CD DAB+ RADIO WITH BLUETOOTH MUSIC SYSTEM BT-9000 Instruction Manual For information and support www.lenco.eu
Important Safety Instructions When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a set basement. 2. Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, 3. Heat & Flame The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Where the power adaptor is used as the disconnect device, the disconnect device shall remain readily operable. The power adaptor wire should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the wire exits the unit to where the adaptor plugged into an AC outlet. 6. Cleaning cleaning instructions. 7. Object and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on shall be placed on the apparatus. 8. Attachments Do not use attachments not recommended by the product manufacturer. Unplug the unit from the wall outlet and disconnect the periods of time. This will prevent damage to the product due to lightning and power-line surges. 10. Overloading A. The power supply cord or plug has been damaged. B. Objects have fallen into or liquid has been spilled into the enclosure. C. The unit has been exposed to rain. D. The unit has been dropped or the enclosure damaged. E. The unit exhibits a marked change in performance or does not operate normally. If the unit is to be left unused for an extended period of time, such as a month or longer, the power cord should be unplugged from the unit to prevent damage or corrosion. The user should not attempt to service the unit beyond those methods described in the user s operating personnel. GB 2
Warnings Follow the advice below for safe and appropriate operations. ON PROTECTION AGAINST LASER ENERGY EXPOSURE casing. Features Thank you for purchasing the CD DAB+ Radio with Bluetooth music system. This model incorporates following features: Bluetooth technology. - ID3 technology displaying song title - FM receiver with digital read out on LCD - LCD Clock - LCD display with back-light - With Bass and Treble settings Installation Clock setting battery back-up A backup battery compartment located at rear of the unit. Remote Control A battery compartment located at bottom of the remote control. - To replace battery, slide out the battery holder then follow the polarity diagram shown on the holder and install a GB 3
INTRO/ Installation AC-DC Adaptor Connection Warnings: - Be sure that the batteries are installed correctly. Wrong polarity may damage the unit. - Do not mix old and new batteries. - Only batteries of the same or equivalent type as recommend are to be used. - If the unit is not to be used for an extended period of time, remove the battery. - Danger of explosion if battery is incorrectly replaced. about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Use only the power supply listed in the user instructions. Description of Parts Main Unit Top View Rear View 1 17 18 19 20 21 22 23 24 11 10 9 8 7 6 5 4 3 2 Front View Remote Control 12 16 15 14 13 12 2 16 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 GB 4
Main Unit Remote Control Description of Parts 2. VOLUME knob --- Adjust volume level up or down. 13. CD slot 14. Remote Control Infrared receiver 15. LCD display 18. Rod antenna 19. Memory backup battery compartment 21. LINE-IN 2 jack --- Audio line2 input 22. DC-in jack --- For the connection of external DC power supply 23. LINE-IN 1 jack --- Audio line1 input 1. Infrared Transmitter In FM menu mode: Act as navigation button. In DAB menu mode: Act as navigation button. GB 5
Description of Parts 34. Battery Compartment --- Located at the rear bottom of the remote control. Bluetooth Operation which also has the NFC function. Pairing / Connection 4. The mobile device will pair and connect with this model automatically. Note: The Bluetooth device name of this model: Lenco BT-9000 3. From the mobile device, turn on its Bluetooth function and it will also search for the nearby Bluetooth device as well. Lenco BT-9000 model for the connection. Note: device last connected, no need to re-scan and pair. Playback Bluetooth music 1. After Bluetooth communication link is set up, run the music player App from the mobile device then playback the mobile device music. desirable volume setting. 3. You may press: Energy Saving Note In Bluetooth mode, if the Bluetooth communication link disconnected for around 10 minutes, the unit will go into standby mode automatically. GB 6
FM Radio Tuner Operation Antenna For the best radio reception, fully extend the rod antenna located at rear of the unit. MENU Option In the FM radio mode, the unit allows you to select following options. Note: poor quality audio from distant stations. Note: result in poor quality audio. The audio quality can be improved using mono. 3. You can press the MENU button to exit menu setting mode at any time. Auto-scan and store Preset Stations The unit allows you to store up to 20 FM stations for easy recall at any time. mode. automatically scan for stations from low to high frequency and then store them in the preset location. Note: After each auto-scan & store operation, it will overwrite the existing preset stations by overwriting and storing the new stations in their place. FM Radio Tuning and manual store Preset Stations mode. FM Radio Tuning 3. You can have following ways to tune to a desired station: button from the remote control and it will tune to the next higher radio station. button from the remote control and it will tune to the next lower radio station. Note: station location. tuner mode. The newly tuned frequency will replace the frequency in the selected preset station location. 7. Repeat steps 3 to 6 to store other stations, if apply. Notes: to normal tuner mode. GB 7
