OSPF Command Reference

Similar documents
IS-IS Command Reference

Configuring OSPF with CLI

IS-IS Configuration Commands. Generic Commands. shutdown IS-IS XRS Routing Protocols Guide Page 533. Syntax [no] shutdown

OSPFv3 Address Families

OSPFv3 Address Families

OSPFv3 Address Families

IP Router Command Reference

OSPF Commands. adjacency stagger, page 7. authentication-key (OSPF), page 14

Alcatel-Lucent 7705 SERVICE AGGREGATION ROUTER OS RELEASE 5.0 ROUTING PROTOCOLS GUIDE ROUTING PROTOCOLS GUIDE

OSPF Commands on Cisco IOS XR Software

OSPF Commands on Cisco ASR 9000 Series Router

Table of Contents 1 OSPF Configuration 1-1

Configuring LDP with CLI

Command Manual IPv4 Routing H3C S3610&S5510 Series Ethernet Switches. Table of Contents

OSPFv3 Commands. address-family (OSPFv3), page 4. authentication (OSPFv3), page 7

Chapter 8 Configuring OSPF

Logging neighbor state changes 38 Configuring OSPF network management 39 Enabling message logging 39 Enabling the advertisement and reception of

Configuring OSPF network management 39 Enabling message logging 39 Enabling the advertisement and reception of opaque LSAs 40 Configuring OSPF to

OSPFv2 deep dive. Михайловский Василий Cisco TAC Poland Ноябрь 17, 2015

OSPF. About OSPF. CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.4 1

Chapter 16 OSPF Version 3 Commands

FiberstoreOS V3.3 IPv6 Routing Command Line Reference

Operation Manual IPv4 Routing H3C S3610&S5510 Series Ethernet Switches. Table of Contents

Table of Contents 1 Static Routing Configuration RIP Configuration 2-1

FSOS IPv6 Routing Command Line Reference

FiberstoreOS. IPv6 Routing Command Line Reference

A Commands. Send comments to

OSPF Protocol Overview on page 187. OSPF Standards on page 188. OSPF Area Terminology on page 188. OSPF Routing Algorithm on page 190

FSOS IP Routing Command Line Reference

IPv6 Routing: OSPFv3

FiberstoreOS IP Routing Command Line Reference

IP Router Command Reference

Chapter 3 Lab 3-2, Multi-Area OSPFv2 and OSPFv3 with Stub Area

OSPF. OSPF processs can be enabled on 2 levels

Chapter 15 OSPF Commands

Chapter 3 Command List

OSPF. Unless otherwise noted, OSPF refers to OSPFv2 throughout this document.

Passit4Sure.4A Questions 4A Alcatel-Lucent Interior Routing Protocols and High Availability

FiberstoreOS IP Routing Configuration Guide

FiberstoreOS IP Routing Configuration Guide

DD2490 p Link-state routing and OSPF. Olof Hagsand KTH/CSC

Chapter 21 RIP Configuration Guidelines

FSOS IP Routing Configuration Guide

HP 6125G & 6125G/XG Blade Switches

IS-IS. In This Chapter XRS Routing Protocols Guide Page 449

Operation Manual OSPF. Table of Contents

Brocade 5600 vrouter OSPFv3

Configuring Networking Protocols

Introduction to OSPF

FiberstoreOS. IP Routing Command Line Reference

HP 7500 Switch Series

Table of Contents. 2 Static Route Configuration Commands 2-1 Static Route Configuration Commands 2-1 delete static-routes all 2-1 ip route-static 2-1

Brocade 5600 vrouter OSPFv3 Configuration Guide

IS-IS Commands. distribute-list in (IS-IS), on page 25 fast-reroute per-prefix (IS-IS), on page 29

OSPF Commands. Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols IP2R-61

Configuration Commands. Generic Commands. shutdown BGP XRS Routing Protocols Guide Page 731. Syntax [no] shutdown

Introduction to OSPF

PASS4TEST. IT Certification Guaranteed, The Easy Way! We offer free update service for one year

Juniper Exam JN0-643 Enterprise Routing and Switching, Professional (JNCIP-ENT) Version: 13.0 [ Total Questions: 221 ]

Configuring EIGRP. Overview CHAPTER

HP 5920 & 5900 Switch Series

4A Alcatel-Lucent. Alcatel-Lucent Interior Routing Protocols and High Availability

Configuring OSPF. Finding Feature Information

Introduction to OSPF

Routing IPV6. Copyright Cisco Academy. Yannis Xydas

EIGRP. About EIGRP. CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.7 1

2001, Cisco Systems, Inc. All rights reserved.

