2.5-inch 40GB PATA Hard Disk Drive PC-HDD40G User s Guide CONTEC CO.,LTD.

Transcription

1 2.5-inch 40GB PATA Hard Disk Drive CONTEC CO.,LTD. Thank you for purchasing the CONTEC PC-HDD40G. Please use this product in accordance with the procedures described in this document. Product Configuration - Hard Disk Drive 1 - Screw (M3x5, with sw, w) 4 - Insulation Film 1 - Jumper 1 Disposal When disposing of the product, follow the disposal procedures stipulated under the relevant laws and municipal ordinances. Safety Information This document provides safety information using the following symbols to prevent accidents resulting in injury or death and the destruction of equipment and resources. Understand the meanings of these labels to operate the equipment safely. DANGER WARNING CAUTION DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury or in property damage. Disclaimers We shall not be liable for any consequential damages such as losses and lost profits resulting from the operation of this product. For any reason we shall provide no warranty for the stored contents on your hard disk. 1 PC-HDD40G

2 Handling Precautions CAUTION - Do not apply pressing force on the top of cover. - Do not cover the breathing hole on the top cover. - The system is responsible for providing sufficient air movement to maintain surface temperatures below 82 C on the top cover - Do not touch the interface connector pins and the surface of printed circuit board. - Hard disk is precision instruments. Be extremely careful in handling during and after assembly. - Hard disk can malfunction when it is subjected to electrostatic discharge (ESD) or physical shock. Handle with care so that antistatic measures are taken in advance and do avoid shock. - Be sure to turn off the power of the unit when plugging in or unplugging interface connectors. - Use the mounting screws (M3x5 with sw, w : for screwing the base) provided with the product. Longer screws may damage the interior of the product. - CONTEC bears absolutely no responsibility for use if modified hard disk. - Excessive vibration or impact greater than its specification, if this hard disk is subjected to, might cause a fatal error that is not recoverable. - Service life of the drive is approximately 5 years or 15,000 power on hours, whichever comes first. These are the standard values when the environmental and operational conditions specified in page 3 are observed and are not the guaranteed values. Unaccommodated host PCs You can not use this drive when if you use these host PCs. IPC-PT/M30(PC), IPC-PE/M30(PC), IPC-PS/M30(PC), IPC-PL/M30(PC), IPC-BX/M20(PC), IPC-BX/M10(PC), PC-386(PC), PC-386(PC)S, PC-486M(PC), IPC-PT/M140(PC), IPC-PS/M140(PC), IPC-PT/M100(PC), IPC-PS/M100(PC), PC-IDE/FD(98)A, PC-486M(PC)H, IPC-PT/M340(PC)H, IPC-PT/M500(PC), IPC-PT/M500S(PC), IPC-PT/M530(PC), IPC-PT/M530S(PC), IPC-TT/M300(PC), IPC-TT/M310(PC), IPC-TT/M340(PC), IPC-TT/M340S(PC), IPC-TT/M500(PC), IPC-TT/M500S(PC), IPC-PT/M140(PC), IPC-PT/M140(PC)H, IPC-BX/M400(PC), IPC-BX/M400(PC)H, IPC-BX/P400(PC) PC-HDD40G 2

3 Specification Item Specification Total recording capacity 40GByte Host interface ATA/ATAPI-6 (up to 100MB/s) Transfer velocity Max. 514Mbit/sec (Gbps) Typ. 461Mbit/sec Input voltage +5VDC (±5%) Consumed power Sleep 0.10W (typ.) Read / Write / Seek 2.15W / 2.15W / 2.4W(typ.) Startup *1 6.5W (Max.) Environment Operating Temperature C Humidity 5-90%RH (With no condensation) Maximum wet bulb 40 C (With no condensation) temperature Temperature change gradient 120 C/h or less for up 60 C/h or less for down (With no condensation from temperature gradient) Altitude 1025hPa hPa (Above the sea m) Swept sine vibration 3.0G or less (10-50Hz) 2.5G or less (50-200Hz) 1.0G or less ( Hz) Shock 250G or less (2ms) 100G or less (11ms) Non-operating Temperature C Humidity 5-95%RH (With no condensation) Maximum wet bulb 40 C (With no condensation) temperature Temperature change gradient 120 C/h or less for up 60 C/h or less for down (With no condensation from temperature gradient) Altitude 1025hPa hPa (Above the sea m) Swept sine vibration 5.0G or less ( Hz) Shock 800G or less (1ms) Operational Power on hours 250 hours/month or less condition Read / Write / Seek 20% or less at power on hours (maximum 3,000 hours) MTBF 550,000H Weight 97g (Max.) *1 Maximum power consumption at motor startup Fixed disk characteristics Bytes per Sector Description Logical Layout Sectors per Track Number Number Number Number of Number of of Heads of Disks of Heads Sectors/ Cylinders Number of Total Logical Data Sectors Bytes Track PC-HDD80S ,383 78,140,160 40,007,761,920 3 PC-HDD40G

4 Physical Dimensions Master/Slave Settings C A C A 4 C 2 DB A Note! D B Master Setting (Open : Default Setting) D B Slave Setting A-B Short Never attach a jumper to settings which are not shown above. PC-HDD40G 4

5 Installation Screw (with sw,w) Installation Part HDD Insulation Film Connector Pin Assignment Pin Signal I/O Type Pin Signal I/O Type 1 RESET- I TTL 2 GND 3 DD07 I/O 3-state 4 DD08 I/O 3-state 5 DD06 I/O 3-state 6 DD09 I/O 3-state 7 DD05 I/O 3-state 8 DD10 I/O 3-state 9 DD04 I/O 3-state 10 DD11 I/O 3-state 11 DD03 I/O 3-state 12 DD12 I/O 3-state 13 DD02 I/O 3-state 14 DD13 I/O 3-state 15 DD01 I/O 3-state 16 DD14 I/O 3-state 17 DD00 I/O 3-state 18 DD15 I/O 3-state 19 GND 20 KEY 21 DMARQ O 3-state 22 GND 23 DIOW- I TTL 24 GND 25 DIOR- I TTL 26 GND 27 IORDY O 3-state 28 CSEL I TTL 29 DMACK- I TTL 30 GND 31 INTRQ O 3-state 32 (reserved) 33 DA01 I TTL 34 PDIAG- I/O OD 35 DA00 I TTL 36 DA02 I TTL 37 CS0- I TTL 38 CS1- I TTL 39 DASP- I/O OD 40 GND 41 +5V logic power 42 +5V motor power 43 GND 44 (reserved) 5 PC-HDD40G

6 Copyright 2010 CONTEC CO., LTD. ALL RIGHTS RESERVED. CONTEC CO., LTD , Himesato, Nishiyodogawa-ku, Osaka , Japan Japanese English A (LYGW173) Chinese _rev3 [ ] No part of this document may be copied or reproduced in any form by any means without prior written consent of CONTEC CO., LTD.