CCNA relevante Befehle

Similar documents
GoCertify Advanced Cisco CCIE Lab Scenario # 1

Lab Manual. ISC 350 (Networks and Telecommunication) Information Technology Solutions. Prepared by: Eng. Altaf Al Farhan.

(ii) Simei(config)#line console 0 Simei(config-line)#password Networking Simei(config-line)#exit

CCNP TSHOOT. Quick Reference Sheet Exam

CCNA 4 - Final Exam (B)

Command Summary. User Exec Mode Commands APPENDIXD

Cisco Cookbook. Kevin Dooley and IanJ. Brown. O'REILLY 4 Beijing Cambridge Farnham Koln Paris Sebastopol Taipei Tokyo

Cisco IOS Configuration Basics

Lab 8.5.2: Troubleshooting Enterprise Networks 2

Education by Simulation Sequential Labs For CCNA

Configure Initial Router Settings on Cisco 4000 Series ISRs

Connections, addressing and common configuration rules.

Skills Assessment Student Training Exam

Lab Configuring IGRP Instructor Version 2500

Unsupported Commands in Cisco IOS Release 12.2(25)SEE

ROUTER COMMANDS. BANNER: Config# banner motd # TYPE MESSAGE HERE # - # can be substituted for any character, must start and finish the message

Cisco Press CCIE Practical Studies CCIE Practice Lab: Enchilada Solutions

Lab Troubleshooting Routing Issues with debug Instructor Version 2500

outing and Switching Elective : Le

CCNP 2: Remote Access

Basic IOS Configuration and Basic Serial WAN Connectivity

The commands in this appendix are organized in the following sections:

SEMESTER 2 Chapter 1 Planning and Cabling a Network V 4.0

Unsupported Commands in Cisco IOS Release 12.2(25)EX

How to Configure a Cisco Router Behind a Non-Cisco Cable Modem

Basic Router Operations

Basic Router Configuration

Configuring VRF-lite CHAPTER

Lab Configuring OSPF Timers 2500 Series

Cisco 6 Routers. Andrew Hamilton John Mistichelli with Bryant G. Tow. San Francisco Paris Düsseldorf Soest London SYBEX

Cisco Router Security: Principles and Practise. The foundation of network security is router security.

Configuring IP Unicast Routing

LAB FOUR Dynamic Routing Protocols

Configuring Legacy DDR Hubs

Configuring Redundant Routing on the VPN 3000 Concentrator

Lab 2.8.1: Basic Static Route Configuration

This document is a tutorial related to the Router Emulator which is available at:

CCNA Commands In 10 Minutes

OSPF single area configuration lab on packet tracer

LAB MANUAL for Computer Network

Chapter 5 RIP version 1

Module 9, Assignment 7

Cisco Router Configuration Handbook

Chapter 3 Command List

Cisco Press CCIE Practical Studies CCIE Practice Lab: Darth Reid Solutions

Cisco Realtests Exam Bundle

Configuring IP Unicast Routing

Advanced IPv6 Training Course. Lab Manual. v1.3 Page 1

Cisco IOS Software p. 1 Benefits p. 2 Packaging p. 6 Features Supported p. 7 Cisco Router Hardware p. 23 Cisco Router Network Hierarchy p.

Connections, addressing and common configuration rules.

Configuring Network Access to the GGSN

CCNA MCQS with Answers Set-1

Configuring IP Unicast Routing

Cisco Press CCIE Practical Studies CCIE Practice Lab: Skynet Solutions

Configuring Virtual Asynchronous Traffic over ISDN

Feature-by-Feature Router Configurations

Lab 1-2Connecting to a Cisco Router or Switch via Console. Lab 1-6Basic Graphic Network Simulator v3 Configuration

Antonio Cianfrani. Packet Tracer

How to configure MB5000 Serial Port Bridge mode

CCNA EXPLORATION V4.0 ROUTING PROTOCOLS AND CONCEPTS ACCESSIBLE INSTRUCTOR MATERIALS POWERPOINT OBJECTIVES

Lab Troubleshooting Routing Issues with show ip route and show ip protocols Instructor Version 2500

CCNA( ) Dumps V2.0( ) CCNA

Integrated IS-IS CHAPTER 4. ISO Network Entity Title (NET)

Configuring Dynamic Addressing on the GGSN

Configuring IP Unicast Routing

SOHO. A Case Study. Case Study: SOHO

Lab Configuring OSPF Authentication 2500 Series

CISCO EXAM QUESTIONS & ANSWERS

Student Instructions: "Rob Router" Learns How to Communicate...Again!

