Cisco Introducing Cisco Data Center Networking - DCICN. Download Full version :

Similar documents
Cisco Exam Questions & Answers

Introducing Cisco Data Center Networking [AT]

Configuring Layer 3 Interfaces

Cisco Implementing Cisco IP Switched Networks (SWITCH v2.0)

Chapter 5: Inter-VLAN Routing. Routing & Switching

HP0-Y49. Applying HP FlexNetwork Fundamentals.

Configuring VLANs. Understanding VLANs CHAPTER

Configuring VLANs. Understanding VLANs CHAPTER

VLANs Level 3 Unit 9 Computer Networks

Configuring VLANs. Understanding VLANs CHAPTER

Configuring Private VLANs Using NX-OS

Configuring VLANs. Understanding VLANs CHAPTER

Configuring VLANs. Understanding VLANs CHAPTER

VLAN Configuration. Understanding VLANs CHAPTER

Configuring VLANs. Understanding VLANs CHAPTER

Configuring EtherChannels and Link-State Tracking

VLANs. CCNA Exploration Semester 3 Chapter Sep-13

Switches running the LAN Base feature set support only static routing on SVIs.

Configuring VLANs. Finding Feature Information. Prerequisites for VLANs

Configuring VLANs. Understanding VLANs CHAPTER

Laboration 2 Troubleshooting Switching and First-Hop Redundancy

Configuring VLANs. Understanding VLANs CHAPTER

Introducing Cisco Data Center Networking (DCICN)

Configuring Layer 3 Interfaces

Configuring VLANs. Understanding VLANs CHAPTER

Configuring EtherChannels

PASS4TEST IT 인증시험덤프전문사이트

Cisco Designing Cisco Data Center Unified Fabric (DCUFD) v5.0. Download Full Version :

MiPDF.COM. 3. Which procedure is used to access a Cisco 2960 switch when performing an initial configuration in a secure environment?

Configuring the MAC Address Table

Configuring Local SPAN and ERSPAN

Configuring VLANs. Finding Feature Information. Prerequisites for VLANs

Skills Assessment (OSPF) Student Training Exam

Chapter 3: VLANs. Routing & Switching

Configuring Flex Links

PrepAwayExam. High-efficient Exam Materials are the best high pass-rate Exam Dumps

Manually Configure Default Gateway Cisco Switch 2960

Configuring EtherChannels and Layer 2 Trunk Failover

Braindumps questions. Cisco Introducing Cisco Data Center Networking

Exam Questions Demo Cisco. Exam Questions

Introduction to Switched Networks Routing And Switching

Skills Assessment (EIGRP) Student Training Exam

Working with Configuration Files

Using the Cisco NX-OS Setup Utility

Using the Cisco NX-OS Setup Utility

Juniper JN Enterprise Routing and Switching, Specialist (JNCIS-ENT)

Configuring SPAN. Finding Feature Information. About SPAN. SPAN Sources

CCNA 1 Chapter 2 v5.0 Exam Answers %

Configuring Interface Characteristics

Skills Assessment (OSPF) Student Training Exam

1. Which two statements are true about VLAN implementation? (Choose two.)

Exam : Cisco Title : Update : Demo. Cisco Certified Network Associate

Computer Networking. December 2004 CEN CN

Exam : Cisco Certified Network Associate(CCNA) Title : Version : DEMO

Cisco Introducing Cisco Data Center Technologies - DCICT. Download Full Version :

Introducing Cisco Data Center Networking Course DCICN v1.0; 4 Days, Instructor-led

Configuring Port Channels

CertifyMe. CertifyMe

Manually Configure Default Gateway On Switch Vlan Cisco

PrepKing. PrepKing

Configuring Link Aggregation

CCNA 1 Chapter 2 v5.0 Exam Answers 2013

3COM 3M Certified Enterprise LAN Specialist Final v3.0. Download Full Version :

The following steps should be used when configuring a VLAN on the EdgeXOS platform:

Configuring Virtual Port Channels

Configuring VM-FEX. Information About VM-FEX. VM-FEX Overview. VM-FEX Components. This chapter contains the following sections:

Implement Inter-VLAN Routing. LAN Switching and Wireless Chapter 6 Modified by Tony Chen 11/01/2008

Command Reference for Voice VLAN

Q&A. DEMO Version

Pass-Through Technology

Configuring VTP V3. Configuring VTP V3. VTP V3 Overview. Guidelines and Limitation. This chapter contains the following sections:

CALLN HOSTED CALL RECORDING CISCO ESW2 SERIES PORT MIRRORING SETUP

Skills Assessment (EIGRP) Student Training Exam

Configuring sflow. Information About sflow. sflow Agent. This chapter contains the following sections:

T e c h n i c a l D o c u m e n t. Cisco 2960G, 2960S, and 2960X Configuration for WheatNet-IP

Cisco Interconnecting Cisco Networking Devices Part 1.

Cisco Exploration 3 Module 3 LAN Switching and Wireless Jim Johnston Class Notes September 9, 2008

Migrate from Cisco Catalyst 6500 Series Switches to Cisco Nexus 9000 Series Switches

Module Specification

Configuring IEEE 802.3ad LACP EtherChannels on the Cisco MWR 2941

Configuring EtherChannels

VLANs. LAN Switching and Wireless Chapter 3. Version Cisco Systems, Inc. All rights reserved. Cisco Public 1

Configuring VTP. Understanding VTP CHAPTER

3. What could you use if you wanted to reduce unnecessary broadcast, multicast, and flooded unicast packets?

Lab 1. CLI Navigation. Scenario. Initial Configuration for R1

Section 1. General Networking Theory

Configuring EtherChannels and Layer 2 Trunk Failover

Configuring VLAN Trunks

Antonio Cianfrani. Virtual LAN (VLAN)

On the Cisco Nexus 5548 Switch, Fibre Channel ports and VSAN ports cannot be configured as ingress source ports in a SPAN session.

