SMT166-FMC User Guide

Transcription

1 Sundance Multiprocessor Technology Limited Product Specification Unit / Module Description: Unit / Module Number: Document Issue Number: Issue Date: Original Author: SMT166-FMC User Guide

2 Revision History Issue Changes Made Date Initials

3 Table of Contents 1 Introduction Related Documents System Photograph Functional Description Verification, Review and Validation Procedures Safety EMC... 32

4 8 Timing Diagrams Circuit Description / Diagrams (SMT166) Circuit Description / Diagrams (SMTSLB-FMC) Layout FPGA Pinout FPGA Pinout (FMC) Board Options Physical Properties Safety EMC Table of Figures

5 NOTE: RED

6 1 Introduction

7

8 2 Related Documents Xilinx - Virtex-6 Families Texas Instrument - clock distribution chip (optional) Micron DDR3 Memory Samtec QSH/QTH connectors Samtec BKS/BKT connectors Huber-Suhner MMCX series Molex PCIe x1 vertical connector: Molex Male-Male PCIe x1 cable: Molex PCIe x4 connector receptacle and housing (with key) Molex PCIe x4: Sundance SLB Specifications

9 Sundance SMT6002 software

10 3 System Photograph

11 4 Functional Description 4.1 Block Diagram Clock Synthesiser Synchroniser PSU Section FMC Mezzanine 0 FMC Mezzanine 1 FMC Mezzanine 2 FMC Mezzanine 3 USB+CPLD +Flash To configure Virtex6 FPGAs and access Master Module Flash SLB SLB SLB SLB PCIe Cable x1 PCIe Cable x4 x1 i x4 j x2 p Full SLB i FPGA_0 Virtex 6 LX130T-LX365T SX315T-SX475T Full SLB j m Half SLB i Channels x2 RSL x2 m R S L SLB Connector Top TIM Connector Master Module R S L Half SLB n RSL x4 o RSL x2 n Full SLB k Full SLB l FPGA_1 Virtex 6 LX130T-LX365T SX315T-SX475T x1 k x4 l x2 q PCIe Cable x1 PCIe Cable x4 Dual SATA3.0 DDR3 Memory Bank 0 DDR3 Memory Bank 1 Bottom TIM Connector DDR3 Memory Bank 2 DDR3 Memory Bank 3 Dual SATA3.0 SMT166 SLB Carrier Board 1Gigabit Ethernet 1Gigabit Ethernet SLB Bus Rocket IOs Parallel Bus An SLB cable can be used to link the SLB on the Master module to the SLB on the SMT166 while using RSLs. PCIe cable connectors can be used as a link to a host PC. 4 and 1-lane cables are available as well as Host Interface Board to communicate to a PC. Figure 1 - SMT166-FMC Block Diagram.

12 i j k l m n SLB & SLB/FMC Links RSL Links i j k l m n o Channel Links i

13 4.2 Module Description Connectors available on the board SLB connectors and cables The mounting posts and securing bolts for the SLBs and TIM are at 3.3V NOT GND.

14 Figure 2 - SLB cable - FlexiPCB. Figure 3 - SLB cable - Blue ribbon cable.

15 TIM Site

16 External clocks PCI Express Figure 4 - PCIe cables.

17 SATA Ethernet RS232 headers This 10-pin header is NOT directly compatible with a standard PC COM port.

18 Power supply Figure 5 - ATX Power connectors. The 4-pin socket adjacent to the 24-pin ATX connector (if fitted) should only be used to power fans and other peripherals. It should not be used for connection to an ATX 12V power source.

19 4.2.2 FPGAs FPGA Power supplies FPGA LX130T LX195T LX240T LX365T SX315T Quiescent Vccint (amps) Quiescent Vccaux (amps) SX475T Figure 6 - FPGA power requirement.

20 FPGA Clock structure FPGA Configuration FPGA Virtex6 LX130T Bitstream size Virtex6 LX195T Virtex6 LX240T

21 Virtex6 LX365T Virtex6 SX315T Virtex6 SX475T Figure 7 - FPGA Bitstream sizes. Flash JTAG FPGA_0 Virtex 6 LX130T-LX395T Config. Port USB2.0 CPLD Configuration Port FPGA_1 Virtex 6 LX130T-LX395T Mode selection made via switches Comport3 Master Module SMT166 Configuration Figure 8 - Configuration Block Diagram.

22 4.2.3 DIP Switch Settings / FPGA Configuration SW3 SW2 Function

23

24 4.2.4 DDR3 Memory

25

26 4.2.5 On-board reset Clock circuitry (optional)

27 4.2.7 General purpose IOs RS232 Signal Pin # Pin # Signal USB Ethernet

28 SATA RSLs to Master module Inter-FPGA RSL links Inter-FPGA channels

29 LEDs

30 4.3 Cooling of the board Figure 9 - Crossflow blower.

31 4.4 FMC IO voltages

32 5 Verification, Review and Validation Procedures 6 Safety 7 EMC 8 Timing Diagrams

33 9 Circuit Description / Diagrams (SMT166) 9.1 Clock circuitry:

34 9.2 CPLD and FPGA configuration: 9.3 DDR3 Memory:

35 9.4 RS232: 9.5 RSL:

36 9.6 SLB: 9.7 SLB Aux Site:

37 9.8 TIM Site: 9.9 USB:

38 9.10 Inter-FPGA Channels:

39 10 Circuit Description / Diagrams (SMTSLB-FMC)

40 11 Layout Figure 10 - PCB Layout.

41 12 FPGA Pinout Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin #

42 Interface Signal / Bus FPGA Pin #

43 Interface Signal / Bus FPGA Pin #

44 Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin #

45 Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin #

46 Interface Signal / Bus FPGA Pin # Interface Signal / Bus FPGA Pin #

47 13 FPGA Pinout (FMC) FMC SLB Signal / FMC FMC SLB Signal / FMC Pin Pin # 0 1 Pin Pin # 0 1

48

49

50

51 14 Board Options SMT166-FMC-ATX SMT166-FMC-12V 15 Physical Properties

52 16 Safety 17 EMC