MP3 CD MULTIMEDIA RECEIVER USB / SD-MMC INPUT - FRONT PANEL AUX-IN SPECIFICATIONS: GENERAL: Detachable Face Panel Ultra Memory Power Circuit LCD Display Illuminated Controls (Blue) ISO DIN Mounting ISO Wiring harness Black & Silver Trim Plates Included Dimensions: (Chassis) 178Wx50Hx158Dmm (Nose Piece) 188Wx58Hx20Dmm 12 Volt DC (10.8-15.6V) Negative Ground Includes 300mm AUX-In Cable (3.5mm Plug) CD PLAYER: Supports MP3/WMA/CD/CDR/CDRW Formats Auto Load / Eject Electronic Shock Protection Intro / Repeat / Random Play / Track Up-Down MP3 ID3 Tag Display TUNER: PLL Synthesized AM/FM Stereo Xtreme Long Range Tuner FM 87.5~108 MHz; AM 522~1710 KHz Interference Absorption Circuit 30 Station Presets - 18FM/12AM Memory Station Seek / Preset Scan / Auto Store Automatic or Manual Tuning Mono / Stereo Local / Distant Control Digital Clock AUDIO CONTROL: Rotary Encoder Electronic Volume / Balance / Bass / Treble / Fader Loud / Mute Beep Adjustment 2 Ch RCA Line Out - 5 Volt (Max) 2 Ch RCA Line In Subwoofer Line Out - 4 Volt (Max) 4-Band DSP Settings Speaker Impedance 4-8 Ohms Max Power 40 Watts x 4 Ch DESIGNED FOR AUSTRALASIAN CONDITIONS AX1201
INSTALLATION PRECAUTIONS Mounting angle adjustment Adjust the mounting angle to less than 20. MOUNTING EXAMPLE Installation in the dashboard 1 Release screw and 1 bracket 3 2 182mm 3 4 TAP 53mm 2 Bend these Note: Keep the release key in a safe place as you may need it in future to remove the unit from the car. TO SUPPORT THE UNIT 4 1. UNIT 2. RELEASE CASE 3. DASH BOARD 4. HEX NUT 5. LOCK WASHER 6. PLAIN WASHER 7. CAR BODY 8. REAR SUPPORT STRAP 9. TAPPING SCREW 10. M5 X 15 HEX BOLT 2 10 3 Dashboard 5 4 8 6 7 1 9 6 5 4 Detaching and attaching the front panel The front panel of this unit can be detached in order to thf. DETACHING THE FRONT PANEL Press the button to release front panel. ull out the panel towards you to detach completelyfrom the main unit. ATTACHING THE FRONT PANEL Make sure the front panel is in the way up B A 2
Notes: CLEANING THE CONNECTOR The unit may not function properly if the connectors between the unit and the front panel are contaminated with dirt. In order ing the button and clean the connector from time to time. Clean the connector with a cotton swab contact as illustrated. Be sure to clean carefully pin by pin sure not to damage the connecting points. Rear of front panel Cotton Swab Main unit WIRE CONNECTION RCA Jack Line Out: Red (right) White (left) RCA Jack Line In: (Black) Red (right) White (left) Subwoofer: (Orange) CONNECTOR A 4. MEMORY +12V 5. AUTO ANTENNA OUTPUT 7. +12V (TO IGNITION KEY) 8. GROUND Note: (connector A 7) must be connected ignition to avoid th battery being drained when the not used for long period. CONNECTOR B 1. REAR RIGHT SPEAKER (+) 2. REAR RIGHT SPEAKER (-) 3. FRONT RIGHT SPEAKER (+) 4. FRONT RIGHT SPEAKER (-) 5. FRONT LEFT SPEAKER (+) 6. FRONT LEFT SPEAKER (-) 7. REAR LEFT SPEAKER (+) 8. REAR LEFT SPEAKER (-) POWER ANTENNA MEMORY FRONT LEFT SPEAKER REAR LEFT SPEAKER ANTENNA CONNECTOR BLUE YELLOW BACK UP + WHITE WHITE/BLACK + GREEN GREEN/BLACK SUBWOOFER LINE OUT BLACK ISO A/B PLUG ORANGE L(WHITE) R(RED) LINE IN ISO CONNECTOR B A GREY + GREY/BLACK VIOLET + VIOLET/BLACK FUSE 10A BLACK GROUND ( ) RED (R) WHITE (L) RED IGNITION SWITCH (B+) FRONT RIGHT SPEAKER REAR RIGHT SPEAKER Maintenance FUSE REPLACEMENT Warning 3
