>> >> >> Note : Table of contents. Introduction --------------------------------------- 0. Installation. Usage Illustration ---------------------------. Installation Steps --------------------------- 0 0. Product Specification. Output Specification -----------------------. Power Supply -----. Trouble Shooting ------------------------------- 05 08 0
>> 0 >> 0. Introduction. Trouble shooting We live up to the promise of Thermaltake logo in our unending quest for excellence. Shall you have any suggestion or comments, please access our web site : http://www.thermaltake.com or e-mail to : thermaltake@thermaltake.com we appreciate your kindly feedback and you will receive the prompt response from our customer service team. Thank you for choosing a quality Thermaltake Purepower 500W PC Power Supply. We trust that you will find it providing you with many years of service. You can always find a Thermaltake PC Power Supply that is suitable for all of your modern PC power needs. Please take the time in familiarize yourself with the power supply, its connectors and the contents of this manual before proceeding with the installation of the power unit. You will need a Phillips crosshead screwdriver, perhaps your PC case manual and most certainly your motherboard manual. Condition : No DC output. The fan or fans are motionless Check: - Is the AC inlet plug firmly plugged into the PSU inlet socket? - Is the wall socket, extension power cord, power strip or surge protector in use, fully functional and wall power switch turned 'ON'? - Is the Main Board socket (pin) plug fully and firmly inserted? Condition : The fan or fans began rotating and then stopped. The system hangs without proceeding any further. Check: - Are the peripheral connectors firmly plugged into accessory devices, such as the main hard drive, CD ROM, etc? - If a plug has been inadvertently connected in an off-set or reversed position, unplug the AC power source, reconnect the offending connectors and then wait for 0 seconds before replug in the AC power source and try again. Note: If the power supply still cannot or is still unable to power up after following the above instruction, please send the unit back to your dealer or retailer for after sales service.
>> 09 >> 0 Technology Features Should you have any questions regarding the aforementioned steps, please contact Thermaltake cm Fan - High thermal performance New (0) pin Main Dual +V Rails directly. Failure to follow the proper procedures may cause sever bodily harm or PC component damage. For Support or General Inquiries, please contact us at: 6 pin PCI- 5-pin S-ATA Express Cable Application Mirror Coating Thermaltake Technology USA Toll Free: (800)988-088 Email: support-usa@thermaltake.com Total Output X X X8 X X -pin Main Max. Load Min. Load Load Reg. Ripple V(p-p) 50 -pin +V Power 50 -pin Peripheral Power -pin Floppy Drive 5-pin S-ATA X 6-pin PCI Express +. V + V + V - V SB A A A 5 A 0. A A 0.5 A 0.5 A.0 A.0 A 0.0 A 0.0 A +5% ~ -5% +5% ~ -5% +5% ~ -5% +5% ~ -5% +0% ~ -0% +5% ~ -5% 00 00 Intelligent Cable Management: > cable sleeving >Optimum air-flow 50 50 5 Thermaltake Europe B.V. Tel:+-0-09-050 Email: johnnyhsu@thermaltake.com.tw Thermaltake Beijing Co.Ltd. Tel:+86-0-88859/89 ext.6 Email: doctort@thermaltake.com.cn Thermaltake Australia and New Zealand Pty Ltd Tel:+6-976-6 Email: sales@thermaltake.com.au Thermaltake Japan Inc. Email: sales-jp@thermaltake.co.jp
Installation >> 0. Usage illustration Features: >> 08. PSU Specification.. Do not pull the AC power cord when the power supply is in use or else damage to components will result... Do not store the Power Supply in a high humidity and high temperature environment... When using an ATX type power supply under testing conditions where the power supply unit is not installed in a PC with its components, please follow the steps below: )Please take a paper clip and untwist it. )Make sure the power supply unit is in the "OFF" position. )Locate the 0 or pin motherboard connector from the power supply unit. )Plug one side of the paper clip into the green wire hole. 5)Plug the other side of the paper clip into any of the black wire holes. 6)Turn on the PSU to see if the power supply fans turn on... High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. -Complies with ATX V.0 Version. -Supports 6-pin PCI-Express, S-ATA, and 0+ pin connector. -PFC function, improved energy efficiency and reduced current load on AC delivery systems. -Low noise cm fan and mirror effect housing. -Protections against Input SPECIFICATION Protection, Over Power, P/N W000 Over Voltage, Short-Circuit, Maximum Power 500 Watts and No Load Operation. Color -Safety / EMI Approvals: ATX Logic on- off additional power Switches rocker switch(5/0 V selector switch) UL, CUL, TUV, FCC, and PFC (Power CB certification. Factor N/A Correction) One cm Fan: SPEED : 00 RPM(+/-0%) DIMENSION : 0 x 0 x 5 mm Cooling System TEMP. AUTO CONTROL 55 rpm at 8.6C~9 rpm at 6.8C Noise 7dB at 00 RPM P. G. Signal 00-500 ms Over Voltage +5V output 6.5 0.75V Protection +.V output.0 0.0V Recycle AC to Reset +V output 5.0 0.6V..5 All warrantees and guarantees shall be voided should there be a failure to comply with any of the warnings and cautions covered in this manual. cm Fan Design - Optimum Air flow and Lowe Noise Unit Size Net Weight Input Voltage Input Frequency Range Input Current Hold-up Time Efficiency DIMENSIONS cm(l)x5cm(w)x8.6cm(h).68 kg INPUT 5 VAC / 0 VAC 7 ~ 6 Hz 9.0A / 5.0A 8ms(minimum) at 80% > 70%
>> 07 >> 0. Installation steps Serial ATA Power +VDC +5VDC +.VDC 5 To prevent electrical shocks, please disconnect the power cord from your existing power supply unit. PSU has Voltage Selector which will change to 5V / 0V. Installation Steps.. Disconnect the power cord from your old power supply... Follow your computer case manual and disassemble the case... Disconnect all the power connectors from the motherboard and from the peripheral devices such as case fans, hard drives, floppy drives. etc... Remove the existing power supply from your computer case and replace it with your new Thermaltake Purepower 500W PSU...5 Connect the power connectors to the motherboard and peripheral devices (refer to the rest of this manual to match the various one-way key-locked connectors to the motherboard and accessories)...6 Connect the 6-pin PCI Express connector to PCI Express graphic card i f you need. Note: Please read the user manual supplied with your graphic card for detail usage instructions...7 Close the computer case...8 Make sure your power supply switch is on "OFF" position, and Connect the supplied power cord to your Thermaltake PSU.
>> 05 >> 06. Product Specification. Output specification Main Power 0 9 8 7 6 5 0 9 8 7 6 5 Voltage +. V +. V PWR_ON sb + V + V +. V Color Gray Purple 5 6 7 8 9 0 5 6 7 8 9 0 Color Blue Green N/C Voltage +. V - V PS_ON# N/C +V connector ( pin) +VDC +VDC Peripheral connector ( pin) +VDC PCI Express connector (6 pin) VDC +5VDC V DC V DC 5 6 Floppy disk connector ( pin) +5VDC +VDC