Installer guide 931A/C17

Size: px

Start display at page:

Download "Installer guide 931A/C17"

Vernon Wood
6 years ago
Views:

1 Installer guide 9/ Interphone power supply V 0Hz 0W

2 S product is according to UL 00 Description of symbols shown in the power supply. double square: it is a class II power supply triangle with ligthning: hazard of electric shock, dangerous voltage; Triangle with exclamation mark: danger, pay attention. UTION RISK OF ELETRI SHOK DO NOT OPEN TTENTION RISQUE DE HO ELETRIQUE NE PS OUVRIR The circuits inside the power supply are further protected by a SIEMENS PT, type 9. N.B. When using continuous duty 0- and 0-S outputs, do not connect loads of over 0.. IMPORTNT SFETY INSTRUTIONS - Read these instructions - Keep these instructions - Heed all warnings - Follow all instructions - Do not use this apparatus near water - lean only with dry cloth - Do not block any ventilation openings. Install in accordance with the manufacturer s instructions. - Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that product heat. 9- Do not defeat the safety purpose of the polarized or grounding-type plug. polarized plug has two blades with one wider than the other. grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 0- Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. - Only use attachments/accessories specified by the manufacturer. - Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. WRNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture and objects filled with liquids, such as vases, not be placed on this apparatus UTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. - pparatus shall not be exposed to dripping or splashing and no objects with liquids, such a vases, shall be placed on the apparatus. - The set disconnection device from the mains is the plug. INSTLLTION RULES. Installation should be carried out observing current installation regulations for electrical systems in the ountry where the products are installed. Ensure clearance around the appliance so there is sufficient ventilation. There must be no dripping or splashes of water on the appliance. WRNING: To prevent injury, the appliance must be secured to the wall as described in the installation instructions. bove the power supply there must be a bipolar circuit breaker that is easily accessible with a contact gap of at least mm. ONFORMITY. LV directive EM directive Standards EN 00, EN 000--, EN Power supply units constitute SELV sources in compliance with the requirements stipulated in rticle... of EI standard - (0). INFORMTION FOR USERS UNDER DIRETIVE 00/9 (WEEE) In order to avoid damage to the environment and human health as well as any administrative sanctions, any appliance marked with this symbol must be disposed of separately from municipal waste, that is it must be reconsigned to the dealer upon purchase of a new one. ppliances marked with the crossed out wheelie bin symbol must be collected in accordance with the instructions issued by the local authorities responsible for waste disposal. EN

3 TEHNIL HRTERISTIS OF RT. 9/ Power supply in grey BS housing; preset for mounting on cases with DIN -module support. This power supply features a dual electronic tone generator which replaces the traditional alternating current call on a buzzer or bell. The sound signal has two different tones (on terminals -), enabling users to immediately identify which point is calling (main entrance, gate, garage, etc.). This solution also makes it possible to use a single loudspeaker built into the phone itself to produce the sound. The use of terminal for push-buttons commun wire for calls coming from the panel enables the activation of an acoustic signal in the same panel when calls are made to the interphones. Furthermore, this power supplier has been preset for operation with interphones with.. call; for such purpose terminal P must be used as push-buttons commun terminal for calls from the door entry panel, which also routes an acoustic sound to the panel. OPERTING INSTRUTIONS This power supply can be used for two types of systems: ) Simple communication between the inside phones and outdoor unit (rt. 90). Diagram c9, c9. ) ommunication between the speech unit (rt. 90) and inside phones with conversation privacy between users. In this case only the phone called from the outdoor unit is enabled for conversation and release of the lock, if any, on the door. Diagram c, c. ONNETIONS TO TERMINLS OF : PRI: } Supply V~ +0% -0% 0Hz 0V protect by PT SIEMENS 0. Power dissipated by power supply:, W } } } : Handset receiver : Handset microphone : Handset receiver and microphone common (-): Intecommunication system power supply (+): 9V c.c. : ommon receiver and microphone for speech unit : Speech unit microphone : Speech unit loudspeaker : Output for call generator with modulated sound for push-buttons commun wire, to be used with Sound System series interphones. : Output for call generator with continuous sound for push-buttons commun wire, to be used with Sound System series interphones. P: V~ output for commun wire push-buttons to be used with.. call interphones. } } 0: Output V~ (on intermittent operation) sec. ON, 0 sec. OFF, 0, continuous : protect by PT SIEMENS 9 0: sec. ON, 0 sec. OFF, 0, continuo Output V rectified (on intermittent operation) sec. ON, 0 sec. OFF, 0, continuous S: protect by PT SIEMENS 9 EN