Configuring OSPF. Cisco s OSPF Implementation

Chapter 12. AAA. Upon completion of this chapter, you will be able to perform the following tasks:

Access Server Dial In IP/PPP Configuration With Dedicated V.120 PPP

COPYRIGHTED MATERIAL. Contents at a Glance. Assessment Test

Routing Overview. Information About Routing CHAPTER

Smart Serial. Show interfaces. Shut down. logging synchronous

Home Agent Redundancy

Configuring IP. IP Configuration Task List

Implementing Static Routes for IPv6

CCNA Practice test. 2. Which protocol can cause high CPU usage? A. NTP B. WCCP C. Telnet D. SNMP Answer: D

Final exam study Guide

The ^ CCNA Cram Guide

Skills Assessment. CCNA Routing and Switching: Connecting Networks. Topology. Assessment Objectives. Scenario

CIS 83 LAB 2 - Single Area OSPF Rich Simms September 12, Objective. Scenario. Topology

Implementing Cisco IP Routing

9.1. Routing Protocols

Passwords and Privileges Commands

Actual4Test. Actual4test - actual test exam dumps-pass for IT exams

CCNA Cisco Certified Network Associate CCNA (v3.0)

Configuration Partitioning

Course: CCNA Bootcamp (Intensive CCNA)

Information About Routing

Seed Metrics and Route Redistribution

Remote Access MPLS-VPNs

Cisco Press CCIE Practical Studies CCIE Practice Lab: Unnamed Solutions

Lab VTY Restriction Instructor Version 2500

TELECOMMUNICATION MANAGEMENT AND NETWORKS

KIM DONNERBORG / RTS. Cisco Lab Øvelse Af Kim Donnerborg / RTS. Side 0 af 8

Cisco Exam Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) Version: 6.0 [ Total Questions: 79 ]

Laboration 1 Examine the Topology and Basic Troubleshooting Commands

CCNA Routing & Switching

Transcription:

CCNA relevante Befehle router>enable Password: router#disable router>en Password: router#configure terminal router(config)#exit router#show arp router#show flash: all router#show history router#show interfaces router#show line router#show running-config router#show sessions router#show users router#show version router#show cdp? interface CDP interface status and configuration neighbors CDP neighbor entries traffic CDP statistics router(config)#cdp? advertise-v2 CDP sends version-2 advertisements holdtime Specify the holdtime (in sec) to be sent in packets timer Specify the rate at which CDP packets are sent (in sec) run router#show cdp neighbors detail router#show cdp interface router(config)#interface serial 0 router(config-if)#no cdp enable router(config)#no cdp run

router#copy? /erase Erase destination file system. flash: Copy from flash: file system ftp: Copy from ftp: file system null: Copy from null: file system nvram: Copy from nvram: file system rcp: Copy from rcp: file system running-config Copy from current system configuration startup-config Copy from startup configuration system: Copy from system: file system tftp: Copy from tftp: file system xmodem: Copy from xmodem: file system ymodem: Copy from ymodem: file system router#copy startup-config running-config _ router(config)#line? <0-6> First Line number aux Auxiliary line console Primary terminal line vty Virtual terminal router(config)#line vty 0 4 router(config)#login router(config)#password... router(config)#no ip domain-lookup router(config)#interface serial 0 router(config-if)#ip address 172.17.0.2 255.255.0.0 router(config-if)#no shutdown router#show ip route? Hostname or A.B.C.D Network to display information about or hostname bgp Border Gateway Protocol (BGP) connected Connected egp Exterior Gateway Protocol (EGP) eigrp Enhanced Interior Gateway Routing Protocol (EIGRP) igrp Interior Gateway Routing Protocol (IGRP) isis ISO IS-IS list IP Access list mobile Mobile routes odr On Demand stub Routes ospf Open Shortest Path First (OSPF) profile IP routing table profile rip Routing Information Protocol (RIP)

