POWERBOX Medline 150 EBM04 Series W Single Output AC/DC Medical Switch Mode Adaptor, Desktop Style

Transcription

1 Features Fulfills IEC :2014 (EMC 4th edition) Low safety ground leakage current Wide input range 90 to 264 VAC Optional output connectors 100% burn-in Overvoltage protection Overcurrent protection Compliant with CEC and Energy Star Efficiency level V requirements (except EBM04031 and EBM04037 to level IV) - No load power consumption less than 0.5 W - Average active efficiency >87% Compliant with RoHS requirements Input Voltage range VAC. Frequency 47-63Hz. Current 2.0A (rms) for 115VAC. 1.0A (rms) for 230VAC. Leakage current 220mA 264VAC, 63Hz. Touch current 100mA 264VAC, 63Hz. Output Power See table. Voltage/current See table. Ripple and noise 1% peak to peak max at full load. Over voltage protection Provided and set at % of its nominal output voltage. Over current protection Protected to short circuit conditions. Temperature coefficient ±0.04%/ C max. Transient response Max excursion of 4% or better on all models, recovering to 1% of final value within 500us after a 25% step load change. Enviromental Operating temperature 0 C to +60 C. Storage temperature 40 C to +85 C. Relative humidity 5-95% non-condensing. Derating Derate from 100% at +40 C linearly to 50% at +60 C. General Switching frequency KHz. Power factor 0.98 typical at 115VAC. Efficiency Average active 87% min. (except 85% min. for EBM04031 and EBM04037). Hold-up time Line regulation 15ms min at 110VAC. ±0.5% max at full load. Inrush current 115VAC, or 230VAC, at 25 C Withstand voltage MTBF Standards cold start. 5,600VAC from input to output (2MOPP). 2,100VAC from input to ground (1MOPP). 700VDC from output to ground. (To verify AC strength, get correct test method to avoid power supply damage.) For Class II models, 4000 VAC from input to output 150,000 hours at full load at 25 C ambient, calculated per MIL-HDBK-217F. Safety standards UL ES , CSA C22.2 No EMC performance EN55011 FCC VCCI File No. E242500, TÜV EN IEC :2014 (4th ed.). EN Harmonic distortion Class A and D. EN EN EN EN EN EN EN EN Line flicker. ESD, ±15 KV air and ±8 KV contact. Radiated immunity, 10 V/m. Proximity test, 9V/m and 28V/m. Fast transient/burst, ±2KV. Surge, ±1KV diff., ±2KV com. Conducted immunity, 10 Vrms ( MHz). 10 Vrms ISM Bands + Amateurs. Magnetic field immunity, 30A/m. Voltage dips: 100% drop, 0.5 periods. 100% dip, 1 period. 30% dip, 25/30 periods. Interruptions: 100% drop, 5 seconds.

2 Model Number 1 Output Min Max Tol Ripple & Max Output Average Active Efficiency Class I Class II V1 Current Current Noise 2 Power 115/230VAC EBM04031 EBM04031F 12.0 V 0 A A ±5% 120 mv 132 W 87 /86% EBM04037 EBM04037F 15.0 V 0 A 9.00 A ±5% 150 mv 135 W 87 /86% EBM04040 EBM04040F 19.0 V 0 A 7.90 A ±5% 190 mv 150 W 88 /88% EBM04046 EBM04046F 24.0 V 0 A 6.25 A ±5% 240 mv 150 W 88 /88% EBM04050 EBM04050F 27.0 V 0 A 5.56 A ±5% 270 mv 150 W 89 /88% EBM04070 EBM04070F 48.0 V 0 A 3.13 A ±5% 480 mv 150 W 88 /88% Notes: 1. Class I models are equipped with IEC320/C14 inlet, and class II models with IEC320/C18 inlet. 2. Ripple and noise is maximum peak to peak voltage value measured at output within 20 MHz bandwidth, at rated line voltage and output load ranges, and with a 10 μf tantalum capacitor in parallel with a 0.1 μf ceramic capacitor across the output. Mechanical Derating Curve EBM04040,-46, -50, -70 EBM04037 EBM04031 Notes: 1. Dimensions shown in inches [mm] 2. Tolerance 0.02 [0.5] maximum 3. Weight: 960 grams (2.1 lbs.) approx. 4. Output connector is 4 pin plug without lock, mating with Kycon P/N KPJX-4S-S socket or equivalent. 5. Add the suffix assigned for a selected connector to a wanted model number, e.g. EBM04046-B1, for ordering (optional output connectors, see page 3-4). Pin Connection Model Pin EBM04031 EBM04031F V1 Return +V1 V1 Return +V1 EBM04037 EBM04037F V1 Return +V1 V1 Return +V1 EBM04040 EBM04040F V1 Return +V1 V1 Return +V1 EBM04046 EBM04046F V1 Return +V1 V1 Return +V1 EBM04050 EBM04050F V1 Return +V1 V1 Return +V1 EBM04070 EBM04070F V1 Return +V1 V1 Return +V1

3 NIL (1) V EXCEPT (4) +V 4-PIN PLUG WITH KPPX-4P OR EBM04031, EBM04037, EBM NIL (1) V (4) +V 4-PIN PLUG WITHOUT LOCK, (MOLDING EBM04031, EBM04037, EBM B1 (FORK RA722 OR B2 RA712 OR B3 (FORK RA712 OR B4 (FORK B5 RA722 OR B6 EIAJ-05 PLUG Lumberg OR Lumberg OR

4 B7 (FORK RA722 OR B8 CENTER: V SLEEVE: +V RA712 OR B10 (FORK RA712 OR B14 (FORK B16 (LOCKING FEATURE) HF (1) +V (3) N.C. (2) V 3-PIN PLUG WITH KPPX-3P OR 3-PIN SOCKEY, KYCON P/N KPJX-3S-S OR HI (1) +V (4) V 4-PIN PLUG WITH KPPX-4P OR HJ (1) V 4-PIN PLUG WITHOUT (4) +V LOCK, (MOLDING Q1 (1) V (2) V 5 PIN AT 180 DIN (3) +V (4) V MALE (5) +V 5 PIN CONTACTS AT 180 DIN RECEPTACLE, 57GB5F OR

5 Q (TYP) DIN )+V1 1 (3) RETURN (4) +V1 (5) RETURN (6) +V1 (7) RETURN (8) RETURN 8 PIN AT 270 DIN MALE, CUI, TYPE: SD-80 8 PIN CONTACTS AT 270 DIN RECEPTACLE, CUI, TYPE: SD-80BV OR Specifications are subject to change without notice