EUROPEAN ETS 300 825 TELECOMMUNICATION October 1997 STANDARD Source: DECT Reference: DE/DECT-060100 ICS: 33.020 Key words: Card, DAM, DECT, GSM Digital Enhanced Cordless Telecommunications (DECT); 3 Volt DECT Authentication Module (DAM) ETSI European Telecommunications Standards Institute ETSI Secretariat Postal address: F-06921 Sophia Antipolis CEDEX - FRANCE Office address: 650 Route des Lucioles - Sophia Antipolis - Valbonne - FRANCE X.400: c=fr, a=atlas, p=etsi, s=secretariat - Internet: secretariat@etsi.fr Tel.: +33 4 92 94 42 00 - Fax: +33 4 93 65 47 16 Copyright Notification: No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 1997. All rights reserved.
Page 2 Whilst every care has been taken in the preparation and publication of this document, errors in content, typographical or otherwise, may occur. If you have comments concerning its accuracy, please write to "ETSI Editing and Committee Support Dept." at the address shown on the title page.
Page 3 Contents Foreword...5 1 Scope...7 2 Normative references...7 3 Definitions, abbreviations and symbols...7 3.1 Definitions...7 3.2 Abbreviations...7 3.3 Symbols...8 4 3 V technology...8 4.1 3 V technology DAM...8 4.2 3 V technology impact...8 4.3 3 V technology DAM identification...8 4.4 3 V technology PE...8 4.5 3 V Only PE...8 4.6 Activation and deactivation...9 4.7 Supply voltage switching...9 4.8 Cross compatibility...9 4.9 Outlook...9 5 Electrical specifications of the DAM-PE interface...9 Annex A (informative): Cross compatibility aspects...10 History...11
Page 4 Blank page
Page 5 Foreword This European Telecommunication Standard (ETS) has been produced by the Digital Enhanced Cordless Telecommunications (DECT) Project of the European Telecommunications Standards Institute (ETSI). This ETS defines the aspects of the DECT Authentication Module - Portable Equipment (DAM-PE) interface which is based on 3 Volt (3 V) technology to be used in the Portable Part (PP) within the DECT system. Transposition dates Date of adoption: 3 October 1997 Date of latest announcement of this ETS (doa): 31 January 1998 Date of latest publication of new National Standard or endorsement of this ETS (dop/e): 31 July 1998 Date of withdrawal of any conflicting National Standard (dow): 31 July 1998
Page 6 Blank page
Page 7 1 Scope This European Telecommunication Standard (ETS) defines the aspects of the Digital Enhanced Cordless Telecommunications (DECT) Authentication Module - Portable Equipment (DAM-PE) interface which is based on 3 Volt (3 V) technology to be used in the Portable Part (PP). It specifies the electrical and logical requirements necessary for the operation of the 3 V DAM-PE interface where it differs from ETS 300 331 [1]. For all aspects of the DAM-PE interface which are not covered by this ETS, ETS 300 331 [1] applies. This ETS is based upon ETS 300 641 [2] which specifies the same requirements for the 3 Volt Subscriber Identity Module (SIM). 2 Normative references This ETS incorporates by dated and non-dated reference, provisions from other publications. These normative references are cited at the appropriate places in the text and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this ETS only when incorporated in it by amendment or revision. For non-dated references the latest edition of the publication referred to applies. [1] ETS 300 331: "Digital European Cordless Telecommunications (DECT); DECT Authentication Module (DAM)". [2] ETS 300 641: "Digital cellular telecommunications system (Phase 2); Specification of the 3 Volt Subscriber Identity Module - Mobile Equipment (SIM - ME) interface (GSM 11.12)". 3 Definitions, abbreviations and symbols 3.1 Definitions For the purposes of this ETS, the following definitions apply: 3 V technology DAM: A DAM operating at 3 V ± 10% and 5 V ± 10%. 