Typical Efficiency (2) 0 ~ 12.5 A 150 W 90.0% EUV-150S012DTA(STA) 0 ~ 6.25 A 150 W 90.5% EUV-150S024DTA(STA) (4)

Transcription

1 EUV150SxxxDTA(STA) Features High Efficiency (Up to 90.5%) Isolated 010V Dimmable(DTA models) NonDimmable (STA models) Deep Dimming down to 0.1% Constant Voltage PWM Output Frequency up to 1.5kHz DimtoOff with Standby Power 0.5 W Input Surge Protection: 4kV lineline, 6kV lineearth AllAround Protection: OCP, OVP, SCP, OTP Waterproof (IP67) and UL Dry / Damp / Wet Location LVLE and SELV Output UL Class P Type TYPE HL, for Use in a Class I, Division 2 Hazardous (Classified) Location 5 Years Warranty Description The EUV150SxxxDTA(STA) series is a 150W, constantvoltage IP67 LED driver that operates from Vac input with excellent power factor. It is created for many lighting applications including LED strip, architectural, decorative and signage. The high efficiency of the driver and compact metal case enables them to run cooler, significantly improving reliability and extending product life. To ensure troublefree operation, protection is provided against input surge, over current, output over voltage, over temperature, and short circuit. Models Output Voltage 12 V 24 V Input Voltage Range(1) 90~305 Vac 127~250 Vdc 90~305 Vac 127~250 Vdc Output Current Range Max. Output Power Typical Efficiency (2) Power Factor 120Vac 220Vac Model Number(3) 0 ~ 12.5 A 150 W 90.0% EUV150S012DTA(STA) 0 ~ 6.25 A 150 W 90.5% EUV150S024DTA(STA) (4) Notes: (1) Certified input voltage range: UL, FCC Vac or Vdc; otherwise Vac or Vdc (except KS). (2) Measured at 100% load and 220Vac input (see below General Specifications for details). (3) SELV output. (4) LVLE output. Input Specifications Input Voltage 90 Vac 305 Vac 127~250Vdc Input Frequency 47 Hz 63 Hz Leakage Current 0.75 MIU UL8750; 277Vac/60Hz 1 / 11 Tel: Fax: sales@inventronicsco.com

2 EUV150SxxxDTA(STA) Input Specifications (Continued) Leakage Current 0.70 ma IEC605981; 240Vac/60Hz Input AC Current Inrush Current(I 2 t) 2.56 A 2 s PF 0.90 THD 20% 1.6 A Measured at 100% load and 120Vac input. 0.9 A Measured at 100% load and 220Vac input. At 220Vac input, 25C cold start, duration=760 μs, 10%Ipk10%Ipk. See Inrush Current Waveform for the details. At Vac, 5060Hz, 70%100% load(105150w) THD 10% At Vac, 5060Hz, 75%100% load( w) Output Specifications Output Voltage Tolerance 2.5%Vo 2.5%Vo At 100% load condition Output Voltage EUV150S012DTA(STA) EUV150S024DTA(STA) Total Output Voltage Ripple (pkpk) 12.5 V 24.2 V 2%Vo At 100% load condition Measured by 20 MHz bandwidth oscilloscope and the output paralleled a 0.1 uf ceramic capacitor and a 10 uf electrolytic capacitor. Startup Overshoot Voltage 5%Vo At 100% load condition Line Regulation ±0.5% Measured at 100% load Load Regulation ±1.5% Turnon Delay Time 1.0 s Measured at 120Vac input, 70%100%load 0.5 s Measured at 220Vac input, 70%100%load Hold up Time 15 ms Measured at 220Vac input, 100%load Load Dynamic Response Output Deviation 5%VO Settling Time 10ms R/S: 1A/μs Load: 25% ~ 75% load Temperature Coefficient of Vo 0.03%/C Case temperature = 0C~Tc max Note: All specifications are typical at 25C unless otherwise stated. 2 / 11 Tel: Fax: sales@inventronicsco.com

3 EUV150SxxxDTA(STA) General Specifications Efficiency at 120 Vac input: EUV150S012DTA(STA) EUV150S024DTA(STA) Efficiency at 220Vac input: EUV150S012DTA(STA) EUV150S024DTA(STA) Efficiency at 277Vac input: EUV150S012DTA(STA) EUV150S024DTA(STA) 85.5% 85.5% 88.0% 88.5% 88.5% 88.5% 87.5% 87.5% 90.0% 90.5% 90.5% 90.5% Measured at 100% load and steadystate temperature in 25C ambient; (Efficiency will be about 2.0% lower if measured immediately after startup.) Measured at 100% load and steadystate temperature in 25C ambient; (Efficiency will be about 2.0% lower if measured immediately after startup.) Measured at 100% load and steadystate temperature in 25C ambient; (Efficiency will be about 2.0% lower if measured immediately after startup.) Standby Power 0.5 W Measured at 230Vac/50Hz; Dimming off MTBF Lifetime Operating Case Temperature for Safety Tc_s Operating Case Temperature for Warranty Tc_w 258,000 Hours 89,000 Hours 40 C +90 C Measured at 220Vac input, 80%Load and 25C ambient temperature (MILHDBK 217F) Measured at 220Vac input, 80%load and 70C case temperature; See lifetime vs. Tc curve for the details 40 C +75C Case temperature for 5 years warranty Storage Temperature 40 C +85 C Humidity: 5%RH to 100%RH Dimensions Inches (L W H) Millimeters ((L W H) 7.08 x 2.66 x x 67.5 x 36.5 With mounting ear 7.91 x 2.66 x x 67.5 x 36.5 Net Weight 950 g Note: All specifications are typical at 25C unless otherwise stated. Dimming Specifications Absolute Maximum Voltage on the Vdim (+) Pin 20 V 20 V Source Current on Vdim (+)Pin 135 μa 150 μa 165 μa Vdim(+) = 0 V Dimming Output Range 0.1% 100% Recommended Dimming Input Range 0 V 10 V Dim off Voltage 0.35 V 0.5 V 0.65 V Dim on Voltage 0.55 V 0.7 V 0.85 V Hysteresis 0.2 V Note: All specifications are typical at 25C unless stated otherwise. 3 / 11 Tel: Fax: sales@inventronicsco.com

