Repair Parts List DRYER MODEL NUMBER DG382. When requesting service or ordering parts, always provide the following information:

Transcription

1 Repair Parts List DRYER MODEL NUMBER DG382 When requesting service or ordering parts, always provide the following information: - Product Type - Part Number - Model Number - Part Description 2005 Maytag Services

2 Section: CONTROL PANEL Model: DG382 MA59D5 1

3 Section: CONTROL PANEL No. Part No. Description Series Qty GRND.WIRE,SUPP.PLTE TO TOP CVR SCREW, #8 X 5/16 INCH SCREW PALNUT, END CAP FASTENER, END CAP N PAD, CONTROL PANEL BUZZER - NON-ADJUSTABLE N MAIN WIRE HARNESS Note: PART NOT USED TIMER N MAIN WIRE HARNESS Note: PART NOT USED N MAIN WIRE HARNESS Note: WIRE HARNESS N CONTROL PANEL NUT N BACK UP PLATE CAP FOR TIMER KNOB KNOB FOR TIMER TIMER DIAL INDICATOR END CAP - LEFT HAND N END CAP - RIGHT HAND SCREW,CTRL.PNL & END CAP(BLK) SCREW -RELAY TO TUB SUPPORT 00 2 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 2

4 Section: FRONT VIEW Model: DG382 MA59D7 3

5 Section: FRONT VIEW No. Part No. Description Series Qty NUT SCREW & FSTNER ASSY(FRT.PANEL) SCREW & FASTENER ASY SCREW SCREW, CABINET N ACCESS DOOR-WHITE BASE ASSY N KNOB AND SCREW N FRONT PANEL-WHITE ADJUSTABLE LEG & NUT N TOP COVER-WHITE CONSOLE (WHT) N CABINET-WHITE DOOR Note: DOOR, WHITE SCREW SCREW N DOOR PANEL-WHITE FOOT, RUBBER - 4 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 4

6 Section: REAR VIEW Model: DG382 MA59D9 5

7 Section: REAR VIEW No. Part No. Description Series Qty NUT N CONVERTER SCREW & FSTNER ASSY(FRT.PANEL) SCREW, #8 X 9/16 CTSK SCREW GROMMET, CORD Note: CORD GROMMET SCREW, CABINET LABEL, ELECTRICAL INSTRUCTION FASTENER,CNTRL PNL TO CONSOLE CLAMP, GROUND (W/SCREW) POWER CORD Note: POWER CORD BASE ASSY SCREW & WASHER ASSY N POWER CORD-5 FT, 3 WIRE Note: PART NOT USED N FRONT PANEL-WHITE ADJUSTABLE LEG & NUT N TOP COVER-WHITE CONSOLE (WHT) N CABINET-WHITE SCREW GROUND WIRE WASHER, TERMINAL BLOCK N SCREW, #10-32 X 1/2 INCH NUT, TERMINAL BLOCK STRAP, GROUND SCREW, #10-24 X 3/4 INCH BRACKET, TERMINAL BLOCK COVER, TERMINAL COVER, ACCESS SCREW - BAFFLE TO TUMBLER SCREW N SCREW----NA FOOT, RUBBER BLOCK, TERMINAL 00 1 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 6

8 Section: FRONT PANEL & DOOR ASSEMBLY Model: DG382 MA59D11 7

9 Section: FRONT PANEL & DOOR ASSEMBLY No. Part No. Description Series Qty SCREW & FSTNER ASSY(FRT.PANEL) SCREW Note: SCREW FASTENER, PANEL N ACCESS DOOR-WHITE N KNOB AND SCREW N DOOR HINGE N FRONT PANEL-WHITE SWITCH, DOOR DOOR LATCH KIT DOOR Note: DOOR,WHITE N INNER DOOR WITH KNOB CLIP, WIRE HARNESS N BUSHING FOR ACCESS STUD Note: BUSHING, ACCESS DOOR SLEEVE-ACCESS PANEL STUD Note: RUBBER SLEEVE, ACCESS DOOR TWIN FASTENER N DOOR PANEL-WHITE CLIP, DOOR LINER TO OUTER PNL DOOR STRIKE RETAINER INSTRUCTION LABEL SCREW DOOR SEAL N GAS IGNITION LABEL SEAL FOR FRONT PANEL N SCREW FOR DOOR KNOB----NA 00 1 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 8

