1 ETHERNET FIBER OPTIC CONVERTERS 1. 100Base-TX to 100Base-FX Converter (SUN-EC1312M) SUN-EC1312M series are SUN Telecom.'s answer to expanding existing Fast Ethernet Networks. A compact, reliable and high specification solution for the migration from copper to fiber based networks. The easy implementation and expansion of 100Base-TX/FX Networks can be further assured with this Converter. Added flexibility is available with ST and SC connectors. Extra distances are possible with the Single Mode version delivering up to 50km connectivity. Complies with 802.3u 100Base-TX/FX standard MDI/MDI-X push button selection for RJ-45 port connection 100Base-TX half/full duplex Auto- Negotiation support for NWay Switch devices-selectable "enable" or "disable"'. Extended distances up to 2km with SC, and up to 120km with Long Haul Single Mode SC connectors Compatible with other 100Base-TX/FX devices Status LEDs for RCV & LNK to easily monitor network configuration External power supply FCC Class A & CE approved Specifications: Standard Connector Max. Distance Unit LED IEEE 802.3u 100Base-TX/FX 1x shielded RJ-45, 1x ST or SC (Multi-mode) 1x shielded RJ-45, 1x SC (Single Mode)) UPT: 100 meters (Cat 5.) Fiber: 2,000 meters (Multi-mode) 20,000-120,000 meters (LH Single Mode) PWR: Illuminated for normal operation FD: Illuminated in full duplex operation pulses from complaint device
RCV: Illuminated or flashing when data packets are being transmitted 2 Delay Power Temp. Humidity Emissions Dimensions Weight Typically less than 23 Bit AC voltage to 12VDC @ 0.8A External power adapter Frequency: 47Hz to 63 Hz Operating: 0 to 70 Storage: -20 to 70 Operating: 10% to 80%RH Storage: 5% to 90%RH FCC Part 15 of Class A & CE approval 110.0 x 68.0 x 23.0mm (L x W x H) 158g Ordering Information: SUN-EC1312MC (2km) 100Base-TX to FX Multi-mode Converter (SC Connector) SUN-EC1312MSC-20 (20km) 100Base-TX to FX Single Mode Converter (SC Connector) SUN-EC1312MSC-40 (40km) (60km) (80km) (100km) (120km)
2. Single Mode, Single-Fiber/Dual-Direction Converters (SUN-EC232SS) 3 Overview: The transceivers of 100Mbps, 10M/100Mbps employ the single strand fiber technology to accomplish full duplex communications over just one strand of fiber by using two separate optical wavelengths, one to receive and the other to transmit the signal. This is a cost saving solution for long distance transmission with not only low cost in fiber optic cabling but also reduce the number of points-of-failure in normal two strand fibers when one strand has a break but not the other fiber. Fully compatible with IEEE 802.3, IEEE802.3u Support 10Base-T, 100Base-TX (UTP), 100Base-FX (Fiber) Transmission distance: 20~40Km (SM) Work mode: full duplex, half duplex, and full/half duplex auto-negotiation Wavelength: SM (1310nm, 1550nm) Twisted-pair connector: NODE/HUB or SWITCH (5 class UTP) Indicator light: PWR, TXL, SPD, FDX, RX, FXL Other Size: 165mm 115mm 33mm Weight: 0.854Kg Power: 100V~275VAC, 50~60Hz or -48VDC (selectable) Operating environment: Temperatur e: 0 ~50 Storage temperature: -20 ~ +70 Humidity: 5 ~ 95 (non condensation) Product compatible with those protocols: IEEE802.3; IEEE802.3u; IEEE802.3x; IEEE802.1d; IEEE802.1Q; IEEE802.1p Ordering Information: SUN-EC232SS-20 SUN-EC232SS-40 SUN-EC232SS-60 20Km, 10/100Mbps, SC, SM 40Km, 10/100Mbps, SC, SM 60Km, 10/100Mbps, SC, SM
3. SUN-MC Series Management Media Converter & Rack Chassis 4 RS-232 Local Area Network management Web Browser based monitoring Support Sun Solarise, HP SUNenView, Castle Rock Computing etc. software with SNMP And MIB II Telnet management: Support Telnet remote log in Hot plug and power redundancy Apply up to 15 slots of RJ45 or fiber module and unit IP address Remote control and auto healing 10M/100M, Full Duplex / Half Duplex controllable by local unit and remote unit Bandwidth management MDI/MDIX Auto switch Apply LLD Auto loop back detect, LLR Auto loop back failure report and LLCF Local unit report function Management Interface: -Connection status -Fiber mode (Single mode or Multimode) -Fiber connection failure detection (by SNMP) -Power status -Speed rate -Transmission mode (Full / Half Duplex) -PING detection -Remote unit detection -System boot up Specifications: Protocol Operation Fiber Transmission Distance IEEE802.3, 10Base-T; IEE802.3u, 100Base-T(UTP) and 100Base-Fx (Fiber) Full Duplex / Half Duplex auto negotiation Multimode 850nm,1300nm ; Single mode 1310nm,1550nm Multimode: 2Km-5Km; Single mode: 25Km; 50Km; 80Km; 120Km UTP Interface NODE\HUB or SWITCH CAT5 UTP Led Indicator PWR power, TXL Transmission, SPD(Speed rate),
