HMI unit 560HMR01 Characteristics Application The 560HMR01 is a rack based human machine interface board of the RTU560 system. The essential tasks of the 560HMR01 are: Interface to RTUs that are running webserver and RTU560 Integrated HMI. It communicates via Ethernet LAN interfaces and provides interfaces to connect a local monitor, mouse, keyboard and audio Run Windows based operating system for RTU560 Integrated HMI The 560HMR01 takes two slots of the RTU560 rack. The connection from the 560HMR01 to the rack is done via a DIN 41612 F-connector. The microetxexpress module with an INTEL Atom CPU is the essential hardware part of the 560HMR01. All connectors (except power supply) are integrated in the front plate (see Fig. 1). The interfaces E1 and E2 are based on the Ethernet standard 10BaseT/100BaseT. The interfaces U1, U2, U3 and U4 are based on the USB 2.0 standard, type A. The connectors of the Ethernet and USB communication interfaces are provided as combined jack with one RJ45 jack and a dual USB 2.0 type A jack. The Audio interface provides a 2-channel High Definition stereo signal for use with an external active speaker system or a headphone. The connector of the VGA interface is integrated in the front plate The operating system of the 560HMR01 can be shut down or started by using the power switch. The power switch is buried placed behind the boards front plate. The power switch can be tripped through the drill in the boards front plate (to the left of the VGA connector) by using a suitable tool. An exchangeable 3V Lithium-battery buffers the 560HMR01 real-time clock in case the device is without power supply. The operating system and the firmware are stored on the fixed installed 16GB data storage (Solid State Disk). Doc.-No.:1KGT 150 808 V001 1 1
Figure 1: Front plate 560HMR01 2 Doc.-No.: 1KGT 150 808 V001 1
Technical Data In addition to the RTU500 series general technical data, the following applies: Main Processor Unit MPU Mechanical Layout Length 170 mm Microprocessor RAM Flash Memory Intel Atom N270 TM 1.6GHz, 512MB L2 Cache max. 2GB DDR2 533MHz SODIMM min. 16GB SSD max. 128GB SSD Width Height Weight 37 mm 130 mm approx. 0.5 kg Ethernet LAN-Interface E1 and E2 Physical Interface 10BaseT / 100BaseT Bit rate 10/100MBit/s Connector types Power Supply 48 pole DIN 41612 F- connector Ethernet Interface RJ45 jack, 8 pole E1, E2 USB-Interface U1, U2, U3 and U4 USB Interface U1, U2, U3, U4 USB 2.0 jack, Type A Physical Interface USB 2.0 Type A (Host) VGA Interface HD-D-SUB, 15 pole Bit rate Low, High and Full Speed (EHCI max. 480MBit/s) Audio Interface 3.5mm jack plug (Stereo) Current supply max. 500 ma (total for all USB interfaces) Immunity tests VGA-Interface Physical Interface VGA HD-SUB 15 (R, G, B, H-Sync, V-Sync) CRT max. Resolution QXGA (2048 x 1536) Audio-Interface EN61000-4-2 Electrostatic Discharge Immunity EN61000-4-3 Radiated RF Field EN61000-4-4 Fast Transient Immunity (Burst) 8 KV air 6 KV direct 20 V/m 2 KV Performance criteria B Physical Interface Jack plug 3.5mm Stereo (2-Channel) EN61000-4-5 Surge Immunity 2 KV / 1 KV DC-Input EN61000-4-6 Conducted RF Field 10V Voltage: 5 VDC Tolerance Range -5 +5 % Max. Current 3 A @ 5 VDC EN55011 RF emissions air EN55011 RF emissions cable 30 MHz up to 1 GHz class A 0.1 MHz up to 30 MHz class B Starting Current: < 10 A, 1.5 ms (Class S1) according IEC 60870-4 Doc.-No.: 1KGT 150 808 V001 1 3
Environmental tests EN60068-2-2 EN60068-2-1 60 C 96h fully active loaded 0 C 96h fully active loaded Electrical Safety EN60950-1 Safety class 1 (EN60950-1 2 nd Edition) Electrical Safety investigation EN60068-2- 1 Start up Test EN60068-2-14 EN60068-2-30 IEC60255-21-3 Seismic Test IEC60255-21-1 Vibration Test IEC60870-2-2 Vibration durance test IEC60255-21-2 Shock Test IEC60870-2-1 Shock Test IEC60255-21-2 Bump Test -25 C System starts on -25 C 0 C /70 C Temperature cycles 48h, fully active loaded 70 C/95% rel. Humidity Storage, not active Class 1 Class 1 Class Bm 15g, Class 1; Class Bm 25g, Class 1; Class Bm 10g, Class 1 Environmental Conditions Nominal operating temperature range Start up Storage temperature range Relative Humidity (EN60068 2-30) Site of operation Ordering Information 0... +60 C -25 C -30 +85 C 5... 95 % (non condensing) Fixed mounted at rack max. 5000m a.s.l. no aggressive gases 560 HMR01 R0001 1KGT 030500 R1001 4 Doc.-No.: 1KGT 150 808 V001 1
Note: We reserve the right to make technical changes or modify the contents of this document without prior notice. With regard to purchase orders, the agreed particulars shall prevail. ABB AG does not accept any responsibility whatsoever for potential errors or possible lack of information in this document We reserve all rights in this document and in the subject matter and illustrations contained therein. Any reproduction, disclosure to third parties or utilization of its contents - in whole or in parts - is forbidden without prior written consent of ABB AG. Copyright 2013 ABB All rights reserved Doc.-No.:1KGT 150 808 V001 1 5