Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide 004-008 Sure Electronics Inc. GP-GS00-Ver.0
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Table of contents Chapter. Brief Introduction and Port Definition..... Product..... Accessories... Chapter. Fast Guide...4 Chapter. Schematics and Physical Dimension...6 -. Schematics...6 -. Physical Dimension...8 Chapter4. Software and Sample Codes...9 4-. PC Software Users Guide...9 4--. How to use Orion Analyzer...9 4--. How to set baud rate... 4-. Sample Codes... Chapter5. Contact Us... 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page i
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Table of contents NOTES: Product Version : Ver.0 Document Version : Ver. GP-GS00-Ver.0-page ii 004-008 Sure Electronics Inc.
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Chapter. Brief Introduction and Port Definition.. Product Figure. Great for GPS based tools or appliance development.. Three useable ports, USB->UART Bridge based on CP0, legacy RS port, and an optional Bluetooth simulated RS port.. Module compatible with Ublx TIM-LC module in pin out. 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page
Brief Introduction and Port Definition 4. Module use unav 80 baseband processor, 008 RF front-end, 4th generation, -5dbm sensitivity. 5. Low power consumption 6. Could locate with the antenna inside the room and meter away from the window (normally when over 6 satellites in view site).. Orion Analyzer software and U-Center software provided, Baud rate, NMEA output package selectable. (GPS module baud rate is constant 9600bps.) 8. All communication method could work together. All ports could control the module and accept NMEA data. 9. USB port and Bluetooth port can not modify the baud rate. User can only modify NMEA output package through these ports. 0. Through RS port, all parameters could be modified.. Update may cause module fail permanently, and will cause warranty void. If user wants to do update, a RS port should be used (not USB bridged type) to update firmware.. Bluetooth optional... Accessories GP-GS00-Ver.0-page 004-008 Sure Electronics Inc.
Brief Introduction and Port Definition Figure. One active antenna. One USB Connecting Line 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Chapter. Fast Guide Figure.Connect the SMA connector of the Active antenna to the demo board and tie the screw (Shown in Figure ). Put the antenna to outdoor and keep the top side face the sky. The antenna has integrated magnet, so it can be magnetized on any iron surface such like roof of your car. Try to place it with a large viewable angle of the sky, if covering with any metal material, the signal would be weak. You could only use.v type active antenna with this demo board, 5V active antenna will not work. Keep the top of the antenna face the sky, or the signal may be too weak. Most active antennas are anti water type, they could work in raining days.. Connect the USB->UART Bridge based on CP0 to your host computer with the USB connector. And tie miniusb to the demo board. Power your host computer and install the driver. This GPS module is compatible with NMEA. protocol, so it could work with most GPS software that accepts NMEA protocol. For testing use, you could find Orion Analyzer software and u-center evaluation software in the accessory CD. It is only for testing and studying use. We do not provide any support on how to use Orion Analyzer and u-center, please view the user s guide from Orion Analyzer and u-center carefully. And notice don t try update firmware with Orion Analyzer or u-center, it may damage your module. GP-GS00-Ver.0-page 4 004-008 Sure Electronics Inc.
Fast Guide Your demo board should work after those steps, if you have any further questions, please refer to the schematics and user s guide carefully, and you could also email to support@sure-electronics.net, we will try to solve all questions. 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page 5
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Chapter. Schematics and Physical Dimension -. Schematics +5V USBRX USBTX C4 04 +5V U CYT8-.V IN OUT TX + C4 uf/6v tan R 0R C5 05 _ANT +5V S SWITCH R0 DNI 4 GPSTXD GPSRXD R9 0K J DB9 6 8 4 9 5 0 + C 00uF/6V C6 05 _ANT PPS + C uf/6v tan C 04 C6 4 C5 4 R6 0K GPS HPM0H-6 RF BB 5 4 0 _ANT R DNI C8 4 9 8 6 5 4 4 5 6 8 6 8 9 0 4 5 6 8 9 0 RF_IN V_ANTENNA _RF RF_ON IO RXD TXD TXD0 RXD0 GPIO5 SPI_SDI/IO SPI_SDO/IO SPI_SCK/IO4 SPI_XCS0 IO RTC_SDA/IO9 RTC_SCK/IO8 WAKEUP/IO J CON8A BAT Li-ion/V V_BAT RESET IO0 IO6 IO5 IO IO0 IO IO4 P SMA ANT_ 4 5 6 8 B - B+ 4 5 D5 N589 +5V C9 05 4 U5 C+ C- C 4 C- Rout 0 Tin Rout Tin MAX 6 8 4 5 9 5 6 F Fuse_00mA D6 N589 S SWITCH C 04 V+ V- Rin Tout Rin Tout C+ 4 + C 00uF/6V U CYT8-.V IN OUT J DJ005B RFIN RFIN C8 05 R 4 C0 RX 04 C C 04 04 Figure 4 GP-GS00-Ver.0-page 6 004-008 Sure Electronics Inc.
