K11 K1 Series Pilot kick type port solenoid valve : Normally closed,normally open NRL PURPS VLV K11 K1 SRIS iaphragm structure Port size : Rc1/, Rc3/, R1/, R3/, R1 JIS symbol K11(normally closed) UT K1(normally open) UT ommon specifications escriptions Standard specifications ptional specifications Working fluid ir, inert gas, low vacu(1.33x10 3 Pa), water, kero, oil (mm /s or less) ther solvent Working pressure diff. rangempa 0 to 1.0 (refer to max. working pressure differential on individual specifications) Max. working pressure MPa Withstanding pressure (water) MPa luid temperature -10 to 0 (no freezing) to 90 (fluoro rubber sealing) mbient temperature -10 to 0 Insulation class lass lass tmosphere No corrosive gas and flammable place Valve structure Pilot kick type poppet structure/diaphragm structure Valve seat leakage (JIS leakage standard) cm 3 /min 0 (0.0 to 1MPa for K11, while 0.0 to 0.MPa for K1) Installation attitude ree Individual specifications escriptions Port rifice v ffec. Min. pparent power (V) size (mm) flow Sec. working Max. working pressure diff. (MPa) Power consumption (W) ir Water, kero Rated voltage olding Starting Mass Series factor rea pressure il (0mm /s) ( kg) (mm diff. ) (MPa) z 0z z 0z /0z when energized : N type K11- Rc1/ 1.0 3 K11-10 Rc3/ 1. 0 0. 0. 0. 0. K11-1 Rc1/ 1. 0 1 1 K11-0 K11- Rc3/ Rc1 3. 1.0 1 31 0. 0. 0. 0. losed when energized : N type K1-1 Rc1/ 1. K1-0 Rc3/ 3. 1 0. 0. K1- Rc1 1.0 31 1 : s above show basic port size. See "ow to order" about other combinations. : ( ) shows power consumption of terminal box. 3 : [ ] shows power consumption of coil woth diode. : Refer to column for maximum working pressure differential of coil with diode. : Variation of rated voltage should be within ±10%. : When the pressure is 0.0MPa or less, 1 series is recommended. 100V /0z 110V 0z 00V /0z 19 1 10/ 11 (10.) 0V 0z 1 10/. 1 3 [1] 1V V V 0 0. 0. 0. 0. 100V 30 10 1 13/11 1 0. 0. 0.9 1.0 1. 1.0 1. 1. 1 T VILL.
eneral purpose valve K11 K1 Series ow to order when energized (N type) K11 3 S 100V Series Port size ody/sealing Mounting plate ther options Rated voltage xample 1 of model number K11-1-0-100V Series : K11 Port size : Rc1/ ody/sealing : ody - bronze, Seal - nitrile rubber oil housing : rommet lead wire to : lank Rated voltage : 100V /0z, 110V 0z oil housing - Surge suppressor Symbol escription Rc1/ 10 Rc3/ 1 Rc1/ 0 Rc3/ Rc1 ody Seal Treat Remarks - thylene propylene rubber il-prohibit Port size ody/sealing P R J L M ST ption ronze Stainless Stainless ronze thylene propylene rubber il-prohibit ot water oil housing ther options Rated voltage able gland onduit escriptions (Marine cable gland) (onduit pipe) escriptions -1a -1b -1c T 19 1/ Mounting plate xample of model number K11-0-S-00V Series : K11 Port size : Rc3/ ody/sealing : ody - bronze, Seal - fluorom rubber oil housing : lead wire (lass coil) Mounting plate : Selected ther options : lank Surge suppressor : Selected Rated voltage : 00V /0z, 0V 0z 1 : See P. to in introduction to check compatibility. : and NPT are available for port thread. 3 : "" P or R is available only for "" (port size) 1/0/. : When combination with ethylene propylene diene rubber seal ("" P or R), the maximum working pressure differential is 0.MPa. : Tropic care treatment (rust proof coating) is available. Surge suppressor 3 3K 3 K K ST ption rommet lead wire terminal box terminal box terminal box + small light Square terminal box Square terminal box + light (1/) (Pg11) (Pg11) (1/) (1/) Square terminal box (1/) (lass coil) Square terminal box + light(1/) Square terminal box (1/) (iode) Square terminal box + light(1/) : See P.10 about coil selection. :, K and are diode rectification coils. : Water proof is available for square terminal box coil (except lass ). 9 : When fluid temperature is 0 over, select "" from,k or. 10: lank when no item selected from "", "" and "". 11: Select one among,,, and for "". 1: When lead wire coil, surge suppressor is attached, while terminal box coil, mounted in the terminal box. 13: Surge suppressor is incorporated in coil with diode and "" V coil as standard. S 1V, V, V, 100V, V 1V, V, V, 100V, V, 100V 1: 100V coil is compatible with 100V/0z, 110V0z, while 00V coils compatible with 00V/0z, 0V0z. Use "",K, coils only for 100V/0z, 00V/0z. 1: onsult with K about other than above voltage. 1: When lead wire length exceeding standard 300mm, custom length is availabe per 0mm increment. 19
