UE Custom USER GUIDE

Transcription

1 USER GUIDE

2 SET-UP HOW TO WEAR CORD MANAGEMENT CLIPS CORD CLIP POWER ON CHARGING / BATTERY STATUS BATTERY LEVEL CHARGING CLIP USING THE CHARGING CLIP TO CHARGE YOUR BUDS DO NOT PULL CORD CONTROLS PAIRING PAIRING WITH A BLUETOOTH ADAPTER MULTIPOINT SMARTWATCHES TROUBLESHOOTING SPECIFICATIONS WARRANTY, WARNINGS & SAFETY

3 QUICK START REMOVE ATTACH Do not pull cord English 3

4 Power On Searching for your music device Headphones connected 4 SEC PUSH Listen for voice prompt Connection 4 English

5 Cord management clips Cord clip English 5

6 MUSIC + CALLS With complete remote controls Page 18 PAIRING BLUETOOTH Remember up to 8 devices Page 19 MULTIPOINT Connect your buds to 2 devices simultaneously Page 21 SMARTWATCH Leave your phone behind & pair with your smartwatch Page 23 6 English

7 HOW TO WEAR Step 1: Insert monitors. Twist forward. Step 2: Snap backwards. Lock into place. Step 3: Push on faceplate. Adjust seal. Step 4: Adjust cable. Wrap behind hear. English 7

8 CORD MANAGEMENT CLIPS Before fitting, install the cord management clips to reduce the slack for a customized fit. 8 English

9 The cord management clips can be used in three ways to manage the length of your cord and find the right fit for you. English 9

10 CORD CLIP Use the included cord clip to secure your buds to the back of your shirt. Long side of the clip on the outside of the shirt. 10 English

11 POWER ON Push 1 sec push 4 sec push Music & Calls Pair buds to your device, play music, and try each size of eartip to find the best fit and sound performance. A proper seal is essential for you to fully appreciate the high quality audio of UE Custom. Voice prompt: Searching... From Off state push for 4 sec to pair. From On state push 4 sec to power off. Microphone ON Red/Green LED English 11

12 CHARGING / BATTERY STATUS HRS 4 ON CLIP HRS 4 ON BUDS 8 HRS PLAY TIME Q U I C K 20 MIN = 1 HR PLAY TIME Charging the battery before use is recommended but not required. UE Custom ships partially precharged, however initial charge will vary. Look for this Bluetooth headset battery status icon in the top right corner of your iphone screen. C H A R G E BATTERY LEVEL Your UE Custom buds will announce an average battery level when you turn them on. Alternatively, an average battery level announcement can be triggered by pressing the Volume + or Volume button when connected and not playing music. 12 English

13 VOICE PROMPT When not playing music, pressing Volume + or Volume will announce battery status. ARE THE BUDS ON? IS THE BATTERY LOW? MICRO USB CHARGING The charging clip that came with your buds also acts as a charging dock. 2.5 hrs for full charge gives hours of playtime. 20 mins charging gives 1 hour of play time. The clip can also be charged separately and used at a later time. In Standby* mode, push +, watch LED: Single Green Flash = 10% or more battery remaining Single Red Flash = Below 10% battery remaining LED STATUS Red: Charging No Light = Powered off * Standby Mode: Powered and not connected to a device but not playing music or on a phone call. Green: Charged (while charger clip is attached) Red+Green Alternating: Pair Mode No Light: Standby / Play Mode / Phone Call / Powered Off English 13

14 CHARGING CLIP To charge your buds, securely attach the charging clip to the back of the controller and insert the micro USB end of your included cable into the bottom end of the charging clip. Plug the other end into any 5V 500mA USB power source. This charges both your buds and the charging clip simultaneously for extended listening. RED LED = CURRENTLY CHARGING GREEN LED = FULLY CHARGED (with USB cable connected to a power source) 14 English

15 USING THE CHARGING CLIP TO CHARGE YOUR BUDS In addition to using the USB charging cable, your charging clip can charge your buds without having to be connected to a power source. Your charging clip has an internal battery and circuitry that extends your play time by 4 hours. Simply attach it to the back of the controller and it automatically starts charging. Every time you attach the charging clip it will reset your buds by turning them off. You may turn your buds back ON and continue to listen to your music while the charging clip is attached and transferring power. Do not use your buds while the USB cable is plugged into a power source. Doing so could cause an electric shock if your power source develops an electrical fault. 4 HRS + 4 HRS = HRS PLAY TIME English 15

16 REMOVE ATTACH ATTACHING & REMOVING THE CHARGING CLIP Attach the charging clip by pushing it directly onto the back of the controller until you feel it click securely in place. When removing the charging clip apply pressure to the top of the controller and separate it from the charging clip. 16 English

