DW-007FIT+ -1-
Congratulations with your Multi sport E-ink watch! All activities are displayed on the APP after synching with the data from the wristband. Please read this manual carefully and check the FAQ if needed. Please note: the screenshots below differs from versions of the APP due updates of the new versions. 1. Specification: Display 1.28 inch 128*128 pixel E-ink display Waterproof IP67 waterproof Charging 3 point connect charge DC 5V/0.5A Function Dynamic heart rate measurement, sleep monitor, activities reminder, pedometer, distance, calorie, remote camera control, call remind, SMS notifications from social media. Compatible with below versions: Apple Store: IOS 8.0 & above Google Play store: Android 4.4 and above Support Bluetooth 4.0 Notice: IP67 standard means under normal temperature, product could be in 1m deep water last for 30 minutes. Please pay attention to following two points: 1. IP67 means that it can pass the test of soak 30 min in 1m deep water, but doesn t mean to swim without being affected. 2. IP67 means that it can keep working under 1 m deep water within 30 min, but doesn t mean vapor proof, so you may find the steam in screen after shower, because waterproof standard is based on cold water. 2. Device activate & charger 1. Charge the watch for 1 hour before using it. 2. Make sure that the watch is full charge in order to work properly. Once the device with low battery status, please charge the device with the charger. Clamp the charging clip to the 3 point positioned on the back of the watch. -2-
3. Device Charging Please place the Magnetic Charging Cable on the back of the watch (as shown in the figure ).Plug it into the power adapter, or 5V/500mA(or above) standard USB adapter. For example: Laptop USB adapter Bank Power and others. When wristband screen appears icon,which means is being charged. Place the Magnetic Charging Cable on the reverse side. 4. Download Application Before connecting with the app Linksmart, please make sure the Bluetooth connection of your mobile device has been enabled. To use LinkSmart APP, make sure your mobile device is connected to the internet via Wi-Fi / 4G/ 3G. 1. Apple iphone (IOS 8.0 and up), please search LinkSmart in the App store to download/ install it. 2. Android phone (4.4 and up), please search LinkSmart in Google Play to download and install it. Download the app by either scanning the QR code below or search for LinkSmart and download in the Apple Store or Google Playstore. -3-
5. Wear the device A. Press and hold the screen until the display will switch on (If there is still no response, please try again after charging) B. Put the watch on the wrist with the screen facing up. Make sure it fits well for accurate results. 6. Pair the device On your mobile device make sure the Bluetooth is enabled. Power on the watch Open the APP Linksmart, Click the Device In the bottom of main interface. In the bottom of Device,click the Add device. For example: The watch ID code is 3892 in the Bracel03-3892. Notice: If connection problems occur and the APP keeps showing pairing but cannot pair successfully. Please power off the watch first.then power on the watch,long press the code,the watch will vibrate three times. Connect the APP again. -4-
7. Function icons: Badminton Basketball Body mechanics Climbing Cycling Dance Fitness Football Plank Pull-up Push-up Sit-up Shuttlecock Running Skating Skipping Yoga Table Tennis Tennis Volleyball Bowling Mountaineering Skiing Sedentary reminder Heart rate Steps Distance Calories Message Function Training Schedule music Power off Camera Alarm clock Remote camera -5-
5. Function schematic diagram: A. Operation mode: touch or slide screen, hold and long press to confirm. B. Operate the watch Left & Right Up & down Press and hold to start Press and hold to end Long Press 6. Synchronize data Icon Function Operation Dial pictures optional Test heart rate automatic. Find your phone Long press and slide to choose dial pictures. Long press to shift on/off. Long press -6-
The Watch synchronizes data automatically after pairing/connecting with your smartphone. Syncing data includes steps, calorie, distance, date and time. To synchronize, please click the above left corner to synchronize; it will take 1-2 minutes. When unable to synchronize data, disconnected the Bluetooth and retry to connect again. 7. Sleeping monitor The watch/device could detect and recognize automatically your sleeping status and monitors the whole sleeping progress. This device will analyze/tracks your sleeping quality based on the movements you make during night. Bad quality sleep > lots of movement Good quality sleep > little movements Note: you will need to wear the watch during the nighttime in order to get the results of your sleeping quality during the night. Enable the sleep monitoring in the app by going to the Device tab and then enable the sleep monitor, the watch will detect automatically if you are under sleeping mode. -7-