K11 K1 Series ow to order losed when energized (N type) K1 1 3 S 100V Series Port size ody/sealing Mounting plate ther options Rated voltage xample 1 of model number K1-0-03-V Series : K1 Port size : Rc3/ ody/sealing : ody - bronze, Seal - nitrile rubber oil housing : lead wire to : lank Rated voltage : V escriptions oil housing Square terminal box oil housing (1/) Square terminal box + light(1/) Square terminal box (1/) (lass coil) Square terminal box + light(1/) Square terminal box (1/) (iode) Square terminal box + light(1/) Surge suppressor Symbol escription 1 Rc1/ 0 Rc3/ Rc1 ody Seal Treat Remarks thylene propylene rubber il-prohibit Port size ody/sealing 3 3K 3 K K P R J L M ST ption ST ption ronze Stainless Stainless ronze thylene propylene rubber : See P.10 about coil selection. :,K and are diode rectification coils. : Water proof is available for square terminal box coil (except lass ). : When fluid temperature is 0 over, select "" from,k or. il-prohibit ot water Mounting plate ther options able gland onduit (Marine cable gland) (onduit pipe) -1a -1b -1c T19 1/ : lank when no item selected from "", "" and "". 9 : Select one among,,, and for "". 10: When lead wire coil, surge suppressor is attached, while terminal box coil, mounted in the terminal box. 11: Surge suppressor is incorporated in coil with diode as standard. xample of model number K1-1-3-100V Series : K1 Port size : Rc1/ ody/sealing : ody - bronze, Seal - fluoro rubber oil housing : Square terminal box + light(1/) Mounting plate : Selected ther options : able gland -1a Surge suppressor : lank Rated voltage : 100V /0z, 110V 0z 1: See P. to in introduction to check compatibility. : and NPT are available for port thread. 3 : Tropic care treatment (rust proof coating) is available. Surge suppressor S Rated voltage escriptions 1V, V, V, 100V, V, 100V 1: 100V coil is compatible with 100V/0z, 110V0z, while 00V coils compatible with 00V/0z, 0V0z. "",K, coils are available only for 100V/0z, 00V/0z. 13: onsult with K about other than above voltage. 1: When lead wire length exceeding standard 300mm, custom length is availabe per 0mm increment. 0
eneral purpose valve K11 K1 Series Internal structure and main parts materials K11- /10 K11-1 /0/ 1 3 1 3 UT UT /10 1 to No. Parts name 1 ore assembly oil 3 Plunger spring Plunger K1 series Material No. Parts name SUS0, 1100(g) lass mold (lass taped) SUS0, NR (KM), copper (silver), nitrile rubber (fluoro) Kick spring Stuffing iaphragm ody Material 31(SS13) NR(KM) (SS13) orging brass (stainless die casting) (fluoro) ronze casting (stainless die casting) ( ) shows options. 1 3 9 10 UT No. Parts name 1 ore assembly Plunger 3 oil ixed ferrous core N valve uter spring Kick spring iaphragm 9 Stuffing 10 ody Material SUS03/30 SUS0 lass mold (lass taped) SUS303, NR (KM), nitrile rubber (fluoro) NR(KM) (fluoro) 31(SS13) orging brass (stainless die casting) (SS13) ronze casting (stainless die casting) ( ) shows options. 1
K11 K1 Series K11 series dimensions rommet lead wire type K11-/10-* rommet lead wire type K11-1/0/- * 3. 3. length (300) 3 length 3. 3. (300) 3 0 9. K11 series optional dimensions terminal box K11- to - * 11. Rc1/() Rc3/(10) 3 K11-1-0 K11-0-0 K11--0 1 0 90 9 3 1. 1.. lead wire type K11- to - * 3 90 9. 10 10 10. 119 0 1 Rc1/ Rc3/ Rc1. (300) 39(1) 9 Pg11 (1/) imensions in ( ) show value of 1/ K11- to - * [ ] - K11-/10- * [ ] - K11-1 to - * [ ] - 3. 3.. (3.).() 0.(0) 3 3 + square terminal box K11- to - * 3 K Mounting plate K11-/10- * * * (ile name : Page to 3 or nding 19 to 3) Mounting plate K11-1/0/- * * * 110 91 9 1/ 30 - dia. 33. M -P K11-1- * * * K11-0- * * * K11-- * * * 3. M N 3 N 0 P 11 dia.
eneral purpose valve K11 K1 Series K1 series dimensions lead wire type K1-1/0/- * 3 (300) K K1-1-03 K1-0-03 K1--03 1 1. 91. 13. 0 1. 9 11 90. 10. 11. 0 1 Rc1/ Rc3/ Rc1 K1 series optional dimensions + square terminal box K1-1/0/- * 3 K + conduit (T19/1/) K1-1/0/- * 3 110 3 () 3 3 T19(1/) 1/ K K 91 + cable gland K1-1/0/- * 3 K Mounting plate K1-1/0/- * * * imensions in ( ) show value of 1/ 110 3 39 3 M -P 3. N K 91 (-1a) 10 dia. (-1b) 11 dia. (-1c) dia. K1-1- * * * K1-0- * * * K1-- * * * M N P 3 0 11 dia. 3