HOW TO ADD A QCW2MPSL ENTRY CAMERA Written By: Q-See 2018 qplus.dozuki.com/ Page 1 of 10
INTRODUCTION Q-SEE PLUS IS ONLY COMPATIBLE WITH WI-FI ENABLED QCW IP CAMERAS. 2018 qplus.dozuki.com/ Page 2 of 10
Step 1 HOW TO ADD A QCW2MPSL ENTRY CAMERA Select the Add Device icon. If you already have a device added, select the + in the top right corner. PLEASE BE SURE THAT THE LED ON THE CAMERA IS BLINKING GREEN. IF NOT, PRESS AND HOLD THE RESET BUTTON FOR 15 SECONDS AND TRY AGAIN. Step 2 Scan the QR Code on your camera cable. If you are having difficulty scanning the QR code try using the Flash on your phone. 2018 qplus.dozuki.com/ Page 3 of 10
Step 3 Select Wi-Fi Camera 2018 qplus.dozuki.com/ Page 4 of 10
Step 4 Ensure that your device is connected to the Wi-Fi connection you wish to connect your QCW Camera to. QCW IP Cameras require a 2.4Ghz Wi-Fi connection, 5G networks are not compatible. Select Next Step 5 Enter the your Wi-Fi Password Select Next 2018 qplus.dozuki.com/ Page 5 of 10
Step 6 While Q-See Plus configures your camera, your mobile device may begin to make a chime noise, this is normal and you can lower the volume if you wish. Q-See Plus will configure the network. Please be patient, this process may take up to 3 minutes depending on the network speed. If the configuration fails, please ensure your phone and Wi-Fi camera are in range of the Wi-Fi signal. IF you are experiencing issues connecting to a Wi-Fi network, (CLICK HERE) for Wi-Fi Connectivity Troubleshooting 2018 qplus.dozuki.com/ Page 6 of 10
Step 7 Enter the Password you wish to set for your camera. Select OK Step 8 Verify your Time Zone to ensure accurate time. Select Start Preview 2018 qplus.dozuki.com/ Page 7 of 10
Step 9 Q-See Plus will begin to show the live feed from your camera. Motion Detection and Push Notifications are enabled by default. Select the Camera icon to take a Snap Shot of the live feed. Select the Microphone icon to begin 2-Way Talk, tap again to stop. Select the Camcorder icon to start recording the live feed, tap again to stop. Select the Bell icon to manually enable the siren. Once enabled, tap again to disable. Select the Light Bulb icon to manually enable the Spotlight. Once enabled, tab again to disable. 2018 qplus.dozuki.com/ Page 8 of 10
Step 10 Select the Share icon in the top right corner to share your feed with others. Select the Gear icon in the top right corner to go to the device's settings. Select the Display icon to alternate between single and 4 channel view. Select the Quality icon to alternate between Standard and High Definition. The Standard Definition feed is shown by default to limit bandwidth use but the High Definition image is still recorded. Select the Speaker icon to begin listening to the audio from the camera, tap again to stop. Select the Full-Screen icon to manually enter full-screen mode. Alternatively, you can rotate your device to enter full-screen mode. 2018 qplus.dozuki.com/ Page 9 of 10
Step 11 Click HERE to Update the Firmware on your Device This document was last generated on 2018-10-21 12:29:56 PM. 2018 qplus.dozuki.com/ Page 10 of 10