Line LED LL series double row is a small profile high performance LED strip. The durable, but flexible products feature a heavier copper board core for better heat dissipation and even illumination over long runs. Available in double row configurations ranging from 72 to 108 LEDs per foot with multiple power feed and options. Line LED LL series double row feature outstanding color consistency with single binning and CRI up to 98. Mounting LLED strip is equipped with 3M self-adhesive tape. The strip must be adhered to either a Luminii aluminum profile or an unpainted aluminum surface. or other surfaces the HST Aluminum heat sink tape will be required to reach the rated 50,000 hours average life Applications Indoor only - above and below cabinets, cove lighting, counter accent, architectural reveals, under banister, display and book cases, etc. Approvals Class 2 damp listed Operating voltage 24 VDC Technical information Average life 50,000 hours Warranty 5 years LEDS/ft 72 108 Light output 3000K Average power consumption (for 15 section) 493 lum/ft 841 lum/ft 6.0 W/ft 10.0 W/ft Ordering increment 1.00 1.3 Maximum run length (in series) Dimensions 16 ft 10 ft 0.59 W 0.07 H 0.63 W 0.09 H CCT INO/LUMEN MULTIPLIER TM-30-15 Color temperature Multiplier (referenced from 3000K) CRI R f R g 2200K 0.87 82 81 99 2400K 0.73 98 95 101 2700K 0.81 98 95 102 2900K 0.86 97 95 102 3000K 1.00 91 90 101 3500K 1.05 95 90 97 4100K 1.28 93 88 96 SECTION START/END OPTIONS emale Male No Soldered leads (72 ) Ordering code COLOR TEMPERATURE 22K 22K - 2200K 24K - 2400K 27K - 2700K 29K - 2900K 30K - 3000K 35K - 3500K 41K - 4100K * only available in this option SECTION START - emale M - Male *SL - Soldered lead wires (72 ) NC - No SECTION END M - emale M - Male *SL - Soldered lead wires (72 ) *NC - No LENGTH view table above for increment options and maximum run limits REV0.4 page 1 of 5 www.luminii.com tel: 224-333-6033
TM-30-15: Data 22K CCT 24K CCT 27K CCT 29K CCT 30K CCT 35K CCT 41K CCT REV0.4 page 2 of 5 www.luminii.com tel: 224-333-6033
Power consumption per linear foot - loads tested with PSD series of power supplies (page4) typical 1 section of LineLED strip Length of strip (L) W/ft Total wattage W/ft Total wattage 1 6.80 6.80 10.80 10.80 2 6.75 13.50 10.60 19.80 3 6.65 19.95 10.30 30.90 4 6.55 26.20 10.28 41.10 5 6.40 32.00 10.25 51.60 6 6.30 37.80 10.30 63.20 7 6.20 43.40 10.10 72.10 8 6.10 48.80 9.90 79.40 9 6.00 54.00 9.80 88.10 10 5.95 59.50 9.70 96.00 11 5.85 64.35 12 5.80 69.60 13 5.75 74.75 14 5.75 80.50 15 5.70 85.50 16 5.70 91.20 REV0.4 page 3 of 5 www.luminii.com tel: 224-333-6033
Accessories Mounting clip: recommended at every 12 when LineLED strip is facing down. 0.20 0.07 Heat sink tape: included with LineLED strip when no extrusions are ordered. Splice Box: low voltage, 4 terminal splice box, black. Part # -2 0.60 1.25 0.23 Part # HST 2.00 Part # LVSP-4T-BK 0.90 3.00 1.90 Connectors 3-pin s (will not work with ) 72 power feed L 0.74 A B Part # P-C-72-BK (black) or -WH (white) Part # LL - 0.74 C 72.50 Power supply 3, 12, 48, 72 flexible Part # C-3-BK (black) or -WH (white) Part # C-48-BK (black) or -WH (white) Part # C-12-BK (black) or -WH (white) Part # C-72-BK (black) or -WH (white) 3.05, 3.50, 12.37, 47.62, 72.50 See fixture and power supply instructions & spec sheet for wiring information. Dimming possible in select models - view Luminii website for list of compatible dimmers. POWER OUTPUT DIMMING LOCATION PSV PSV - PSV Series 40 40-40 W 60-60 W 96-96 W 24V 24-24 VDC U2DIM U2DIM - Dimming 0-10V U2ND - Non Dimming D D - Dry Location IP65 - Wet Location PSD PSD - PSD Series POWER 48 24 48-48 W 96-96 W 288-288 W (3x 96W) OUTPUT INPUT 24-24 VDC Blank - 120 V 240-240 V 277-277 V LTEA4U1UKL-CV240 Lutron Hi-lume 1% 2-wire LED driver (120V forward phase only) L3DA4U1UKL-CV240 Hi-lume 1% EcoSystem Voltage LED Driver L3D0-96W24V-U Hi-lume 0.1% EcoSystem Voltage LED Driver with Soft-On, ade-to-black Sample layout with s B A 24 VDC Class 2 power supply LineLED 24V strip A C mounting clip -2 REV0.4 page 4 of 5 www.luminii.com tel: 224-333-6033
Optional mounting channels - Double row LEDs Slim Wide 8 Slim Wide 8 Recessed Slim Slim Wide Wide 8 8 H 0.81 0.88 0.30 1.45 0.87 1.77 H Slim S Wi Wide 15 15 1.16 0.88 0.89 0.33 0.62 Lens options H PRI Clear rosted Half (50%) frosted Prismatic Installation All mounting channels are field cuttable using miter saw with circular blade suitable for cutting aluminum. H Powerline 35 Recessed Powerline 35 Power Line 35 Recessed P ower Line 35 1.73 Ordering Extrusions are sold separately. View respective specsheets for details on ordering extrusions and their accessories (endcaps, mounting brackets, etc). PowerLine S Slim Wide 8 PowerLine Recessed Slim Wi Single de 8 PRI PowerLine Double Slim S Wi Wide 15 36 0.40 1.75 H Slim Wide 20 Recessed Slim Wide 20 Power Line 35 Recessed P ower Line 35 0.91 0.21 0.91 Slim Wide 20 Wall Power Line 35 0.90 REV0.4 page 5 of 5 www.luminii.com tel: 224-333-6033