DATA SHEET ExtremeSwitching Industrial Ethernet Switches HIGHLIGHTS MODELS 4 POE+ ports, 2 ports, and 2 4 /1000 POE+ ports, 2 /1000 ports, and 2 8 POE+ ports, and 4 8 /1000 POE+ ports, and 4 PERFORMANCE Full Wire Speed Layer 2 Switching All PoE ports IEEE 802.3af and 802.3at compliant and support up to 30W concurrently Dual DC power input and reverse power protection -40 C to +75 C operating temperature Industrial Networking Designed for industrial use, Extreme Industrial Switches provide continuous uptime, manageability and operational efficiency. With full PoE+ power per PoE port, each switch offers the performance needed for todays power-hungry surveillance devices and WLAN access points. Extreme Industrial Switches are an excellent choice for industrial environments, including intelligent transportation systems, utilities, and smart cities. Full redundant ring technology creates fault-tolerant networks with high availability with industry standard technologies. FORM FACTOR PART NO. SWITCH MODELS PORT COUNTS AGGREGATE BANDWIDTH FORWARDING RATE DIN Rail or Wall Mountable POE+ /1000 /1000 POE+ SFP Rugged IP30 Enclosure FEATURES Highly Resilient LACP, Spanning tree STP, RSTP & MSTP, fast Ring fail-over and G.8032 ERPS protection options 16801 ISW 4-P, 2-T, 2-SFP 2 4 - - 2 5.2 Gbps 3.87 Mpps 16802 ISW 8-P, 4-SFP - 8 - - 4 9.6 Gbps 7.14 Mpps 16803 ISW 4GBP, 2GBT, 2-SFP - - 2 4 2 16 Gbps 11.90 Mpps 16804 ISW 8GBP, 4-SFP - - - 8 4 24 Gbps 17.85 Mpps Port-based /tag-based VLAN, IEEE 802.1ad/QinQ VLAN, Add/remove VLAN tags IGMP v1/v2/v3, multicast proxy and snooping Multicast/Broadcast/Flooding Storm Control IEEE802.1x access control Per VLAN mirroring CLI/Web/SNMP management interfaces PoE PSE power management and PD power consumption Industrial Ethernet Switches Data Sheet 1
Specifications OPERATING MODE Store and forward, L2 wire-speed/non-blocking switching engine MAC Addresses- 8K Jumbo Frames- 9K Bytes COPPER RJ45 PORTS Mbps or /1000 Mbps depending on model IEEE 802.3af and IEEE 802.3at on POE enabled ports MDI/MDIX Auto-Crossover Auto-negotiation, full and half duplex Ethernet Isolation- 1500VRMS 1 minute PLUGGABLE SFP PORTS 100FX SFP and 100/1000BaseX SFP Transceiver NETWORK REDUNDANCY Fast Failover Ring Protection with single and multiple rings, ring coupling, dual homing and chain modes IEEE 802.1D STP, IEEE 802.1w RSTP, IEEE 802.1s MSTP Static trunk or Dynamic via LACP (Link Aggregation Control Protocol) BRIDGING, VLANS, MULTICAST Flow Control IEEE 802.3x (Full Duplex) and Back-Pressure (Half Duplex) VLAN Capacity- 1024 Port-based VLANs; MAC-based VLANs; IP Subnet-based VLANs Protocol-based VLANs TRAFFIC MANAGEMENT AND QOS Priority IEEE 802.1p QoS Queues per port- 8 Scheduling Strict, Weighted Round Robin Port-based shaping SECURITY Port Security IP and MAC-based access control, IEEE 802.1X authentication Network Access Control, RADIUS and TACACS+ AAA (Authentication, Accounting and Authorization) Storm Control Multicast/Broadcast/Flooding Storm Control MANAGEMENT CLI GUI SNMP v1, v2c, v3 Telnet Management Security- HTTPs, SSH, RADIUS client for management FTP- Configuration Import/Export, Firmware Upgrade SYSLOG Per VLAN mirroring Ethernet Copper Diagnostics