Clearfly SIP Trunks Cnfiguratin Guide PBX Platfrm: KX-TDE/NCP 6/19/2012 1 Versin1
Overview This dcument describes the cnfiguratin prcedures required fr the KX-TDE100/200/600 and NCP500/1000 t make full use f the capabilities f Clearfly Type SIP Trunks Services. The SIP trunks services f the TDE/NCP PBX are prvided thrugh virtual CO line cards (V- SIPGW16) which are designed t be easily integrated int an Internet Telephny Service prvided by an ITSP (Internet Telephny Service Prvider). This guide describes the specific cnfiguratin items fr the virtual SIP Gateway card in additin t the PBX basic cnfiguratin related t SIP trunks functinality. It als describes basic Netwrk cnfiguratin t familiarize dealers with the netwrk setup. It des nt describe the purpse and use f all cnfiguratin ptins n the virtual SIP Gateway card. Fr thse details, see the KX- NCP500/1000 and KX-TDE100/200/600 Prgramming Manual fr Virtual SIP CO Line Card and the KX-TDE100/200/600 and KX-NCP500/1000 Manuals available frm Panasnic Cmmunicatin Slutins. DSP card and Activatin keys The PBX has t be equipped with a DSP card in rder t prvide cmmunicatin between the TDM side f the PBX and the SIP trunks. Activatin keys fr SIP-Trunks has t be installed in the PBX t prvide the SIP-trunks functinality T check the number f activatin keys installed int the PBX and add new licenses please refer t Page 12 in this guide 6/19/2012 2 Versin1
Architecture Overview The fllwing diagram illustrates simple VOIP netwrks cnnecting the TDE/NCP PBX: The Case f Clearfly Setup: Clearfly will prvide its services ver the Public Internet sc.cfly.c Default GW 192.168.0.1 MPR IP Address 192.168.0.101 VOIP IP Address 192.168.0.102 Prt Frwarding rules n the end ruter: Frward Prt 35060 t MPR IP address Frward Prt Range12000~12127 t VOIP-DSP IP address 6/19/2012 3 Versin1
Basic V-SIPGW16 Settings fr Clearfly Trunks 1-Install the PBX Maintenance cnsle int yur PC The maintenance cnsle shuld be available t certified dealers; Dealers can get the latest versin f the UPCMC frm www.btsdealer.cm (UPCMC versin 7.2.1.0 r higher) 2- Cnnect t the PBX Start the UPCMC Click Cnnect and chse the methd f cnnectin using either LAN, RS- 232, Mdem, r USB t Cnnect t yur PBX fr interactive cnfiguratin ** We will be using the LAN methd thrughut this guide** Prvide the IP address f the MPR card and the passwrd f the INSTALLER Level 6/19/2012 4 Versin1
G t 1-Cnfiguratin, 1-Slt, mve yur muse ver the MPR card and select the card prperty Make sure that the default gateway shuld be the end ruter LAN IP address Make sure that yu have a valid DSP-VOIP LAN address 6/19/2012 5 Versin1
3- Installing V-SIP W16 card G t 1-Cnfiguratin, 1-Slt, mve yur muse twards the IPCMPR virtual shelf and click n select shelf Highlight the V-SIPGW16 card frm the cards list in the left side Drag the VSIPGW16 card int the trunk prtin f the virtual shelf by using the PC muse lift buttn Release the Muse lift buttn and click Yes n the dialgue bx 6/19/2012 6 Versin1
Take the V-SIPGW16 card OUS in rder t be able t enter the fllwing settings 4-Cnfiguring the VSIP-GW16 card a- Shelf Prperty settings: Mve the cmputer muse ver the VSIPGW16 card and chse Shelf prperty The fllwing settings are required fr Clearfly SIP trunk services n the shelf prperty: 6/19/2012 7 Versin1
Click Apply and then OK t exit the shelf prperty settings screen. b- Card Prperty settings: Mve the cmputer muse ver the VSIPGW16 card and chse Card prperty Click n Cmmn settings DNS Server IP address methd is Manual Prvide yur ISP DNS serevers IP addresses. (Cntact yur ISP t btain DNS IP addresses if needed) 6/19/2012 8 Versin1
These addresses are just sample. Please use yur ISP prvided infrmatin Click Apply and then OK Click Cancel n the card prperty- Virtual SIP gateway screen t exit this screen c- Prt Prperty settings: Mve the cmputer muse ver the VSIPGW16 card and chse prt prperty Basic Channel setup: Please lcate the Clearfly SIP Trunks accunt details frm yur Clearfly accunt Welcme letter/email.. Sample is shwn belw.. 6/19/2012 9 Versin1
