AN626 Application note

Similar documents
AN2667 Application note

STEVAL-SPBT4ATV3. USB dongle for the Bluetooth class 1 SPBT2632C1A.AT2 module. Features. Description

STEVAL-CCM002V1. TFT-LCD panel demonstration board based on the STM32 as LCD controller. Features. Description

AN2672 Application note

AN2676 Application note

AN4113 Application note

STEVAL-PCC010V1. ST802RT1A Ethernet PHY demonstration board with STM32F107 controller add-on board. Features. Description

STTS V memory module temperature sensor. Features

AN2143 Application note

STM32-MP3NL/DEC. STM32 audio engine MP3 decoder library. Description. Features

AN2470 Application note TS4871 low voltage audio power amplifier Evaluation board user guidelines Features Description

SOT23-6L ESDALCL6-2SC6

UM1572 User manual. STEVAL-IPE020V1: ST energy meter application based on the Android platform. Introduction

EV-VNQ5E050AK VNQ5E050AK evaluation board

STM3210B-SK/KEIL STR91X-SK/KEI, STR7-SK/KEIL

AN3996 Application Note

Obsolete Product(s) - Obsolete Product(s)

OSPlus USB Extension. OSPlus USB 2.0 extension. Description. Features. Application. TCP/IP stack NexGenOS NexGenIP VFS. FAT Ext2 LVM Device layer

EMIF02-MIC01F2 2-line IPAD, EMI filter including ESD protection Features Application Description Complies with the standards:

AN2855 Application note

STM32-SK/KEIL STR91X-SK/KEI, STR7-SK/KEIL

STA bit single chip baseband controller for GPS and telematic applications. Features

STM3220G-SK/KEI. Keil starter kit for STM32F2 series microcontrollers (STM32F207IG MCU) Features. Description

EMIF01-SMIC01F2 IPAD. Single line EMI filter including ESD protection. Main application. Description. Benefits. Pin configuration (Bump side view)

EMIF02-SPK02F2. 2-line IPAD, EMI filter and ESD protection. Features. Application. Description. Complies with the following standards

ST19WR08 Dual Contactless Smartcard MCU With RF UART, IART & 8 Kbytes EEPROM Features Contactless specific features

AN3279 Application Note

STEVAL-IHM028V1. 2 kw 3-phase motor control demonstration board featuring the IGBT intelligent power module STGIPS20K60. Features.

UM0401 User manual. User manual for eight bit port expander STMPE801 demonstration board. Introduction

AN3354 Application note

STLC2500D. Bluetooth V2.1 "Lisbon" + EDR. Features. Description

AN2240 Application note

STICE CF/Stice_Connect AD/Stice_Connect AS/Stice_Connect

AN2474 Application note

ST33F1M. Smartcard MCU with 32-bit ARM SecurCore SC300 CPU and 1.25 Mbytes high-density Flash memory. Features. Hardware features.

AN2673 Application note

EVAL6235PD. L6235 three-phase brushless DC motor driver demonstration board. Features. Description

UM0693 User manual. 1 Introduction. STM8L101-EVAL demonstration firmware

AN3250 Application note

UM1488 User manual. STPMC1 evaluation software. Introduction

AN2261 APPLICATION NOTE

STM32-SK/RAIS,STR91X-SK/RAI,STR7-SK/RAIS STM32-D/RAIS,STR9-D/RAIS,STR7-D/RAIS

AN2734 Application note S-Touch design procedure Introduction

SMP75. Trisil for telecom equipment protection. Features. Description. Applications. Benefits

ST19NP18-TPM-I2C Trusted Platform Module (TPM) with I²C Interface Features

LD A very low drop adjustable positive voltage regulator. Description. Features

AN3965 Application note

AN2825 Application Note

STM8 I 2 C optimized examples

AN3980 Application note

AN2408 Application note

Main components 1 A, high efficiency adjustable single inductor dual mode buckboost DC-DC converter

STMicroelectronics. STxP70-4 assembler. User manual Rev A. October

ST21NFCB. Near field communication controller. Features. RF communications. Hardware features. Communication interfaces. Electrical characteristics

AN2737 Application note Basic in-application programming example using the STM8 I 2 C and SPI peripherals Introduction

UM0792 User manual. Demonstration firmware for the DMX-512 communication protocol transmitter based on the STM32F103Zx.

Main components USB charging controller with integrated power switch

STM8-SK/RAIS STM8-D/RAIS ST7-SK/RAIS ST7-D/RAIS

AN2361 Application note

AN2594 Application note

AN3154 Application note

SMP30. Trisil for telecom equipment protection. Features. Applications. Description. Benefits

Getting started with DfuSe USB device firmware upgrade STMicroelectronics extension

UM1084 User manual. CR95HF development software user guide. Introduction. Reference documents

STM32 embedded target for MATLAB and Simulink release 3.1. Summary for STM32 embedded target for MATLAB and Simulink release 3.1:


EMIF03-SIM06F3. 3-line IPAD, EMI filter including ESD protection. Description. Features. Application. Complies with the following standards:

AN2592 Application note

ECMF02-3F3. Common mode filter with ESD protection. Features. Description. Applications. Complies with the following standard:

AN3362 Application note

AN4440 Application note

AN2557 Application note

MEMS functional sensor: smart 3D orientation and click detection standalone device. FC30-40 to +85 LGA-14 Tray FC30TR -40 to +85 LGA-14 Tape and reel

AN3001 Application note

RN0046 Release note. 1 Introduction. SimpleMAC library for STM32W108xx kits. About this release note

ST33TPM12SPI. Trusted Platform Module with SPI based on 32-bit ARM SecurCore SC300 CPU. Features. TPM features. Security features.

