SPEIFITIOS odel HWP 48RKS Item o. (Standard/Opposite Hand) 509-048-001 / 509-048-011 ooling capacity (net) to S/ZS 3823 T1 4.3 kw Heating capacity H1 4.6 kw Electrical input - cooling 1.2 kw Electrical input - heating 1.3 kw EER / EER (cooling) 3.64 / 3.62 OP / OP (heating) 3.66 / 3.64 Unit ontroller U8 Refrigerant R410 Refrigerant charge 770 g ompressor type rotary connections 1/2" male SP ominal EWT on cooling 30 ominal EWT on heating 21 ominal @ EWT LWT = 5k 0.27 l/s Entering system pressure drop @ nominal flow 27.6 kpa (4 psi) in. water temp. Heat cycle at nominal flow 10 in. water temp. ool cycle at nominal flow 15 in. water temp. ool cycle with water flow control valve 5 ax. EWT Heat cycle at nominal flow 30 ax. EWT ool cycle at nominal flow 50 in. water flow @ nominal EWT 0.07 l/s ax. water pressure excluding hoses 3200 kpa (464 psi) Power supply 1 ph. 23 ac 50Hz ompressor run amps at rating cond. 4.4 ompressor run capacitor 40 µfd Indoor fan motor size 150 W Indoor fan motor (1ph.) - full load 1.8 ontrol circuit breaker (internal) 10 Running amps (total system) 5.2 ax. running amps (total system) 7.7 et weight 70 kg ccessories: Spring mounts supplied hoses 600mm long, rated 250psi 1/2" female SP, supplied Replacement filter 119-000-098 513x265x13 ondensate lift-pump 507-003-009 Optional: ST-3 Room temperature controller 201-000-146 TZT-100 Room temperature controller 201-000-350 Refer to temperzone for other options, eg remote sensors Tested in accordance with S/ZS 3823 15102
DIESIOS (mm) PROJETIO HWP 48RKS Standard ot to Scale Right handed model shown here W ELETRIL OX X POIT LODS (kg) W X Y Z 23 13 22 ote: Fan motor can be accessed from panel above, below or sides; no more than two panels at once. Z Y HWP 48RKS Opposite Hand POIT LODS (kg) W X Y Z 23 13 22 W ELETRIL OX X ote: Fan motor can be accessed from panel above, below or sides; no more than two panels at once. Z Y 355 OTE Specifications are subject to change without notice due to the manufacturer's ongoing research and development programme.
ELETRIL ETH2 T1 TL2W1 1 2 T2 T3 T4 External Protection & Isolation Pump Verification Dry ontacts If Pump Verification Option fitted remove this link T6 1 2 E1 T7 Pump1 Pump2 ctive 6-6- 7-D D 7-D U8 DIP switch settings U8 JUPER settings DIP switch On/Off 1,13,14 On ll Others Off Off Position Jumper REV DESRIPTIO Initial Release E DTE PPROVED ain Earth Symbol updated 3837 19-03-16 D... FR & SR now fitted as standard 3941 23-05-17 D... temperzone Ltd 2014 DO OT SLE - SK lient Wiring ETH3 K P1 S R 1~ SR / 1-1- ondensate Pump FR / U8 Temp Sensors (Refer to table) 1 1 FLT EXV1 EXV2 UX HI E LO 1 I#1 I#1 2 HT P I#2 I#2 DL SL 2 2 odbus master port for optional T/stat (TZT100/ST-3) ontrol Valve E HIGH ED LOW 3 HPT LPT Pressure sensors DEI O I V1 V2 D1 D2 D3 S O P4W1 P2W1 0-1 to Regulating Valve If ondensate Float Switch Option fitted remove