Kendo M Wet RG Extruded aluminum linear illumination system, Kendo M Wet is available in sections up to 116. Specifically designed LED engine provides constant illumination levels from the beginning to the end of the runs. Kendo M Wet is suitable for cove lighting, architectural accents, and many other applications. lass 2 listed for wet locations. 0.73 0.79 0.67 0.63 with frosted narrow lens with frosted medium lens with clear, half frosted, and frosted linear lens with fixed mounting clips and linear lens 0.9 IP67 90 90 0.93 0.82 Finish options djustable mounting bracket allows 90 tilt in both directions. dimmable lack ronze Silver anodized White Technical information Output Options Output type Lumens verage power consumption at 4 Maximum system length chievable via feed through fixture wiring. Operating Voltage Operating Environment Temperature RG 98 lum/ft 4.45 W/ft* 30 24VD -30 to 50 *with all 3 circuits at full brightness Ordering code KMW KMW - Kendo M Wet LENGTH 12 12-116 increments OlOR OUTPUT LENS MOUNTING FINISH RG RG - Red, Green, & lue MO MO - Medium - lear F - Frosted M - Medium N - Narrow - djustable F - Fixed S S - Silver K - lack Z - ronze WH - White (K,Z,WH finishes will have an upcharge and require longer lead times) POWER FEED F1 F1 - wire leads F2 - wire leads at one end and quick connect at other - Single quick connect F4 - Dual quick connect page 1 of 5 www.luminii.com tel: 224-333-6033
Kendo M Wet RG Power consumption per fixture length* *with all 3 circuits at full brightness MO Nominal Length ctual Length W/ft Total wattage 12 13-2/16 4.60 4.60 16 17'' 4.60 6.10 20 20-14/16'' 4.60 7.60 2 24-14/16'' 4.55 9.10 28 28-12/16'' 4.55 10.50 32 32-11/16'' 4.55 12.00 36 36-10/16'' 4.50 13.50 actual length of assembled fixture 40 40-9/16'' 4.50 14.90 4 44-8/16'' 4.50 16.40 48 48-7/16'' 4.45 17.80 52 52-6/16'' 4.45 19.20 56 56-5/16'' 4.45 20.60 60 60-4/16'' 4.40 22.00 6 64-3/16'' 4.40 23.30 68 68-2/16'' 4.40 24.60 72-1/16'' 4.35 26.00 76 76'' 4.35 27.30 Power supply 80 79-15/16'' 4.35 28.60 8 83-14/16'' 4.30 30.00 88 87-13/16'' 4.30 31.30 92 91-12/16'' 4.30 32.60 96 95-12/16'' 4.25 34.00 100 99-10/16'' 4.25 35.30 10 103-8/16'' 4.25 36.50 108 107-7/16'' 4.20 37.80 112 111-7/16'' 4.20 39.00 116 115-6/16'' 4.20 40.00 See fixture and power supply instructions & spec sheet for wiring information. Dimming possible in select models - view Luminii website for list of compatible dimmers. Non-Dimming: POWER OUTPUT DIMMING LOTION PSV PSV - PSV Series 40 40-40 W 60-60 W 96-96 W 24V 24-24 VD - Requires a controller & a decoder to work properly U2ND U2ND - Non Dimming S D D - Dry Location IP65 - Wet Location PSV Dry PSV Wet Length Width 9.2 3. 9.5 4.12 Depth 1.9 2.3 DMX: POWER OUTPUT PSDMX PSDMX - DMX Power Supply dims down to 0% 3X100 3X100-3 X 100 WTT 24 24-24 VD S PSDMX - Features eldoled s LINERdrive configurable dimmable drivers Length 15.75 Width 6.60 Depth 4.80 page 2 of 5 www.luminii.com tel: 224-333-6033
Kendo M Wet RG onnectors Male quick connect end #WET-ON-MLE-4PIN Female quick connect end #WET-ON-FEMLE-4PIN Lead wires end Powerfeed options with fixed bracket Powerfeed options with adjustable bracket -F1 -F1 -F2 -F2 - - -F4 -F4 ccessories Splice ox: Wet rated, low voltage splice box, gray 2.6 Part # LVSP-WET 2.6 2.2 onnector: Low voltage splice box wet cable management gray Part # LVSP-WET-M 0.87 1.3 Sample layout of powerfeed connections 24 VD power supply F4 F2 Maximum System Length page 3 of 5 www.luminii.com tel: 224-333-6033
Kendo M Wet RG Touch DMX ontroller Touch screen digital LED controller Programmable advanced DMX512 lighting controller featuring a touchscreen interface. Operates as stand alone controller or integrated with most architectural lighting control systems. an controller endless DMX512 enabled devices. Mounts to standard single or dual gang wall box with the included power supply inside the junction box. Terminal block design for power and data connections. 5.00 Power supply 9 VD (included) Data programming US 2.0 computer connection required for initial setup Output signal DMX512 (1024 channels) Sound activation uilt in microphone olor parameters rightness Saturation Speed of color changing sequence Fading / dimming / brightness 0.4 6.56 ORDERING ODE Model TSDMX TSDMX - Touchscreen DMX controller DMX/Wireless RG-W ontroller RGW LED 1 or 3 Zone ontroller DMX /Wireless RG-W wall-mount controller controls DMX lighting fixtures, wireless control of RG-W lighting fixture or use both simultaneously. Fits in any standard US switch box. Includes all the outputs in the back of the controller. ontrol brightness levels with a single touch, personalize and memorize 3 different scenes, and even create 3 variations of white. Operating voltage 12-24V D Features 2 in 1 in-wall ontroller: DMX ontrol or Wireless RG-W 65,000 olor Options, Dimming and Speed ontrol Memory Function 50 Foot Wireless Range Easily Fits Standard US Switch oxes Touch Sensitive Glass Surface Includes 10 uilt in Programs, or reate and Play Your Own Ordering ode DMX DMX 3Z 3Z - Three Zone 1Z - One Zone RGW RGW - Red, Green, lue, & White olor parameters rightness Saturation Primary colors Fading olor changing speed page 4 of 5 www.luminii.com tel: 224-333-6033
Kendo M Wet RG DMX decoder DMX signal to RGW decoder (required to operate DMX controller) Translates controller DMX512 programs for RG and white LED strips. Unique DMX address for the decoder can be set easily and displayed by the numeric display on the case. hanging and resetting the DMX address requires manual input. Operating voltage 12-36 VD Power capacity up to 96W at 24V Operating temperature range from -4 F to +122 F in case Use power repeater to expand output. numeric display 1.75 ORDERING ODE 0.73 7.00 Model DDMX-RGW DDMX-RGW - DMX decoder page 5 of 5 www.luminii.com tel: 224-333-6033