FM Radio Tuner Operation RDS function DAB / DAB+ Tuner Operation The unit is able to receive available DAB and DAB+ radio stations in your area. Antenna For the best radio reception, fully extend the rod antenna located at rear of the unit. MENU Option able for your selection, if apply. Navigation button In the menu setting mode, you can make use of following navigation buttons to implement the option selection. MENU Options loudest and quietest audio being broadcast. Effectively, this makes quiet sounds comparatively louder and loud sounds comparatively quieter. Note: name. Full scan operation mode. list. Manual tune operation information for your area. 1. In the DAB radio mode, press the MENU button entering menu setting mode. Save preset station 1. Whilst a desired station is displayed, press the MEM button from the remote control. The preset channel number appears on display and blinks. Note: stations location. DAB tuner mode. The new station will replace the last station in the selected preset station location. GB 8
DAB / DAB+ Tuner Operation Notes: - There is a few seconds delay when programming, after this delay time, the unit will automatically switch back to normal tuner mode. - You can overwrite a preset station by overwriting and storing the new station. Recalling Preset Station Change listening channel displayed. Display DAB radio station information information. Listening to CD Music CD Playback 3. Insert a CD with printed side facing up into the CD slot. 4. Music playback will automatically start. the remote control. CD Play Modes LCD. To playback CD tracks in random order, press the RAN button from the remote control. indicator appears on LCD. Cancel CD play mode GB 9
Listening to CD Music CD Program Playback The LCD shows following indication: entered. Note: ID3 Function To enable this function: 2. To turn off the ID3 function, press the ID3 button again. Note: Treble and Bass Settings Listening to External Audio Source You can connect to three different external audio sources. RCA type audio connector can be connected to the LINE-IN 1 and LINE-IN 2 audio input jacks. 4. Turn on the external auxiliary audio device. 5. The volume can now be controlled through the unit. Operate all other functions on the external device as usual. Notes: Don t forget to switch off the power of the external audio device as well. GB 10
Clock Setting Auto-setting Each time a DAB station is received and its time information will be copied to this unit automatically which will overwrite current time setting on the unit. Manual setting Exit setting mode Sleep Timer Function Sleep to timer This feature allows you to fall asleep to the CD, radio or Bluetooth for up to 90 Minutes. The unit shuts off automatically when the time expires. 2. Either tune to the desired FM or DAB radio station in radio mode, playback CD song or playback Bluetooth music. time then automatically turns off. Notes: timer will shut off the power to this system but it will not turn off the external device. then shut off automatically no matter the sleep timer setting. For example, if your CD is only 30 minutes long and 45 minutes sleep timer is selected, the unit will shut off approximately 3 minutes after the disc ends. GB 11
Care and Maintenance - Do not subject the unit to excessive force, shock, dust or extreme temperature. - Do not tamper the internal components of the unit. - Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. If drop-outs or interruptions occur in the music during play, or if the disc fails to play at all, its bottom surface may require cleaning. Before playing, wipe the disc from the center outwards with a good soft clean cloth. Resetting the Unit If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller may lock up and the unit will not respond to any commands from the panel controls. 1. In this event, unplug and then reconnect the AC power plug into the wall outlet. will be erased. RESET Button CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT. Note: resume normal operation. the product to resume normal operation. In case the function could not resume, please use the product in other location. GB 12
Output DC 18V 3000mA Main unit supply power Remote Control battery DC 18V 3000mA DC3V --- CR2025 x 1 Lithium battery Dimensions Weight 351 x 136 x 214 mm 3300g and Humidity 70% ment. This product is suited for this purpose within all EU counties. This symbol indicates that the relevant electrical product or battery should not be disposed of as general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of electrical waste All rights reserved THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE SET ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. GB 13
Service and Support For information: www.lenco.com Lenco helpdesk: When contacting Lenco, you will always be asked for the model and serial number of your product. The serial num- Model: Lenco offers service and warranty in accordance to European law, which means that in case of repairs (both during Important note: It is not possible to send products that need repairs to Lenco directly. Important note: This device is not suitable for professional use. In case of professional use, all warranty obligations of the manufacturer will be voided. GB 14