Whirlamatic UHSB 17 PARTS LIST Advance MODEL

Transcription

1 PARTS LIST Advance MODEL /97 revised 12/01

2 TABLE OF CONTENTS 3 DESCRIPTION PAGE CHASSIS AND SHROUD HANDLE ASSEMBLY PAD DRIVE ASSEMBLY WIRING DIAGRAM WHEN ORDERING PARTS * Use the 8 digit numbers from the Ref. No. columns in this parts list. * Specify the model and serial number of the machine. * Use the space below to record the model and serial number for future reference. Model Serial No.

3 4 CHASSIS AND SHROUD

4 CHASSIS AND SHROUD Shroud Assembly (#1-6) Scr, Pan Phil #6-32 x Keeper Nut, Hex Nyl Loc-Thin # Shroud Scr, Pan Phil Thd Form #10-24 x Bracket Connector with Wires Battery Boot Cable TSB Battery Tray Chassis Nut, Push Cap 3/ Trim Pin Wheel Bushing Caster Scr, Hex Thd Form 1/4-20 x Nut, Hex Nyl Loc # Decal, Pad Replacement Wsh, Bowed Bumper Decal, UHSB Latch Grommet Decal, Maintenance Decal, Important * Battery Cable TSB 730 * Battery Cable TSB 730 * = Not Shown

5 6 HANDLE ASSEMBLY

6 HANDLE ASSEMBLY Handle Assembly Battery Meter Green Indicator Light (before February 1998) Green Indicator Light (after January 1998) Red Indicator Light (before February 1998) Red Indicator Light (after January 1998) Amp Meter TSB Decal, Control Handle Connector with Wires Handle Weld t Decal, Switch Decal, Cable Routing Scr, Hex Hd 3/8-16 x Scr, Hex Hd 5/16-18 x Scr, Hex Hd x Main Switch Scr, Hex Cap 1/4-20 x Scr, Hex Thd Form 1/4-20 x Scr, Pan Phil x Scr, Hex Hd Loc 6-32 x Lever Bushing Pad Up Switch Nut Plate Pedal Retaining Ring Scr, Pan Phil Thd Form 8-32 x Nut, Hex Nyl Loc-Thin Grip Nut. Hex Jam 1/ Leveler Tube Pad Scr, Pan Phil x Wsh, Bowed Wsh, Flt SAE # Scr, Soc Set Loc 5/16-18 x Collar Spring Rod Panel Decal, Wiring Decal, Caution Handle Grommet Insulated Stand-Off Stud 1/4-20 x Wsh, Int Shprf 1/ Nut, Hex Jam 1/ Scr, Hex Thd Form 1/4-20 x Contactor 36V Wsh, Flt Bearing Block Assembly Bushing Scr, Hex Hd x Pivot Nut, Hex Nyl Loc 5/ Support Nut, Hex Nyl Loc 3/ Wsh, Flt SAE 3/ Spring Washer Thrust Bearing Grip Lever TSB Shunt Mercury Switch Switch Decal, Circuit Breaker Circuit Breaker Circuit Breaker Wsh, Bowed Bracket, Keylock Spring Scr, Hex Hd 1/4-20 x Wsh, Flt SAE 1/ Bushing Bushing Nut, Hex Nyl Loc-Thin 1/ Nut, Hex Nyl Loc-Thin 10-24

7 8 PAD DRIVE ASSEMBLY

8 PAD DRIVE ASSEMBLY Drive Unit Assembly (#1-17) Scr, Flt Phil Thd Form x Cover Motor TSB 672 * Carbon Brush Set (for #3) * Brush Spring Set (for #3) Hose Clamp Hose Frame Scr, Hex Hd 5/16-18 x Motor Mount Wsh, Flt SAE 1/ Scr, Hex Thd Form 1/4-20 x Bushing Wsh, Flt SAE 5/ Nut, Hex Nyl Loc 5/ Wsh, Int Shprf 3/ Scr, Hex Hd 3/8-16 x Bushing Linkage Bag (package of 6) Shroud Skirt ' Gasket (61 cm) Dust Shroud Assembly (#19-21) Pad Holder Retainer Scr, Hex Hd x Pad (not included) Wsh, Flt Hrd Scr, Hex Thd Form 1/4-20 x Wsh, Flt Scr, Hex Loc 5/16-24 x Scr, Hex Hd 1/2-13 x Wsh, Flt Hrd Bushing Nut, Jam 1/ Axle Wsh, Bowed Wheel Wsh, Flt Wsh, Flt Scr, Hex Hd Loc 5/16-18 x Scr, Hex Hd Loc 5/16-18 x Wsh, Int Shprf 1/ Insulated Stand-Off Stud, 1/4-20 x Connector Assembly 50 Intentionally Omitted Nut, Hex Nyl Loc 1/ Scr, Hex Hd 1/4-20 x 1.75 * A/R Burnishing Pads (5 pack) * = Not Shown

9 10 WIRING DIAGRAM V X1 X4 X1 X3 RED CB1 ORN X2 S1 S2 YEL V BLK BRN YEL R1 DS1 G BLK S3 BLU S4 VIO D1 K1 BLK CB2 2 RED R A BLK 1 K1 29 M1 M 3 BRN/YEL R2 YEL/WHT G DS2

10 WIRING DIAGRAM 11 A Amp Meter CB Circuit Breaker 10 Amp CB Circuit Breaker 80 Amp D Diode DS Green Indicator Light (before February 1998) Green Indicator Light (after January 1998) DS Red Indicator Light (before February 1998) Red Indicator Light (after January 1998) K Contactor M Pad Motor R Shunt R Resistor 330 Ohm (before February 1998) R Resistor 330 Ohm (before February 1998) S Main Switch S Mercury Switch S Pad Up Switch S Pad Motor Switch V Battery Meter X1 1 Battery Disconnect X Stud, 1/4-20 x.88 X Stud, 1/4-20 x.88 X Connector Assembly Wiring Harness (before February 1998) Wiring Harness (after January 1998)

11 Nilfisk-Advance, Inc st Avenue North Plymouth, MN, Phone: Fax: Nilfisk-Advance, Inc., Plymouth, MN Printed in the U.S.A.