1
Main OC Tweaker Advanced H/W Monitor Boot Security Exit System Overview System Time System Date BIOS Version Processor Type Processor Speed Microcode Update L1 Cache Size : 512KB L2 Cache Size : 2048KB Total Memory DDR3_A1 DDR3_B1 DDR3_A2 DDR3_B2 [ 17:00:09] [Wed 04/07/2010] : 880GMH/USB3 P1.00 : AMD Athlon(tm) II X4 620 Processor (64bit) : 2600MHz : 100F52/1000086 : 1024MB with 128MB shared memory Single-Channel Memory Mode : 1024MB/533MHz DDR3_1066 :None :None :None Use [Enter], [TAB] or [SHIFT-TAB] to select a field. Use [+] or [-] to configure system Time. +- Change Field Tab Select Field v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. Main OC Tweaker Advanced H/W Monitor Boot Security Exit EZ Overclocking Turbo 50 [Press Enter] Load Optimized CPU OC Setting [Press Enter] Load Optimized mgpu OC Setting [Press Enter] CPU Configuration Overclock Mode CPU Frequency (MHZ) CPU DOC Frequency (MHZ) PCIE Frequency (MHz) Spread Spectrum Boot Failure Guard Boot Failure Guard Count Advanced Clock Calibration CPU Active Core Control Processor Maximum Frequency North Bridge Maximum Frequency [200] [100] [3] [All Cores] x10.5 2100 MHZ x9.0 1800 MHz Overclocking may cause damage to your CPU and motherboard. It should be done at your own risk and expense. Enter Go to Sub Screen v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. 2
3
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Load Optimized CPU OC Setting Load Optimized mgpu OC Setting CPU Configuration Overclock Mode CPU Frequency (MHZ) CPU DOC Frequency (MHZ) PCIE Frequency (MHz) Spread Spectrum Boot Failure Guard Boot Failure Guard Count Advanced Clock Calibration CPU Active Core Control [Press Enter] [Press Enter] [200] [100] [3] [All Cores] Processor Maximum Frequency x10.5 2100 MHZ North Bridge Maximum Frequency x9.0 1800 MHZ Processor Maximum Voltage 1.2500 V Multiplier/Voltage Change [Manual] If Manual, multiplier and voltage will be set based on user selection. Final result is depending on CPU s capability. And Cool n Quiet will be disabled. Enter Go to Sub Screen v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. 4
Memory Timing OC Tweaker Power Down Enable Bank Interleaving Channel Interleaving [HASH 2] CAS Latency (CL) TRCD TRP TRAS TRTP TRRD TWTR TWR TRC TRWTWB TRWTTO TWRRD 9 12 12 30 5 4 5 10 33 8 7 2 +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit 5
6
7
8
9
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Advanced Settings Options for CPU WARNING : Setting wrong values in below sections may cause system to malfunction. CPU Configuration Chipset Configuration ACPI Configuration Storage Configuration PCIPnP Configuration Floppy Configuration SuperIO Configuration USB Configuration BIOS Update Utility ASRock Instant Flash Enter Go to Sub Screen v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. 10
Advanced CPU Configuration Boot Failure Guard Cool n Quiet Secure Virtual Machine Enhanced Halt State L3 Cache Allocation Enable or disable the feature of Boot Failure Guard. +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit 11
Chipset Settings Advanced Onboard HD Audio Front Panel OnBoard Lan Primary Graphics Adapter Internal Graphics Mode Share Memory Onboard HDMI HD Audio Surround View [PCI] [UMA+SIDEPORT] Options UMA SIDEPORT UMA+SIDEPORT + - Change Option 12
Advanced ACPI Settings Suspend To RAM Check Ready Bit Away Mode Support Restore on AC / Power Loss Ring-In Power On PCI Devices Power On PS / 2 Keyboard Power On RTC Alarm Power On ACPI HPET Table [Power Off] Select auto-detect or disable the STR feature. +- Change Option 13
Advanced Storage Configuration Onboard SATA Controller SATA Operation Mode IDE1 Master IDE1 Slave SATAII_1 SATAII_2 SATAII_3 SATAII_4 SATAII_5 esata_1 [IDE] [Hard Disk] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] [Not Detected] Configure onboard serial ATA controller. +- Change Option F1 General Help F9 Load Defaults F10 Save and Exit ESC Exit Advanced Primary IDE Master Device Vendor Size LBA Mode Block Mode PIO Mode Async DMA Ultra DMA S.M.A.R.T. :Hard Disk :MAXTOR 6L080J4 :80.0 GB :Supported :16Sectors :4 :MultiWord DMA-2 :Ultra DMA-6 :Supported Type LBA/Large Mode Block (Multi-Sector Transfer) PIO Mode DMA Mode S.M.A.R.T. 32Bit Data Transfer Select the type of device connected to the system. +- Change Option 14
15
Advanced Advanced PCI / PnP Settings PCI Latency Timer PCI IDE BusMaster [32] ValueinunitsofPCI clocks for PCI device latency timer register. +- Change Option Advanced Floppy Configuration 1 Floppy A [1.44 MB 3 2 "] Select the type of floppy drive connected to the system. +- Change Option 16
Advanced Configure Super IO Chipset OnBoard Floppy Controller Serial Port Address Infrared Port Address PS/2 Port Type [3F8 / IRQ4] Allow BIOS to Enable or Disable Floppy Controller. +- Change Option 17
Advanced USB Configuration USB Controller USB 2.0 Support Legacy USB Support USB 3.0 Controller To enable or disable the onboard USB controllers. +- Change Option 18
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Hardware Health Event Monitoring CPU Temperature M / B Temperature : 37C/98F : 27C/80F Enable/Disable CPU Quiet Fan Function. CPU Fan Speed Chassis Fan Speed Power Fan Speed : 4722 RPM : N /A : N /A Vcore + 3.30V + 5.00V + 12.00V CPU Fan Setting : 1.216V : 3.248V : 5.136V : 12.091V F1 F9 F10 ESC General Help Load Defaults Save and Exit Exit 19
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Boot Settings Boot Settings Configuration Configure Settings during System Boot. 1st Boot Device 2nd Boot Device 3rd Boot Device 4th Boot Device Hard Disk Drives Removable Drives CD/DVD Drives [1st Floppy Device] [HDD: PM - HDS722580VL] [CD / DVD: 3S - CD - ROM C] [USB] Enter Go to Sub Screen v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. Boot Boot Settings Configuration Full Screen Logo AddOn ROM Display Boot Logo Boot From Onboard LAN Bootup Num-Lock [On] Disabled: Displays normal POST messages. Enabled: Displays OEM Logo instead of POST messages. + - Change Option 20
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Security Settings Supervisor Password : Not Installed User Password : Not Installed Change Supervisor Password Change User Password Install or Change the password. Enter Change v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. 21
Main OC Tweaker Advanced H/W Monitor Boot Security Exit Exit Options Save Changes and Exit Discard Changes and Exit Discard Changes Load BIOS Defaults Load Performance Setup Default (IDE/SATA) Load Performance Setup AHCI Mode Load Performance Setup RAID Mode Load Power Saving Setup Default Exit system setup after saving the changes. F10keycanbeused for this operation. Enter Go to Sub Screen v02.54 (C) Copyright 1985-2005, American Megatrends, Inc. 22