3630 MAINSTREET. Intelligent, high perfomance multiplexing that terminates up to 31 voice or data circuits. PRIMARY RATE MULTIPLEXER Release 5.

Transcription

1 3630 MAINSTREET PRIMARY RATE MULTIPLEXER Release 5.3 Alcatel s 3630 MainStreet Primary Rate Multiplexer (PRM) serves as a gateway on the customer premises to primary rate facilities for a wide range of equipment. As well, the 3630 MainStreet PRM can be used as a managed network termination unit on the customer s premises. The 3630 MainStreet PRM is a high performance, compact, intelligent T1 (1.544 Mb/s) or E1 (2.048 Mb/s) multiplexer, terminating up to 30 voice or data circuits. The 3630 MainStreet PRM digitizes analog transmissions and integrates voice and data circuits for transmission on a primary rate link. The HDSL module allows T1/E1 rates over the local copper loop without repeaters or generators. The manual ring down (MRD) module (North America) or GEN-GEN module (Europe) supports voice interfaces typically used by financial institutions for dealer room communication applications. Intelligent, high perfomance multiplexing that terminates up to 31 voice or data circuits

2 Flexible interfaces The 3630 MainStreet PRM can be equipped with two T1 (1.544 Mb/s) interfaces or two E1 (2.048 Mb/s) interfaces. The second interface can be configured to provide protection switching and drop and insert capabilities. Both T1 and E1 interfaces are available with high bit rate digital subscriber line (HDSL) interfaces. The 3630 MainStreet PRM can accommodate: a maximum of 30, 2- or 4-wire voice terminations 30 V.24, TIA/EIA-232 terminations at speeds up to 38.4 kb/s up to 16 X.21 or V.35 terminations at speeds up to 1,920 kb/s 24 OCU-DP ports for access to DDS services up to kb/s co-directional (G.703) terminations, or 16 2B1Q terminations for 275x MainStreet Data Termination Unit (DTU) connectivity. These voice and data terminations can be employed in any combination. Connections for remote data devices The 3630 MainStreet PRM supports the 275x MainStreet DTUs, which allow for connections to multiple data devices, with the use of 2B1Q modules. The DTUs connect to the 3630 MainStreet PRM over a single copper pair, thereby extending the reach of the 3630 MainStreet PRM for distribution of services. The 275x MainStreet DTUs support a link distance of up to 5.5 kilometers (3.4 miles) over 24 AWG twisted pair. GEN-GEN signaling support GEN-GEN signaling (generator input, generator output) is a signaling system for use with dealer room equipment in a financial institution. The 3630 MainStreet PRM offers an MRD (GEN-GEN) module to support GEN-GEN signaling over an E1 link. Node and network management All operating parameters of the 3630 MainStreet PRM are software configurable and an array of performance statistics allows for a detailed evaluation of system status at any time. The Alcatel 5620 Network Manager (NM), formerly the Network Manager*, provides full network management control of the 3630 MainStreet PRM. Figure 1 illustrates a 3630 application for financial dealer boards using European GEN-GEN (or North American MRD) voice interfaces. Financial Institution Switching Unit Multiple copper twisted pair GEN-GEN connections 3630 PRM Primary E1 Link Private Leased Network * This product belonged to the Newbridge family. Newbridge was acquired by Alcatel in May

3 Applications Channel bank application The 3630 MainStreet PRM can groom up to 30 voice circuits, 30 data circuits or a combination of these onto a single E1 aggregate. When two 3630 MainStreet PRM systems feed into a dual E1 card on a 3600 MainStreet Multiservice Bandwidth Manager system, the port density is 60 voice or data circuits per card slot. GEN-GEN channel bank The 3630 MainStreet PRM can be used as a channel bank for GEN-GEN voice interfaces from dealer boards. Financial institutions using this type of equipment within their dealer rooms need point-to-point connections for voice circuits. A connection between the copper pair, using GEN-GEN signaling and an E1 link, is provided by the institution s private network or by a public service provider. Leased bandwidth delivery in the local loop The 3630 MainStreet PRM can be used in a carrier environment to distribute multiple leased line services up to 128 kb/s in the local loop. By using the 275x MainStreet DTU and the 2B1Q module, a local loop distance of up to 5.5 kilometers (3.4 miles) over 24 AWG twisted pair is possible. High speed network termination unit (NTU) The 3630 MainStreet PRM is often used as a managed NTU by service carriers for delivering high speed bandwidth services. An HDSL LIM can be added to the 3630 MainStreet PRM to allow delivery of 1,920 kb/s over two twisted pairs in the local loop at typical distances of up to 5 kilometers (3.1 miles). With a conventional E1 LIM, the 3630 MainStreet PRM can deliver up to 1,920 kb/s or several 64 kb/s services over a 2 Mb/s leased line. Figure 2: The 3630 can aggregate PBX and data traffic over two copper pairs. Office Central Office 2B1Q LAN 2721 RTU 5620 NM V.35/X.21 E1/HDSL or E1/HDB3 Video Teleconferencing 3630 PRM 3600 Multiservice Bandwidth Manager E1 PBX 3

