Specifications FOX Matrix 3200/7200/14400/320x Series, SMX 88/1616 FOX NOTE: The I/O boards are class 1 laser products. They meet the safety regulations of IEC-60825, FDA 21 CFR 1040.10, and FDA 21 CFR 1040.11. Optical specifications Number/type... Fiber optic inputs and outputs I/O board 3200/7200 Series... 8 singlemode or 8 multimode (8 Tx and 8 Rx) 14400/320x Series... 16 singlemode or 16 multimode (16 Tx and 16 Rx) SMX 88/1616 FOX... 8 or 16 singlemode, or 8 or 16 multimode NOTE: Only one fiber is required to transmit video, audio, and unidirectional data. A second fiber is required to transmit return data for bidirectional control/communication. Connectors... 16 or 32 LC connectors per I/O board Operating distance Singlemode... 30 km (18.75 miles) with singlemode (SM) cables with an Extron singlemode distribution amplifier or transmitter/receiver Multimode... 300 m (985') with 62.5 µm multimode (MM) cables with an Extron multimode Tx/Rx unit 1 km (3280') with 50 µm multimode (MM) cables with an Extron multimode Tx/Rx unit 2 km (6561') with 50 µm, 2000 MHz bandwidth, laser-optimized multimode (MM) cables with an Extron multimode Tx/Rx unit NOTE: Operating distance is approximate. These are typical distances. The maximum distance may be greater than these typical numbers depending on factors such as fiber type, fiber bandwidth, connector splicing, losses, modal or chromatic dispersion, environmental factors, and kinks. Nominal peak wavelength... 850 nm for multimode (MM), 1310 nm for singlemode (SM) Transmission power Singlemode... -5 dbm, typical Multimode... -5 dbm, typical Maximum receiver sensitivity Singlemode... -18 dbm, typical Multimode... -12 dbm, typical Optical loss budget Singlemode... 13 db, maximum Multimode... 7 db, maximum Maximum channel data rate... 4.25 Gbps Video fiber optic Routing 3200 Series... 8 x 8 up to 32 x 32 unidirectional (Tx) matrix or 4 x 4 up to 16 x 16 bidirectional (Tx/Rx) matrix 7200 Series... 8 x 8 up to 72 x 72 unidirectional (Tx) matrix or 4 x 4 up to 36 x 36 bidirectional (Tx/Rx) matrix 14400 Series... 16 x 16 up to 144 x 144 unidirectional (Tx) matrix or 8 x 8 up to 72 x 72 bidirectional (Tx/Rx) matrix 1
320x Series... 16 x 16 up to 320 x 320 unidirectional (Tx) matrix or 8 x 8 up to 160 x 160 bidirectional (Tx/Rx) matrix SMX 88/1616 FOX... 8 x 8 or 16 x 16 unidirectional (Tx) matrix or 4 x 4 or 8 x 8 bidirectional (Tx/Rx) matrix Gain... Unity Pixel data bit depth... 8 bits per channel, 3 channels (R, G, B) Video/audio input or output fiber optic Number/signal type 3200 Series... 8 to 32 fiber optic signals 7200 Series... 8 to 72 fiber optic signals 14400 Series... 16 to 144 fiber optic signals 320x Series... 16 to 320 fiber optic signals SMX 88/1616 FOX... 8 or 16 fiber optic signals Connectors 3200/7200 Series... 8 LC connectors per I/O board 14400/320x models... 16 LC connectors per I/O board SMX 88/1616 FOX... 8 or 16 LC connectors per I/O board NOTES: Input comes from an Extron fiber optic transmitter or fiber optic distribution amplifier. Output connects to an Extron fiber optic receiver. Digital video SDI/HD-SDI (FOX 3200/7200 Series with FOX I/O HD-SDI) Routing 3200 Series... 8 x 8 up to 32 x 32 matrix 7200 Series... 8 x 8 up to 72 x 72 matrix Gain... Unity Maximum data rate... 2.97 Gbps Auto data rate lock... Yes Data types... 