1080P HD Dome IP Camera IPD2220ES 4.3/6 Instruction Manual
IMPORTANT SAFEGUARDS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. GRAPHIC SYMBOL EXPLANATION The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the unit. CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
CAUTION Do not drop or strike this equipment. Sensitive electronics inside are vulnerable to excessive shock. Do not install the equipment near any naked flames or heat sources. Excessive heat could damage this unit. Do not expose this unit to rain or excessive moisture, avoid smoke and dust. Please the camera in an environmental housing for protection. If the camera gets wet, unplug it and have it checked by qualified service personnel. Do not cover cloth or to install this unit in poorly ventilated places. This may lead to overheating. Do not continue to operate if there appears to be fault. If the unit ceases to function, contact qualified service personnel for help. Do not touch the power connection with wet hands. Risk of short circuit or electric shock. Do not damage the power cord or leave it under pressure. Risk of fire or shock circuit.
CONGRATULATIONS Thank you for purchasing this 2 Megapixel HD Dome IP Camera. You now own one of the many fine network products we manufactured. This product has been carefully inspected under rigid quality control and should reach you in perfect condition. With reasonable care, it will provide years of reliable performance. We recommend that you read this installation and operation manual thoroughly before installing and operation your new system. Here you will find all the information you need to set up and use the system. If any questions are not answered in the manual, please contact your dealer. Before proceeding, please read and observe all instructions and warnings contained in this manual. Retain this manual with the original bill of sale for future reference and, if necessary, warranty service. When unpacking your new camera, check for missing or damaged items. If any item is missing, or if damage is evident, DO NOT I NSTALL OR OPERATE THIS PRODUCT. Contact your dealer for assistance.
Executive Summary IPD2220ES series is an 2 Megapixel 1080P HD Dome IP Camera, built-in H.264 AVC(Advanced Video Coding) video compression. H.264 AVC video compression engine supports high definition video quality, 1080P(1920x1080) resolution, bandwidth efficiency with PPPoE and DDNS. Also it provides higher bit rate of internet and diverse alarm functions such as movement video detection e-mail or FTP. Moreover, IPD2220ES series can do remote surveillance with ipad, iphone or Android cell phone. The software R&D engineer can use HTTP protocol(httpapi) or ONVIF protocol to develop related software, and integrate them with existing application software system. IPD2220ES series is ideal solution for remote video monitoring via internet.
PART DESCRIPTION & DIMENSION 120 1 2 102 3 10 4 5 6 7 8 9 1 Bottom Chassis 2 RJ-45 Network Connector 3 Dome Cover 4 Microphone 5 Mask 6 Camera Body 7 Network Indicator LEDs Green(LINK): Network cable connected, this LED lit. Orange(ACT): Data communications, this LED flashes. 8 Micro SD Card Slot 9 Reset Key To restore the server to factory default setting. 10 DC12V input connector (Optional Wire) Unit: mm
INSTALLATION 1. Please use the enclosed hexagon screw driver to untighten the 3 screws on the dome cover (FIG.1). FIG. 1 2. Put the provided screws (M3.0*25, wooden screw) through the holes marked as "a", and fix the bottom chassis in the desired area (FIG.2 & FIG.3). 45.7 20 a a a 62 62 FIG. 2 FIG. 3 3. Loosen the screws on the camera body cover to rotate the camera body to the desired angle and then tighten the screws (FIG.4 & FIG.5).
FIG. 4 FIG. 5 4. To connect DC12V input connector with wire accessory, than put the wire to fixed plates of the base (FIG.6 & FIG.7). FIG. 6 FIG. 7 5. Put on the dome cover, use hexagon screw driver to screw dome cover into bottom chassis and then tighten the screws (FIG.8). FIG. 8
1080P HD Dome IP Camera IPD2220ES 4.3/6 Instruction Manual IPD552EX2.2/4.2 N/P NOTE: Wire & Power Accessory (99-IPD2220WR) are option product. PRODUCTION COMPONENTS 1. 2 Megapixel 1080P HD Dome IP Camera 2. Instruction Manual H.264 Full HD IP Cameras INSTRUCTION MANUAL 3. CD Software Pack 4. L type Hex Key Wrench
SYSTEM ARCHITECTURES For connecting IPD2220ES series to the network, please follow one of the system architectures: (1). Use with PoE of the network switch connected to the network. LAN LAN / Internet IPD2220ES PoE Switch (2). Use PoE power injector and the network switch connected to the network. PC LAN LAN LAN / Internet IPD2220ES PoE Power Injector AC Non-PoE Switch PC EMERGENCY FACTORY DEFAULT Use hardware to restore factory default settings, follow these steps: 1. Hold "RESET Key" for 10 seconds, then release. 2. After about 40 seconds, the network LED light is off, and then lit. 3. This camera has completed the factory default settings, and then reboot. 4. Use IPScan software search for this IP device. 5. Using a Internet browser open the IP device. 6. Enter the default username "admin" and password "pass" to operate. NOTE For the convenience of users, restore the factory default settings will revert to the default IP address 192.168.0.200.
