Click on Series name for product info on aimtec.com Series AMEPRC-AZ Models Single output Model Max Output Power (W) 1 FEATURES: Output Voltage Range (V) 3 Output Current 3 AMEPRC-120AZ 36-0 - 1.20 AMEPRC-361AZ 59.8 24-36 0-1. AMEPRC-242AZ 12-24 0-2. AMEPRC-120AZ 5-12 0-5.0 AC-DC Constant Current or Constant Over Temperature Protection Voltage LED Driver Over Current Protection Input range -5VAC/47-4Hz Waterproof Case rated IP68 High Efficiency up to 86% Power Factor Correction Operating temperature - to 85 C Short Circuit Protection Dimmable via resistive / 0-10Vdc / PWM 5 Years Limited Warranty OC P / OV P Input Voltage (VAC/Hz) Input Voltage (VDC) Mode of Operation 115 VAC Efficiency (%) 1.27-5/47- Constant Current 84 86 86.7 1-4 4 Constant Voltage 2 84 86 86 1.77-5/47- Constant Current 84 86 86 36.6 1-4 4 Constant Voltage 2 84 86 86 2.55-5/47- Constant Current 82 83 83 24.5 1-4 4 Constant Voltage 2 82 83 83 5.2-5/47- Constant Current 79 81 12.3 1-4 4 Constant Voltage 2 79 81 2 VAC 277 VAC 1 Exceeding the maximum output power will permanently damage the converter 2 The dimming feature is not supported when units are used in Constant Voltage mode only. 3 In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. All models can be ordered with optional North American colour input wires (black (L), white (N), green (GND)). Add NA to part number when ordering. Note: Aimtec limited warranty of 5 years is valid based on product operation at datasheet specifications at ambient temperature of 25 C, humidity<75%, nominal input voltage (115/2/277VAC) and at rated output load unless otherwise specified. See http://www.aimtec.com/terms-sale AMEPRC-AZ s AC/DC LED drivers have electrical safeguards designed within to protect it from conventional electrical abnormalities with the levels listed in the safety table. Applications for use within rural agricultural, heavy industrial, and other areas or regions which are prone to dirty electrical conditions which would subject any of the above models to excessive voltages surges or spikes, may damage or cause early life failure of product. In this case consideration should be made by the end user to ensure that adequate line or mains surge suppression is installed in front of Aimtec device to ensure the longevity of the products. Failure to identify excessive line surges violations prior to installation may damage sensitive equipment permanently. Input Specifications Parameters Conditions Typical Maximum Units Inrush current <2ms 115VAC 2VAC A Leakage current 115VAC 0.5 2VAC 0.7 ma AC current 115VAC 0.73 2VAC 0.33 A 115VAC 0.98 Power Factor 2VAC 0.96 277VAC 0.93 External fuse 2V/1.5A Start up time 2 ms Surge voltage 2sec 4 V Output Specifications Parameters Conditions Typical Maximum Units Current accuracy (CC Mode) ±3 % Voltage accuracy (CV Mode) ±3 % Line regulation LL-HL ±1 % F 052.1e R3.I 1 of 13 North America only
Load regulation 0-100% load ±3 % Ripple & Noise 4 20MHz Bandwidth 75 mv p-p Hold-up time ms Current adjustment range 100-10 % Minimum Load Voltage See the models table 4 Tested with 0.1µF (C/C) or (M/C) and 47µF (E/C) parallel capacitors at the end. Isolation Specifications Parameters Conditions Typical Rated Units Tested I/O voltage 3 sec/3.5ma 00 VAC Isolation Resistance 0VDC >1000 MΩ Isolation Capacitance 1000 pf General Specifications Parameters Conditions Typical Maximum Units Switching frequency 1 KHz AMEPRC-120AZ 1.27 Over current protection AMEPRC-361AZ 1.77 AMEPRC-242AZ 2.55 A AMEPRC-120AZ 5.2 Over voltage protection Refer to Constant Current vs. Constant Voltage Mode curve Short circuit protection Continuous Short circuit restart Auto recovery Over temperature protection >105 C Operating temperature With derating over 55 C - to +85 o C Maximum case temperature 100 o C Storage temperature - to +95 o C Temperature coefficient ±0.02 % / o C Cooling Free air convection Humidity 95 % RH Case material Plastic Potting Epoxy (IP67 rated) Wires UL1015 18AWG *20CM Weight 5 g Dimensions (L X H X W) 5. x 2.27 x 1.59 inches 134. x 57.68 x. mm MTBF >0,000 hrs (MIL-HDBK-217F at +25 C) Safety Specifications Parameters Agency approvals Standards culus, CE UL87, UL9-1, EN522, class B, EN529(IP68), EN61347-1, EN61347-2-13 Information Technology Equipment EN522 Class B Harmonic Current Emissions IEC/EN 61000-3-2, Class C Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN555-3) Electrostatic Discharge Immunity IEC 61000-4-2 Level 3 RF, Electromagnetic Field Immunity IEC 61000-4-3 Level 2 Electrical Fast Transient / Burst Immunity IEC 61000-4-4 Level 2 Surge Immunity IEC 61000-4-5 Level 3 RF, Conducted Disturbance Immunity IEC 61000-4-6 Level 2 Power frequency Magnetic Field Immunity IEC 61000-4-8 Level 1 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 F 052.1e R3.I 2 of 13 North America only