Digital Diagnostics for SFP ports DHCP- Client, Server, Relay, Snooping, Option 82 NTP PoE scheduling, power control, PoE PD power consumption IEEE 802.1Q tag-based VLANs IEEE 802.1ad Double Tagging (Q in Q) IGMP v1, v2, v3 with up to 1000 multicast groups IGMP snooping and querying Immediate leave and leave proxy Throttling and filtering IEEE 802.1ab Link layer Discovery Protocol (LLDP) ITU G.8032 Ethernet Ring Protection Switching (ERPS) Industrial Ethernet Switches Data Sheet 2
STANDARD MIBS RFC 1213 MIB II RFC 1215 A Convention for Defining Traps for Use with the SNMP RFC 2613 SMON MIB: VLAN statistics and port copy RFC 2674 VLAN MIB RFC 2819 RMON (Group 1, 2, 3, and 9) RFC 2863 Interface Group MIB using SMI v2 RFC 3411 SNMP Management Frameworks RFC 3414 User-based Security Model for SNMPv3 RFC 3415 View-based Access Control Model for SNMP RFC 3621 LLDP-MED Power RFC 3635 Ethernet-like MIB RFC 3636 802.3 Medium Attachment Units (MAUs) MIB RFC 4133 Entity MIB v3 RFC 4188 Bridge MIB RFC 4292 IP Forwarding Table MIB RFC 4293 Management Information Base for the Internet Protocol (IP) RFC 4668 RADIUS Authentication Client MIB RFC 4670 RADIUS Accounting MIB RFC 5519 Multicast Group Membership Discovery MIB IEEE 802.1 MSTP MIB IEEE 802.1AB LLDP MIB (LLDP MIB included in clause of standard) IEEE 802.1X MIB (PAE MIB included in clause of standard) IEEE 802.1Q Bridge MIB 2008 IEEE 802.3ad MIB (LACP MIB included in clause of standard) PRIVATE MIBS Access Management MIB ACL MIB AGGR MIB ARP Inspection MIB Authentication MIB Daylight Saving MIB DDMI MIB DHCP6 Client MIB DHCP Relay MIB DHCP Server MIB DHCP Snooping MIB DNS MIB EEE MIB ERPS MIB Firmware MIB PRIVATE MIBS (CONT.) GVRP MIB HTTPS MIB ICFG MIB ICMP MVR MIB ICMP Profile MIB ICMP Snooping IP MIB JSON RPC Notification MIB LACP MIB LLDP MIB Loop Protection MIB MAC MIB MEP MIB MSTP MIB NAS MIB NTP MIB POE MIB Port MIB Privilege MIB PSEC MIB QOS MIB SMI MIB SNMP MIB SSH MIB SYSLOG MIB System Utilities MIB Textual Convention MIB Users MIB VLAN MIB Voice VLAN MIB POWER Redundant Input Terminals Input voltage range- Non-POE mode 12-58VDC 802.3af POE mode 46-58VDC 802.3at POE mode 50-58VDC Power Consumption- 15 Watts without POE PD loading POE Budget 16801 and 16803 120 watts POE Budget 16802 and 16804 240 watts Reverse Power Protection Transient Protection- >15K Watts peak Industrial Ethernet Switches Data Sheet 3
OPTIONAL INDUSTRIAL RATED AC-DC POWER SUPPLIES Input- 88-264VAC and 124-370VDC Frequency Range 47-63Hz 240 watt and 480 watt output models available Operating Temperature -20 C to 70 C DIN Rail LEDS Power Input Status Per Port Ethernet Link, Speed and POE Status Ring Status MEMORY 128MB DRAM 16MB FLASH 4MB Packet buffer Environmental and Compliance OPERATING TEMPERATURE RANGE -40 C to +75 C (cold startup at -40 C) STORAGE TEMPERATURE RANGE -40 to +85 C HUMIDITY (NON-CONDENSING) 5 to 95% RH VIBRATION, SHOCK AND FREEFALL CERTIFICATIONS IEC 60068-2-6 (Vibration) IEC 60068-2-27 (Shock) IEC 60068-2-32 (Freefall) REGULATORY AND SAFETY North American ITE UL 60950-1 2nd Ed., Listed Device (U.S.) (In Process) CSA 22.2 #60950-1-03 2nd Ed. (Canada) (In Process) International ITE CB Report and Certificate per IEC 60950-1 