8. Calling and message reminder Go to [Device] tab, click [Device setting] to choose [ message push]. For Android smartphones, it will show you below, allow LinkSmart to send you notifications For IOS smartphones, you need to allow LinkSmart to send your notifications, once you download the app or go to phone Setting to allow the notifications. If it is unable to get these notifications when it is connected with your smartphone, please disconnected the device with the smartphone and disable the notification function. Then enable again. Call/message reminder Incoming call/messages (WhatsApp, SMS, etc.) will show on the watch screen and will vibrate. Once enabled the function, the name of the caller will show on the screen. For messages, you will see the name of the sender and the content of the messages -8-
9. Alarm and activity/sedentary reminder Set alarm by going to Device tab in order to add alarm. The watch will vibrate to remind you. To remind you to be active after (adjusted) period without any movements, please enable sedentary reminder in the Device tab in order to adjust the setting according to your preference. 10. (Remote) Camera Control By going to the Device tab, you can click on Camera. You will see a circle icon on the screen of the app. By touching/press on the icon, you can control the remote of making photos. 11. Sports type Go to the [Activity] tab, click on the + to add sport type. Or go to [Device] interface, click on the [Target setting]. You can choose any five type of sports. You can set an exercise goal and reminder. 12. Check day/week/month activity data -9-
Go to [Home] tab to check each day activity date ( step /sleeping quality/heart rate,etc). Click the above right corner to check your week/month activity date: 13. Total/average activity data Go to App [Me] interface to check your total and average activity data -10-
14. Device setting Go to App [Device] tab, check tracker information details. Go to [Device setting] to customize your watch. -11-
FAQ Q:After connecting the watch with the APP, the data sync is finished but the watch time display is still incorrect? A:Go to the [Device setting],click sync time function then time display will be correct. Q:The caller ID is not displayed on the watch For Android: After being connected with the watch with APP, please allow Linksmart to receive calls,sms,contacts and keep Linksmart running in background. If there are security softwares on your phone,set up the software Linksmart as trust. IOS:If no Call ID display,please restart your mobile and connected the watch again.when it is connected,please wait until the phone pops up Bluetooth pairing request and click pair, then the Call ID display function comes. Q: The watch icon shows the bluetooth was connected, but the APP can t sync data? A:It is caused by the bluetooth of the phone in general.please switch off the APP first, restart the bluetooth and repair. If the above step does not work, please restart your phone and try again. Q:Why is only walking displayed in my daily activity? A: Walking shows every day as default,other sports need to be added in (Linksmart) APP. You can add five sports types at most every day. Sports types show on watch after added in APP by manual. (Please make sure height and weight is not zero in setting, make sure the date you choose including today ) Precautions Prolonged exposure may cause skin irritation or allergic to some users. If you find any skin redness,swelling, itching or other allergic symptoms, please discontinue use or wear over clothing. Continue to use, even after the symptoms subside, If symptoms recur even worse. If symptoms persist, please consult your doctor. This product contains electronic components may cause injury if not done correctly. This product is non-medical equipment, not for diagnosis, treatment or prevention purposes. In driving or other potentially dangerous situation due to distractions, do not view call notifications or other data. This product is not a toy. Do not allow children or pets touch your products and services. This product contains small parts that may cause smothering interest rate risks. Nursing and wear Considerations -12-
Periodically clean, especially the parts in contact with the skin. Use a clean, moist cloth. Wear loose, to ensure that the air circulation. Remove the product from time to time, in order to clean, but also let the skin breathe. Do not open the housing or demolition. If the display is broken, do not use. This product and its battery contains substances may be harmful to the environment, but also may be due to damage caused by improper handing or operation. Do not place the product in the washing machine or drying machine. Do not expose your product to extremely high or low temperatures. Do not sweat in the sauna or steam room to use the product. Do not make the product for a long time by the direct sunlight. Do not place the product in a fire process. The battery may explode. Do not use abrasive cleaners to clean the product. If the product gets wet, do not charge. If you feel Product in the heat, remove it. Built-in Battery Precautions Product is equipped with built-in battery, the user can not replace. Product damage, or attempt to open the product will void the warranty and could pose security risks. Use certified by a recognized test computer charging treasure or power to charge the battery. Charge the battery in accordance with the instruction in this guide. -13-