static Static routes summary Summary of all routes supernets-only Show supernet entries only vrf Display routes from a VPN Routing/Forwarding instance Output modifiers <cr> router#show ip eigrp topology router#show ip eigrp topology 20.0.0.0 router#show ip eigrp neighbour router#show ip eigrp neighbour detail router#show ip protocols router#show ip eigrp interface router#show ip eigrp traffic router#show ip eigrp events router#debug? aaa AAA Authentication, Authorization and Accounting access-expression Boolean access expression adjacency adjacency all Enable all debugging arp IP ARP and HP Probe transactions async Async interface information backup Backup events callback Callback activity cca CCA activity cdapi CDAPI information cdp CDP information chat Chat scripts activity compress COMPRESS traffic condition Condition confmodem Modem configuration database cpp Cpp information custom-queue Custom output queueing dhcp DHCP client activity dialer Dial on Demand dnsix Dnsix information domain Domain Name System dxi atm-dxi information eigrp EIGRP Protocol information ethernet-interface Ethernet network interface events frame-relay Frame Relay interface interface ip IP information lapb LAPB protocol transactions lex LAN Extender protocol list Set interface or/and access list for the next debug

llc2 modem nhrp ntp nvram packet pad ppp priority probe radius rif rtr serial smf snapshot snmp spantree standby tacacs tbridge telnet template tftp token tunnel v120 vprofile vtemplate x25 x28 command LLC2 type II Information Modem control/process activation NHRP protocol NTP information Debug NVRAM behavior Log unknown packets X25 PAD protocol PPP (Point to Point Protocol) information Priority output queueing HP Probe Proxy Requests RADIUS protocol RIF cache transactions RTR Monitor Information Serial interface information Software MAC filter Snapshot activity SNMP information Spanning tree information Hot standby protocol TACACS authentication and authorization Transparent Bridging Incoming telnet connections Template activity TFTP debugging Token Ring information Generic Tunnel Interface V120 information Virtual Profile information Virtual Template information X.25, CMNS and XOT information X28 mode router#debug eigrp neighbors router#debug eigrp packets router#debug ip eigrp router#terminal monitor router(config)#router rip router(config-router)#network 10.0.0.0 router(config-router)#version 1 router(config)#no router rip router(config)# ip nat inside source static 192.168.0.10 20.0.0.20 router(config)#interface ethernet0 router(config-if)#ip nat inside router(config)#interface serial0

router(config-if)#ip nat outside router(config)#ip nat pool natpool 20.0.0.20 20.0.0.25 netmask 255.0.0.0 router(config)#access-list 1 permit 192.168.0.0 0.0.0.255 router(config)#ip nat inside source list 1 pool natpool router(config)#interface ethernet0 router(config-if)#ip nat inside router(config)#interface serial0 router(config-if)#ip nat outside router(config)#access-list 10 deny 172.16.20.2 0.0.0.255 router(config)#access-list 10 permit any router(config)#interface ethernet 0 router(config-if)#ip access-group 10 in router(config)#router ospf 1 router(config-router)#network 172.16.0.0 0.0.255.255 area 0 router#show ip ospf? <1-4294967295> Process ID number border-routers Border and Boundary Router Information database Database summary flood-list Link state flood list interface Interface information neighbor Neighbor list request-list Link state request list retransmission-list Link state retransmission list summary-address Summary-address redistribution Information virtual-links Virtual link information Output modifiers <cr> router#show ip ospf neighbor detail router#debug ip ospf router(config)#username mitte password salinas router(config)#interface serial 0 router(config-if)#encapsulation ppp router(config-if)#ppp encapsulation chap router#debug ppp authentication

router(config)# interface serial0 router(config-if)# encapsulation frame-realy router(config)# ip address 30.0.0.1 255.0.0.0 router(config)# frame-realy interface-dlci 100 router(config)# no shutdown router(config-if)# exit router# show ip interface brief router# show frame-relay pvc router# show frame-relay map