Volume: 182 Questions Question No : 1 A network architecture team is looking for a technology on Cisco Nexus switches that significantly simplifies extending Layer 2 applications across distributed data centers. The team wants the Cisco Data Center Interconnect between sites and without changing or reconfiguring the existing network design. Which technology should be used? A. Multiprotocol Label Switching B. Cisco FabricPath C. virtual switching system D. virtual port channel E. Overlay Transport Virtualization Answer: E Question No : 2 Which three devices support FCoE? (Choose three.) A. Cisco Nexus 5500 B. Cisco Nexus 7000 C. Cisco Nexus 3000 D. Cisco Nexus 1000V E. Cisco UCS Fabric Interconnect Answer: A,B,E Question No : 3 Which is the maximum number of active zone sets on Cisco MDS 9500 Series Fibre Channel Switches? A. 1 with all licenses
B. 2 with Standard Zoning license C. 3 with Enhanced Zoning license D. 4 with Enterprise Zoning license Answer: A Question No : 4 In a large enterprise, which two SAN switches are ideal core switches for providing high availability? (Choose two.) A. Cisco Nexus 5548 B. Cisco MDS 9710 C. Cisco MDS 9509 D. Cisco Nexus 7028 E. Cisco MDS 9222i Answer: B,C Question No : 5 A network engineer wants to enable a FCoE feature on a Cisco Nexus 5500 Series Switch. When does that occur? A. after the configuration is saved and rebooted B. after the configuration is saved C. after at least one port is configured to operate in FCoE mode D. after the license is applied Answer: A Question No : 6 In a Cisco Nexus 7009 switch with three N7K-F248XP-25E modules, what is the minimum number of
Fabric-2 modules needed to support full utilization of all the installed ports? A. 2 B. 3 C. 4 D. 5 E. 6 Answer: D Question No : 7 Where does the data plane operate on a Cisco Nexus 7000 Series Switch? A. unified crossbar fabric B. unified port controller C. supervisor module D. Policy Feature Card E. Connectivity Management Processor Answer: A Question No : 8
The Cisco Nexus 7000 Switch supports feature-based Licenses for various protocols. On Nexus-7010-PROD-A Switch, which package (PKG) applies to OTV? A. MPLS_PKG B. TRANSPORT_SERVICES_PKG C. FCOE-N7K-F132XP D. OTV_LICENSE_PKG
Answer: B Question No : 9 Refer to the exhibit. Which two pieces of configuration information about interface Ethernet 1/10 can the engineer determine? (Choose two.) A. It runs at 10 Gbps. B. It is part of a logical port channel interface. C. It is configured as a point-to-point interface. D. It is administratively down. E. It uses a nonstandard MTU size. Answer: A,B Question No : 10 Customer is configuring FCoE and NPV in their Data Center on Cisco Nexus 5000 Series Switches. Please go through the Topology and Exhibit 1 through 4 to answer the following questions. Topology:
Which two statements are true regarding disruptive load balancing and regarding the configuration in this example? (Choose two). A. In this scenario disruptive load balancing is disabled. B. In this scenario disruptive load balancing is enabled. C. Since FCID: 0x1c0000 is reserved, disruptive load balancing is not configured correctly. D. When disruptive load balancing is enabled, NPV redistributes the server interfaces across all available NP uplinks when a new NP uplink becomes operational. To move a server interface from one NP uplink to another NP uplink, NPV forces reinitialization of the server interface so that the server performs a new login to the core switch.
Answer: A,D Question No : 11 Refer to the exhibit. An engineer has configured a primary fabric interconnect with this configuration. Which two pieces of information are needed to guarantee high availability and fail over for the secondary fabric interconnect for the cluster? (Choose two.) A. Cisc0123! B. 10.10.10.10 C. 10.10.10.1 D. 10.10.10.16 E. 10.0.10.25 F. Fabric-A Answer: A,B Question No : 12 A network engineer needs to add four native Fibre Channel ports to a pair of UCS fabric interconnects. What two items would be the result of the engineer configuring four universal ports in the fabric interconnect expansion card for storage mode and selecting apply? (Choose two.) A. The fabric interconnect port module reboots. B. The fabric interconnect reboots.
C. The ports immediately transition to storage ports. D. The ports are reconfigured as Fibre Channel storage ports. E. The ports are reconfigured as Fibre Channel host adapter ports. Answer: A,D Question No : 13 What is the role of FIP in FCoE enabled Storage Area Networks? A. uses a dedicated EtherType of 0xFFFF B. discovers and initializes converged network capable devices connected to an Ethernet cloud C. reduces the number of network interface cards required to connect to disparate storage and IP networks D. reduces the number of cables and switches Answer: B Question No : 14 Which is a key characteristic of virtual device contexts? A. allowing logical switches to be aggregated into a single physical switch B. allowing logical switches to be aggregated into multiple physical switches C. allowing physical switches to be partitioned to a single virtual switch D. allowing physical switches to be partitioned to multiple virtual switches Answer: D Question No : 15 Which three are features of Cisco OTV? (Choose three.) A. control plane-based MAC learning