Link State Routing. Link State Packets. Link State Protocol. Link State Protocols Basic ideas Problems and pitfalls

Router Lab Reference

Which of the following describe the process identifier that is used to run OSPF on a router? (Choose two)

Vendor: Alcatel-Lucent. Exam Code: 4A Exam Name: Alcatel-Lucent Interior Routing Protocols and High Availability.

Lab - Configuring Multi-area OSPFv3 Topology

OSPFv2 Cryptographic Authentication

Sample Configuration for OSPFv3

OSPF Stub Router Advertisement

Alcatel-lucent EXAM - 4A Alcatel-Lucent Interior Routing Protocols and High Availability. Buy Full Product.

OSPFv2 Local RIB. Finding Feature Information

Configuring OSPF. Cisco s OSPF Implementation

Configuring OSPF. Finding Feature Information

Operation Manual Routing Protocol. Table of Contents

Implementing Cisco IP Routing (ROUTE)

CIS 83 LAB 2 - Single Area OSPF Rich Simms September 12, Objective. Scenario. Topology

OSPFv2 Segment Routing Strict SPF

exam. Number: Passing Score: 800 Time Limit: 120 min File Version: Cisco

cisco. Number: Passing Score: 800 Time Limit: 120 min.

Routing Protocol Type Primarily IGP or EGP RIP Distance-Vector IGP EIGRP OSPF IS-IS BGP

DD2490 p Link-state routing and OSPF. Olof Hagsand KTH/CSC

Chapter 7 Interface Commands

Juniper JN0-647 Exam. Volume: 65 Questions. Question: 1 Which protocol is a multicast routing protocol? A. OSPF B. BGP C. PIM D. IS-IS.

IS-IS for ISPs. ISP Workshops. Last updated 25 th August 2015

Configuring OSPF. Finding Feature Information. Contents

The following questions are designed to test your understanding of this chapter s

Lab- Configuring Basic Single-Area OSPFv2

Lab 4: Routing using OSPF

Exam Questions 4A0-101

ArubaOS-Switch Multicast and Routing Guide for KA/KB.16.04

Configuring RIP. Information About RIP CHAPTER

Link State Routing. Link State Packets. Link State Protocol. Link State Protocols Basic ideas Problems and pitfalls

CCNA 3 (v v6.0) Chapter 8 Exam Answers % Full

Organization of Product Documentation... xi

Transcription:

OSPF OSPF Command Reference Command Hierarchies Configuration Commands on page 329 Show Commands on page 333 Clear Commands on page 333 Debug Commands on page 333 Configuration Commands config [no] ospf [ospf-instance] [router-id] [no] area area-id [no] interface ip-int-name [secondary] node-sid [no] area area-id segment-routing no segment-routing prefix-sid-range {global start-label label-value max-index index-value} no prefix-sid-range tunnel-mtu bytes no tunnel-mtu tunnel-table-pref preference no tunnel-table-pref ospf3 [instance-id] [router-id] [no] ospf3 instance-id advertise-router-capability {link area as} no advertise-router-capability advertise-tunnel-link {link area as} no advertise-tunnel-link [no] area area-id area-range ip-prefix/mask [advertise not-advertise] no area-range ip-prefix/mask [no] blackhole-aggregate [no] interface ip-int-name [secondary] [no] advertise-subnet authentication-key [authentication-key hash-key] [hash hash2] no authentication-key authentication-type {password message-digest} no authentication-type auth-keychain name no auth-keychain 7950 XRS Routing Protocols Guide Page 329

Command Hierarchies bfd-enable [remain-down-on-failure] no bfd-enable dead-interval seconds no dead-interval hello-interval seconds no hello-interval interface-type {broadcast point-to-point} no interface-type [no] loopfree-alternate-exclude lfa-policy-map route-nh-template template-name no lfa-policy-map lsa-filter-out [all except-own-rtrlsa except-own-rtrlsa-anddefaults] [no] lsa-filter-out message-digest-key key-id md5 [key hash-key] [hash hash2] no message-digest-key key-id metric metric no metric mtu bytes no mtu [no] passive priority number no priority retransmit-interval seconds no retransmit-interval rib-priority {high} prefix-list-name no rib-priority transit-delay seconds no transit-delay [no] loopfree-alternate-exclude [no] nssa area-range ip-prefix/mask [advertise not-advertise] no area-range ip-prefix/mask area-range ip-prefix/prefix-length [advertise not-advertise] no area-range ip-prefix/prefix-length originate-default-route [type-7] [no-adjacency-check] no originate-default-route [no] redistribute-external [no] summaries [no] stub default-metric metric no default-metric [no] summaries [no] virtual-link router-id transit-area area-id authentication-key [authentication-key hash-key] [hash hash2] no authentication-key authentication-type {password message-digest} no authentication-type auth-keychain name no auth-keychain dead-interval seconds no dead-interval hello-interval seconds Page 330 7950 XRS Routing Protocols Guide

