Series 5 Compact Mixing Console 5/SX www.dhd- audio.com DHD. audio Digital Broadcast Technology Made in Germany
5/SX Features Input page Equalizer page Dynamics page Main page PPMs, clock, stopwatch, phase metering Snapshots page Aux page Monitoring page Encoder for channel settings, gain, input, Aux level Brilliant multitouch IPS Display with flexible pages for main, EQ, dynamics, input settings, snapshot management Program bus push buttons Pre-listening & talkback speaker with built-in amp Aux bus status indicators Encoder section for control of EQs, dynamics, other settings Channel select push buttons, access to central section PFL push buttons Channel ON status light bar OLED displays for 6-character channel names, encoder function, status and input level icons, 60 viewing angle Flexible encoder & OLED display section for additional volume and monitor selectors, studio support GPIO push buttons Talkback microphone with built-in preamp Monitor selector, expanded by touch-display selector Professional high-grade 00 mm conductive plastic faders Professional high-grade volume potentiometers On/Off push buttons Talkback push buttons Professional push buttons with silent mm travel and multi-colour LEDs Magnetic fixing for panels; flat or angled installation with split options Pre-labeled push-button function printed on front panel
5/SX Overview Compact Mixer - Powerful Features The 5/SX is a modular compact mixing console for radio and TV. The priceoptimised mixer is ideal for On-Air studios, audio workstations and smaller OB vans. It complements DHD's 5/MX and 5/RX product lines. The 5/SX is based on the same Series 5 firmware platform. It can be configured with a simplified version of the Toolbox8 software called SXConfig. The 5/SX can be extended to allow seamless networking with other Series 5 products, including DSP Control Software and Remote Control PC Software. The console consists of, 8,, or 6 faders and a central control section including talkback microphone, loudspeaker, and a 7" TFT Touch Display. 5/SX consoles are available in flat or angled versions, with split options. The modular -U core with I/O modules and DSP features microphone, headphone, analogue line, digital inputs and outputs (AES3, S/ PDIF, USB a udio), MADI, APC and Gigabit audio interfaces. The cabling between fader units, central section, DSP units and I/O units is realised solely via Ethernet (DHD audio, PoE mains supply, DHD control IP), thus allowing the usage of the commonly used CAT cabling systems. Console & I/O System Sizes -fader console Inputs/outputs available: Microphone/line inputs Headphone outputs line inputs line outputs Digital inputs, AES3/EBU Digital inputs, S/PDIF Digital inputs, USB Digital outputs, AES3/EBU Digital outputs, S/PDIF Digital outputs, USB TM Dante AoIP - inputs TM Dante AoIP - outputs General purpose inputs General purpose outputs control inputs height unit I/O system (5-80 + x 5-335) 5-80 5-335 Expanded system (5-80 + x 5-335) 5-335 5-335 5-80 x 5-335 x 5-335 8 8 3 0 0 6 6 6 0 0-77...+8 dbu sensitivity stereo max. + dbu max. + dbu opto coupler photo mos relays for external potentiometers 6-fader console Inputs/ outputs available on central module 5-0: Talkback microphone PFL/Talkback speaker built-in, connected via ethernet built-in, connected via ethernet MADI (hardware option) 5-73: MADI input channels MADI output channels up to x 6 up to x 6 AES0 format, licensed SFP module, LC duplex/fibre AES0 format, licensed SFP module, LC duplex/fibre DSP Control Software Gigabit audio networking (hardware option) 5-739: Gigabit audio interface input channels up to x 5 Gigabit audio interface output channels up to x 5 Dante / AES67 (hardware option) 5-7080: Audio over IP input channels Audio over IP output channels 6 6 DHD format, licensed SFP module, LC duplex/fibre DHD format, licensed SFP module, LC duplex/fibre SXConfig Software
5/SX Console Layouts Two fader module layouts for different customer preferences 5-0 Fader Modules Channel On/Off buttons located above faders, no buttons below. 5-05 Fader Modules Channel On/Off buttons located below faders. Specifications and design are subject to change without notice. The content of this document is for information only. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use. Publication thereof does neither convey nor imply any license under patent rights or other industrial or intellectual property rights.
