TYPICAL SWITC ORDERING EXAMPLE JW L R C A M L RATINGS TV5 Rated 0A @ 5/50V AC TV8 Rated 6A @ 5/50V AC ARRIER TYPES R No arrier With arrier OUSING COLORS A lack POLES SPST SPDT * DPST DPDT * DPST must have international ON-OFF symbols for VDE approval. CIRCUITS ON NONE OFF ON NONE ON A C CAP COLORS lack Red INSCRIPTION ORIENTATION No No inscription Code orizontal Vertical These are inscriptions for Single Throw models only. ARRIER COLORS A lack Colors are for arrier type only IMPORTANT: Standard markings: TV Rating, UL, CSA, & VDE. Specific models & ratings for international approvals noted on General Specifications page. DESCRIPTION FOR TYPICAL ORDERING EXAMPLE JWLRCA Red Rocker Cap with International ON-OFF Symbols in Vertical Orientation DPST ON-NONE-OFF Circuit lack ousing TV8 Rated 6A @ 5/50V AC NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0
GENERAL SPECIFICATIONS Electrical Capacity (Resistive Load) Power Level: 0A @ 5/50V AC for JWM models 6A @ 5/50V AC for JWL models Other Ratings Contact Resistance: 0 milliohms maximum for JWM; 0 milliohms maximum for JWL Insulation Resistance:,000 megohms minimum @ 500V DC Dielectric Strength:,000V AC minimum between contacts; 4,000V AC minimum between contacts & case Mechanical Life: 5,000 operations minimum Electrical Life: 5,000 operations minimum Nominal Operating Force: JWM Single Pole 340 grams & Double Pole 70 grams JWL Single Pole 360 grams & Double Pole 690 grams Angle of Throw: 6 Materials & Finishes ousing/frame: arrier: Interior Seal: Case/ase: Movable Contacts: Stationary Contacts: Terminals: Polyamide Polyamide Polyphenylene sulfide Phenolic resin Silver alloy with silver plating Silver alloy with silver plating rass with silver plating Environmental Data Operating Temp Range: umidity: Vibration: Shock: Process Seal: -5 C through +70 C (-3 F through +58 F) 90 ~ 95% humidity for 96 hours @ 40 C (04 F) 0 ~ 500z with peak-to-peak amplitude of.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for hours 50g acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Dust resistant inner seal Installation Soldering Time & Temperature: 3 seconds @ 350 C Standards & Certifications Flammability Standards: UL Recognized: CSA Certified: VDE Approved: UL94V-0 for housing/frame & case/base of JWL models All JWM models recognized at 0A @ 50V AC, TV5 & all JWL models recognized at 6A @ 50V AC, TV8; 5A @ 7V DC; UL File No. E4445 All JWM models certified at 0A @ 50V AC, TV5 & all JWL models certified at 6A @ 50V AC, TV8; CSA File No. LR3535 All JWM models approved at steady state 5A, inrush 80A, resistive 0A, & motor load 6A all at 50V AC; VDE License No. 68746; all JWL models approved at steady state 8A, inrush 8A, resistive 6A, & motor load 8A all at 50V AC; VDE License No. 6493 Note: JWM & JWL Double Pole, Single Throw models approved only with the international on-off symbols on the actuator. NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0
