The is a small profile LED strip featuring a unique 4 chips into 1 LED. Each LED has a red, green, blue and warm white (3000K) diode built in for greater range of color mixing and control. ounting LLED strip is equipped with 3 adhesive transfer tape (9472LE). The strip must be adhered to either a Luminii aluminum profile or an unpainted aluminum surface. or other surfaces the HST Aluminum heat sink tape will be required to reach the rated 50,000 hours average life Applications Indoor only - above and below cabinets, cove lighting, counter accent, architectural reveals, under banister, display and book cases, etc. Approvals Class 2 damp listed Operating voltage 24 VDC (RGBW controller and power supply required) Average life 50,000 hours Technical specifications ODEL Section start/end options LEDs/ft 18 Light output 256 lumen/ft Soldered leads (72 ) Average power consumption (for 15 section Ordering increment aximum run length Dimensions 4.85W/ft 4.00 20 ft 0.47 W 0.09 H No connector Ordering code ODEL CCT (White channel) 30K 30K - 3000K SECTION START SL SL - Soldered lead wires (72 ) NC - No connector SECTION END NC SL - Soldered lead wires (72 ) NC - No connector LENGTH View specifications for increment options REV0.7 page 1 of 4 www.luminii.com tel: 224-333-6033
ounting accessories ounting clip: recommended at every 12 when LineLED strip is facing down. 0.19 0.05 Heat sink tape: included with LineLED strip when no extrusions are ordered Part # CL-1 0.40 Part # HST 1.00 0.23 2.00 Power consumption per linear foot* * with all 4 circuits at full brightless Length of Strip (L) W/ft Total wattage Length of Strip (L) W/ft Total wattage 1 5.65 5.65 2 5.65 11.30 3 5.65 16.95 4 5.60 22.40 5 5.50 27.50 6 5.45 32.70 7 5.35 37.45 8 5.30 42.40 9 5.25 47.25 10 5.20 52.00 11 5.15 56.65 12 5.10 61.20 13 5.05 65.65 14 4.95 69.30 15 4.85 72.75 16 4.75 76.00 17 4.60 78.20 18 4.50 81.00 19 4.40 83.60 20 4.30 86.00 Power supply See fixture and power supply instructions & spec sheet for wiring information. Dimming possible in select models - view Luminii website for list of compatible dimmers. Non-Dimming: ODEL POWER OUTPUT DIING LOCATION PSV PSV - PSV Series 40 40-40 W 60-60 W 96-96 W 24V 24-24 VDC U2ND U2ND - Non Dimming D D - Dry Location IP65 - Wet Location - Requires a controller & a decoder to work properly ODELS PSV Dry PSV Wet C A Length 9.2 9.5 A B Width 3.4 4.12 B C Depth 1.9 2.3 DX: C B ODEL POWER OUTPUT PSDX PSDX - DX Power Supply dims down to 0% 3X100 3X100-3 X 100 WATT 24 24-24 VDC - eatures eldoled s LINEARdrive configurable dimmable drivers ODELS PSDX A Length B Width C Depth 15.75 6.60 4.80 A REV0.7 page 2 of 4 www.luminii.com tel: 224-333-6033
DX-3Z-RGBW RGBW LED 1 or 3 Zone Controller DX /Wireless RGB-W wall-mount controller controls DX lighting fixtures, wireless control of RGB-W lighting fixture or use both simultaneously. its in any standard US switch box. Includes all the outputs in the back of the controller. ORDERING CODE odel DX DX - DX controller DX decoder Zones 3Z 3Z - Three Zone 1Z - One Zone Touch DX Controller Touchscreen digital LED controller ORDERING CODE odel TSDX TSDX - Touchscreen DX controller Control brightness levels with a single touch, personalize and memorize 3 different scenes, and even create 3 variations of white. Color RGBW RGBW - Red, Green, Blue & White Programmable advanced DX512 lighting controller featuring a touchscreen interface. Operates as stand alone controller or integrated with most architectural lighting control systems. Can controller endless DX512 enabled devices. ounts to standard single or dual gang wall box with the included power supply inside the junction box. Terminal block design for power and data connections. DX signal to RGBW decoder (required to operate DX controller) Translates controller DX512 programs for RGB and white LED strips. Unique DX address for the decoder can be set easily and displayed by the numeric display on the case. Changing and resetting the DX address requires manual input. Use power repeater to expand output. Operating voltage 12-24V DC eatures 2 in 1 in-wall Controller: DX Control or Wireless RGB-W 65,000 Color Options, Dimming and Speed Control emory unction 50 oot Wireless Range Easily its Standard US Switch Boxes Touch Sensitive Glass Surface Includes 10 Built in Programs, or Create and Play Your Own Color parameters Brightness Saturation Primary colors ading Color changing speed Power supply 9 VDC (included) Data programming USB 2.0 computer connection required for initial setup Output signal DX512 (1024 channels) Sound activation Built in microphone Color parameters Brightness Saturation Speed of color changing sequence ading / dimming / brightness Operating voltage 12-36 VDC Power capacity up to 96W at 24V Operating temperature range from -4 to +122 in case ORDERING CODE odel DDX-RGBW DDX-RGBW - DX decoder REV0.7 page 3 of 4 www.luminii.com tel: 224-333-6033
Optional mounting channels - lens type per channel / light transmission percentage per lens / dimensions Lens options / light transmission percentage per lens CL Clear rosted H Half (50%) frosted edium beam frosted N G Narrow Gel color filter suitable 0.94 0.99 1.20 CL 78% 50% CL CL 70% 79% 50% 58% H H 61% 69% Alu-Round Alu-45 Alu-Corner 0.72 CL 85% CL 63% 63% CL 85% 0.95 43% H 75% 63% H 54% 0.27 0.27 87% H 75% 65% N 84% 87% N 60% 78% N 84% 54% G Slim Line 7 Recessed Slim Line 7 Slim Line 15 G 0.63 0.59 CL 63% 0.95 43% CL 85% 0.59 H 54% 63% 65% H 75% N 60% 87% Recessed Slim Line 15 Alu-lat Alu-Wall 2.05 0.30 CL 47% 44% 2.76 2.36 1.16 0.33 0.33 CL 85% CL 85% CL 69% 0.89 60% 60% 0.89 44% 0.89 H 71% H 71% H 55% Slim Wide 8 Recessed Slim Wide 8 Slim Wide 15 0.66 0.89 3.93 3.24 1.81 1.81 2.31 Alu-Stair Installation All mounting channels are field cuttable using miter saw with circular blade suitable for cutting aluminum. 34% 34% Alu-Stair-Carpet Sample layout Alu-Edge wireless or wired RGBW controller 1.00 Ordering Extrusions are sold separately. View respective specsheets for details on ordering extrusions and their accessories (endcaps, mounting brackets, etc). + - receiver / decoder 24V PSV power supply repeater OPTIONAL REV0.7 page 4 of 4 www.luminii.com tel: 224-333-6033
Lampsplus.com