Owner s Detailed Manual Thank you for purchasing ELECKEY E6. Please refer to this guide for all operation. Please contact us freely if you need any help. Email: eleckey@ieleckey.com 1 / 18
Table of Contents Layout...3 Quick guide... 4 5 Menu operation...6 10 Audio Recording System... 10 Supplement lamp...10 Automatic Recording... 10 Emergency Record Lock...11 Auto LCD OFF... 11 In case of emergency... 11 Playback on dash cam...11 15 Take a photo with dash cam...11 15 Lock or Delete the video file manually... 16 Parking Mode...17 Reset... 18 Installation... 18 Warranty... 18 Contact us... 18 2 / 18
Layout 3 / 18
Quick Guide 1. Install microsd card into the card slot with correct direction. Reminder: No memory card, Samsung Evo 32GB card is recommended. If you are using a 64GB card, please format it to FAT32 before use. 2. Slide the camera to the fixed plate and adjust proper vertical and horizontal positions. 3. Remove protection tape from the fixed plate and install plate on the windshield glass. (Rotate the position which showed on the below picture to make it locked) 4 / 18
4. Connect the power cord to charging port of the camera. 5. Connect the car charger to the cigarette lighter socket in your car. And then start your vehicle. Wish you enjoy with E6 recording system. Signals of Automatic Recording Mode show as below picture. 5 / 18
Menu Operation E6 is turning into the Automatic Recording Mode when the power is connected. Under the Automatic recording mode, the LCD. red led signal will flash on Press to stop recording. ( red led signal will disappear) And then press to active the Menu selection. 6 / 18
RESOULTION 2304*1296/30F 1920*1080/30F 1920*1080/30F(HDR) 1280*720/60F 1280*720/30F 2560*1080/30F Default setting: 2304*1296/30F VIDEO QUALITY QUALITY:S.Fine / QUALITY: Fine / QUALITY:Normal Default setting: QUALITY:S.Fine RECORD OVERWRITE 1MIN /3MIN/5MIN/OFF Default setting: 1MIN MOTION DETECTION OFF /ON Default setting: OFF POWER ON RECORD ON/OFF Default setting: ON POWER OFF DELAY 30SEC /OFF/10SEC/20SEC Default setting: 30SEC POWER ON DELAY OFF/10SEC/20SEC/30SEC Default setting: OFF MIC ON/OFF Default setting: ON TIME LAPSE OFF/1SEC/5SEC/30SEC Default setting: OFF LANGUAGE Default setting: ENGLISH 7 / 18
CAR NUMBER SET TV TYPE NTSC/PAL Default setting: NTSC AUTO POWER OFF 3MIN/5MIN/OFF Default setting: 3MIN AUTO LCD OFF 3MIN/OFF/30SEC/60SEC Default setting: 3MIN TIME SETUP Please active the Menu selection and then press TIME SETUP to find the Then press to active TIME SETUP operation. Please set the Year, Month, Date and Time one by one. You can change the setting by up and down button; And you can confirm it by button. 8 / 18
STAMP Default setting: DATE/TIME STAMP BEEP SOUND VOLUME:100% OFF VOLUME:20% VOLUME:40% VOLUME:60% VOLUME:80% Default setting: VOLUME:100% FLICKER 50Hz /AUTO/60Hz Default setting: 50Hz CONTRAST STANDARD /HARD/SOFT Default setting: STANDARD SHARPNESS STANDARD /HARD/SOFT Default setting: STANDARD WHITE BALANCE AUTO/SUNNY/CLOUDY/FLUORESCENT/INCANDESCENT Default setting: AUTO EV SETTING 0/0.3/0.7/1/1.3/1.7/2/-2/-1.7/-1.3/-1/-0.7/-0.3 Default setting: 0 G-SENSOR SET OFF/1/2/3/4/5/6/7 Default setting: OFF Recommended setting: 5 (Please set it to 5 before using) WDR ON/OFF Default setting: ON LDWS DETECT 9 / 18
OFF/ON Default setting: OFF LDWS CALIBRATION NO/YES Default setting: NO DEFAULT SETTING NO/YES Default setting: NO FORMAT NO/YES Default setting: NO FIRMWARE VERSION Default setting: ELB03FMHZDNE.170221.V1.1 After finishing the setting, press pause mode. to go back to Recording And then press to start Automatic Recording Mode. Audio Recording System Under the Automatic recording mode, if press down button, the audio recording system will pause. And you press down button again, it will start. Supplement lamp Under the Automatic recording mode, if press up button, the supplement lamp will turn on. And you press up button again, it will turn off. Automatic Recording The E6 is automatically configured to start recording anytime the power is received through the cigarette lighter plug. The camera will shut off a few seconds after power is turned off. It is set to automatically loop the SD card as well. The previous file will be automatically overwritten with the newest once the SD card is full. 10 / 18
