Intercom Installation The b-red KIT audio entry control systems AKW200/201
What is the b-red 2 wire system? The b-red is an entry level intercom system, It makes use of digital technology and as such communication is on a polarised 2 wire set-up. The 2 wires will facilitate intercom and gate release function. This system allows one to create an audio entry system with up to 2 calls. The entry panel can be configured to allow 1 or 2 entry buttons by means of a jumper setting. The system can be expanded up to 4 handsets Intercom Installation The b-red
The audio entry control kit includes a handset with two buttons, one to open the door and the other for an additional command. The power supply unit is equipped with a rectifier that provides continuous voltage of 18 V - 9 VA (500mA) and is thermally and electronically protected against overloads and short circuits. The entry panel is a surface mount unit with a single call button able to serve one or two residences, depending on the system configuration. The call button is back-lit with a green LED light. Intercom Installation The b-red
2 kits available, either with or without power supplier AKW200 audio kit with power supplier AKW201 audio kit without power supplier Intercom Installation The b-red
Expandability Example of an expansion in a single dwelling Example of an expansion in a semi-detached home Intercom Installation The b-red
Pre selected groups The kit is set up for intercommunication between internal extensions, either all together or in two groups as in a semi-detached house or apartments, with secrecy of speech without requiring additional wiring or accessories. As the handset has only one button to call the group, a handset can only call the group that it has been assigned to by means of the jumpers. Intercom Installation The b-red
Handset AUX L / + L+ AUX L / + L+ Auxiliaries 100mA Mains data line / Power supply Power supply 14V 18V Positive data extension Entry panel Auxiliaries 100mA Mains data line / Power supply Power supply 14V 18V Positive data extension Solenoid lock connection Solenoid lock connection Max 12V 0.5A Gate Relay The b-red - Installation and configuration
Table of distances with power supplier included Intercom Installation The b-red
The power supplier has electronic protection of the transformer and power supplier against overloads and short-circuits. To reset to normal operating mode in case of interruption the following instructions must be followed: a. Disconnect 230V b. Correct the reason for the power supply shut down c. Let the power supply cool down for at least one minute d. Reconnect to 230V Intercom Installation The b-red
Function and configuration of the jumpers JP1 Call volume control. Default (on) position is for normal audio level. JP3 JP2 JP1 If 2 or more handsets is on the same call a master and slave set-up is needed. The handset with the set JP1 will receive the ring and then this handset will forward the ring command to the other handsets with their removed JP1. The jumpers have to be stet as follows: JP1 JP1 JP1 If the other handsets JP1 is not removed the system will not function properly when the call button is pressed The b-red - Installation and configuration
JP2 JP2 JP2 JP2 JP2 JP2 JP2 JP2 JP2 Intercom selection. Default (on) allows intercommunication with all handsets with the same JP2 setting. Remove JP2 to communicate with all other handsets with the same JP2 removed. The b-red - Installation and configuration
1 2 JP4 JP4 JP4 Call button selector. Default (on) selects single call activation 1 Remove JP4 to activate second call. The entry pane has a small wire in the corner that when cut will increase the ring to the striker lock or relay from 1 sec to 5 sec The b-red - Installation and configuration
1 2 1 1 2 JP3 Call selection. Default (on) This handset will respond to button one being called. Remove JP3 This handset will respond to button two being called. 1 2 2 The b-red - Installation and configuration
Accessories L2 MPRED MPREDSS Powder coated gooseneck Gooseneck mounting plate for audio panel Gooseneck mounting plate for audio panel Stainless steel The b-red - Accessories