10 Section: LINT SCREEN, TUMBLER (FRONT & BACK) Model: DG382 MA59D13 9

11 Section: LINT SCREEN, TUMBLER (FRONT & BACK) No. Part No. Description Series Qty RUBBER ADHESIVE, 2 OZ TUBE RIVET SCREW BEARING & ROLLER ASSEMBLY TUMBLER BEARING KIT OUTLET DUCT & GRID ASSEMBLY OUTLET DUCT & GRID TUMBLER BACK TUMBLER W/BAFFLES LINT SCREEN N TUMBLER FRONT----NA CLIP, WIRE HARNESS WASHER SCREW SCREW WASHER, ROLLER SHAFT NUT, ROLLER SHAFT SHAFT, TUMBLER ROLLER BELT, TUMBLER & MOTOR SCREW OUTLET DUCT - OUTER HALF WASHER, SPRING (ROLLER SHAFT) TUMBLER SEAL N SCREW----NA N SCREW GUIDE FOR LINT SCREEN LINT SEAL N COVER, THREAD SCREW, INLET DUCT WASHER TUMBLER W/OUT BAFFLES BAFFLE (SHORT) BAFFLE (TALL) RING, RETAINING WIRE, GROUND 00 1 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 10

12 Section: INLET DUCT, GAS VALVE, CONE & EXTENSION Model: DG382 MA59E3 11

13 Section: INLET DUCT, GAS VALVE, CONE & EXTENSI No. Part No. Description Series Qty SCREW N SCREW, HEX HD #8 X 3/8 INCH N SCREW ASSM - BLUE BLOCK OPE SHUT-OFF, GAS VALVE CONE, COMBUSTION INLET DUCT ASSEMBLY - DG SENSOR, RADIANT PIPE & BRACKET ASSY THERMOSTAT, HI-LIMIT (GAS) CONE, EXTENSION (COMBUSTION) IGNITER ASSY, GAS VALVE SCREW BURNER ASSEMBLY N MAIN BURNER ORIFICE KIT-LPG COIL, SECONDARY COIL, HOLDING & BOOSTER VALVE, GAS PLUG, BLOCKING (LPG REGULATOR) CONVERSION KIT (NATURAL TO LP) CONVERSION KIT (LP TO NATURAL) SCREW RETAINER, HEATER CHAMBER N SCREW----NA SCREW BRACKET, GAS VALVE LEAK LIMITER (LPG) 00 1 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 12

14 Section: MOTOR, BLOWER, BASE FRAME & THERMOSTATS Model: DG382 MA59E5 13

15 Section: MOTOR, BLOWER, BASE FRAME & THERMO No. Part No. Description Series Qty SCREW CLIP, MOTOR NUT SET SCREW, PULLEY SCREW MOTOR BASE ASSY IDLER ARM & SHAFT ASSY EXHAUST DUCT ASSY PULLEY, IDLER BLOWER WHEEL ASSEMBLY & CLAMP SWITCH, MOTOR Note: PROD.# , # , & # SWITCH, MOTOR STARTPROD. Note: SWITCH, MOTOR START PROD. # & # IDLER SPRING ASSEMBLY CYCLING THERMOSTAT 140 DEG ADJUSTABLE LEG & NUT PULLEY, MOTOR (W/SET SCREW) N SWITCH, MOTOR START-PROD. Note: SWITCH, MOTOR START PROD. # N WIRE CLIP, WIRE HARNESS SCREW WASHER, IDLER SHAFT (QTY-1) N COVER FOR THERMOSTAT OPENIN HOUSING, BLOWER N SLEEVE, IDLER ARM N COVER FOR BLOWER----NA N SUPPORT, MOTOR SEAL, BLOWER RETAINING RING, IDLER SHAFT BELT, TUMBLER & MOTOR SCREW CLAMP, BLOWER HOUSING N RETAINER, WIRE HARNESS N SCREW----NA SPACER, IDLER BRACKET FOOT, RUBBER RING, RETAINING SPRING, WIRE HARNESS WIRE, GROUND SCREW, GROUND WIRE 00 2 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 14

16 Section: INSTALLATION ACCESSORIES Model: DG382 MA59E7 15

17 Section: INSTALLATION ACCESSORIES No. Part No. Description Series Qty 1 N BLADE, SAW N REPLACEMENT DRILL N HOLE SAW W/DRILL BIT N EXTENSION CHUCK, DRILL HOOD, VENT PIPE, VENTING ELBOW, VENTING (4") N PLATE, ALUM. WINDOW (15"X20") VENT DUCT ASSY FLEXIBLE VENT KIT N RECTANGULAR VENT KIT N DAMPER, BACK DRAFT SCREW FASTENER, EXHAUST DUCT KIT N EXHAUST DEFLECTOR KIT FLEXIBLE ALUMINUM VENT DUCT CLAMP, FLEXIBLE DUCT EXHAUST DUCT KIT BAG, LINT (DACRON) INSULATION, EXHAUST DUCT KIT N BRACKET, EXHAUST DEFLECTOR 00 1 *Color Code (-)=Not Shown #=Series, Serial Prefix or Run No., N=Not Available 16

18