Hell, T: New Custmer cc: supprt <supprt@clearfly.net> Subject: Clearfly SIP Trunk Infrmatin: Yur Clearfly SIP trunk is nw active and has been prvisined as fllws: PBX IP: 1.2.3.4 NAT Fixed-Glbal IP address Clearfly SIP Server: sc.cfly.c SIP Server Lcatin Transprt: UDP/5060 Cdec: G.711u & G.729a RTP Paylad Type: 101 DTMF Relay: RFC2833 Digits Transferred: Default is 10. Please respnd if yu'd like smething different. 123.456.7890 has been ruted t this trunk <-- DID/BTN /accunt username.. If yu have any questins abut r prblems with this trunk, ur techs are available fr test/turn-up frm 8AM-5PM MST, Mnday-Friday at +1.866.652.7520. Regards, Main tab: Accrding t the accunt inf abve, we need t cnfigure the Basic Channel Prt as fllws: Please Nte: the infrmatin abve is just a sample, please lcate yur accunt details in yur Clearfly welcme letter/email 1- Prt 1 channel attribute = Basic channel 2- Prvider name= Clearfly 3- SIP Server Name= sc.cfly.c 4- SIP server prt number =5060 5- SIP service Dmain = Blank 6- Subscriber number = 1234567890 (Optinal) Accunt tab: 1- user name == 1234567890 2- Authenticatin ID== same as BTN & Username 1234567890 3- Passwrd == Prvided by Clearfly 6/19/2012 10 Versin1
Register Tab: Changes frm Default settings: 1- Register abilty== Enable 2- Unregister ability when prt INS= Disable NAT Tab: Same as default Calling Party tab: Changes frm Default settings: 1- P-asserted Identity Header = Enable Called party Tab: Same as default Vice/Fax Tab: Changes frm Default settings: 1- IP Cdec pririty (1st = G.729A, 2nd= G.711u, 3 rd =Nne) RTP/RTCP Tab: Same as default T.38, T.38 Optin Same as default DSP Same as default Supplementry services: Changes frm Default settings: 1- CNIP (Receive) = Yes Additinal DID s Please set the channel attribute fr number f prts depending n the number f active SIP lines as additnal channel fr channel 1 Fr example,if there are 3 Simultaneus calls can be received n this trunk, the number f V-SIPGW prts t be set as an additnal channel fr channel 1 will be 2 prts 6/19/2012 11 Versin1
Essential PBX Cnfiguratin: Please lcate yur DID infrmatin in the Clearfly Welcme letter T Assign the DID numbers destinatins, G t 10-3.CO & Incming Call DID table Clearfly Imprtant nte: Make sure that yu prvide the 10 digits DID number in the DID number field t be able t make use f the additinal DID s assigned by the Prvider. SIP trunks Activatin keys: 1- The DSP card installed nt the PBX MPR Card has preinstalled number f SIP trunks activatin keys (DSP4 and DSP16 have 4 IP trunks and DSP64 has 16 IP trunks) 2- T btain additinal activatin keys, yu need t purchase the apprpriate activatin key cdes (Fr IP Trunks) and access the Key Management System. Yu can dwnlad the activatin keys as an activatin key file frm the Key Management System. T dwnlad the activatin keys, enter the MPR ID number shwn n the IPCMPR Card in the PBX, and activatin key number and registratin ID prvided n each activatin key cde. 3- T check the Number f Activatin Keys Installed int yur system G t 1- Cnfiguratin, 1-Slt, click n Activatin Keys (Tp f the PBX image) 6/19/2012 12 Versin1
UPCMC NCP TDE 100/200 TDE600 Minimum System Sftware requirements: V7.2.1.0 r higher V5.0002 r higher V5.0002 r higher V5.0002 r higher Useful Hints: 1- Update yur system sftware nce the update is available thrugh the Dealer website t make use f added features and imprved functinality 2- Update yur PCMC (Maintenance Tl) with the latest versin available n the BTS website and thrugh Panasnic Tech supprt department 3- Back up yur cnfiguratin file with the Gd knwn settings 4- Cnsult with yur netwrk administratr prir t installatin t guarantee a smth setup fr yur system ver the existing netwrk Imprtant Ntes: 1- Fax and Mdem cmmunicatin: Clearfly desn t supprt Fax r Mdem cmmunicatin ver their SIP trunks. Clearfly always suggests using POTS line fr these types f cmmunicatin. 2- E911 : Please Wrk Clsely with Clearfly team t ensure that E911 service is cnfigured and tested prperly 6/19/2012 13 Versin1