 Troubleshooting Frequently Asked Questions What should I do when my computer halts while it is receiving data from the TMS Reader? Make sure that the status light glows when there is media in the reader. If it does not, try inserting a different memory card. Remove the media from the TMS Reader and completely disconnect the reader from your computer s USB port. Then, reconnect the TMS Reader and reinsert the media. Remove the media and disconnect the TMS Reader from your computer s USB port. Then, restart your computer, reconnect the TMS Reader and reinsert the media. CAUTION: For a Macintosh computer, make sure that you move the Untitled removable drive icon to the trash can before removing media from the TMS Reader or disconnecting the reader from your computer s USB port. Remove the driver software and then reinstall it. NOTE: To uninstall the driver software, the TMS Reader must be connected to your computer.

9 Targus Memory Stick Reader 9 To uninstall the driver software: Windows 98/Me Operating System 1 From the desktop, right-click the My Computer icon. 2 Click Properties and select the Device Manager tab. 3 Locate the USB to Media Port Driver and click + to expand the list. 4 Right-click USB to Media Port Driver and then click Delete. Windows 2000 Operating System 1 From the desktop, right-click the My Computer icon. 2 Click Properties and select the Hardware tab. 3 Click Device Manager. 4 Locate the USB Serial Bus Controllers and click + to expand the list. 5 Right-click USB to Memory Stick (LC1) Drive. 6 Click Uninstall and then OK.

10 Targus Memory Stick Reader 10 Macintosh 1 Turn on your computer (if it is not already on). 2 Exit all active programs, including those in the Startup folder, and disable any virusscanning software. 3 Insert the driver software CD into your computer s CD-ROM drive. 4 From the driver software CD, double-click the USB Storage icon. 5 Click the pull-down box, located in the upperleft corner, and select Uninstall. 6 Click the Uninstall button and follow the remaining on-screen instructions. 7 To complete the uninstall process, restart your computer. Technical Support In the unlikely event that you encounter a problem with your Targus accessory, please contact our technical support team at: techsupport@targus.com Internet:

11 Targus Memory Stick Reader 11 Our knowledgeable staff is also available to answer your questions through one of the following telephone numbers. North America Monday through Friday, 8:00 a.m. (08:00) to 8:00 p.m. (20:00) Eastern time: US & Canada Europe Belgium Denmark France Germany Italy Netherlands Spain Sweden Switzerland United Kingdom Eastern Europe & others

12 Targus Memory Stick Reader 12 Warranty Targus warrants this product to be free from defects in materials and workmanship for one year. If your Targus accessory is found to be defective within that time, we will promptly repair or replace it. This warranty does not cover accidental damage, wear and tear, or consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage to, a computer; nor loss of, or damage to, programs, records, or data; nor any consequential or incidental damages, even if Targus has been informed of their possibility. This warranty does not affect your statutory rights. Warranty Registration at: Regulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Statement Tested to Comply This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause

13 Targus Memory Stick Reader 13 harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Move the computer away from the receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Windows and Windows 98/Me/2000 are registered trademarks of Microsoft Corporation. Macintosh is a registered trademark of Apple Computer, Inc. All other trademarks are the property of their respective owners.

14 A