Configuring Link Aggregation

CCNA 1 Chapter 6 v5.0 Exam Answers 2013

Cisco 4-Port and 8-Port Layer 2 Gigabit EtherSwitch Network Interface Module Configuration Guide for Cisco 4000 Series ISR

Configuring VTP. Understanding VTP CHAPTER

Configuring Layer 2 Switching

Actual4Test. Actual4test - actual test exam dumps-pass for IT exams

Configuring Voice VLAN

Configuring FCoE NPV. Information About FCoE NPV. This chapter contains the following sections:

Question No : 1 Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)

Catalyst 1900 Series and Catalyst 2820 Series Enterprise Edition Software Configuration Guide

Transcription:

Cisco 640-911 Introducing Cisco Data Center Networking - DCICN Download Full version : http://killexams.com/pass4sure/exam-detail/640-911

There is a large amount of traffic inside a network segment with a destination address of FF:FF:FF:FF:FF:FF. What type of traffic uses this address? A. FF:FF:FF:FF:FF:FF is the Layer 2 broadcast address. B. FF:FF:FF:FF:FF:FF is the Layer 2 network address. C. FF:FF:FF:FF:FF:FF is the Layer 3 broadcast address. D. FF:FF:FF:FF:FF:FF is the Layer 3 network address. E. FF:FF:FF:FF:FF:FF is multicast traffic. Answer: A QUESTION: 200 A network engineer has been tasked with connecting a Nexus 5548 switch to an older Catalyst 3750. After configuring the interfaces, the engineer noticed that the end hosts did not have network connectivity and the Nexus 5548 had the following log message: %STP-2-BRIDGE_ASSURANCE_BLOCK: Bridge Assurance blocking port Ethernet1/27 VLAN0010 What command can solve this problem? A. configure no spanning-tree port type network on the Nexus 5548 interface B. configure spanning-tree mode rapid-pvstp on the Catalyst 3750 C. configure switchport trunk native VLAN 10 on the Catalyst 3750 interface D. configure spanning-tree mode rapid-pvstp on the Nexus 5548 Answer: A QUESTION: 201 Exhibit

Refer to the exhibit. What two commands will allow the Nexus 5000 switch to continue to boot? (Choose two.) A. boot n5000-uk9-kickstart.5.2.1.n1.4.bin B. load n5000-uk9.5.2.1.n1.4.bin C. copy kickstart-latest n5000-uk9-kickstart.5.2.1.n1.4.bin startup D. copy system-latest n5000-uk9.5.2.1.n1.4.bin E. boot n5000-uk9.5.2.1.n1.4.bin admin-password Cisco123 F. load n5000-uk9-kickstart.5.2.1.n1.4.bin Answer: A, B QUESTION: 202 Exhibit

Refer to the exhibit. Both Cisco Nexus 5596UP Switches have one Layer 3 card installed each. Which two additional options are available? (Choose two.) A. Eight additional Cisco Nexus 2000 switches can be connected in the same manner. B. Sixteen additional Cisco Nexus 2000 switches can be connected eight individually to each 5596. C. One additional Layer 3 expansion module can be installed in each 5596 to increase the Layer 3 forwarding capability. D. FEX ports can be configured as router ports, extending Layer 3 redundancy to top of rack. E. FEX ports can be configured for FCoE, reducing cabling footprint. F. Sixteen additional Cisco Nexus 2000 switches can be connected in the same manner. Answer: A, B QUESTION: 203 What is the maximum distance that is supported by Cisco active Twinax cables? A. 8 m B. 10 m C. 12 m D. 15 m Answer: B QUESTION: 204 Which statement is correct regarding a routed port on a multilayer switch? A. A routed port requires an SVI definition.

B. Routed ports cannot be configured on a multilayer switch that uses SVIs. C. A maximum of 32 routed ports can be provisioned on a given multilayer switch. D. A routed port is a physical port that supports Layer 3 routing. Answer: D QUESTION: 205 Which three options represent a subnet mask that allows for 60 host addresses on a subnet? (Choose three.) A. /25 B. 255.255.255.192 C. /26 D. 255.255.255.240 E. 255.255.255.248 F. /28 G. /30 Answer: A, B, C QUESTION: 206 Where does Cisco Nexus Operating System store the startup configuration file? A. RAM B. flash C. bootflash D. volatile E. NVRAM Answer: E Explanation: "A persistent copy of Cisco Router configuration file is called as "startup-config" file. The "startup-config" file is kept in NVRAM and the contents of the "startup-config" file are retained after a reboot." http://www.omnisecu.com/cisco-certified-network-associate-ccna/cisco-routerconfiguration-files.php QUESTION: 207 What are two advantages of employing an external router for inter-vlan routing over an IEEE 802.1Q trunk link? (Choose two.)

A. Layer 3 functionality is not required on the switch. B. The router facilitates communication between VLANs. C. The single traffic path is optimized. D. Latency is reduced as packets leave the switch. E. Equal-Cost Multipath is supported. Answer: A, B QUESTION: 208 How many IP addresses are usable for a subnet that has the address 10.6.128.0/21? A. 1024 B. 2048 C. 1022 D. 2046 E. 256 Answer: D QUESTION: 209 What is the maximum distance for 100Base-TX? A. 10m B. 100m C. 400m D. 500m Answer: B

For More exams visit http://killexams.com Kill your exam at First Attempt...Guaranteed!