this link ondensate Float Switch (ormally closed) L 5 VF V TL2W2 L1 T5 24V/VD Optional 0-1 E2R Relay 2 DP1 Refer to DIP S/W settings Display SW1 SW2 odbus slave port for S (monitoring or control option) / Relay 1 SW3 4 Remote On/Off Dry ontact P2 RV D If Remote On/Off Option fitted remove this link R (HIGH) RED (ED-HI) LU 1 GRY (ED-LOW) IF1 WHT (LOW) Sensors (S) / Transducers (T) ame Type olour DL Discharge Temp S RED SL Suction Temp S WHITE I Indoor oil S YELLOW HPT High Pressure T P PITOR OTROL IRUIT REKER PRESSOR OTOR PRESSOR OTTOR P2W OETOR PLUG 2 WY P4W OETOR PLUG 4 WY E2R EXV2 RELY ORD FR FULT RELY ORD ETH ERTH IF IDOOR F OTOR K KLIXO RV REVERSIG VLVE SR STTUS RELY ORD T TERIL LOK TL2W TERIL LOK LIK 2 WY U8 UIT OTROLLER 8 Drawn: pprvd:..w. Date: 29-09-14 Title: Drawing o: Rev: 291-000-796 HWP 36 & 48RKS U8 Wiring Schematic SHEET 1 OF 1
003-000-034 06/17 www.temperzone.biz temperzone limited 2017
SPEIFITIOS odel HWP 48KS HWP 48EKS Item o. - Standard 509-048-101 509-048-102 Item o. - Opposite Hand 509-048-111 509-048-1 ooling capacity (net) to S/ZS 3823 T1 4.3 kw Heating capacity - Electric heat n/a 2.0 kw Electrical input - cooling 1.2 kw Electrical input - heating n/a 2.2 kw EER / EER (cooling) 3.64 / 3.62 Unit ontroller Refrigerant Refrigerant charge ompressor type connections U8 R410 770 g rotary 1/2" male SP ominal EWT on cooling 30 ominal @ EWT LWT = 5k Entering system pressure drop @ nominal flow 0.27 l/s 27.6 kpa (4 psi) in. water temp. ool cycle at nominal flow 15 in. water temp. ool cycle with water flow control valve 5 ax. EWT ool cycle at nominal flow 50 in. water flow @ nominal EWT ax. water pressure excluding hoses Power supply ompressor run amps at rating cond. ompressor run capacitor Indoor fan motor size Indoor fan motor (1ph.) - full load ontrol circuit breaker (internal) 0.07 l/s 3200 kpa (464 psi) 1 ph. 23 ac 50Hz 4.4 40 µfd 150 W 1.4 10 Running amps (total system) 5.2 9.5 ax. running amps (total system) 7.7 10.1 et weight 69 kg 70 kg ccessories: Spring mounts hoses 600mm long, rated 250psi Replacement filter - rated EU2/G2 supplied 1/2" female SP, supplied 119-000-098 513x265x13 ondensate lift-pump 507-003-009 Optional: ST-3 Room temperature controller 201-000-146 TZT-100 Room temperature controller 201-000-350 Refer to temperzone for other options, eg remote sensors Tested in accordance with S/ZS 3823 15110
DIESIOS (mm) PROJETIO HWP 48 KS/EKS Standard ot to Scale ELETRIL OX W X POIT LODS (kg) W X Y Z 23 13 22 ote: Fan motor can be accessed from panel above, below or sides; no more than two panels at once. Z Y HWP 48 KS/EKS Opposite Hand POIT LODS (kg) W X Y Z 23 13 22 W ELETRIL OX X ote: Fan motor can be accessed from panel above, below or sides; no more than two panels at once. Z Y 355 OTE Specifications are subject to change without notice due to the manufacturer's ongoing research and development programme.