4 Technical Summary Interfaces T1 interfaces D4 and ESF compatible Bit rate Mb/s (± 25 ppm) B8ZS or JB7 zero code suppression options Clock stability ± 25 ppm (Stratum 4) Integral CSU available E1 interfaces Compatible with applicable sections of ITU-T Rec. G.703, G.704, G.711, G.732 Bit rate Mb/s (± 25 ppm) HDB3 coding 75/120 ohm line impedance options Termination Interfaces Loop/ground start subscriber (LGS) Loop/ground start exchange (LGE) Integral ringing generator Optional integral tone generation E&M (Type I, II, and V; 2- or 4-wire) Manual ring down (MRD) 2B1Q circuits to data termination units 50-pin connectors to customer circuits Dual port V.24, TIA/EIA-232 Single port V.35 and X.21 Dual port OCU-DP with switched 56 kb/s support Dual port co-directional module (64 kb/s G.703) Data Termination Units V.35, X.21 and V.24, TIA/EIA-232 units Single twisted pair (<5.5 km/3.4 mi., 0.4 mm/0.02 in.) Synchronous data rates up to 128 kb/s (including 14.4 kb/s) Asynchronous data rates up to 38.4 kb/s (including 14.4 kb/s) Loop Signaling Characteristics Maximum external resistance: 450 ohm Maximum dial pulse speed: 20 pps Maintenance All parameters are software configurable DTE and DCE maintenance ports Multilevel password protection Automatic self-diagnostics and directed diagnostics with statistics Alarm storage buffer Remote alarm signaling Local and remote loopbacks Access over X.25-based (CPSS) message system Alarm contacts and sensors Operational and diagnostic displays Compatible with AT&T statistics over T1 ESF channel Compatible with ITU-T G.821 CRC-4 statistics over E1 Physical Description Height: cm (23.85 in.) Width: cm (11.9 in.) Operating Environment 0 C to 40 C (32 F to 104 F) 5% to 95% relative humidity, noncondensing Product Safety UL1459, CSA C22.2 No. 225, EN60950 EMC Standards FCC Part 15, ICES-003, EN55022, EN50082 Network Attachment FCC Part 68, IC CS-03, CTR12 Power AC 115/230 V, 50/60 Hz input DC 44 V 54 V input Maximum power consumption: 75 W Ringing generator 20 Hz or 25 Hz Depth: 11.3 cm (4.45 in.) Weight: 9.1 kg (20 lb.) Lockable wall-mount cabinet Rack-mount variants available 4

5 Feature Summary Voice Interfaces E&M LS/GS Subscriber (LGS) LS/GS Exchange (LGE) T1 RBS E1 CAS MRD/GEN-GEN Data Interfaces V.24, V.28, T1A/E1A-232-C 2WTO and 4WTO V.35 X.21/V.11 OCU-DP 2B1Q (interfaced with 275x DTUs) Aggregate Interfaces Mb/s T1 (D4, ESF, 64 kb/s chan.) Mb/s E1 (CAS, CCS, 64 kb/s chan.) E1 HDSL Fractional E1 X.21 V.35 ISDN S/T BRI Optical Extension E1 DSP Applications Voice compression 8 and 16 kb/s HCV compression 8 kb/s A-CELP (ITU-T Rec. G.729) 16 kb/s LD-CELP (ITU-T Rec. G.728) ADPCM (ITU-T Rec. G.721) 32 kb/s G3 fax support (V.17) over compressed voice (14.4 kb/s max.) Modem (V.32bis) tones support over compressed (CELP) voice (14.4 kb/s) Subrate multiplexing Echo cancellation Voice conference bridging Multidrop data bridging High capacity multiplexing (HCM) DDS rate adaptation Packet Services Frame relay switching Transport HDLC encapulation Voice over frame relay DLCI multiplexing General (maximum) # of E1 ports 2 2 # of fractional E1 ports 4 # of T1 ports 1 2 # of circuits

6 For more information Alcatel, the Alcatel logo, MainStreet and Newbridge are registered trademarks of Alcatel. All other trademarks are the property of their respective owners. Alcatel assumes no responsibility for the accuracy of the information presented, which is subject to change without notice Alcatel. All rights reserved CL TQZCA Ed.02