8 or 10 bit Operation standards... SMPTE 292M, SMPTE 259M, SMPTE 424M, ITU-RBT.601, ITU-RBT.1120 Digital video input SDI/HD-SDI (FOX 3200/7200 Series with FOX I/O HD-SDI) Number/signal type... 8 single link SDI, HD-SDI; or dual link HD-SDI per board Connectors... 8 female BNC per board Nominal level... 0.80 Vp-p ± 10% Impedance... 75 ohms Return loss... <-14 db @ 1 MHz to 1.5 GHz Equalization... Automatic Input cable equalization distance HD-SDI Extron SHR, Belden 1694A cable 492' (150 m) Extron HR, Belden 1505A cable 328' (100 m) SDI Extron SHR, Belden 1694A cable 984' (300 m) Extron HR, Belden 1505A cable 656' (200 m) NOTE: The transmission distance varies depending on the signal resolution and on the type of cable, graphic card, and display used in the system. 2
Digital video output SDI/HD-SDI (FOX 3200/7200 Series with FOX I/O HD-SDI) Number/signal type... 8 single link SDI, HD-SDI; or dual link HD-SDI per board Connectors... 8 female BNC per board Nominal level... 0.80 Vp-p ± 10% Impedance... 75 ohms Return loss... <-12 db @ 1 MHz to 1.5 GHz DC offset... 0 V with input at 0 offset Re-clocking... Automatic, or use available bypass mode for nonstandard rates Jitter... <0.2 UI Rise and fall time (20-80%)... 600 ps ±100 ps Control/remote switcher NOTE: For the FOX Matrix 320x Series, the front panel Config port and rear panel RS-232 port are independent of each other and can be used at the same time. Serial control ports... 1 bidirectional RS-232 or RS-422, female 9-pin D connector (rear panel) 1 bidirectional RS-232, 2.5 mm mini stereo jack (front panel ) Baud rate and protocol... 9600 to 115200 baud, 9600 baud (default), 8 data bits, 1 stop bit, no parity Serial control pin configurations Female 9-pin D connector... RS-232: 2 = Tx, 3 = Rx, 5 = GND RS-422: 2 = Tx-, 3 = Rx-, 5 = GND, 7 = Rx+, 8 = Tx+ Mini stereo jack... RS-232: tip = Tx, ring = Rx, sleeve = GND Ethernet control port... 1 female RJ-45 connector Ethernet data rate... 10/100Base-T, half/full duplex with autodetect Ethernet protocol... ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet Default settings... Link speed and duplex level = autodetected IP address = 192.168.254.254 Subnet mask = 255.255.0.0 Gateway = 0.0.0.0 DHCP = off Web server... Up to 200 simultaneous sessions 7 MB nonvolatile user memory Program control... Extron control/configuration program for Windows Extron Simple Instruction Set (SIS ) Microsoft Internet Explorer ver. 6 or higher, Telnet General Power*... 100 VAC to 240 VAC, 50-60 Hz; internal, hot-swappable * A redundant power supply is standard. NOTE: All wattages are measured at 115 VAC, 60 Hz and 240 VAC, 50 Hz. 3200 Series... 2 (positive-negative), 175 watts each (primary and redundant) Enclosure without boards: 31 watts Enclosure fully loaded with 4 singlemode boards: 55 watts Enclosure fully loaded with 4 multimode boards: 51 watts Enclosure fully loaded with 4 SDI/HD-SDI boards: 67 watts Each singlemode board: 6 watts at 115 VAC, 60 Hz Each multimode board: 5 watts at 115 VAC, 60 Hz Each SDI/HD-SDI board: 9 watts at 115 VAC, 60 Hz 3