ELETRIL ETH2 T1 ETH3 TL2W1 TL2W2 External Protection & Isolation 1 2 L1 T2 T3 T4 T5 K P1 S R 1~ SR / 24V/VD 1-1- Optional 0-1 ondensate Pump FR / U8 Temp Sensors (Refer to table) 1 1 FLT EXV1 EXV2 UX HI E LO 1 I#1 I#1 2 HT P I#2 I#2 DL SL 2 2 odbus master port for optional T/stat (TZT100/ST-3) Pump Verification Dry ontacts If Pump Verification Option fitted remove this link T6 1 2 E1 T7 Pump1 Pump2 ctive 6-6- 6-D D 7-D ontrol Valve P2 E HIGH ED LOW 3 HPT LPT Pressure sensors D DEI O I V1 V2 D1 D2 D3 S O P4W1 P2W1 0-1 to Regulating Valve If ondensate Float Switch Option fitted remove this link If Remote On/Off Option fitted remove this link ondensate Float Switch (ormally closed) L 5 VF V E2R Relay 2 DP1 Refer to DIP S/W settings Display SW1 SW2 odbus slave port for S (monitoring or control option) / Relay 1 SW3 4 Remote On/Off Dry ontact R (HIGH) REV DESRIPTIO Initial Release E DTE PPROVED ain Earth Symbol updated 3837 19-03-16 D... FR & SR now fitted as standard 3941 23-05-17 D... LU IF1 U8 DIP switch settings DIP switch On/Off 1,13,14 On ll Others Off Off 1 RED (ED-HI) GRY (ED-LOW) WHT (LOW) U8 JUPER settings Position Jumper Sensors (S) / Transducers (T) ame Type olour DL Discharge Temp S RED SL Suction Temp S WHITE I Indoor oil S YELLOW HPT High Pressure T P PITOR OTROL IRUIT REKER PRESSOR OTOR PRESSOR OTTOR P2W OETOR PLUG 2 WY P4W OETOR PLUG 4 WY E2R EXV2 RELY ORD FR FULT RELY ORD ETH ERTH IF IDOOR F OTOR K KLIXO SR STTUS RELY ORD T TERIL LOK TL2W TERIL LOK LIK 2 WY U8 UIT OTROLLER 8 temperzone Ltd 2014 DO OT SLE - SK lient Wiring Drawn: pprvd:..w. Date: 29-09-14 Title: Drawing o: Rev: 291-000-795 HWP 36 & 48KS U8 Wiring Schematic SHEET 1 OF 1
ETH2 T1 ETH3 T2 T3 TL2W1 1 1- SR R P1 T4 TL2W2 Optional 0-1 1-24V/VD / 2 S K 1~ T5 L1 EH External Protection & Isolation EH1 EH2 V VF HI E LO 1 5 I#2 I#2 I#1 I#1 2 HT P 1 1 UX EXV2 EXV1 odbus slave port for S (monitoring or control option) FR U8 Refer to DIP S/W settings FLT / ondensate Pump odbus master port for optional T/stat (TZT100/ST-3) 2 2 SW1 SW2 E2R Temp Sensors (Refer to table) DP1 DL SL Display Relay 2 0-1 to Regulating Valve If ondensate Float Switch Option fitted remove this link V1 V2 DEI SW3 E Relay 1 O I / ontrol Valve Pump Verification Dry ontacts 6- P4W1 D1 D2 Pressure sensors HPT LPT 6- T6 1 2 ondensate Float Switch (ormally closed) D3 S 3 LOW ED HIGH E1 P2W1 If Pump Verification Option fitted remove this link Remote On/Off Dry ontact O L 4 6-D If Remote On/Off Option fitted remove this link D 7-D HST T7 Pump1 Pump2 t D ctive ST EH2 EH1 t P2 R (HIGH) RED (ED-HI) LU 1 GRY (ED-LOW) IF1 WHT (LOW) ETH ERTH HST HIGH TEPERTURE SFETY THEROSTT IF IDOOR F OTOR K KLIXO ST UL SFETY THEROSTT SR STTUS RELY ORD T TERIL LOK TL2W TERIL LOK LIK 2 WY U8 UIT OTROLLER 8 P PITOR OTROL IRUIT REKER PRESSOR OTOR PRESSOR OTTOR P2W OETOR PLUG 2 WY P4W OETOR PLUG 4 WY E2R EXV2 RELY ORD EH ELETRI HET EH ELETRI HET OTTOR FR FULT RELY ORD U8 JUPER settings U8 DIP switch settings Position Jumper Sensors (S) / Transducers (T) ame Type olour Fast Temp Sensor S LK DL Discharge Temp S RED SL Suction Temp S WHITE I Indoor oil S YELLOW HPT High Pressure T DIP switch On/Off 1,3,4,13,14 On ll Others Off Off REV DESRIPTIO E DTE PPROVED Initial Release ain Earth Symbol updated. Dip switch 3 3837 19-03-16 D... now on, was off FR & SR now fitted as standard 3941 23-05-17 D... Title: Drawing o: Rev: 291-000-797..W. Date: 29-09-14 Drawn: temperzone Ltd 2014 lient Wiring SHEET 1 OF 1 HWP 36 & 48EKS U8 Wiring Schematic pprvd: DO OT SLE - SK 003-000-032 06/17 www.temperzone.biz temperzone limited 2017