Schematics and Physical Dimension 4 USBRX UC 5 6 4HC04 +5V PPS R R 0 D LED/R VTX R 0k 4 U4D 4HC00 UB 4 4HC04 R9 0 R 0 Q 904 R0 0K TP5 TP TP4 TP6 VRX 4 4 U4B 4HC00 R6 K D LED/Y GPSRXD R4 0 BTTX BTRX TP8 4 5 6 4 UF 4HC04 USBTX RX D4 LED/B TP +5V VRX D LED/G R4 0k UE 0 4HC04 TP 0 U6 GL-6B UART-TX UART-RX UART-CTS UART-RTS PCM-CLK PCM-OUT PCM-IN PCM-SYNC AIO(0) AIO() RESET.V PIO() PIO(0) PIO(9) PIO(8) PIO() PIO(6) PIO(5) PIO(4) PIO() PIO() PIO() PIO(0) 4 0 9 8 6 5 4 PPS 4 5 6 8 9 4 4 5 6 8 9 0 USB D- SPI-CSB SPI-MOSI SPI-MISO SPI-CLK USB D+ BTTX R8 0k R5 0k BTRX 4 U4A 4HC00 +5V D LED/G TP 5VTX 5VRX VTX 0 4 U4C 4HC00 UA 4HC04 9 8 4 GPSTXD UD 9 8 4HC04 4 TX 5VTX R5 0k R8 0K 5VRX GPSRXD R 0 TP9 Figure 5 Notice: The above schematics are just for reference. There may be a little difference in production batch. 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page
Schematics and Physical Dimension -. Physical Dimension Figure 6 GP-GS00-Ver.0-page 8 004-008 Sure Electronics Inc.
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Chapter4. Software and Sample Codes 4-. PC Software Users Guide 4--. How to use Orion Analyzer. Open Orion Analyzer. It could be located by the following operation: Start All Programs unav Orion Analyzer Orion Analyzer. When the program is running, you will see a window as shown in Figure 9. Figure. Click icon on the toolbar to open New Connection dialog box. Select port from the pull-down menu of Port. Interface built in RS- to UART is COM- normally, but that built in modem of laptop is COM normally. USB-RS adapter use COM-8, and Bluetooth adapter will occupy COM4-5. In some occasions the situation may be changed. User can choose right port according to above presentation. Select right baud rate from the pull-down menu of Baudrate, for example, most GPS modules use 4800 as default, but as to GPRS modules and some other devices, it is 9600 or other baud rate adjusted by themselves. Baud rate of this product is set 9600 before shipping. Modification of this value is not suggested. Otherwise product may be failed. Click Create button to finish setting New Connection. As shown in figure 0. 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page 9
Software and Sample Codes Figure 8 If it has already connected to PC, you will see the port is opened in the bottom. After -5 minutes, you will see a window as below. Figure 9. You could refer to the user s guide of Orion Analyzer for more information. 4. Every demo board was tested for times before shipping. If it could not run, please make sure that the connection is correct. 5. It can work with almost all navigation software, and its setting is similar to Orion Analyzer. You could check the user s manual of those software for more information. GP-GS00-Ver.0-page 0 004-008 Sure Electronics Inc.
Software and Sample Codes 4--. How to set baud rate Baud rate can be set via Orion Analyzer as to serial interface. Click icon on the toolbar. Then select Output Configuration from the pop-up dialog box to activate the pull-down menu of baud rate. You can select right baud rate. Click Sent button. If the message box at the bottom of the window is said that The message has been sent, it means that baud rate has been set. Click Close button to close this dialog box. If product can receive and send message normally, baud rate has been modified successfully. Figure 0 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page
Software and Sample Codes Figure Notice: Improper modifications maybe damage the product. 4-. Sample Codes N/A GP-GS00-Ver.0-page 004-008 Sure Electronics Inc.
Mini USB & Bluetooth Interface GPS Module Demo Board User s Guide Chapter5. Contact Us Sure Electronics Co., Ltd. Floor 5, A zone, Qinhuai Technology Innovation center, NO.05-, DaMing Road, Nanjing, China Tel: +86604088 Email: Website: +86-5-6660640 (English service, from GMT-0AM, only for technical questions) support@sure-electronics.net www.sure-electronics.net www.sure-electronics.com www.sureelectronics.net 004-008 Sure Electronics Inc. GP-GS00-Ver.0-page