igital Lighting Systems, Inc. -MPW our hannel MX5 TRI / SR Trigger oard MX5 compatible -MPW USR'S MNUL -UM 0-
Low Voltage Wiring Methods igure 4 M Network Ports onnections. uttom view 8 to V / 00 M rom transformer Same phase as Hot Input of or 0V and 0V applications only - T +T MX5 ata igure 5 - Typical Installation 0V 0V 0V To Loads To Loads To Loads MX ONTROL QUIPMNT One twisted pair data M400 -MX-0 9- V Logic power M400 -MX-0 * * * 9- V Logic power M400 -MX-0 9- V Logic power To more MX quipment * The 9-0 V logic power is not needed in low voltage applications : 8-4V The same Low voltage transformer could be used for the all -0 connected to the same phase 0 SW 8 t. ; Miami, L 8 Tel: 05-99-844 ax: 05-99-85 opyright 0 igital Lighting Systems, ll rights Reserved Specifications are subject to change without notice. Printed in U.S.. -UM 0- PG
The can control up to 4 s on the same phase. This iring board is compatible with MX5 controllers and dimming systems and equivalent to 4 dimmers. 4.5".95" Optocouplers 4 SR SR xisting parts 4.50" 4.0" S MX V. Microprocessor 0 0 RS485 ommunication S High address 4 Jp Load ack to ack SRs X NUTRL HOT hannel Indicators Triac typical connection 9 V - + lack Yellow Transformer 9 V 9 V mp Violet + T MX5 T US Red - T -MPW is supplied with prewired RJ Jacks PIN # = - ; Pin #8 = + 0V IN Transformer from 8 V to V for logic power and phase reference. Included in -MPW s connected to this oard should be on the same phase to operate correctly. T T TRI T T Load X NUTRL HOT 0 SW 8 t. ; Miami, L 8 Tel: 05-99-844 ax: 05-99-85 opyright 0 igital Lighting Systems, ll rights Reserved Specifications are subject to change without notice. Printed in U.S.. PG -UM 0-
MX ddress Setting Up to 8 firing/ trigger Modules may be installed per system and their MX input daisy-chained. ifferent addresses ranging from to 509 may be selected for each dimmer Module( starting address for group of 4 channels), depending on which MX channel(s) will be used to control it. ach iring / trigger Module uses four consecutive MX bytes from the input stream beginning at the address selected using rotary selectors S, S and address expansion jumper S. (See igure on page for selectors location). The is shipped from the factory with jumper S installed allowing a MX address range between and 5 to be selected by S & S (See Table 4). or higher addresses ( 5-509) jumper S must be removed (See Table 5). Non-im Output Setting ny or all of the outputs may be configured for non-dim (switch only) operation. This prevents inadvertent dimming, or damage, of loads that cannot be dimmed, such as contactors, mechanical relays, motors, non-dim fluorescent, etc... Since this procedure involves adding external wire jumpers to the INT4 board, it is preferable to have it performed by the factory, at time of order. However, a qualified electronic technician can perform the procedure in the field when necessary. igure 8 shows the location for installing the non-dim (N) jumpers. The numbers shown next to the N jumpers represent the corresponding output number of the. Installing an N jumper makes the corresponding output non-dim (switch only). MX value greater than turns a non-dim output to full intensity. MX value of or less turns it fully off. 0. use - Optocouplers 4 S 0 9 V MX- V4. Microprocessor 0 - RS485 ommunication S S hannel Indicators + High address N N N N4 4 hannel 4 hannel hannel hannel ddress xpansion Jumper (S) S Installed (S,S) ddress Range: -5 S Removed (S,S) ddress Range: 5-509 Non-im Jumpers N-N4 Installed Output Is Non-im (Switch Only) Removed Normal Output. Unit is shipped without N jumpers. igure 8 - M400 ddress & Mode Selection. 0 SW 8 t. ; Miami, L 8 Tel: 05-99-844 ax: 05-99-85 opyright 0 igital Lighting Systems, ll rights Reserved Specifications are subject to change without notice. Printed in U.S.. PG -UM 0-