OSPF no hello-interval message-digest-key key-id md5 [key hash-key] [hash hash2] no message-digest-key key-id retransmit-interval seconds no retransmit-interval transit-delay seconds no transit-delay [no] asbr [trace-path domain-id] [no] compatible-rfc1583 [no] disable-ldp-sync export policy-name [ policy-name...(up to 5 max)] no export export-limit number [log percentage] no export-limit external-db-overflow limit seconds no external-db-overflow external-preference preference no external-preference [no] graceful-restart [no] helper-disable import policy-name [policy-name...(upto 5 max)] no import [no] ldp-over-rsvp [no] loopfree-alternate loopfree-alternate-exclude prefix-policy prefix-policy [prefix-policy... up to 5] no loopfree-alternate-exclude [no] mcast-import-ipv6 [no] multicast-import overload [timeout seconds] no overload [no] overload-include-ext-2 [no] overload-include-stub overload-on-boot [timeout seconds] no overload-on-boot preference preference no preference reference-bandwidth bandwidth-in-kbps reference-bandwidth [tbps Tera-bps] [gbps Giga-bps] [mbps Mega-bps] [kbps Kilobps] no reference-bandwidth rib-priority {high} prefix-list-name no rib-priority rtr-adv-lsa-limit limit [log-only] [threshold percent] [overload-timeout {seconds forever}] no rtr-adv-lsa-limit -id ip-address no router-id [no] rsvp-shortcut timers [no] incremental-spf-wait inc-spf-wait [no] lsa-accumulate lsa-accum-time [no] lsa-arrival lsa-arrival-time 7950 XRS Routing Protocols Guide Page 331

Command Hierarchies [no] lsa-generate max-lsa-wait [lsa-initial-wait [lsa-second-wait]] [no] redistribute-delay redist-wait [no] spf-wait max-spf-wait [spf-initial-wait [spf-second-wait]] [no] traffic-engineering [no] unicast-import-disable Page 332 7950 XRS Routing Protocols Guide

OSPF Show Commands Clear Commands show ospf [ospf-instance] prefix-sids ospf3 [ospf-instance] area [area-id] [detail][lfa] capabilities [router-id] database [type {router network summary asbr-summary external nssa all} [area area-id] [adv-router router-id] [link-state-id] [detail] interface [area area-id] [detail] interface [ip-int-name ip-address] [detail] lfa-coverage neighbor [remote ip-address] [detail] neighbor [ip-int-name] [router-id] [detail] opaque-database [link link-id area area-id as] [adv-router router-id][ls-id] [detail] range [area-id] routes [ip-prefix[/prefix-length]] [type] [detail] [alternative] [summary] [excludeshortcut] spf [lfa] statistics status virtual-link [detail] virtual-neighbor [remote ip-address] [detail] clear Debug Commands ospf [ospf-instance] ospf3 [ospf-instance] database [purge] export neighbor [ip-int-name ip-address] overload {rtm fib rtr-adv-lsa-limit} statistics debug ospf [ospf-instance] ospf3 [ospf-instance] area [area-id] no area area-range [ip-address] no area-range cspf [ip-addr] no cspf 7950 XRS Routing Protocols Guide Page 333

Command Hierarchies [no] graceful-restart interface [ip-int-name ip-address] no interface leak [ip-address] no leak lsdb [type] [ls-id] [adv-rtr-id] [area area-id] no lsdb [no] misc neighbor [ip-int-name router-id] no neighbor nssa-range [ip-address] no nssa-range packet [packet-type] [ip-address] no packet rtm [ip-addr] no rtm spf [type] [dest-addr] no spf virtual-neighbor [ip-address] no virtual-neighbor Page 334 7950 XRS Routing Protocols Guide