Dimension Weight Power Supply FDX Full Duplex, RX Receiver, FXL Fiber status 426mmX278mmX111mm 5Kg Operation Temperature 0 ~60 Storage Temperature -10 ~70 Humidity 100V~275VAC; 50~60Hz or -48VDC 5%~95% (node condense) 5 Ordering Information: Model SUN-MC2312M-2 SUN-MC2322M-5 SUN-MC2322S-25 SUN-MC3322M-2 SUN-MC3322S-25 SUN-MC2324/34S-25 SUN-MC3422M-0.5-D1 SUN-MC3422S-10-D1 SUN-PM12 Description 10/100M internal multimode SC 850nm 2Km 10/100M internal multimode SC 1300nm 5Km 10/100M internal single mode SC1310nm 25Km 10/100M module multimode SC 1300nm 2Km 10/100M module single mode SC1310nm 25Km 10/100M single fiber single mode SC13/15nm 25Km 1000M network card multimode SC 850nm 0.5Km 1000M network card single mode SC1310nm 10Km 2U 16 slot rack chassis 110~220V/-48V power supply
4. 19-inch Multi-media Converter Chassis 6 19-inch multi-media converter chassis is designed to accommodate 16 slide-in modules of various type of media converter at a central location for multiple segments cross connection. Users can transparently link backbone equipment such as switches, routers to LAN workgroup segments. Because each channel operates independently, new modules may be added as required. This flexibility allows the unit to grow with the network. Installation is easy. Simply slide module into the chassis and the media is connected. All of the OPT-1600 modules are hot swappable thus eliminating costly network downtime. OPT-1600 series converter rack fits cleanly into any network environment. With a slim low profile chassis and a mix of 10Mbps, 100Mbps and Gigabit media converter cards, the OPT-1600 becomes the perfect solution for connecting today's evolving networks. Slim 2U design to save expensive data center space Intelligent management to efficiently monitor your critical connections Redundant power to prevent costly downtime Multiple choices of power, either 110~240 VAC or -48VDC to meet your application needs. All series products are hot swappable. Reliable products backed by years of experience in converter and optic networking Standards: IEEE802.3u 10/100Base-TX, 100Base-FX Cable: UTP Cable: Cat. 5 cable and up to 100m Single Fiber Cable Recommended: 9/125m single-mode Optional: 8.3/125, 8.7/125, or 10/125m single-mode Base Units: LAN Port: The LAN port for in-band management Console Port: The console port for out-of-band management Management LED Slot Capacity: 16 Slots for modular Media converter (Per slot DC Power Output: 1A @+5VDC) Ambient Temperature: 0~50 C Humidity: 5~90% Dimensions: 90(H) x 424(W) x 230(D) mm (mountable for 19-inch rack) Certification: FCC Part 15 Class A & CE Mark
Ordering Information: 7 Model Fiber Distance Wavelength KM nm Connector SUN-EC3322S-20 0 20 SUN-EC3322S-40 SM 0 40 1310 SUN-EC3322S-60 Dual fiber 0 60 SUN-EC3332S-80 10/100M 0 80 SUN-EC3332S-100 0 100 1550 SUN-EC3312M-2 MM 0 2 850 SC SUN-EC3322M-2 Dual fiber 10/100M 0 2 1300 SUN-EC3324/34S-20 SM 0 20 1310/1550 SUN-EC3324/34S-40 Simplex 0 40 pair SUN-EC3324/34S-60 10/100M 0 60 SUN-D1 AC 200-260V 50-60HZ power supply SUN-D2 DC 48V power supply SUN-PE11 19" 2U rack chassis one power supply 220V SUN-PE12 19" 2U rack chassis one power supply 220V SUN-PE21 19" 2U rack chassis one power supply -48V SUN-PE22 19" 2U rack chassis two power supply -48V SUN-PM11 19" 2U rack chassis one power supply 220V SUN-PM12 19" 2U rack chassis one power supply 220V SUN-PM21 19" 2U rack chassis one power supply -48V SUN-PM22 19" 2U rack chassis one power supply -48V SUN-MCU Network management module SUN-P1 Rack power supply module 220V SUN-P2 Rack power supply module -48V Power AC 200-260V 50-60HZ or DC-48V