LOCATIONS OF CONTROLS 1 10 12 3 2 11 9 19 MD SUB AX1201 A/PS BD LD 5 8 7 6 13 14 15 16 17 18 2 4 (1-6) 1. POWER ON/OFF / MUTE (MU) 2. FUNCTION ECT BUTTON: BASS/TREBLE/BALANCE/FADER / DISP/LOCAL/STEREO/BEEP/ADJ TIME/AUDIO DSP 3. VOL UP/VOL DOWN FOR BASS/TREBLE/BALANCE/FADER / DISP/LOCAL/STEREO/BEEP/ADJ TIME/AUDIO DSP 5. MODE / SUBWOOFER BUTTON (MD/SUB) 6. BAND / LOUDNESS BUTTON (BD/LD) 7. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN /CD TRACK/SEARCH BUTTON) 8. AUTO SEEK SEARCH TUNING (A/PS) 9. LCD DISPLAY 10. PANEL RELEASE BUTTON ( ) 11. CD SLOT 12. CD EJECT BUTTON ( ) 13. PAUSE BUTTON (PAU) 14. REPEAT BUTTON (RPT) 15. INTRO BUTTON (Preview all Tracks) (INT) 16. RANDOM BUTTON (RDM) 19. USB PORT 20. SD/MMC CARD SLOT 21. AUX IN RESET 20 2 4
OPERATING INSTRUCTIONS 1. POWER ON/OFF ( ) / MUTE (MU) 2. ECT 3. VOLUME UP/DOWN 1 shows how functions are selected: 1 2 3 4 5 Fig. 1 Selection of sound control function 1. VOL 2. BAS 3. TRB 4. BAL 5. FAD Increase or decrease the volme by turning VOL or VOL. DISPLAY (2) the VOL knob again (for more than 2 seconds) to activate DISPLAY: DISP. LOCAL/DX (2) Press the VOL knob again (for more than 2 seconds) to activate LOCAL: DISP LOC VOL DX/LOCAL Local position in areas with signal radio strong stations during manual tuning (LOC appears). Press to Distant position stations. STEREO/MONO (2) Press the VOL knob again (for more than 2 seconds) to STEREO: DISP LOC STEREO VOL STEREO/MONO. BEEP MODE (2) Press the VOL knob again (for more than 2 seconds) to activate BEEP: DISP LOC STEREO BEEP VOL 2nd / ALL / OFF ALL Button sound is on permanently 2nd Button sound is triggered by secondary button functions (hold button down for a while) OFF Button sound is off ADJUST TIME (2) Press the VOL knob again (for more than 2 seconds) to activate ADJUST TIME: DISP LOC STEREO BEEP VOL ADJ VOL to set minute VOL / to set hour Turn VOL knob clockwise to set hours and counter clockwise to set minutes. 5
AUDIO DSP CONTROLS (2) Press the VOL knob again (for more than 2 seconds) to activate D DISP LOC STEREO BEEP ADJ DSP VOL FLAT / POP / ROCK / CLASSICAL 4. PRESET STATIONS (1-6) Six numbered preset buttons store and recall stations for each band. Storing a station: 1. Select a band (if needed) 2. Select a station 3. Hold a preset button longer than one second. Preset station number appears in the display when station is saved. Recall a station: 1. Select band (if needed) 2. Press a preset button for less than one second to select stored station. Note: This unit is equipped with built-in memory I.C. (Integrated Circuits) to save user settings such as tuner preset stations and audio control settings. To cancel these settings, switch to Radio mode, press and hold button 1 for 2 seconds (do not release button) followed by pressing MD button. Unit will automatically restart after 5 seconds. 5. MODE / SUBWOOFER BUTTON (MD/SUB) Press MD to select between: AUX/TUNER/CD-MP3/USB or MMC/SD modes. SUBWOOFER: Press and hold the button to engage subwoofer output. 6. BAND ECTOR / LOUDNESS BUTTON (BD/LD) LOUDNESS: Press and hold the button to select LOUD mode. 7. AUTOMATIC OR MANUAL TUNING (FREQ UP OR FREQ DOWN ) (A) RADIO MODE (B) CD/MP3 PLAYER MODE When pressed longer than 1 second 8. AUTOMATICALLY STORE STATIONS (A/PS) Select six strong stations and store them in current band. 1. Select a band (if needed) 2. Hold A/PS button for more than three seconds. The new stations replace stations already stored in that band. Preset Scan Scan stations stored in current band 1. Select a band (if needed) 2. Hold A/PS station. Press A/PS again to stop scanning when desired station is reached. 9. ACTIVE MATRIX DISPLAY The Active Matrix Display will display the current state of the unit. 10. PANEL RELEASE BUTTON ( ) Press button andthe front panel will detach. 6