L6460. SPI configurable stepper and DC multi motor driver. Features. Description

STM8L-PRIMER STM32-PRIMER STMPRIMER

AN4321 Application note

ST33F1M, ST33F1M0, ST33F896, ST33F768, ST33F640, ST33F512

AN2202 Application note

Description SPC564A-DISP. March 2014 DocID Rev 3 1/5

EMIF M8. 4-line IPAD low capacitance EMI filter and ESD protection in micro QFN package. Features. Applications. Description

AN2430 Application note

STM8L-PRIMER STM32-PRIMER STMPRIMER

EMIF M16. 8-line IPAD low capacitance EMI filter and ESD protection in micro QFN package. Features. Description.

ESDA25LY Automotive dual Transil array for ESD protection Features Applications Description Benefits

AN2768 Application note LIS331DL 3-axis digital MEMS accelerometer: translates finger taps into actions Introduction

TN0189 Technical note

AN4274 Application note

How to interpret the LPS331AP pressure and temperature readings. Main components mbar absolute barometer with digital output

AN3988 Application note

AN3099 Application note

b. Typical values, independent of external clock frequency and supply voltage. a. TCG website:

TN0132 Technical note

AN2781 Application note

ST10F271B/E, ST10F272B/E Errata sheet

STM6904. Quad, ultralow voltage supervisor with push-button reset. Features. Applications

AN3991 Application note

AN3140 Application note

Transcription:

Application note Serial EEPROM product numbering This application note provides a detailed description of the part numbering scheme of Serial EEPROM products. The part numbering scheme consists of a maximum of 13 digits grouped into nine fields (A to H) as shown in Table 1: Serial EEPROM part numbering scheme on page 1<Blue>Table 1.. Fields A to C represent the product identifiers and fields D to H the product options. The - character is used to separate the identifiers from the options. Table 1. Serial EEPROM part numbering scheme Digit Field Use 1st A Product line ( M = memory) 2nd 3rd 4th 5th 6th B C Device type (Product family) Device function (Memory capacity) 7th - Dash, to separate the product number identifiers from the product option designators 8th D Operating range (V CC ) 9th 10th E Package type 11th F Device grade (Temperature range) 12th G Option 13th H Plating technology An additional / followed by two digits are used by ST to aid traceability, and might appear on some documents at the bottom of the Ordering information scheme table under Process. This information offers the die and technology references (for temperature range 3 devices) and can be ignored for temperature range 6 devices. Table 2. Product line code Field A, 1 st character, product line Product line type M Memory April 2008 Rev 3 1/5 www.st.com

Table 3. Field B, 2 nd and 3 rd characters, product family Family code Memory type Family 93 MICROWIRE 24 Non-volatile memory I 2 C 95 SPI 33 MICROWIRE 34 Application-specific memory Non-volatile memory I 2 C 35 SPI Table 4. Field C, 4 th, 5 th and 6 th characters, memory capacity Capacity Microwire (M93) I²C (M24) SPI (M95) 1 Kb C46 C01 010 2 Kb C56 C02 020 4 Kb C66 C04 040 8 Kb C76 C08 080 16 Kb C86 C16 160 32 Kb - C32 320 64 Kb - C64 640 128 Kb - 128-B 128 256 Kb - 256-B 256 512 Kb - 512 512 1 Mb - M01 M01 Table 5. Field D, 8 th character, V CC range Voltage range code Memory Voltage range Blank W R F Serial EEPROMs 4.5 V to 5.5 V 2.5 V to 5.5 V 1.8 V to 5.5 V 1.7 V to 5.5 V 2/5

Table 6. Field E, 9 th and 10 th characters, package (two letters used in every case) Package code Package type BN DW DS DL MN ML MW MB PSDIP8 standard TSSOP8 TSSOP8 3 3 mm (MSOP8) TSSOP14 SO8 narrow 0.150 mils SO14 SO8 wide 0.200 mils UFDFPN8 (MLP8) Table 7. Device grade Field F, 11 th character, temperature range 1 0 C to 70 C 3 Temperature range 40 C to +125 C, with a certified reliability flow tailored for the automotive industry 6 40 C to +85 C Table 8. Option code Field G, 12 th, packing option Option Blank T Table 9. Code P or G Standard packing Tape and reel packing Field H, 13 th, plating technology Plating technology ECOPACK (RoHS compliant) For complete details of the correct product number, and ordering codes, for a specific product, please contact your nearest ST sales office or distributor. 3/5

Revision history AN626 Revision history Table 10. Document revision history Date Revision Changes June-1998 1.0 First Issue. 22-Nov-2004 2.0 15th digit concerning Plating option added in Table 1: Serial EEPROM part numbering scheme. Tables 3, 5, 5, 6 updated and Table 9: Field H, 13 th, plating technology added. 25-Apr-2008 3 Document reformatted. All tables updated. 4/5

Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries ( ST ) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. UNLESS OTHERWISE SET FORTH IN ST S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER S OWN RISK. Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. 2008 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 5/5