4 EUV150SxxxDTA(STA) Dimming Principle for PWM Style Output 0 Hz Vdim(+) = V Output PWM frequency 1.5 khz Vdim(+) = V 300 Hz 1.5 khz Vdim(+) = V Note: Dimming is achieved by varying the duty cycle of the output current when driving LED strips. Safety & EMC Compliance Safety Category Standard UL UL8750,CAN/CSAC22.2 No CE EN , EN KS KS C 7655 EMI Standards EN (1) EN EN Notes Conducted emission Test &Radiated emission Test Harmonic current emissions Voltage fluctuations & flicker ANSI C63.4 Class B FCC Part 15 (1) EMS Standards EN EN EN This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] this device may not cause harmful interference, and [2] this device must accept any interference received, including interference that may cause undesired operation. Notes Electrostatic Discharge (ESD): 8 kv air discharge, 4 kv contact discharge RadioFrequency Electromagnetic Field Susceptibility TestRS Electrical Fast Transient / BurstEFT 4 / 11 Tel: Fax: sales@inventronicsco.com

5 EUV150SxxxDTA(STA) Safety & EMC Compliance (Continued) EMS Standards EN EN EN EN EN Notes Surge Immunity Test: AC Power Line: line to line 4 kv, line to earth 6 kv Conducted Radio Frequency Disturbances TestCS Power Frequency Magnetic Field Test Voltage Dips Electromagnetic Immunity Requirements Applies To Lighting Equipment Note: (1) This LED driver meets the EMI specifications above, but EMI performance of a luminaire that contains it depends also on the other devices connected to the driver and on the fixture itself. Derating Lifetime vs. Case Temperature 5 / 11 Tel: Fax: sales@inventronicsco.com

6 EUV150SxxxDTA(STA) Inrush Current Waveform Efficiency vs. Load EUV150S012DTA(STA) EUV150S024DTA(STA) Power Factor 6 / 11 Tel: Fax: sales@inventronicsco.com

7 EUV150SxxxDTA(STA) Total Harmonic Distortion Protection Functions Parameter Notes Over Current Protection Over Voltage Protection Short Circuit Protection Over Temperature Protection Auto Recovery. The driver shall be selfrecovery when the fault condition is removed. Limits output voltage at no load and in case the normal voltage limit fails. Auto Recovery. No damage will occur when any output is short circuited. The output shall return to normal when the fault condition is removed. Auto Recovery. Returning to normal after over temperature is removed. Dimming 010V Dimming The recommended implementation of the dimming control is provided below. Implementation 1: DC Input 7 / 11 Tel: Fax: sales@inventronicsco.com

8 EUV150SxxxDTA(STA) Notes: 1. The dimmer can also be replaced by an active 010V voltage source signal or passive components like resistors and zener diode. 2. Do NOT connect Dim to the output V or V+, otherwise the driver will not work properly. 3. If 010V dimming is not used, Dim + should be open. Resister Dimming Implementation 2: External Resistor Mechanical Outline EUV150S012DTA INPUT (UL SJTW 3*18AWG 7.8) DIMMING WIRE(UL2464 2*22AWG 4.2) Tc AC/L (BLACK) AC/N (WHITE) GND (GREEN) V+ (RED) V (BLUE) GRAY PURPLE OUTPUT (UL SJTW 2*14AWG 8.8) PROJ: Unspecified tolerance:±1 8 / 11 Tel: Fax: sales@inventronicsco.com

9 EUV150SxxxDTA(STA) EUV150S024DTA INPUT (UL SJTW 3*18AWG 7.8) DIMMING WIRE(UL2464 2*22AWG 4.2) Tc AC/L (BLACK) AC/N (WHITE) GND (GREEN) V+ (RED) V (BLUE) GRAY PURPLE OUTPUT (UL SJTW 2*18AWG 7.3) PROJ: Unspecified tolerance:±1 EUV150S012STA INPUT (UL SJTW 3*18AWG 7.8) OUTPUT (UL SJTW 2*14AWG 8.8) Tc AC/L (BLACK) AC/N (WHITE) GND (GREEN) V+ (RED) V (BLUE) PROJ: Unspecified tolerance:±1 9 / 11 Tel: Fax: sales@inventronicsco.com

10 EUV150SxxxDTA(STA) EUV150S024STA INPUT (UL SJTW 3*18AWG 7.8) OUTPUT (UL SJTW 2*18AWG 7.3) Tc AC/L (BLACK) AC/N (WHITE) GND (GREEN) V+ (RED) V (BLUE) RoHS Compliance PROJ: Unspecified tolerance:±1 Our products comply with the European Directive 2011/65/EU, calling for the elimination of lead and other hazardous substances from electronic products. 10 / 11 Tel: Fax: sales@inventronicsco.com

11 EUV150SxxxDTA(STA) Revision History Change Date Rev. Description of Change Item From To A Datasheet Release / / B Features / Updated Note of Dimming Specifications Dimming Output Range / Deleted 11 / 11 Tel: Fax: sales@inventronicsco.com