RATINGS M L TV5 Rated Power Level 0A @ 5/50V AC TV8 Rated Power Level 6A @ 5/50V AC Note: See Engineering Particulars page to find complete explanation of TV ratings. POLES & CIRCUITS Rocker Position Connected Terminals Throw & Schematics Pole Model Down Center Up Down Center Up Note: Terminal numbers are shown on the switch. Actuator positions oriented with switch part number facing front. SP JWM JWL ON NONE OFF -b OPEN OPEN SPST SP JWM JWL ON NONE ON -b OPEN -a SPDT DP JWM JWL ON NONE OFF -b -b OPEN OPEN DPST DP JWM JWL ON NONE ON -b -b OPEN -a - DPDT a () b () a b () b () b b b ARRIER TYPES & COLORS R No arrier With arrier arrier Material: Polyamide Finish: Matte No-barrier type R has a flat flange which is an integral part of the switch. This housing is molded polyamide matte finish material. arrier type designates that either AT7 (for JWM) or AT8 (for JWL) is factory assembled. Dimensions for barriers are shown in the Accessories section. arrier Colors Available: A lack CAP COLORS Cap Material: Polyphenelene Oxide Finish: Matte Cap Colors Available: Rocker cap is an integral part of the switch and not available separately. A lack C Red NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0
INSCRIPTIONS No Code No Inscription Inscription for orizontal Mounting Inscription for Vertical Mounting DPST models without inscriptions do not have VDE approval. The IEC symbols for On-Off are supplied with Single Throw models only. Orientation of inscription must be selected. Inscription Colors: lack ink on or cap. White ink on lack or Red cap. Contact factory for other inscriptions. OUSING Material: Polyamide Finish: Matte A Colors Available: lack C Red PANEL CUTOUTS For JWM Rockers For JWL Rockers Panel Thickness Range: (4.0).945 (9.5).6 Without arrier:.0mm ~ 4.0mm (.039" ~.57") With arrier: 0.6 mm ~ 3.mm (.04" ~.6") (5.4).606 (0.5).807 TERMINALS Epoxy Seal (0.6) R.04 (.6).063 (3.).6.95 (.8).0 Thk = (0.5).00 Wiring for JWM Solder Lugs.063" x.6" terminal hole accommodates solid or stranded 6-gauge wires. Epoxy Seal (.5) R.059 (0.65) R.06 (4.75).87 Thk = (0.5).00 (7.) (4.).83.65 (3.).6 Wiring for JWL Solder Lugs The pear shaped.8" dia. terminal hole accommodates solid 0-gauge wire or stranded 8-gauge wires. These solder lug terminals can be used with connectors; however, this switch assembly with connectors is not UL, CSA, or VDE approved. NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0
TYPICAL SWITC DIMENSIONS TV 5 No arrier 0 Amp (6.0).36 (5.0).59 (9.6).77 6 (6.4).646 (7.7) Typ.303 (.6).890 b b a (7.0).063 JWMRCA (3.6).535 (8.0).709 (.0).079 (.5).847.95 (0.5) Typ.00 (6.).44 (5.4).606 (.8) Typ.0 TV 5 With arrier 0 Amp (5.0).59 (9.6).77 (5.0).984 (7.7) Typ.303 (.6).890 b b (30.0).8 a JWMAA- (3.6).535 (8.0).709 (.).874 (7.).83 (8.9).744.95 (0.5) Typ.00 (6.).44 (5.4).606 (.8) Typ.0 TV 8 No arrier 6 Amp (7.0).76 (0.0).787 (4.4).96 6 (0.).795 (9.8) Typ.386 (8.0).0 b b a (3.0).60 JWLRCA (7.6).693 (3.0).906 (.0).079 (4.0).945 (7.).83.95 (0.8) Typ.03 (9.0).354 (0.5).807 (4.75) Typ.87 TV 8 With arrier 6 Amp (0.0).787 (4.4).96 (9.0).4 (9.8) Typ.386 (8.0).0 b b (35.0).378 a JWLAA- (7.6).693 (3.0).906 (7.).07 (8.5).3 (.4).843 (7.).83.95 (0.8) Typ.03 (9.0).354 (0.5).807 (4.75) Typ.87 Single pole models do not have terminals,, & b; single throw models also do not have a &. NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0
WATERTIGT OOT AT46 Splash Cover for JWL Rocker Lid: Clear Polyvinyl Chloride ase: lack Polyamide Recommended Temperature Range: -0 C ~ +70 C (+4 F ~ +58 F) Loses pliability below 0 C (3 F) Recommended Panel Thickness: 0.8mm ~ 3.4mm (.03" ~.34") (4.0).654 (.).874 (8.6).339 (.6).0 (33.0).99 Top Side ottom Assembly Instructions: Switch Groove () Insert bottom of switch through the base until the tabs lock into place. () Snap the switch into the panel. Lid ase (3) Seat the lid into the grooves of the base. Groove NKK Switches email: sales@nkkswitches.com Phone (480) 99-094 Fax (480) 998-435 8-0