7200 Series... 2 (positive-negative), 175 watts each (primary and redundant) Enclosure without boards: 34 watts Enclosure fully loaded with 9 singlemode boards: 88 watts Enclosure fully loaded with 9 multimode boards: 79 watts Enclosure fully loaded with 9 SDI/HD-SDI boards: 119.5 watts Each singlemode board: 6 watts Each multimode board: 5 watts Each SDI/HD-SDI board: 9.5 watts 14400 Series... 2 (positive-negative), 100 VAC to 240 VAC, 50-60 Hz; internal, 400 watts each Enclosure without boards: 50 watts Enclosure fully loaded with 9 singlemode boards: 167 watts Enclosure fully loaded with 9 multimode boards: 149 watts Each singlemode board: 13 watts Each multimode board: 11 watts *A redundant power supply is standard. 320x Series... 4 (positive-negative), 400 watts each Enclosure without boards: 120 watts Enclosure fully loaded with 20 singlemode boards: 380 watts Enclosure fully loaded with 20 multimode boards: 340 watts Each singlemode board: 13 watts Each multimode board: 11 watts *A redundant power supply is standard. SMX 200 Series with SMX 88 FOX One SM board: 9 watts One MM board: 8 watts SMX 200 Series with SMX 1616 FOX One SM board: 13 watts at 115 VAC, 60 Hz and 240 VAC, 50 Hz One MM board: 12 watts at 115 VAC, 60 Hz and 240 VAC, 50 Hz Temperature/humidity... Storage: -40 to +158 F (-40 to +70 C) / 10% to 90%, noncondensing Operating: +32 to +122 F (0 to +50 C) / 10% to 90%, noncondensing Cooling... Fan, right to left (as viewed from front panel) Thermal dissipation, full load 3200 Series 115 VAC, 60 Hz... Dual power supplies: 228.6 BTU/hr 240 VAC, 50 Hz... Dual power supplies: 232.0 BTU/hr 7200 Series 115 VAC, 60 Hz... Dual power supplies: 407.8 BTU/hr 240 VAC, 50 Hz... Dual power supplies: 411.1 BTU/hr 14400 Series 115 VAC, 60 Hz... Dual power supplies: 569.8 BTU/hr 240 VAC, 50 Hz... Dual power supplies: 573.2 BTU/hr 320x Series 115 VAC, 60 Hz... 4 power supplies: 1296.6 BTU/hr 240 VAC, 50 Hz... 4 power supplies: 1301.7 BTU/hr Mounting Rack mount... Yes Enclosure type... Metal Enclosure dimensions 3200 Series... 7.0" H x 17.0" W x 12" D (4U high, full rack wide) (17.8 cm H x 43.2 cm W x 30.5 cm D) (Depth excludes connectors and buttons. Width excludes integrated rack ears.) 7200 Series... 14.0" H x 17.0" W x 12" D (8U high, full rack wide) (35.6 cm H x 43.2 cm W x 30.5 cm D) (Depth excludes connectors and buttons. Width excludes integrated rack ears.) 4
14400 Series... 14.0" H x 17.0" W x 12.25" D (8U high, full rack wide) (35.6 cm H x 43.1 cm W x 31.1 cm D) (Depth excludes connectors and handles. Width excludes rack ears.) 320x Series... 29.75" H x 19.0" W x 12.25" D (17U high, full rack wide) (75.6 cm H x 48.3 cm W x 31.1 cm D) (Depth excludes connectors and handles. Width excludes rack ears.) Product weight (fully loaded) 3200 Series... 34.5 lbs (15.6 kg) 7200 Series... 61.1 lbs (27.7 kg) 14400 Series... 69.1 lbs (31.3 kg) 320x Series... 113 lbs (51.3 kg) Shipping weight 3200 Series... 41 lbs (19 kg) 7200 Series... 68 lbs (31 kg) 14400 Series... 75 lbs (34 kg) 320x Series... 123 lbs (56 kg) SMX 88 FOX... 2 lbs (1 kg) SMX 1616 FOX... 3 lbs (2 kg) Vibration... ISTA 1A in carton (International Safe Transit Association) Regulatory compliance Safety... CE, c-ul, UL EMI/EMC... CE, C-tick, FCC Class A, ICES, VCCI MTBF... 30,000 hours Warranty... 3 years parts and labor NOTE: All nominal levels are at ±10%. NOTE: Specifications are subject to change without notice. 8.0-101110-D6 5