5/XS Core & Multi-I/O Box for 5/SX Console XS Multi-I/O Box 5-335 XS Core 5-80 General purpose inputs & outputs control inputs 9" Adapter panel S/ PDIF digital audio input & output AES3/EBU digital audio inputs & outputs USB digital audio interfaces DHD audio, power & control ethernet ports for I/O, TFT, fader and control modules and optional APC audio Wordclock and AES sync Dante 6ch/6ch (hardware option) Serial control (software option) ½ 9" U module ½ 9" U module Mic/Line inputs & headphone outputs line inputs & outputs DHD audio, power & control ethernet interface DHD Gigabit audio networking or MADI ( hardware option) USB port, reserved for future use ( software option) DHD network, TCP/IP external control, maintenance, Dante ch/ch interface Redundant 8 V power supply inputs High-performance 0-bit floating-point digital signal processing for 3-band full parametric equalizers, subsonic filter, dynamics, limiter, delay for all 6 fader channels, mono or stereo 6 stereo summing busses, Aux busses, clean feeds and PFL 6 clean feeds (mix-minus, mono or stereo) monitoring busses for control room and studio support flexible talkback, logic and GPIO system integrated routing matrix internal tone generator low-latency interconnection between 5/XS cores or to other DHD products via Gigabit Audio (fibre, 5 input and 5 output channels) or APC (CAT 5/6, 8 input and 8 output channels) USB audio interface for direct connection to PC Dante interface with ch/ch built-in, additional option for 6ch/6ch Dante AoIP internal or external 8 khz or. khz sync Rear view XS I/O Core 5-830 (for up to 8 faders) Front view XS I/O Core 5-830 stand-alone system does not require a PC; no fan, no hard disc, no battery inside highly efficient external, wide-range power supply, Energy Star Level V, redundancy option minimal system power consumption expandable modular system allows optional integration with other DHD product lines TCP/IP or serial interface options to radio automation or other external control systems
5/SX Modules and Specifications Product Number 5-0A 5-0A 5-05A 5-08A 5-335A 5-80A 5-830A 5-73A 5-99A 5-98B 5-950 5-739A 5-8583 5-08B 5-60A 5-606A 5-608A 5-60A 5-6A 5-68A 5-307A 5-80A 5-806A 5-808A 5-80A 5-8A 5-88A 5-300A Product Name SX Central Module SX Fader Module SX Fader Module SX Blank Module XS Multi-I/O Box XS Core, 8-6 Fader Processing XS I/O Core, 8 Fader Processing XC MADI port, multimode SFP XS 9" Adapter Panel XS Power Supply 8 V / 00 W XS Core extended feature upgrade XS Core Gigabit Audio Port XS Core Control Networking TFT/Touch Display, 7" IPS Table-Top Stand for 5-08 Console Mounting Kit for 5-08 Description 9 push buttons, volume controls 6 rotary encoders 3-character OLED display built-in loudspeaker/amp, mic/preamp fader channels, each with: - 5 push buttons above fader - 3-character OLED display - 00 mm conductive plastic faders - rotary encoder fader channels, each with: - push button below, above fader - 3-character OLED display - 00 mm conductive plastic faders - rotary encoder 80 mm x 399 mm x 36 mm mic/line inputs, preamp, 8 V stereo headphone outputs 8 analogue line inputs, el. bal., dbu 8 analogue line outputs, el. bal., dbu 3 AES3/EBU inputs, S/PDIF input AES3/EBU outputs, S/PDIF output USB audio IF, 0 GPI, 0 GPO, ACI replaces 5-330 DSP & Controller with Micro SD Card 8 audio, power & control ports supports SX console with up to 6 faders number of available functions limited by XS core hardware, see specifications DSP & Controller & I/O Box audio, power & control ports supports 8-fader SX console number of available functions limited by XS core hardware, see specifications 56 or 6 in/out ch., multimode fibre, LC SFP module for 5-80, 5-830 for housings / 9" width input voltage 90-6 VAC allows Toolbox5 configuration instead of configuration assistant with predefined function set Gigabit audio interface to DHD routers or other DHD mixers control interface for logic exchange between DHD devices 7" / 78 mm diagonal size aluminium extrusion frames for flat installation magnetic fixing for panels table cutout required angled console frame with metal sides rear height 5 mm magnetic fixing for panels simple table cutout required Typical fader mixer (5-995) 3 Typical 6 fader mixer, split Mic/Line Input Specifications Input sensitivity: Gain setting: Frequency response: Dynamic range: THD+N: Equivalent input noise: Phantom power 8 V: Max. input level: Converter technology: Line Input Specifications Max. input level: Frequency response: THD+N: Dynamic range: Converter technology: Line Output Specifications Max. output level (phones, single-ended): Minimum load (outputs short-circuit protected): Frequency response: THD+N: Dynamic range: Converter technology: Digital Input/Output Specifications Input/output impedance: Input sensitivity: Sample rate converters (SRC): Input SRC sampling frequency range: Output SRC sampling frequency range: Dynamic range (SRC off): Output level: Output dither: 5/SX Mounting Frames Table-Installation Frames 5-6xx Specifications and design in this document are for information only and subject to change without notification. -77 dbu... 8 dbu analogue preamp 0 db, 0 db... 63 db in steps of db, -0... +0 db digital gain in steps of db < 0.03 db (0 Hz... 0 khz) > db (A-weighted) < -8 db / 0.008% (- dbfs, +7 dbu, 0 db analogue / digital gain) < -7 dbu (50 ohm source), < -6 dbu (00 ohm source) switchable per input channel, unloaded input: 8 V ± 0% 8 dbu (balanced) bit, oversampling sigma-delta dbu (balanced) < 0.05 db (0 Hz... 0 khz) < -85 db / 0.006% (- dbfs, +3 dbu) > 98 db (A-weighted) bit, oversampling sigma-delta dbu (balanced) 600 ohm < 0. db (0 Hz... 0 khz) < -8 db / 0.006% (- dbfs, +3 dbu) > 0 db (A-weighted) bit, oversampling sigma-delta 0 ohm (AES3/EBU) or 75 ohm (S/PDIF) > 00 mv inputs and outputs (switchable, slaved to related input) 8 khz... 08 khz 8 khz... 5 khz db (-bit digital audio) 3. V (into 0 ohm load) off, 6, 0 bit (switchable by configuration software) version 06-08-9 Console Frames 5-8xx Mixing Routing Controlling Networking Switching DHD audio GmbH Haferkornstr. 5 09 Leipzig / Germany sales@dhd- audio.de www.dhd- audio.com