4 ELVOX rt. 9/ PRI - P O S - Entrance panel series Patavium 000, 00, 00, 00 B- dditional push-button for lock - Electric lock V~ D- Outdoor unit rt.90, 90 L- Bulb for panel lighting (xv W max.) 0xV W with rt. / XV W with rt. / L rt. rt. / B D rt. 00 U E P S N.B. IN SE OF NOISE IN THE UDIO MOVE, IN THE, THE WIRE ONNETED ON THE DOOR LOK TERMINL N. TO TERMINL S. S H N 9 WIRING DIGRM OF ELETRI DOOR OPENER WITH SOUND SYSTEM LL, ONVERSTION PRIVY, DIRET LOK RELESE notice ND call in door entry panel EN

5 R rt. rt. 9/ PRI - P O S E rt rt. U U E E E P S L D S H B - Entrance panel series Patavium 000, 00, 00, 00 B- dditional push-button for lock - Electric lock V~ D- Outdoor unit rt.90, 90 E- ard for conversation privacy rt. L- Bulb for panel lighting (xv W max.) 0xV W with rt. / XV W with rt. / S BL BI RO + - N.B. On interphone rt. leave the jumper on terminals -S. N WIRING DIGRM OF ELETRI DOOR-OPENER SYSTEM WITH LL SYSTEM SOUND SYSTEM, ONVERSTION PRIVY, DIRET LOK RELESE and for notice of call in door entry panel. EN

6 R rt. rt. 9/ PRI - P O S RELY rt. 00/0 E rt U E P S E N U E L D S H B S BL BI RO + - rt. - Entrance panel series Patavium 000, 00, 00, 00 B- dditional push-button for lock - Electric lock V~ D- Outdoor unit rt.90, 90 L- Bulb for panel lighting (xv W max.) 0xV W with rt. / XV W with rt. / N.B. On interphone rt. displace jumper on terminal -. N WIRING DIGRM OF ELETRI DOOR-OPENER SYSTEM WITH LL SYSTEM SOUND SYSTEM, ONVERSTION PRIVY, LOK RELESE FTER THE LL and for notice of call in door entry panel. EN

7 - Entrance panel series Patavium 000, 00, 00, 00 B- dditional push-button for lock - Electric lock V~ D- Outdoor unit rt.90, 90 L- Bulb for panel lighting (xv W max.) 0xV W with rt. / XV W with rt. / rt. 9/ PRI - P O S L rt. 0 B B D ELVOX rt. 0R B N.B. IN SE OF NOISE IN THE UDIO MOVE, IN THE, THE WIRE ONNETED ON THE DOOR LOK TERMINL N. TO TERMINL S. S H N 9 WIRING DIGRM OF ELETRI DOOR ENTRY SYSTEM WITH.. LL ND LL ON DOOR ENTRY PNEL. EN

8 VRIZIONI DEGLI SHEMI BSE VERSIONS FROM STNDRD WIRING DIGRMS VERSION onnection of outdoor call push-button. When activating the outdoor push-button the phone sounds with a tone different from the one obtained by the external entrance panel call. rt. 9/ - Outdoor push-button (P) rt. rt. rt. 00 (P) VERSION onnection of the call repeater rt. 000/. The loudspeaker module rt. 000/ repetes the phone sound leaving the tone unaltered. rt. 9/ rt. rt. rt. 00 (P) (S) (P) all repeater rt. 000/ EN

9 VRIZIONI DEGLI SHEMI BSE VERSIONS FROM STNDRD WIRING DIGRMS VERSION onnection of stair-lighting push-button by using repeater relay rt. 00/00. rt. 9/ RELY rt. 00/00 rt. rt. rt. 00 (P) rt. 0 STIR-LIGHT PUSH-BUTTON Max. load -0V N.B. To switch on stair-light press push-button with bulb symbol. The maximum capacity of the phone button contacts is V 0.../D.. VERSION onnection of additional bell. V~ additional bells can be fitted using the relay rt. 00/0 connected as shown in the diagram. RELY rt. 00/0 Max. load -0V Bell supply rt. rt. rt. 00 (P) (S) EN 9

10 MINIML ONDUTORS SETION FOR DOOR ENTRY SYSTEMS (mm ) Tipical section Terminals Ø up to 0 m. Ø up to 00 m. Ø up to 00 m. a 0,,,, -, S, S,,, P, P 0, mm 0, mm, mm lock, calls b others 0, mm 0, mm mm onversion table of sections-diameters and relative resistances for 00 m. standard conductors. Section mm 0, 0, 0, 0,0 0,,00,0,0,00,00 Diameter mm. 0,0 0, 0, 0,0,00,,0,0,0,0 WG 0 0 Decimal diameter /0 /0 /0 0/0 /0 /0 /0 Resistance W 00m.,00,0,0,0,0,0, 0,9 0,9 0, 0 EN

11 EN

12 Vimar Sp: Viale Vicenza, 0 Marostica VI - Italy Tel Fax (Italia) 0 Fax (Export) VIMR - Marostica - Italy

1/4 Guitar / Mic input

1/4 Guitar / Mic input Important Safety Instructions 1) Read these instructions All the safety and operating instructions should be read before this product is operated. 2) Keep these instructions The