2nd Edition + National Differences EMI/EMC Standards: North American EMC for ITE FCC CFR 47 part 15 Class A (USA) ICES-003 Class A (Canada) European EMC Standards EN 61000-6-2:2005 EN 61000-6-4:2007 +A1:2011 2004/108/EC EMC Directive International EMC Certifications CISPR 22: 2006 Ed 5.2, Class A (International Emissions) CISPR 24:A2:2003 Class A (International Immunity) IEC 61000-4-2:2008/EN 61000-4-2:2009 Electrostatic Discharge, 6kV Contact, 8kV Air, Criteria B IEC 61000-4-3:2008/EN 61000-4-3:2006+A1:2008 Radiated Immunity 20V/m, Criteria A IEC 61000-4-4:2004 am1 ed.2./en 61000-4-4:2004/A1:2010 Transient Burst, 4 kv, Criteria A IEC 61000-4-5:2005 /EN 61000-4-5:2006 Surge, 1kV DC Input, 2kV Ethernet Ports Criteria B IEC 61000-4-6:2008/EN 61000-4-6:2009 Conducted Immunity, 0.15-80 MHz, 10V RMS, Criteria A IEC/EN 61000-4-8:2009 Power Frequency Magnetic Field Immunity, 300 A/m, Criteria A IEC/EN 61000-4-9:1993 +A1:2001 Pulsed Magnetic Field Immunity, 300 A/m, Criteria A ROHS AND WEEE RoHS (Pb free) and WEEE compliant MTBF > 25 years Mechanical INGRESS PROTECTION IP30 DIN Rail mounting or wall mounting DIMENSIONS 77mm(W) x 154mm(H) x 128mm(D) WEIGHT 1410g Industrial Ethernet Switches Data Sheet 4
Ordering Information PART NUMBER NAME DESCRIPTION 16801 ISW 4-P,2-T,2-SFP 4-port POE+ 2-Port w/ 2-port SFP Operating Temperature -40 C - +75 C 16802 ISW 8-P,4-SFP 8-port POE+ w/ 4-port SFP Operating Temperature -40 C - +75 C 16803 ISW 4GBP,2GBT,2-SFP 4-port POE+ Gigabit, 2-port Gigabit w/ 2-port SFP Operating Temperature -40C - +75C 16804 ISW 8GBP,4-SFP 8-port POE+ Gigabit w/ 4-port SFP Operating Temperature -40C - +75C 16807 IS AC-DC PS 240W IS AC-DC Power Supply 240W Output DIN Rail -25-70C 16920 IS AC-DC PS 480W IS AC-DC Power Supply 480W Output DIN Rail -25-70C 10051H 1000BASE-SX SFP, Hi 1000BASE-SX SFP, MMF 220 & 550 meters, LC connector, Industrial Temp 10052H 1000BASE-LX SFP, Hi 1000BASE-LX SFP, MMF 220 & 550 meters, SMF 10km, LC connector, Industrial Temp 10053H 1000BASE-ZX SFP, Hi 1000BASE-ZX SFP, SMF 70km, LC connector, Industrial Temp 10056H 1000BASE-BX-D SFP, Hi 1000BASE-BX-D SFP, 1490-nm TX/1310-nm RX wavelength, Industrial Temp 10057H 1000BASE-BX-U SFP, Hi 1000BASE-BX-U SFP, 1310-nm TX/1490-nm RX wavelength, Industrial Temp 10066 100BASE-LX10 SFP 100BASE-LX10 SFP module, SMF 10km link, LC-connector for Fast Ethernet SFP Port 10067 100BASE-FX SFP 100BASE-FX SFP module, MMF 2km link, LC-connector for Fast Ethernet SFP Port *These products are currently subject to regional availability, please contact your Extreme Networks representative for additional details. http://www.extremenetworks.com/contact Phone +1-408-579-2800 2017 Extreme Networks, Inc. All rights reserved. Extreme Networks and the Extreme Networks logo are trademarks or registered trademarks of Extreme Networks, Inc. in the United States and/or other countries. All other names are the property of their respective owners. For additional information on Extreme Networks Trademarks please see http://www.extremenetworks.com/company/legal/trademarks. Specifications and product availability are subject to change without notice. 10320-1017-20 WWW.EXTREMENETWORKS.COM Industrial Ethernet Switches Data Sheet 5