ddress Selection Information Table 4 - ddresses -5 ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S 00 0 5 40 9 0 9 80 0 9 0 5 0 0 4 4 98 0 8 94 0 5 4 99 8 95 4 0 8 4 00 8 4 9 8 5 04 4 9 44 0 4 84 5 4 9 4 9 4 05 8 5 0 0 5 4 85 5 98 5 0 5 0 9 4 0 5 8 99 8 0 40 4 04 8 8 00 9 08 4 8 48 05 8 88 9 8 0 8 8 0 09 4 9 4 49 0 9 8 0 9 0 9 4 9 0 4 5 4 0 9 8 0 5 0 44 4 08 40 8 04 0 4 09 4 8 05 4 0 4 8 4 0 4 8 4 0 8 5 0 4 9 4 4 8 5 0 9 0 48 80 4 44 8 08 40 0 49 0 8 50 0 90 0 09 0 4 0 8 50 8 5 4 4 9 8 0 4 9 5 8 5 5 4 9 9 4 0 5 84 5 48 9 80 44 4 5 4 85 54 4 49 94 8 4 4 4 5 54 5 8 55 8 5 50 95 8 5 4 5 4 5 55 8 5 9 5 9 8 5 4 4 5 88 5 0 5 9 84 48 5 8 5 8 58 8 5 98 85 8 8 49 8 9 58 9 90 59 9 54 99 8 9 8 9 50 9 59 9 5 55 9 8 9 5 8 0 9 5 4 5 9 88 0 5 9 9 5 5 5 9 5 0 94 5 58 9 90 54 95 5 59 9 9 55 4 9 5 8 0 9 9 4 5 Table 4 - ecimal to Hexadecimal ddress hart. ddress Selection hart Using S-S with JUMPR INSTLL 0 SW 8 t. ay #05 Miami, L 8 Tel: 05-99-844 ax: 05-99-85 opyright 00 igital Lighting Systems, ll rights Reserved Specifications are subject to change without notice. Printed in U.S.. PG 4 -UM 0-
ddress Selection Information Table 4 - ddresses 5-509 ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ha. Select ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S ddr. S S 5 00 0 40 5 0 85 80 4 0 449 0 48 0 58 0 90 4 54 8 8 48 0 48 59 0 9 4 55 8 8 49 48 0 0 9 4 4 5 88 8 40 484 04 9 4 5 44 5 4 84 4 4 4 485 4 05 94 5 58 5 90 85 4 5 4 5 48 5 0 95 4 59 9 8 4 5 48 4 0 9 8 4 0 9 8 44 488 5 08 9 8 9 48 8 9 88 8 8 4 8 09 98 9 0 49 9 94 4 9 8 9 490 9 0 99 4 95 8 4 9 49 8 0 00 4 4 9 8 48 40 49 9 0 0 4 5 9 8 49 4 49 0 0 0 4 4 98 8 40 4 494 0 0 5 4 99 8 4 4 495 0 04 4 8 400 8 4 44 49 0 05 0 50 9 0 40 90 4 0 45 0 49 0 4 0 8 5 0 40 9 44 4 498 5 0 9 5 40 9 4 499 08 40 5 404 9 4 48 500 4 09 4 4 54 4 405 94 4 4 49 4 50 4 8 5 0 5 4 55 4 5 40 95 48 5 40 5 50 5 9 4 5 5 40 9 49 4 50 80 44 5 408 9 440 4 504 8 8 8 58 8 409 98 44 8 4 8 505 8 8 9 4 9 4 59 8 9 40 99 44 9 44 9 50 9 8 5 4 5 9 4 9 44 45 50 84 48 5 80 4 9 444 4 508 85 49 5 8 4 9 4 4 509 8 8 50 5 8 44 9 44 48 50 N/ 8 9 5 5 8 45 9 44 49 5 N/ 88 0 5 5 84 4 9 448 480 5 N/ Table 5 - ecimal to Hexadecimal ddress hart. ddress Selection hart Using S-S with JUMPR RMOV 0 SW 8 t. Miami, L 8 Tel: 05-99-844 ax: 05-99-85 opyright 00 igital Lighting Systems, ll rights Reserved Specifications are subject to change without notice. Printed in U.S.. PG 5 -UM 0-
LIMIT WRRNTY igital Lighting Systems, warrants to the purchaser that its products have been carefully manufactured and inspected and are warranted to be free from defects of workmanship and materials when used as intended. ny abuse or misuse contrary to normal operation shall void this warranty. igital Lighting Systems' obligation under this warranty shall be limited to replacement or repair of any units as shall within two years of date of invoice from igital Lighting Systems, prove defective; and igital Lighting Systems shall not be liable for any other damages, whether direct or consequential. The implied warranties of merchantability and fitness for a particular purpose are limited to the duration of the expressed warranty. Some states do not allow the exclusion of the limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, you may also have other legal rights which vary from state to state. Upon request, replacement unit(s) will be shipped as soon as available. Unless immediate shipment of replacement merchandise is requested, igital Lighting Systems will not ship replacement merchandise until defective merchandise is received, inspected, and determined to be defective. No labor charges in connection with warranty problems will be reimbursed by igital Lighting Systems without prior written approval from the factory. igital Lighting Systems distributors and representatives have no authority to change this warranty without written permission. igital Lighting Systems reserves the right to determine the best method of correcting warranty problems. efective merchandise may be returned to igital Lighting Systems, prepaid, after prior notification has been given and approval obtained for the return. To obtain prior approval for the return of the defective items, contact your local igital Lighting Systems distributor, representative, or: igital Lighting Systems, Inc. ttn: ustomer Service epartment 0 SW 8 t. Miami, L 8 (05) 99-844 igital Lighting Systems, Inc. 0 SW 8 t. Miami, L 8 Tel 05-99-844 ax 05-99-85 e-m info@digitallighting.com Printed in U.S.. 0/ 0