CD/MP3 CONTROL Inserting the CD Carefully slide the CD or CD-R or CD-RW through the CD slot into the. The CD starts playing automatically. TRACK/SEARCH BUTTON FORWARD AND REVERSE TRACK SEARCH (8) Press and release to advance to next track or to return to the beginning of the current track (rack number will be displayed). Press and hold to fast forward or reverse. Play will begin at the point when 11. CD SLOT 12. CD EJECT BUTTON ( ) Press the EJECT button to remove the CD. The receiver will automatically switch to radio mode. 13. PAUSE BUTTON (PAU) Press PAU button to pause CD playback. Press again to resume playback. 14. REPEAT BUTTON (RPT) 15. INTRO BUTTON (Preview all Tracks) (INT) played. Press again to stop intro and listen to current track. 16. RANDOM BUTTON (RDM) Press Button 5: Previous Folder / Press Button 6: Next Folder HOW TO ECT MP3/WMA FILES A. Searching by Track: A/PS. Digit starts blinking. VOL / VOL VOL knob until the desired track number shows or select short cut button as below: 0= /MU button 1=1 PAU button 2=2 RPT button 3=3 INT button 4=4 RDM button 5=5 FL- button 6= button 7=MD button 8= button 9= button button. B. Searching by Folder: A/PS twice. VOL / VOL VOL knob to select folder name then press VOL knob. VOL / VOL VOL VOL knob to start playback. 7
19,20. USB PORT / SD/MMC MEMORY CARD The device is equipped with a USB interface and a memory card reader for SD/MMC cards. MP3 or WMA 1. Plug your USB storage medium into the USB port. RESET 3. The player automatically switches to the input used and starts playback. Note: will be available with this device. 21. FRONT AUX IN An external audio source (e.g. portable MP3 player) can be connected to the AUX IN socket to be played back by the vehicle loudspeakers. RESET Reset button is placed on the housing e reset button the following : RESET RESET 8
CAUTION & MAINTENANCE This detachable panel AM/FM car radio with MP3/CD player is an example of superior design and craftsmanship. The following suggestions will help you care for the product and experience many years of enjoyment. 1. Do not touch the contacts on the front panel or the unit body. 3. Avoid exposing your product to high temperature and humidity. 4. Handle the product with care. Dropping it can damage circuit boards and cause the product to malfunction. 5. Modifying or tampering with internal components can cause damage and may invalidate the warranty. TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE SOLUTION No sound or power No sound in one channel Poor FM reception CD sound quality poor Speaker cord disconnected. Bad power connection Blown fuse. Mis-adjusted balance control Damaged speaker wire or speaker Insensitive or defective antenna. Disc reading malfunction. Disc may be damaged or dirty. Lens may need cleaning. Check to see that all the power and speaker leads are securely connected. Replace fuse with same amperage. Check balance control. Reverse left and right channel speaker leads If no sound from other both speakers. Replace with a good sensitivity antenna. Try a different disc. Clean Disc with a soft cloth. Insert a quality lens cleaning disc. 9
TECHNICAL SPECIFICATIONS CD/MP3/WMA PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response TUNER (FM) Frequency Range Sensitivity Stereo Separation Signal to Noise Ratio Channel Step > 60 db > 50 db (1kHz) 20Hz - 20 khz 87.5-108 MHz 2.8 μv 30 db 50 db 100 khz TUNER (AM) Frequency Range 522-1710 KHz Channel Step 9 khz GENERAL Power Supply Speaker Impedance Output Power SUB OUT Frequency Response Sensitivity Max Output RCA OUT Frequency Response Sensitivity Output Impedance Max Output AUX IN Frequency Response Sensitivity Input Impedance DIMENSIONS Chassis Nose piece 12V DC (10.8-15.6V allowable) 4 or 8 Ohm 40W x 4CH 20 Hz - 50 Hz 300 mv 4V 20 Hz - 20 KHz 200 mv 2 K 5 Volt (max.) 20 Hz - 20 KHz 775 mv 20 K 178(W)x50(H)x158(D) mm 188(W)x58(H)x20(D) mm Note: 10