17 DO NOT PULL CORD When removing the clip DO NOT PULL on the cord. Doing this may cause damage to your buds and will void your warranty. English 17

18 CONTROLS PUSH 1 SEC PUSH 4 SEC PUSH Music & Calls ADDITIONAL CALL COMMANDS Switch call to UE Custom ON OFF Redial Mute & un-mute call When not on a call or playing music: On center button activates Siri or Voice Commands If you have a 2nd incoming call: On center button will answer 2nd call, hold active and switch between active and hold 18 English

19 PAIRING 1. With buds turned off, & within 1 meter (3 ft) of music device, push and hold center key for more than 4 sec until you see alternating red/green LED and a voice prompt saying Searching For Your Music Device. 2. On your phone/music device, turn Bluetooth on & have it search for Bluetooth devices. 3. Select Jaybird Freedom (enter passcode 0000 if prompted). 4. Voice prompt will say Headphones Connected. 5. If the pairing is not successful, switch off buds by pushing the center key for more than 4 seconds and repeat the steps outlined above. Jaybird Freedom English 19

20 PAIRING WITH A BLUETOOTH ADAPTER 1. Place buds and device within 1 meter (3 feet) of each other. 2. Put the buds into pair mode as outlined on prior page. 3. If using BAU Universal Bluetooth Adapter put into pair mode also (see BAU manual). 4. Plug the Bluetooth adapter into the music device and play a song. 5. The buds and adapter will pair automatically (passcode of adapter must be 0000). 6. After successful pairing and connecting, the buds will say Headphones Connected. 20 English

21 MULTIPOINT PAIRING WITH SEVERAL BLUETOOTH DEVICES Multipoint enables you to simultaneously pair and connect your buds with two different Bluetooth devices. For example you can have your UE Custom buds connected to your laptop and your phone at the same time. You can listen to music from your laptop and are still able to answer an incoming call on your phone using your UE Custom buds controller. Pretty wicked, eh?! English 21

22 MULTIPOINT 1. Pair your buds to the first device. Jaybird Freedom Jaybird Freedom 2. Put your buds back in pairing mode and then hold down the center button. 3. Search and select your UE Custom buds on the second device. 22 English

23 SMARTWATCHES With the right smartwatch you can leave your phone at home. Just sync music to your smartwatch and pair with your buds. Now that s freedom! NOTE: Some smartwatches have a weaker Bluetooth signal which may cause possible intermittent signal drop. Works with smartwatches like: APPLE SAMSUNG MOTOROLA English 23

24 TROUBLESHOOTING RESET If your buds are not responding, connect the charging clip and USB cable to a power source. This will turn your buds off and perform a soft reset. FACTORY RESET 1. To reset your buds to their original factory settings put your buds in pairing mode by turning the buds off then push and hold the center button for more than 4 sec until you see alternating red/green LED. 2. While the LED is flashing red/green double tap the center button. Upon successful factory reset, the LED turns orange and your buds turns off. NOTE: Once your buds have been reset and you power on they will automatically go into pairing mode. Select Forget or Remove Jaybird Freedom from your device s Bluetooth menu and pair again. LED 24 English

25 SPECIFICATIONS Bluetooth Version Codec Profile Effective Range Play Time Standby Time AC Power Charging Time Quick Charge 4.1, Multipoint AAC, SBC, Modified SBC Handsfree, Headset, A2DP, AVCRP, SPP 10 meters (30 feet) 8 Hrs* (4 hrs on buds plus an additional 4 hrs with included charging clip) 110 Hrs* DC 5V 500mA 2.5 Hrs 20 Min = 1 Hr play time on buds + an extra hour through charging clip * Play time and standby time may vary due to usage conditions. English 25

26 WARRANTY, WARNINGS & SAFETY Full warranty, care & maintenance details at: WARNING: Due to the isolating characteristics of these headphones do not use while driving, riding a bike or where vehicular traffic is present, or in any other activity where failure to hear surrounding sounds could be dangerous. Use of these headphones at excessive volumes may cause permanent hearing damage. Always turn the volume down before use. Take caution in regards to inserting objects into ear canal, use at own risk. Do not wear the device while it is connected to a power source driven from main 110V or 220V lines. 26 English

27 Copyright 2016 Logitech. Logitech, Logi and other Logitech marks are owned by Logitech and may be registered. All rights reserved. Jaybird, and the Jaybird logo are trademarks of Jaybird, LLC. Bluetooth is a trademark owned by Bluetooth SIG, Inc. USA, and licensed to Jaybird, LLC. iphone, ipad and ipod are trademarks of Apple, Inc., registered in the US and other countries and App Store is a service mark of Apple Inc. Android is a trademark of Google Inc. in the United States and other countries. All other trademarks are the property of their respective owners. Manufactured under Freebit patent numbers EP , US , US and corresponding international patents. Assembled in Malaysia