3 V technology PE: A PE operating the DAM-PE interface at 3 V ± 10% according to this ETS and 5 V ± 10% according to ETS 300 331 [1]. 3 V only PE: A PE only operating the DAM-PE interface at 3 V ± 10% according to this ETS. 3.2 Abbreviations For the purposes of this ETS, the following abbreviations apply: ATR CLK DAM DECT GSM IC I/O ME PE PP RST SIM Answer To Reset Clock DECT Authentication Module Digital Enhanced Cordless Telecommunications Global System for Mobile communications Integrated Circuit Input/Output Mobile Equipment Portable Equipment Portable Part Reset Subscriber Identity Module
Page 8 3.3 Symbols For the purposes of this ETS, the following symbols apply: t F t R V IH V IL V OH V OL Fall time Rise time Input Voltage (High) Input Voltage (Low) Output Voltage (High) Output Voltage (Low) 4 3 V technology 4.1 3 V technology DAM The DAM shall operate on both 5 V ± 10% according to ETS 300 331 [1], and on 3 V ± 10% according to this ETS. If the PE supplies 5 V to the DAM, both the PE and the DAM shall operate according to ETS 300 331 [1]. The logical operation of the 3 V technology DAM shall be as defined in ETS 300 331 [1]. Clock stop mode shall be supported by the DAM. The DAM shall indicate "Clock Stop Allowed" in the file characteristics of the status information as specified in ETS 300 331 [1]. 4.2 3 V technology impact The text of ETS 300 641 [2], subclause 4.2 applies, where "SIM" is replaced by "DAM". 4.3 3 V technology DAM identification The 3 V technology DAM shall contain an identification. The identification is coded on bit 5 in byte 14 of the status information as follows: "0" = 5 V only DAM; "1" = 3 V technology DAM. In the case that the PE offers full compatibility by being able to operate the DAM interface at both 3 V and 5 V, then bit 5 in byte 14 of the status information, when set to "1", indicates that the DAM may be operated at 3 V. The procedure for deriving the identification bit shall be performed by the PE immediately after the Answer To Reset (ATR) and before issuing any other command. The procedure consists of one command, either STATUS or GET RESPONSE. 4.4 3 V technology PE The text of ETS 300 641 [2], subclause 4.4 applies, where "GSM 11.11 (ETS 300 608)" is replaced by "ETS 300 331", "SIM" is replaced by "DAM" and "ME" is replaced by "PE". 4.5 3 V Only PE The text of ETS 300 641 [2], subclause 4.5 applies, where "GSM 11.11 (ETS 300 608)" is replaced by "ETS 300 331", "SIM" is replaced by "DAM", "GSM" by "DECT" and "ME" is replaced by "PE".
Page 9 4.6 Activation and deactivation The text of ETS 300 641 [2], subclause 4.6 applies, where "GSM 11.11 (ETS 300 608)" is replaced by "ETS 300 331", "SIM" is replaced by "DAM" and "ME" is replaced by "PE". 4.7 Supply voltage switching The text of ETS 300 641 [2], subclause 4.7 applies, where "GSM 11.11 (ETS 300 608)" is replaced by "ETS 300 331", "SIM" is replaced by "DAM" and "ME" is replaced by "PE". 4.8 Cross compatibility The text of ETS 300 641 [2], subclause 4.8 applies, where "SIM" is replaced by "DAM" and "ME" by "PE". 4.9 Outlook The text of ETS 300 641 [2], subclause 4.9 applies, where "SIM" is replaced by "DAM" and "ME" is replaced by "PE". 5 Electrical specifications of the DAM-PE interface The text of ETS 300 641 [2], clause 5 applies, where "GSM 11.11 (ETS 300 608)" is replaced by "ETS 300 331", "SIM" is replaced by "DAM" and "ME" is replaced by "PE".
Page 10 Annex A (informative): Cross compatibility aspects The text of ETS 300 641 [2], annex A applies, where "SIM" is replaced by "DAM" and "ME" is replaced by "PE".
Page 11 History Document history January 1997 Public Enquiry PE 9720: 1997-01-17 to 1997-05-16 July 1997 Vote V 9739: 1997-07-29 to 1997-09-26 October 1997 First Edition ISBN 2-7437-1759-9 Dépôt légal : Octobre 1997