SPECIFICATIONS Model No. Focal Length Lens Iris Angle of view Pick Up Element Effective Pixels Chip Size Scanning System Minimum Illumination White Balance Back Light Compensation Electrical Shutter Sense Up Sense Up Plus Auto Gain Control 3D Noise Reduction 2D WDR Privacy Masking Image Effects Operating Temperature Dimension Weight Power SInput Voltage Power Consumption 1080P HD DOME IP CAMERA IPD2220ES4.3 IPD2220ES6 4.3mm 6mm F1.6 F1.8 70 (H) ~ 51 (D) ~ 89 (D) 49.3 (H) ~ 35.9 (D) ~ 64.5 (D) 1/2.7" CMOS Image Sensor 1920(H) x 1080(V) = 2,073,600(pixel) 5.856mm(H) x 3.276mm(V) Progressive Scan Color: 0.6Lux at F1.6 Color: 0.8Lux at F1.8 Auto/ Tungsten/ Indoor/ Fluorescents1/ fluorescents2/ Outdoor1/ Outdoor2 Off/ On 1/30(25)s ~ 1/8000s Off/ 1Frame/ 2Frames/ 3Frames/ 7Frames Yes 36dB Variable Gain Off/ Low/ Middle/ High Off/ On Off/ On (4 zones) Brightness, Contrast, Hue, Saturation, Sharpness, Mirror, Flip -10 ~ +50 (14 ~ 122 ) ψ105 x 39mm 250g PoE (IEEE 802.3af compliant) 5W Design and specifications are subject to change without notice.
Video Compression Resolution Profile #1 Profile #2 Multiple profile Profile #3 Profile #4 Video Streaming Video Bitrate Security Users eptz & Digital Zoom OSD Alarm Functions CPU, Memory Maintenance Network Interface PC Requirement Network Protocols Mobile Phone and PDA Support System Integration CMX Video Display OS One-way Audio SD Card Recording 1080P HD DOME IP CAMERA NETWORK H.264, Motion JPEG 1080P(1920x1080) / 720P(1280x720) / D1(720x480) / CIF(352x240) H.264 1920x1080 @30fps, H.264 720x480 @30fps, JPEG 720x480 @25fps, JPEG352x240 @25fps H.264 1280x720 @30fps, H.264 720x480 @30fps, JPEG 352x240 @25fps H.264 1920x1080 @30fps, H.264 720x480 @30fps, JPEG 1280x720 @25fps H.264 1920x1080 @30fps, H.264 720x480 @30fps, JPEG 720x480 @25fps RTP/HTTP, RTP/TCP, RTP/UDP 128Kbps ~ 5Mbps Frame rate and bit rate controllable on-the-fly VBR/ CBR/ GOP supported Base64 HTTP encryption Multiple user access levels with password protection 10 user accounts available 8 simultaneous users Yes, ROI is supported Text overlay for date, time, and camera name Alarm/ motion/ tampering/ face detection triggering into SD card Image upload over FTP and E-mail by face/ tampering/ audio/ motion detection Embedded SoC ARM11, 528MHz 256MB DDR2, 256MB flash memory Firmware update via HTTP, Firmware available at web site 10Mbps / 100Mbps Base-T, RJ-45 OS : Windows 2000, Windows XP, Windows Vista, Windows 7 Browser : Windows Internet Explore 6.0 or above CPU : Intel Pentium 4 1.8GHz or above RAM : 1GB or above, Independent Display Card IP, TCP, UDP, HTTP, SMTP, NTP, DDNS, UPnP, FTP, ARP, DHCP, PPPoE, DNS, RTSP, RTCP, Telnet, ONVIF ipad, iphone and Android support ONVIF & LILIN HTTP API Free CMX HD3.6 support LILIN Universal ActiveX & LILIN Java Applet Embedded Linux 2.6.32 G.711 Support Micro SD/SDHC card for circular recording (card is not included) Design and specification are subject to change without notice. 66-IPD222CSE-1
MERIT LILIN ENT. CO., LTD http://www.meritlilin.com 66-IPD222CSE