Emergency Record Lock Seamless loop recording plus G-Sensor data protection automatically detect any impact and lock the important video segments so they are not overwritten or corrupted, preserving a complete record of the event, you will never miss an important moment. Note: Please set the value of G-sensor to 5 before using. Auto LCD OFF Auto LCD OFF after the recording begins so you won't be disturbed by another glowing rectangle on your windshield. In Case of Emergency The E6 is equipped with a built-in battery. In case of emergency, and in the event of a power loss, this will ensure the camera finishes recording the file and does not corrupt the SD card. In the event of an accident, or some other emergency case the quickest and easiest way to ensure you save the file is to power down the camera by disconnecting the power cord. The camera will shut off after a few seconds. The SD card can then be viewed with the supplier USB memory card adapter. Playback on dash cam and Take a photo with dash cam The dash cam under the Automatic recording mode Press to stop recording. Recording pause mode 11 / 18
Press to start Photo Mode You can take a photo by pressing under Photo Mode Press again under Photo Mode The system will log into system files Page as below picture. 12 / 18
And then Press to start Preview Mode You can select the video or picture by up and down button. Please select the last file which is shown on the screen and then press down button. The recording video files will show on the screen now.(they are hidden before this step) Please select the video that you want to view. And then press to start Full screen Mode. 13 / 18
Press mode. again under Full screen Mode to start the playback Press down under playback mode to start Fast forward. And press up under playback mode to start Slow motion. 14 / 18
Finish viewing and want to go back to Automatic recording mode 1.Press under system files Page or Preview mode, the system will go back to Recording Pause Mode. And then press to start Automatic recording Mode. 2. Long press for 3 seconds to turn the dash cam off; Pull out the charging cable from the dash cam. And then connect the charging cable to the dash cam again to start the machine and the system will automatically go to Automatic recording Mode. NOTE: This step is fit for any status when you want to go back to Automatic recording mode 15 / 18
Lock or Delete the video file manually Under the Preview mode You can lock the selected video file by pressing You can delete the selected video file by long press for 2 seconds. And then press the again to delete the file. 16 / 18
Parking Mode(Not commonly use) To use the parking mode, please connect it with an external battery because the battery of dash cam itself is small-capacity. Please connect the external battery to the dash cam and start the machine. And then active the Menu selection and then press MOTION DETECTION to find the And then press to active MOTION DETECTION operation. Please select ON and confirm it by pressing again. Then press, the system will go into Parking mode as below picture. Under the Parking mode, the camera will auto record when people or things come closer to your car from in front. And it will automatically stop recording when it senses no movement in 10 seconds. You want to finish Parking mode and go back to normally Automatic recording mode. Long press for 3 seconds to turn the dash cam off; Disconnect the charging cable from the external battery. And then connect the charging cable to the dash cam again from car cigarette lighter to start the machine and the system will automatically go to Automatic recording mode. 17 / 18
Reset Please reset all the setting by pushing the below position in case of system crash. Installation We recommend you install the dash cam behind of the rearview mirror as below picture so that you never see the LED indicator when driving. Wish you a wonderful experience with E6. Warranty We ELECKEY provide free warranty service for parts and labor within 12 Months from the date of purchase. Contact Us If you have any questions or comments, please feel free to contact us! Email: eleckey@ieleckey.com Web: www.ieleckey.com 18 / 18