Appendix. Specifications

Transcription

1 Appendix A Specifications PC Interface Resources are assigned automatically (Plug&Play) ME-000 PCI/cPCI (Rev..) PCI Local Bus Specification Rev.. ( bit, MHz, Universal-PCI: V/.V) ME-000 PCI-Express PCI Express x Specification Rev..0 ( bit, MHz,.V) ME-0/00 PCI/cPCI PCI Local Bus Specification Rev.. ( bit, MHz, V) ME-0 PC/-Plus PC/-Plus Specification Rev.. ( bit, MHz, Universal-PCI: V/.V) Note: On MIX versions RS- and RS-/ ports can be combined on one board. UARTs (ME-000/0/00, ME-0 PC/-Plus) Number of ports ME-000:, or (RS-, RS-/) (RS- + RS-/) ME-0: or (RS-, RS-/) ME-00: (RS-) ME-0 PC/-Plus: (RS-, RS-/) Type ME-000 and ME-0 PC/-Plus Octo-UART integrated in the PCI controller of type EXAR XRDIV; register compatible to the 0 with integrated transmit and receive FIFO for each port Type ME-0 resp. Quad-UARTs of type OXC or compatibles (depends on number of ports); register compatible to the 0 with integrated transmit and receive FIFO for each port Type ME-00 Quad-UARTs of type OXC or compatibles; register compatible to the 0 with integrated transmit and receive FIFO FIFO capacity for each port ME-000/ME-0 PC/-Plus: each byte ME-0/00: each byte Transfer rates /0//0/00/00/.0/.00/.00/.00/.0/.00/.00/.0/.00/.00/.0/.000/0.00/ 0.00/.00 Bd Meilhaus Electronic Page Specifications

2 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie Parity none, odd, even, mark, space Data bits ; ; ; ; Stop bits ;,; Flow control Xon/Xoff, hardware, none RS- Ports (ME-000/0/00, ME-0 PC/-Plus) Signals RxD, TxD, DCD, DTR, DSR, RTS, CTS, RI Transfer distance max. m Voltage level for output signals (TxD): logical 0 : typ. +,V (+V < U < +,V) logical : typ. -,V (-,V < U < -V) Voltage level for input signals (RxD): logical 0 : +V < U < +V logical : -V < U < -V ESD protection up to kv (IEC 00) Electrical isolation for i -versions up to 00V for p -versions up to 00V RS-/ Ports (ME-000/0, ME-0 PC/-Plus) Operation modes - RS- - RS- half duplex (automatic flow control) - RS- full duplex Transfer distance max. m Differential output voltage of the buffer. V Differential input voltage for high level min. 0 mv Differential input voltage for low level max. 0 mv Output offset voltage relating to GND V Electrical isolation for i and p versions: - to PC ground: 00V - between the ports (only p -models): 00V Multi-I/O Pins (ME-000, ME-0 PC/-Plus) Number bit bidirectional Type TTL ports Interrupt IRQ-DIO (must be enabled) Output level U OL : max. ma (Vcc = V±%) U OH : -ma Specifications Page Meilhaus Electronic

3 Input level U IL : -0, < 0,V (Vcc = V±%) U IH :,0V <,0V Reference to GND PC ground () Counter (ME-000, ME-0 PC/-Plus) Number x bit Type Down counter Modes Single-Shot or Retrigger Clock source internal/external Internal Oscillator Crystal oscillator (, MHz/0 ppm) Ext. clock input TMRCK Interrupt IRQ-CNT (must be enabled) Reference to GND PC ground () General Information Power consumption typ.. + V Max. load of VCC on the customer design area (CDA) resp. ST of the ME-000: max. 00 VCC (+V resp. +.V) Max. load of VCC via ST of the ME-0 PC/-Plus: max. 00 VCC (+V) Physical size ME-000 PCIe: x mm (without mounting bracket ME-000 PCI: x mm and connectors) ME-0 PCI: x mm ME-00 PCI: x mm ME-0 PC/-Plus: 0 x mm CompactPCI models: U CompactPCI Connection ME-000 pin D-Sub female connector with dual, quad or octopus cable to pin D-Sub male connectors pin IDC connector (ST) for MIO pins incl. flat ribbon cable to pin D-Sub female connector Connection ME-0 pin D-Sub female connector with dual, quad or octopus cable to pin D-Sub male connectors Connection ME-00 x pin VHDC female connectors Connection ME-0 PC/-Plus Bus connectors for PCI and ISA bus (ISA bus looped through only), x 0pol. IDC connectors (with 0 angle) incl. flat ribbon cables with each x pin D-Sub male connector, pin IDC connector (ST) for MIO pins incl. flat ribbon cable to pin D-Sub female connector Meilhaus Electronic Page Specifications

4 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie Operating temperature Storage temperature Relative humidity ME-000: -0 + C ME-0/00: 0 0 C; ME-0 PC/-Plus: -0 + C ME-000/0: -0 0 C ME-00: -0 0 C ME-0 PC/-Plus: -0 0 C % (not condensing) CE Certification EMC Directive //EMC Emission EN 0 Noise immunity EN 00- Specifications Page Meilhaus Electronic

5 B Pinout Note the different pinout of the RS- and RS-/ ports. The MIX versions provide RS- as well as RS-/ ports. The RS- ports occupy always the lower significant ports followed by the RS- ports. B ME-000/0 RS- Port Port Port Port DCD DTR RxD TxD DCD DTR RxD TxD DCD DTR RxD TxD DCD DTR RxD TxD RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS RI DSR CTS RTS DCD DTR RxD TxD DCD DTR RxD TxD DCD DTR RxD TxD DCD DTR RxD TxD Port Port Port Port Diagram : Pinout of the pin D-Sub female connector for RS- ports *see note on page! Meilhaus Electronic Page Pinout