Dimensions Top View 137.33 (5.41) End View. (1.59) 16.75 (0.66) 6 (2.36) 3 6 (1.26) (2.36) Side View. (1.59) 20 (8.00) 20 (8.00) Input/Output Wires are 18 AWG 20cm 161. (6.35) 2. (0.09) Wire connection: Wire Brown Blue Green Red Black Blue (Dimming) White (Dimming) Connection AC L AC N Ground +V output -V Output + Vs dimming -Vs dimming Temperature Graph Free Air Convection 100 55 º C Output Power % 20 Safe Operating Area 0 85 - -20 0 20 100 Ambient Temperature º C F 052.1e R3.I 3 of 13 North America only
Dimming Control C Versions AMEPRC-120AZ 1. 1.20 0. 0. 0. 0.20 0 10 20 Dimming-Resistance VS Output Current 100 0 20 100 120 K(Ω) 1. 1.20 0. 0. 0. 0.20 Dimming-PWM VS Output Current 95 6 10 20 0 20 100 120 (Duty%) 1. Dimming- 0-10Vdc VS Output Current 1.20 9.00 1 8.00 0. 7.00 0. 0. 0.20 8.00 1 1 (V) F 052.1e R3.I 4 of 13 North America only
AMEPRC-361AZ 1. 1. 1. 1.20 0. 0. 0. 0.20 0 10 20 Dimming-Resistance VS Output Current 0 20 100 120 K(Ω) 100 1. 1. 1. 1.20 0. 0. 0. 0.20 Dimming-PWM VS Output Current 95 20 6 10 0 20 100 120 (Duty%) Dimming- 0-10Vdc VS Output Current 1. 1 1. 9.00 1. 8.00 1.20 7.00 0. 0. 0. 0.20 8.00 1 1 (V) F 052.1e R3.I 5 of 13 North America only
AMEPRC-242AZ 2. 1. 0. Dimming-Resistance VS Output Current 100 20 0 10 0 20 100 120 K(Ω) 2. 1. 0. Dimming-PWM VS Output Current 95 20 6 10 0 20 100 120 (Duty%) Dimming- 0-10Vdc VS Output Current 2. 1 8.00 9.00 1. 7.00 0. 8.00 1 1 (V) F 052.1e R3.I 6 of 13 North America only
AMEPRC-120AZ Dimming-Resistance VS Output Current 100 20 0 10 0 20 100 120 K(Ω) Dimming-PWM VS Output Current 95 6 10 20 0 20 100 120 (Duty %) Dimming- 0-10Vdc VS Output Current 1 9.00 8.00 7.00 8.00 1 1 (V) F 052.1e R3.I 7 of 13 North America only
Efficiency Vs. Input Voltage & Output Current (Constant current load) AMEPRC-120AZ Series AMEPRC-AZ (%) Efficiency Vs. Input Voltage & Output Current 110Vac, 0.24, 81.4 2Vac, 1.2, 110Vac 110Vac, 88.01.2, 2Vac 87.9 2Vac, 0.24, 74.0 AMEPRC-361AZ (%) Efficiency Vs. Input Voltage & Output Current 110Vac, 0.34, 81.4 2Vac, 110Vac 1.7, 110Vac, 88.01.7, 2Vac 87.9 2Vac, 0.34, 74.6 F 052.1e R3.I 8 of 13 North America only
AMEPRC-242AZ (%) Efficiency Vs. Input Voltage & Output Current 110Vac, 0.5, 81.7 2Vac, 2.5, 110Vac 87.0 2Vac 110Vac, 2.5, 85.4 2Vac, 0.5, 78.1 AMEPRC-120AZ (%) Efficiency Vs. Input Voltage & Output Current 2Vac, 5, 110Vac 84.9 110Vac, 5, 2Vac 83.9 110Vac, 1, 73.4 2Vac, 1, 72.9 F 052.1e R3.I 9 of 13 North America only
PFC Value vs. Output Load Current (constant current mode) AMEPRC-120AZ Series AMEPRC-AZ (value) PFC value Vs. Output Load Current 115VAC, %, 0.98 115VAC, 115VAC 100%, 2VAC 2VAC, 100%, 0.96 2VAC, %, 0.91 (load) AMEPRC-361AZ (value) PFC value Vs. Output Load Current 115VAC, %, 0.98 115VAC, 115VAC 100%, 0.992VAC 2VAC, 100%, 0.96 2VAC, %, 0.88 (load) F 052.1e R3.I 10 of 13 North America only
AMEPRC-242AZ (value) PFC value Vs. Output Load Current 115VAC, %, 0.98 2VAC, %, 0.77 115VAC, 115VAC 100%, 2VAC 2VAC, 100%, 0.94 (load) AMEPRC-120AZ F 052.1e R3.I 11 of 13 North America only
Constant Current vs. Constant Voltage Mode AMEPRC-120AZ Constant Current Vs. Constant Voltage 36 36, 1.21, 1.22 38.4, 52, (V) AMEPRC-361AZ Constant Current Vs. Constant Voltage 24 24, 1.71 36, 1.73 26 28 36.4, 38, (V) F 052.1e R3.I 12 of 13 North America only
AMEPRC-242AZ Constant Current Vs. Constant Voltage 12 12, 2.51 24, 2.53 14 16 24.5, 26, (V) AMEPRC-120AZ Constant Current Vs. Constant Voltage 5 5, 5.04 12, 5.02 6 7 12.3, 14, (V) NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25 C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec s standard Terms of Sale available at www.aimtec.com. F 052.1e R3.I 13 of 13 North America only