PCIe Card Selection Guide PCIe-CAN Card Bus Interface PCI Express x 1 LPE-C122 PCE-C122D PCE-C122T Channels I/O Isolation Voltage Baud Rate Terminator Resistor I/O PIN Type 2 Max. 1 Mbps Jumper for 120 Ω terminator resistor DB15 Male * 1 DB9 Male * 2 5-pin TB * 2 PCIe-COM Card Bus Interface PCI Express x 1 PCE-C114 PCE-C114A PCE-C118 RS-232 Ports 4-8 RS-422/485 Ports I/O Isolation Voltage Baud Rate FIFO Size I/O PIN Type - 4 - ±15000Vrms Max. 921.6 kbps 256 bytes DB15 Male * 2 DB15 Male * 2 DB62 Female * 1 19
LPE-C122 PCE-Communication 2-port Isolated CAN Bus Card Low profile form factor Two independent CAN communication operation Up to 1 Mbit/s programmable transfer rate on 120 ohm termination resistor selected by jumper CAN Number of port 2 CAN controller SJA1000 1Mbps Signal support CAN_H, CAN_L, GND Isolation voltage Termination resistor 120 ohm selected by jumper Connectors DB15 Male 3.3VDC at 100mA, 12VDC at 100mA typical 1 2 3 1 2 3 CAN_L CAN_H GND CAN2_L CAN2_H GND LPE-C122 2-port lsolated CAN Card Y Cable from DB15 to Two DB9 MM DB15 - DB9M+DB9M, 0.5M Support Visual C/C++, C#, Microsoft.NET Framework programming on Windows 2000/XP/7 platform with DLL DeviceNet DLL supported by request 20
PCE-C122D 2-port Isolated CAN Bus Card Two independent CAN communication operation Direct memory mapping to the CAN controllers Up to 1 Mbit/s programmable transfer rate on 120 ohm termination resistor selected by jumper CAN Number of port 2 CAN controller SJA1000 1Mbps Signal support CAN_H, CAN_L, GND Isolation voltage Termination resistor 120 ohm selected by jumper Connectors DB9 Male 3.3VDC at 100mA, 12VDC at 100mA typical PCE-C122D 2-port lsolated CAN Card with DB9 Conncetor Support Visual C/C++, C#, Microsoft.NET Framework programming on Windows 2000/XP/7 platform with DLL DeviceNet DLL supported by request 21
PCE-C122T PCE-Communication 2-port Isolated CAN Bus Card Two independent CAN communication operation Direct memory mapping to the CAN controllers Up to 1 Mbit/s programmable transfer rate on 120 ohm termination resistor selected by jumper CAN Number of port 2 CAN controller SJA1000 1Mbps Signal support CAN_H, CAN_L, GND Isolation voltage Termination resistor 120 ohm selected by jumper Connectors 5 pin TB 3.3VDC at 100mA, 12VDC at 100mA typical PCE-C122T 2-port lsolated CAN Card with 5-pin Terminal Block Support Visual C/C++, C#, Microsoft.NET Framework programming on Windows 2000/XP/7 platform with DLL DeviceNet DLL supported by request 22
PCE-C114 4-port Isolated Serial Communication Card Short card form factor Enhanced 16550 compatible UARTs 256-byte hardware FIFO for Up to 921.6 kbps programmable transfer rate on Communication mode selected by jumper Serial Port Number of port 4 Parity Data bits 5, 6, 7, 8 50 bps ~ 921.6 kbps None, Odd, Even, Mark, or Space Stop bits 1, 1.5, 2 FIFO Flow control Data signals 256 bytes DTR/DSR, RTS/CTS, Xon/Xoff RS232:RXD, TXD, RTS, CTS, DTR, DCD, RI RS422:RX+, RX-, TX+, TX- RS485:Data+, Data- 3.3VDC at 300mA typical PCE-C114 4-port RS-232 lsolated Serial Communication Card PCE-C114A 4-port RS-422/485 lsolated Serial Communication Card Modbus DLL supported by request 23
PCE-C118 PCE-Communication 8-port Isolated Serial Communication Card Enhanced 16550 compatible UARTs 256-byte hardware FIFO for Up to 921.6 kbps programmable transfer rate on Serial Port Number of port 8 50 bps ~ 921.6 kbps Parity None, Odd, Even, Mark, or Space Data bits 5, 6, 7, 8 Stop bits 1, 1.5, 2 FIFO 256 bytes Flow control Data signals DTR/DSR, RTS/CTS, Xon/Xoff RS232:RXD, TXD, RTS, CTS, DTR, DCD 3.3VDC at 300mA typical PCE-C118 8-port RS-232 lsolated Serial Communication Card Modbus DLL supported by request 24