6 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie B ME-000/0 RS-/ Port Port Port Port RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- RxD+ RxD- TxD+ TxD- Port Port Port Port Diagram : Pinout of the pin D-Sub female connector for RS-/ ports *see note on page! Pinout Page Meilhaus Electronic

7 B ME-00 RS- TxD () RI () DSR () DTR () TxD () RI () DSR () CTS () RTS () RxD () DCD () CTS () DTR () TxD () RI () DSR () CTS () GND RxD () DCD () CTS () RTS () RxD () DCD () GND DTR () TxD () RI () DSR () GND RTS () RxD () DCD () GND RTS () CTS () DCD () RxD () RTS () CTS () DCD () RxD () RTS () CTS () DCD () RxD () RTS () CTS () DCD () RxD () RTS () DTR () DSR () RI () TxD () DTR () DSR () RI () TxD () DTR () DSR () RI () TxD () DTR () DSR () RI () TxD () DTR () Diagram 0: pin VHDC female connector of the ME-00 Pinout is valid for both VHDC connectors (connector A: lower, connector B: upper). The numbers in brackets describe the port numbers of connector B. Meilhaus Electronic Page Pinout

8 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie B ME-0 PC/-Plus 0 0 board/print Diagram : 0pin IDC connector of the ME-0 PC/-Plus Both of the 0pin IDC connectors for COM and COM are allocated identically (see the following table). Pin COM RS- Direction RS-/ Direction or DCD Input RxD+ Input or DSR Input or RxD Input RxD- Input or RTS Output or TxD Output TxD+ Output or CTS Input or DTR Output TxD- Output or RI Input or GND Masse GND Masse or +V VCC or DCD Input RxD+ Input or DSR Input or RxD Input RxD- Input or RTS Output or TxD Output TxD+ Output or CTS Input or DTR Output TxD- Output or RI Input or GND Masse GND Masse Table : Pinout of the 0pin IDC connector Pinout Page Meilhaus Electronic

9 Pin COM RS- Direction RS-/ Direction or +V VCC or DCD Input RxD+ Input or DSR Input or RxD Input RxD- Input or RTS Output or TxD Output TxD+ Output or CTS Input or DTR Output TxD- Output or RI Input or GND Masse GND Masse 0 or +V VCC or DCD Input RxD+ Input or DSR Input or RxD Input RxD- Input or RTS Output or TxD Output TxD+ Output or CTS Input or DTR Output TxD- Output or RI Input or GND Masse GND Masse 0 or +V VCC Table : Pinout of the 0pin IDC connector Meilhaus Electronic Page Pinout

10 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie B Auxiliary Connector ST (ME-000) ME-AK-DF/S: Adapter cable from pin IDC connector to mounting bracket with pin D-Sub female connector (comes with the board). ST MIO_0 MIO_ MIO_ MIO_ TMRCK MIO_ MIO_ MIO_ MIO_ VCC (V/,V) ST MIO_0 MIO_ MIO_ MIO_ TMRCK MIO_ MIO_ MIO_ MIO_ VCC (V/,V) ME-000 Diagram : Pinout of ST on ME-000(i) Note: Connect the mounting bracket pin of the flat ribbon cable (red marked line) as shown above to the IDC connector ST. Pinout Page 0 Meilhaus Electronic

11 B Auxiliary Connector ST (ME-0 PC/-Plus) ME-AK-DF: Adapter cable for multi-i/o port of the ME-0 PC/ -Plus from pin IDC connector to pin D-Sub female connector (comes with the board). ST VCC (V) MIO_ MIO_ MIO_ MIO_ TMRCK MIO_ MIO_ MIO_ MIO_0 ST VCC (V) MIO_ MIO_ MIO_ MIO_ TMRCK MIO_ MIO_ MIO_ MIO_0 COM ME-0 PCI Diagram : Pinout of ST of the ME-0 PC/-Plus Note: Connect pin of the flat ribbon cable (red marked line) as shown above to pin of the IDC connector ST. Meilhaus Electronic Page Pinout

12 Rev..E Manual ME-0 PC/-Plus, ME-000/0/00 cpci/pci/pcie B pin male connector ME-000/0/00 DSR RTS CTS RI DCD RxD TxD DTR RxD+ TxD+ TxD- RxD- RS- RS-/ Diagram : pin D-Sub male connector ME-x00 * Ground Reference ME-000 Series Note the different ground reference at the GND pins of the connectors of the ME-000 series: - TTL models (without opto-isolation): PC ground (). - i -models: from application view one common ground (GND_C) isolated to PC ground. - p -models: ground of the single ports isolated from each another and to PC ground, so called island-grounds (GND_x). B pin male connector ME-0 PC/-Plus DSR RTS CTS RI DCD RxD TxD DTR GND RxD+ RxD- TxD+ TxD- GND RS- RS-/ Diagram : pin D-Sub male connector of ME-0 PC/-Plus Pinout Page Meilhaus Electronic

13 B pin RJ- female connectors TxD DTR RTS RxD DCD DSR CTS RS- Diagram : pin RJ- female connector for RS- ports (Rocket-Port pinout) TxD- RxD TxD+ RxD+ RS-/ RS- Diagram : pin RJ- female connector for RS-/ ports (not Rocket-Port compatible) B Null modem cable RxD TxD CTS RTS RS- RxD TxD CTS RTS RxD+ TxD+ TxD- RxD- RxD+ TxD+ TxD- RxD- RS-/** Diagram : Null modem cable RS- (left), RS-/ (right) *see note on page! **not for ME-0 PC/-Plus Meilhaus Electronic Page Pinout