Square Sun BI-COLOR SOFT LED FLOOD USER MANUAL
Square Sun INTRODUCTION THANK YOU FOR CHOOSING GENARAY The Genaray Square Sun LED light fixture provides photographers and videographers with ultra-bright yet soft continuous light. This 1024-LED fixture can operate on AC or battery power, and it features flicker-free dimming from 100% to 10% with broad 120-degree coverage. The built-in diffuser and the recessed placement of the LEDs within the fixture contribute to a bright and punchy light that also has a soft wraparound quality. This design eliminates the multiple shadows that are often associated with LED lighting. The Square Sun supports DMX-512 so the light s settings can be remotely controlled from a DMX console. It has 512 selectable channels and a 3-pin XLR output jack to daisy chain other DMX-compatible lights. Square Sun fixtures come in a heavy-duty metal chassis that can withstand the most demanding professional environments. For compatibility in the studio, the integrated yoke can be mounted to a light stand with a baby-pin stud or a junior-pin receiver. 2 Square Sun Bi-Color Soft LED Flood - USER MANUAL
PRECAUTIONS Please read and follow these instructions, and keep this manual in a safe place. Keep this unit away from water and any flammable gases or liquids. Make sure the unit is powered off when plugging it into a power source. Use only the correct, recommended voltage. Handle the unit with care. Do not attempt to disassemble or repair the equipment doing so will void the warranty, and Genaray will not be responsible for any damage. Do not stare directly at the lights when they are powered on. Clean the unit with only a soft, dry cloth. Images are for illustrative purposes only. Precautions Square Sun Bi-Color Soft LED Flood - USER MANUAL 3
Barndoors Barndoor locking tabs PRODUCT OVERVIEW LED array / Soft panel Yoke Locking knob 4 Square Sun Bi-Color Soft LED Flood - USER MANUAL
Gel clips Battery status indicator D-tap input power socket Battery plate V-mount release button Fan Fan on/off switch Tilt adjustment knob Dimmer/DMX knob Power switch Color temperature knob Product Overview LCD screen 4-pin XLR power socket DMX output socket DMX input socket DMX address Color temperature Brightness Square Sun Bi-Color Soft LED Flood - USER MANUAL 5
Contents CONTENTS INCLUDE LED with yoke AC adapter DMX cable Power cord Barndoors MOUNTING THE SS-12 Mount the SS-12 on any heavy-duty light stand with a 5/8-inch baby-pin stud, and turn the locking knob until secure. Remove the locking knob to mount the SS-12 into a 1 1 8-inch junior pin receiver. 6 Square Sun Bi-Color Soft LED Flood - USER MANUAL
POWERING THE SS-12 The SS-12 can be powered directly from an AC outlet or by two V-mount batteries (not included). USING THE SS-12 WITH AC POWER Important The SS-12 is a multivoltage fixture capable of running on 100 240 V, 50/60 Hz. The included cable has a 120 V, 50 Hz (North American) plug. To use this fixture with other voltages, you must use a plug adapter (sold separately). Connect the AC power adapter to the SS-12 with the 4-pin XLR cable, and plug the power cable into an outlet. The AC adapter comes in a mounting frame that fits into one of the V-mounts. Align the adapter with one of the V-mounts, and slide it into the mount until it clicks. To remove the AC adapter, press the V-mount release button, and slide the adapter off of the V-mount. USING THE SS-12 WITH BATTERY POWER The SS-12 is powered by two V-mount batteries. To operate the SS-12 on battery power, both V-mount batteries must be attached. When attaching the batteries, make sure the power switch is in the Off position, and the fixture is not plugged into a wall outlet. Three-stud batteries can be used by connecting them to the SS-12 with D-tap power cables (not included). Instructions Square Sun Bi-Color Soft LED Flood - USER MANUAL 7
Instructions The battery status indicator on the rear panel displays the remaining battery power. 4 lights (green) 80 to 100% 3 lights (green) 50 to 80% 2 lights (green) 30 to 50% 1 light (green) 10 to 30% 1 light (orange) Less than 10% (the light will not operate) OPERATING THE SS-12 USING THE BARNDOORS To attach the barndoors, place the barndoor frame on the two lower locking tabs. Press the top of the barndoor frame into the top locking tabs until they click into place. To remove the barndoors, pull the top barndoor locking tabs to release the frame. 8 Square Sun Bi-Color Soft LED Flood - USER MANUAL
ADJUSTING BRIGHTNESS AND COLOR TEMPERATURE Open the barndoors, and power the SS-12 on. The LCD screen will show the last setting that was used. After powering on the SS-12, set the brightness and color temperature by rotating the knobs on the back of the fixture. Color temperature can be adjusted from 3200 to 5600 K in 100 K increments. Brightness can be adjusted from 100% to 10% in 1% increments. For quieter operation, turn the fan off via the fan on/off switch. Note When the fan is turned off, the maximum brightness will be capped at 80%. USING DMX The SS-12 supports DMX-512 so the light s settings can be remotely controlled from a DMX lighting control console. To setup DMX operation on the SS-12, follow these steps: 1. Use a 3-pin XLR cable to connect a DMX controller to the SS-12 DMX input jack. 2. Use the SS-12 DMX output jack to connect multiple lights. 3. To set the DMX address on the SS-12, press the dimmer knob to activate DMX mode. 4. Turn the knob to select a DMX address. Important Make sure the DMX address on the SS-12 matches the DMX console. Press the dimmer knob again to return to brightness control mode. Instructions Square Sun Bi-Color Soft LED Flood - USER MANUAL 9
PRODUCT SPECIFICATIONS Specifications LED count: 1024 Color temperature: 3200 (±150) to 5600 K (±300 K) Luminance: 2565 lx @ 1 m Coverage: 120 CRI: 96 TLCI: 96 Output power: 100 W Working voltage: AC: 100 240 V DC: 24 30 V Mount: 5/8 in. baby pin convertible to 1 1 8 in. junior pin Dimensions: Light only: 14.8 14.8 3.3 in. (37.7 37.7 8.5 cm) With yoke: 17 21.9 3.3 in. (43.3 55.7 8.5 cm) Weight (with barndoors and yoke, without batteries): 12.45 lb. (5.6 kg) 10 Square Sun Bi-Color Soft LED Flood - USER MANUAL
ONE-YEAR LIMITED WARRANTY This Genaray product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. Genaray s responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at Genaray s discretion, of any product that fails during normal use of this product in its intended manner and in its intended environment. Inoperability of the product or part(s) shall be determined by Genaray. If the product has been discontinued, Genaray reserves the right to replace it with a model of equivalent quality and function. This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse, improper installation or maintenance. EXCEPT AS PROVIDED HEREIN, GENARAY MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty provides you with specific legal rights, and you may also have additional rights that vary from state to state. To obtain warranty coverage, contact the Genaray Customer Service Department to obtain a return merchandise authorization ( RMA ) number, and return the defective product to Genaray along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser s own risk and expense. For more information, or to arrange service, visit www.genaray.com or contact us at info@genaray.com. 2017 Genaray. All Rights Reserved
GG2